A new THOR shoulder design: a comparison with volunteers, the Hybrid III, and THOR NT

OBJECTIVE: Since the shoulders are rarely seriously injured in frontal or oblique collisions, they have been given low priority in the development of frontal impact crash test dummies. The shoulder complex geometry and its kinematics are of vital importance for the overall dummy kinematics. The shoulder complex also influences the risk of the safety belt slipping off the shoulder in oblique forward collisions. The first aim of this study was to develop a new 50th percentile male THOR shoulder design, while the second was to compare the new shoulder, mounted on a THOR NT dummy, with volunteer, THOR NT, and Hybrid III range of motion and stiffness data. The third aim was to test the repeatability of the new shoulder during dynamic testing and to see how the design behaves with respect to belt slippage in a 45 degrees far-side collision. METHODS: The new 50th percentile THOR shoulder design was developed with the aid of a shell model of the seated University of Michigan Transportation Research Institute (UMTRI) 50th percentile male with coordinates for joints and bony landmarks (Schneider et al., 1983). The new shoulder design has human-like bony landmarks for the acromion and coracoid processes. The clavicle curvature and length are also made similar to that of a male human, as is the range of motion in the anterior-posterior, superior-inferior, and medial-lateral directions. The new shoulder design was manufactured and tested under the same conditions that T?rnvall et al. (2005b) used to compare the shoulder range of motion for the volunteers, Hybrid III, and THOR Alpha. The new design was also tested in two dynamic test configurations: the first was a 0 degrees full-frontal test and the second was a 45 degrees far-side test. The dummy tests were conducted with an R-16 seat with a three-point belt, the Delta V was 27.0+/-0.5 km/h and the maximum peak acceleration was approximately 14.6+/-0.5 g for each test. RESULTS: A new shoulder design with geometry close to that of humans was developed to be retrofitted to the THOR NT dummy. The results showed that the range of motion for the new shoulder complex during static loading was larger by at least a factor of three, for the maximum load (200 N/arm), than that of either the Hybrid III or the THOR NT; this means it was more similar to the volunteers' range of motion. It was observed that the THOR NT with the new shoulder did not slide out of the shoulder belt during a far-side collision. The performance of the new shoulder was reasonably repeatable and stable during both the static tests and the sled tests. CONCLUSION: A new shoulder for the THOR NT has been designed and developed, and data from static range of motion tests and sled tests indicate that the new shoulder complex has the potential to function in a more human-like manner on the THOR dummy.     

Effect of Aging on Brain Injury Prediction in Rotational Head Trauma—A Parameter Study with a Rat Finite Element Model

Objective: The aim of this study was to investigate the possible effects of age-related intracranial changes on the potential outcome of diffuse axonal injuries and acute subdural hematoma under rotational head loading.

Methods: A simulation-based parametric study was conducted using an updated and validated finite element model of a rat head. The validation included a comparison of predicted brain cortex sliding with respect to the skull. Further, model material properties were modified to account for aging; predicted tissue strains were compared with experimental data in which groups of rats in 2 different lifecycle stages, young adult and mature adult, were subjected to rotational trauma. For the parameter study, 2 age-dependent factors—brain volume and region-specific brain material properties—were implemented into the model. The models young adult and old age were subjected to several injurious and subinjurious sagittal plane rotational acceleration levels.

Results: Sequential analysis of the simulated trauma progression indicates that an increase in acute subdural hematoma injury risk indicator occurs at an early stage of the trauma, whereas an increase in diffuse axonal injury risk indicators occurs at a later stage. Tissue stiffening from young adult to mature adult rats produced an increase in strain-based thresholds accompanied by a wider spread of strain distribution toward the rear part of the brain, consistent with rotational trauma experiments with young adult and mature adult rats. Young adult to old age brain tissue softening and brain atrophy resulted in an increase in diffuse axonal injuries and acute subdural hematoma injury risk indicators, respectively.

Conclusions: The findings presented in this study suggest that age-specific injury thresholds should be developed to enable the development of superior restraint systems for the elderly. The findings also motivate other further studies on age-dependency of head trauma.     

The two reindeer parasites,Hypoderma tarandi andCephenemyia trompe (Oestridae), have evolved similar olfactory receptor abilities to volatiles from their common host

Summary Using the linked gas chromatographical/electroantennogram (GC/EAG) technique it was revealed that the reindeer warble fly (H. tarandi) was specifically able to sense the same components from reindeer interdigital pheromone gland as the reindeer nose bot fly (C. trompe) another reindeer endoparasite. These two species belong to the same family (Oestridae), but different subfamilies, and the evolution towards an endoparasitic life cycle is thought to have been independent. The development of olfactory abilities to find reindeer from long distances is hypothesized to have taken place through convergent evolution or exists because of their common ancestry.     

