The interaction between physical and social-psychological factors in indoor environmental health

Indoor environmental health is now recognized as an important factor in preventing respiratory health problems in the United States. It is also a concern in Canada due to the amount of time that Canadians spend indoors because of cold weather and the potential for increased time indoors during the summer if theclimate warms. The negative health effects are often labeled assick building syndrome, but diagnosing a building or itsoccupants as sick is complicated by the variety of symptoms, thepresence of chronic versus acute symptoms and social andpsychological (socio-psychological) factors that may reduce theeffectiveness of an engineering solution. As a case study, thecontribution of various factors to indoor environmental health,in three buildings at the University of Toronto, was examinedusing five different methods. The results indicate that theinhabitants of the buildings consider features other than airquality in considering building health such as design,maintenance, funding cuts and socio-psychological factors.     

Cadmium solubility and sorption in a long-term sludge-amended arable soil

Cadmium solubility and sorption in an arable clay loam soil that had received sewage sludge for 41 years were compared to an unsludged control in batch studies. Soil pH dominated Cd sorption, explaining >92% of the variation in Kd values in both treatments. At any pH, Cd sorption was apparently slightly but significantly (p < 0.05) smaller in the sludge-amended soil compared to the control, even though the organic carbon content was 70% larger and the ammonium oxalate-extractable iron content was roughly doubled. Correction for dissolved organic carbon (DOC) complexation with the speciation model WHAM reduced the difference in sorption between treatments, but the sludged soil still had significantly smaller Kd values (p < 0.01). Batch equilibrations without addition of Cd showed that there was no significant difference in the solubility of "native" cadmium (defined as EDTA-extractable Cd) in sludged and control soils. The reason for the lack of increase in Cd sorption in the sludge-amended soil has not been established, but it may be due to competition for sorption sites on humic compounds with sludge-derived Fe and trace metals such as zinc. The fact that the pyrophosphate-extractable (i.e., organically associated) iron content was seven times larger in the sludged soil provides some supporting evidence for this hypothesis.     

Development of a biaxial loading frame for sheet metal

Characterization of the evolving yield loci and forming limit diagrams for sheet materials under biaxial loading is necessary for the development of accurate sheet metal forming process simulations. Biaxial tension testing has been shown to have significant advantages over the current computational and experimental methods for such material characterization; however, the few commercially available loading frames are far too large and expensive to be practical for most metal forming research laboratories. In this paper, the design of a practical servohydraulic biaxial loading frame is presented. The design, control, and operation of the loading frame are discussed in detail, and experimental data is provided to validate the effectiveness of the control system with respect to specimen center shifting.     

Connecting the dots: mapping habitat connectivity for tigers in central India

Large connected landscapes are paramount to maintain top predator populations. Across their range, tiger (Panthera tigris) populations occur in small fragmented patches of habitat, often isolated by large distances in human-dominated landscapes. We assessed connectivity between 16 protected areas (PAs) in central India, a global priority landscape for tiger conservation, using data on land use and land cover, human population density, and transportation infrastructure. We identified and prioritized movement routes using a combination of least-cost corridor modeling and circuit theory. Our analyses suggest that there are several opportunities to maintain connectivity in this landscape. We mapped a total of thirty-five linkages in the region and calculated metrics to estimate their quality and importance. The highest quality linkages as measured by the ratio of cost-weighted distance to Euclidean distance are Kanha–Phen/Bandhavgarh–SanjayGhasidas/Melghat–Satpura, and cost-weighted distance to least-cost path length are Nawegaon–Tadoba/Achanakmar–SanjayGhasidas/Kanha–Phen. We used current flow centrality to evaluate the contribution of each PA and linkage toward facilitating animal movement. Values are highest for Kanha and Pench tiger reserves, and the linkages between Kanha–Phen, Kanha–Pench, and Pench–Satpura, suggesting that these PAs and linkages play a critical role in maintaining connectivity in central India. In addition, smaller areas such as Bor, Nawegaon, and Phen have high centrality scores relative to their areas and thus may act as important stepping stones. We mapped pinch points, which are sections of the linkages where tiger movement is restricted due to unfavorable habitat, transportation networks, human habitation, or a combination of factors. Currently, very limited data exist on tiger movement outside of PAs to validate model results. Regional-scale connectivity mapping efforts can assist managers and policy makers to develop strategic plans for balancing wildlife conservation and other land uses in the landscape.     

