生态工程组合工艺应用于城市污水处理厂尾水深度处理

针对城市污水处理厂尾水的特点,采用生态氧化池／垂直流人工湿地／自然湿地生态工程组合工艺对其进行深度处理,重点分析了运行效果和去除机理。数据结果表明,该工艺运行稳定,系统出水COD,BOD5,NH3-N和TP平均分别为14．4,3．4,0．84,0．19mg／L,平均去除率均在65％以上,出水水质达到《地表水环境质量标准》（GB3838-2002）中Ⅳ类标准。     

沈阳市地铁疏干水的利用探析

针对沈阳市地铁疏干水利用的现状,综合考虑沈阳市的实际情况,总结出地铁疏干水利用的几种方法,主要包括作为运河、湖泊的补换水源,用于修复、重建湿地,农业灌溉用水以及作为水源热泵的水源等。提出沈阳市地铁疏干水利用的指导思想和法律保障。     

液中放电应用于TNT废水的降解

研究了液中放电处理ＴＮＴ废水的可行性及其能量效率关系。实验结果表明,液中放电法可以快速有效地降解废水中的ＴＮＴ。在单次电储能为２５０Ｊ。电极距离为５ｍｍ,ＴＮＴ初始浓度为３６ｍｇ／Ｌ条件下,降解率达８５％。     

Resource utilization of drinking water treatment aluminum sludge in green cementing materials:Hydration characteristics and hydration kinetics

As a byproduct of water treatment,drinking water treatment aluminum sludge(DWTAS)has challenges related to imperfect treatment and disposal,which has caused potential harm to human health and the environment.In this paper,heat treatment DWTAS as a supplement cementitious material was used to prepare a green cementing material.The results show that the 800℃ is considered as the optimum heat treatment temperature for DWTAS.DWTAS-800℃ is fully activated after thermal decomposition to form incompletely crystallized highly active γ-Al2O3 and active SiO2.The addition of DWTAS promoted the formation of ettringite and C-(A)-S-H gel,which could make up for the low early compres-sive strength of cementing materials to a certain extent.When cured for 90 days,the com-pressive strength of the mortar with 30％ DWTAS-800℃ reached 44.86 MPa.The dynamic process was well simulated by Krstulovic-Dabic hydration kinetics model.This study pro-vided a methodology for the fabrication of environmentally friendly and cost-effective com-pound cementitious materials and proposed a\"waste-to-resource\"strategy for the sustain-able management of typical solid wastes.     

New indicator approaches for effective urban air quality management

Measurements of urban air quality at monitoring stations in developed countries have frequently involved the criteria gaseous pollutants, particulates, hazardous air pollutants, perceived air quality and relevant meteorological conditions. Large numbers of indicators have therefore been established to quantify emissions, concentrations and environmental and human health impacts of each of these groups of substances. To simplify the data for management, several indicators have been grouped together to form urban air quality indices but the weightings of individual variables is contentious. In industrialising and developing countries, data may be limited and traditional air pollutant indicators cannot often be constructed. The emphasis therefore has to be placed on the development of policy-relevant indicators, such as Response Indicators that reflect different policy principles for regulating air pollutant emissions. Indices that quantify the air quality management capabilities and capacities at the city level provide further useful decision-relevant tools. Four sets of indices, namely, 1. air quality measurement capacity, 2. data assessment and availability, 3. emissions estimates, and 4. management enabling capabilities, and a composite index to evaluate air quality management capability, were constructed and applied to 80 cities. The indices revealed that management capability varied widely between the cities. In some of the cities, existing national knowledge on urban air quality could have been more effectively used for management. It was concluded that for effective urban air quality management, a greater emphasis should be given, not just to monitoring and data capture programmes, but to the development of indicators and indices that empower decision-makers to initiate management response strategies. Over-reliance on restricted, predetermined sets of traditional air quality indicators should be avoided.     

