热脱附-气相色谱法测定空气中的总挥发性有机化合物研究

建立了热脱附-毛细管气相色谱法测定空气中苯、甲苯、乙酸丁酯、乙苯、对/间二甲苯、邻二甲苯、苯乙烯和十一烷等挥发性有机物的检测方法。九种挥发性有机物在一定浓度范围内标准曲线线性良好,相关系数均在0.997~0.999之间。检出限在0.002~0.005 mg/m3(采样体积1.0 L计)。用该方法检测了企业产生的有机废气及厂区周边环境空气,实验结果表明该方法灵敏度高、操作简单、重现性好、准确可靠,能够满足对实际样品的分析要求。     

金属氧化物降解六氯苯的活性比较及催化机理研究

以氧化铝(α-Al_2O_3、γ-Al_2O_3)、氧化钙(CaO)、过渡金属氧化物(Mn O_2、α-Fe_2O_3、γ-Fe_2O_3、Ni_2O_3、CuO)为催化剂,考察了催化剂种类、添加比例等因素对六氯苯(Hexachlorobenzene,HCB)降解效果和产物组分的影响.结果表明,催化效果随催化剂添加比例的提高显著增加.在反应温度为350℃,反应时间1 h,金属氧化物添加比例为100∶1的条件下,碱土金属氧化物CaO及过渡金属氧化物中的α-Fe_2O_3和Ni_2O_3降解活性较好,这3种氧化物对HCB的降解率分别达到65.5%、100.0%和100.0%,脱氯率D_1分别为54.4%、81.9%和77.5%.HCB降解有机产物分析结果显示,8种金属氧化物与HCB样品反应产物中均存在低氯代苯,在α-Fe_2O_3和Ni_2O_3的催化作用下有2~4氯代低氯苯检出,说明在降解过程中存在明显的逐级脱氯/加氢反应;与CaO反应后的产物中低氯代苯较少,经拉曼光谱定性分析,有无序碳的检出,说明除了脱氯/加氢还存在脱氯缩合反应.     

The boiling liquid expanding vapour explosion

The boiling liquid expanding vapour explosion (BLEVE) has existed for a long time and for most of this time it has been cloaked in mystery. Several theories have been put forward to explain this very energetic event but none have been proven. This paper describes a series of tests that have recently been conducted to study this phenomenon.

The study involved ASME code automotive propane tanks with nominal capacities of 400 litres. The tanks were exposed to a combination of pool and/or torch fires. These fire conditions led to thermal ruptures, and in some cases these ruptures resulted in BLEVEs. The variables in the tests were the pressure-relief valve setting, the tank wall thickness, and the fire condition.

In total, 30 tests have been conducted, of which 22 resulted in thermal ruptures. Of those tanks that ruptured, 11 resulted in what we call BLEVEs. In this paper, we have defined a BLEVE as the explosive release of expanding vapour and boiling liquid following a catastrophic tank failure. Non-BLEVEs involved tanks that ruptured but which only resulted in a prolonged jet release.

The objective of this study was to investigate why certain tank ruptures lead to a BLEVE rather than a more benign jet-type release. Data are presented to show how wall temperature, wall thickness, liquid temperature and fill level contribute to the BLEVE process.     

VARIABILITY IN THERMAL STRATIFICATION IN A RESERVOIR1

ABSTRACT: The thermal stratification characteristics of a flow-augmentation reservoir, Round Valley Reservoir, New Jersey, and attendant driving conditions were documented and analyzed for portions of three years. Substantial differences in the thermal stratification regime of the reservoir occurred in response to the documented changes in meteorological, operating, and light penetration conditions. The features of stratification that were affected included: the depth of the upper mixed layer, the average temperature of the epilimnion, the temperature gradient in the metalimnion, and the average temperature in the hypolimnion.     

废塑料生产汽柴油技术分析与应用中的误区

从废塑料生产汽柴油技术的工艺流程入手，对该项技术中存在的一些问题进行了分析，内容涉及原料来源及范围，裂化反应条件，传热与除焦，油品质量及收率，新形成的污染和经济效益评估等；指出了此项技术在应用中存在的误区。     

DISTRIBUTED DISCHARGE OF COOLING WATER ALONG DIRECTION OF STREAM FLOW1

ABSTRACT. A multiple-outfall system for cooling water disposal which is distributed along the direction of stream flow is analyzed. The results provide a simple method of preliminary design of a cooling water discharge outfall system and for a quick extimate of water quality of a polluted stream. It is shown that a properly designed distributed discharge system is capable of preventing serious pollution due to localized discharge of wastes and waste heat; however, the final design of the discharge system should take into account alternative schemes of waste heat disposal and their economic consequences.     

ECOLOGICAL MANAGEMENT PROBLEMS CAUSED BY HEATED WASTE WATER DISCHARGE INTO THE AQUATIC ENVIRONMENT1

Discharge of heated waste water may affect the entire aquatic ecosystem–the interrelated biological, chemical, physical system–and, if the temperature change is large, may destroy the capacity of the ecosystem to serve a variety of beneficial purposes. However, it is possible to discharge heated waste water in carefully controlled amounts without seriously degrading the aquatic ecosystem. There are four basic alternatives which are open to us with regard to the heated waste water problem which we may choose singly or in various combinations: (1) Placing all heated, waste water in streams, lakes, and oceans without regard to the effects. Thus considering the environmental damage as a necessary consequence of our increased power demand. (2) Using, but not abusing, existing ecosystems. This means regulating the heated waste water discharge to fit the receiving capacity of the ecosystem. (3) Finding alternative ways to dissipate or beneficially use waste heat. (4) Modifying ecosystems to fit the new temperature conditions. We are all dependent upon a life-support system which is partly industrial and partly ecological. Unfortunately, we have reached a stage of development where the non-expandable, ecological portion of our life-support system is endangered by the expanding industrial portion. Optimal function and full beneficial use of both portions of our life-support system will only be possible if a variety of disciplines and diverse points of view can cooperate and work together effectively. Since wastes in amounts that are acceptable taken one at a time may be lethal collectively, environmental management should be on a regional basis.     

DIGITAL SIMULATION OF THE EFFECT OF THERMAL DISCHARGE ON STREAM WATER QUALITY1

A modified transient version of the Streeter-Phelps model along with the energy balance equation is employed to analyze the effects of waste heat discharge from power plants on stream water quality. Analysis is also made to examine the effects of the upstream water quality and stream velocity on the downstream DO concentration level. The resulting coupled nonlinear hyperbolic partial differential equations representing the energy, BOD and DO concentrations are solved by the method of characteristics and simulated on a digital computer. Final numerical results indicate that the allowable quantity of thermal discharge does heavily depend on the upstream quality.     

锚索拉断火花引爆瓦斯的实验研究

设计了锚索拉断火花引爆瓦斯实验装置 ,在瓦斯浓度为爆炸范围的环境中 ,对锚索拉断时产生火花规律及引起瓦斯爆炸的可能性进行了一系列实验研究。结果表明 :锚索拉断产生火花的概率为 5 0 % ,锚索钢绞线破断产生的火花不能引起瓦斯爆炸。采用红外热成象仪对锚索拉断火花温度的测试表明 ,锚索拉断产生的火花最高温度远小于瓦斯爆炸所需的最低点燃温度 6 5 0℃。