Mold spore penetration through wall service outlets: a pilot study

A pilot study was conducted to estimate fungal spore penetration for wall service outlets subjected to a constant air pressure. During the laboratory experiment, a wall chamber was fabricated, and telephone, electrical, and cable service outlets were installed. Penicillium chrysogenum spores were aerosolized into the chamber that was held under pressure. Spores that penetrated the outlets were funneled into an impinger for microscopic enumeration. Thirty trials were conducted for each of the five outlets (N?= 150), and the wall chamber was decontaminated between trials. Results of an analysis of variance suggest wall service outlets allow spore penetration. The penetration factor for the telephone outlet was significantly greater than all other outlets (p?< 0.05), and there was no difference in penetration between electrical outlets with and without plugs. Penetration factor differences were attributed to air leakage rates across the outlets. Due to the experimental design and equipment limitations, further research is needed to support these findings.     

Phytoremediation of a Petroleum‐Hydrocarbon Contaminated Shallow Aquifer in Elizabeth City,North Carolina,USA

A former bulk fuel terminal in North Carolina is a groundwater phytoremediation demonstration site where 3,250 hybrid poplars, willows, and pine trees were planted from 2006 to 2008 over approximately 579,000 L of residual gasoline, diesel, and jet fuel. Since 2011, the groundwater altitude is lower in the area with trees than outside the planted area. Soil‐gas analyses showed a 95 percent mass loss for total petroleum hydrocarbons (TPH) and a 99 percent mass loss for benzene, toluene, ethylbenzene, and xylenes (BTEX). BTEX and methyl tert‐butyl ether concentrations have decreased in groundwater. Interpolations of free‐phase, fuel product gauging data show reduced thicknesses across the site and pooling of fuel product where poplar biomass is greatest. Isolated clusters of tree mortalities have persisted in areas with high TPH and BTEX mass. Toxicity assays showed impaired water use for willows and poplars exposed to the site's fuel product, but Populus survival was higher than the willows or pines on‐site, even in a noncontaminated control area. All four Populus clones survived well at the site. © 2014 Wiley Periodicals, Inc.*     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Development of competitive immunoassays to hydroxyl containing fungicide metabolites

This paper describes the isolation of monoclonal antibodies and the development of competitive immunoassays to pesticide metabolites of the fungicides imazalil, carbendazim and thiabendazole. The metabolite specific hydroxyl residues were used as the reactive group with which to link the metabolite to the carrier proteins Keyhole Limpet Haemocyanin (KLH) and Bovine Serum Albumin (BSA). In each case immune responses in mice were raised and monoclonal antibodies were produced. Antibodies were developed into competitive ELISAs to the appropriate metabolite. The antibody raised to a metabolite of imazalil was optimised into a competitive ELISA format which had an assay IC50 of 7.5 μg/L and a limit of detection (LOD) of 1.1 μg/L. A single antibody isolated against the metabolite of carbendazim had assay IC50s of 3.2 and 2.7 μg/L for the metabolites of carbendazim and thiabendazole respectively with an LOD of 0.38 μg/L for both. These sensitive immunoassays may have application in the monitoring of human exposure to these fungicide residues either by occupational or non-occupational routes.     

Evaluation of catalyzed and electrically heated filters for removal of particulate emissions from diesel-A- and JP-8-fueled engines

In-service diesel engines are a significant source of particulate matter (PM) emissions, and they have been subjected to increasingly strict emissions standards. Consequently, the wide-scale use of some type of particulate filter is expected. This study evaluated the effect of an Engelhard catalyzed soot filter (CSF) and a Rypos electrically heated soot filter on the emissions from in-service diesel engines in terms of PM mass, black carbon concentration, particle-bound polycyclic aromatic hydrocarbon concentration, and size distribution. Both filters capture PM. The CSF relies on the engine's exhaust to reach the catalyst regeneration temperature and oxidize soot, whereas the electrically heated filter contains a heating element to oxidize soot. The filters were installed on several military diesel engines. Particle concentrations and compositions were measured before and after installation of the filter and again after several months of operation. Generally, the CSF removed at least 90% of total PM, and the removal efficiency improved or remained constant after several months of operation. In contrast, the electrical filters removed 44-69% of PM mass. In addition to evaluating the soot filters, the sampling team also compared the results of several real-time particle measurement instruments to traditional filter measurements of total mass.