Main particulate matter components in Saxony (Germany)

Aerosol filter samples have been collected nearby the industrialised basin of Leipzig in Saxony (Germany) at the research station Melpitz of the Institut für Troposphärenforschung e.V. (IfT). Time series (1992–1998) and a three year comparison (1995–1997) of two different aerosol filter sampling systems, the Sierra-Andersen-PM 10 high volume sampler (daily sample, PM 10 inlet) and the Rupprecht and Patashnik Co. Inc. Model Partisol 2000 (weekly sample, PM 10 and PM 2.5 inlet) are presented and discussed. The comparison of the different sampling systems and strategies yields small differences between the daily and weekly samples for mass and different ions, which may be influenced by sampling duration and flow rates. A general trend of change in aerosol composition was observed: Soot and Sulphate concentrations decreased whereas Nitrate and Ammonium concentrations increased. During summers the mass of coarse particles is higher than in other seasons. One reason could be found in the occurence of longer periods of dry ground surfaces enabling reemission of crustal and biological material. The time series have been integrated in a longer historical aerosol mass trend for Saxony and do show a good agreement. Since 1990 a significant downward trend in gravimetric mass concentration was found.     

Measurements of peroxyacyl nitrates (PANS) in Mexico City: implications for megacity air quality impacts on regional scales

Peroxyacyl nitrates (PANs) were measured using gas chromatography with electron capture detection (GC/ECD) in north central Mexico City during February–March of 1997. Peroxyacetyl nitrate (PAN) was observed to exceed 30 ppb during five days of the study, with peroxypropionyl nitrate (PPN) and peroxybutryl nitrate (PBN) reaching 6 and 1 ppb maximum, respectively. Levels of total PANs typically exceeded 10 ppb during the period of measurement and showed a very strong diurnal variation with PANs maximum during the early afternoon and falling to less than 0.1 ppb during the evening hours. These levels of PANs are the highest reported values in North America (and the world) for an urban center, since levels of approximately 30 ppb were reported during the late 1970s in the Los Angeles area (South Coast Air Basin, Tuazon et al., 1978). Hydrocarbon measurements indicate that the levels of olefins, specifically butenes are significant in Mexico City. A time series taken of source indicator hydrocarbons taken before and during a Mexican National Holiday with reduced automobile traffic clearly show that mobile sources of butenes are as important as liquefied petroleum gas. Observations of 10–40 ppb C methyl-t-butyl ether (MTBE) are consistent with MTBE/gasoline fuel usage as a source of isobutene and formaldehyde. Both these reactive species can lead to increased oxidant and PAN formation. The strong diurnal profiles of PANs are consistent with regional clearing of the Mexico City air basin on a daily basis. Estimates are given using a simple box model calculation for a number of key primary and secondary pollutant emissions from this megacity on an annual basis. These calculations indicate that megacities can be important sources of both primary and secondary pollutants, and that PANs produced in megacity environments are likely to contribute strongly to regional scale ozone and aerosol productions during long range transport.     

中低温厌氧处理城市污水污泥颗粒化的研究

用高径比为3：1的UASB反应器分别在35℃和室温条件下处理模拟城市污水,研究了污泥的颗粒化过程.比较了在不同温度、浓度下形成的颗粒污泥的特征.水温为9～25℃,进水浓度为100～200 mg COD/L,水力上流速度（Vup）在0.013～0.11 m/h的4^#UASB反应器在60 d内在形成了成熟的颗粒污泥.研究表明,进水中低的有机物浓度,低的Ca^2＋、Mg^2＋浓度和低的Vup没有抑制颗粒化进程.     

焦炉装煤烟尘治理方案的探讨

焦炉装煤烟尘含有害物质，污染环境，危害人体健康。袋式除尘器的使用，消除了烟尘的污染，但因投资大、运行费用高、操作复杂，难以得到快速、广泛的推广。根据实验结果和已有应用情况，本文推荐了三相流化床除尘装置和颗粒层除尘器，它们可用于焦炉装煤烟尘治理，其投资和运行费用会大大降低。