Co-digestion of grease trap sludge and sewage sludge

Redirection of organic waste, from landfilling or incineration, to biological treatment such as anaerobic digestion is of current interest in the Malmö-Copenhagen region. One type of waste that is expected to be suitable for anaerobic digestion is sludge from grease traps. Separate anaerobic digestion of this waste type and co-digestion with sewage sludge were evaluated. The methane potential was measured in batch laboratory tests, and the methane yield was determined in continuous pilot-scale digestion. Co-digestion of sludge from grease traps and sewage sludge was successfully performed both in laboratory batch and continuous pilot-scale digestion tests. The addition of grease trap sludge to sewage sludge digesters was seen to increase the methane yield of 9–27% when 10–30% of sludge from grease traps (on VS-basis) was added. It was also seen that the grease trap sludge increases the methane yield without increasing the sludge production. Single-substrate digestion of grease trap sludge gave high methane potentials in batch tests, but could not reach stable methane production in continuous digestion.     

Tank-connected food waste disposer systems – Current status and potential improvements

An unconventional system for separate collection of food waste was investigated through evaluation of three full-scale systems in the city of Malmö, Sweden. Ground food waste is led to a separate settling tank where food waste sludge is collected regularly with a tank-vehicle. These tank-connected systems can be seen as a promising method for separate collection of food waste from both households and restaurants. Ground food waste collected from these systems is rich in fat and has a high methane potential when compared to food waste collected in conventional bag systems. The content of heavy metals is low. The concentrations of N-tot and P-tot in sludge collected from sedimentation tanks were on average 46.2 and 3.9 g/kg TS, equalling an estimated 0.48 and 0.05 kg N-tot and P-tot respectively per year and household connected to the food waste disposer system. Detergents in low concentrations can result in increased degradation rates and biogas production, while higher concentrations can result in temporary inhibition of methane production. Concentrations of COD and fat in effluent from full-scale tanks reached an average of 1068 mg/l and 149 mg/l respectively over the five month long evaluation period. Hydrolysis of the ground material is initiated between sludge collection occasions (30 days). Older food waste sludge increases the degradation rate and the risks of fugitive emissions of methane from tanks between collection occasions. Increased particle size decreases hydrolysis rate and could thus decrease losses of carbon and nutrients in the sewerage system, but further studies in full-scale systems are needed to confirm this.     

Identification of Characteristic Regions and Representative Stations: A Study of Water Quality Variables in the Kattegat

Gradients in nutrient distributions and the effects of eutrophication are common features in most coastal marine areas. These structures occur in aquatic systems due to spatial differences in hydrography, nutrient loading and key biogeochemical processes. Two statistical methods, cluster analysis and probability mapping, have been used in the present study to determine characteristics and patterns in water quality variables. Combined, these two methods provide a useful tool to statistically determine spatial homogeneity and representativity of areas and stations. A case study is presented here in which water quality variables (salinity, dissolved inorganic nitrogen, dissolved inorganic phosphorus and chlorophyll) in surface waters of the Kattegat are analysed for the time period 1993-1997. It was found that morphology, the proximity to sources of nutrient loading from land, nutrient uptake and the infrequent water exchange between the Baltic Sea in the south and the Skagerrak in the north all contribute to create distinct regions of water quality. Regions with concentrations significantly different from the overall mean are identified. In addition to identification of regions with similar characteristics, representative stations (as well as not representative stations) for the respective regions were made. This type of information can be used to design new or revise old monitoring programs.     

Beat frequency of cilia in the branchial basket of the ascidian Ciona intestinalis in relation to temperature and algal cell concentration

To elucidate the effects of temperature and algal cell concentration on pumping of water in the ascidian Ciona intestinalis a number of different experiments were performed. Beat frequency of the lateral cilia in the openings of the branchial sac was measured in intact specimens using a microprojection objective and a monochrome CCD video camera. At constant low algal cell concentration, beat frequencies increased linearly with temperature from 4.0 Hz (±0.5) at 7.4 °C to 13.6 Hz (±1.6) at 20.1 °C. At a constant temperature of 15 °C, beat frequency decreased with increasing algal cell concentration from approximately 3000 to >10 000 Rhodomonas sp. cells ml⁻¹. The decrease was observed both in experiments where the ascidians had been acclimated to a fixed algal cell concentration and in experiments with changing concentrations. Effect of algal cell concentration on squirting/siphon closure and flow velocity in the exhalent siphon was measured using a thermistor. At low algal cell concentrations, flow velocity in the exhalent siphon was stable, apart from a few short squirts. At very high algal cell concentrations, the flow velocity was reduced and much less stable, with prolonged squirting. The effect of gut content on filtration was studied in experiments with specimens acclimated to high algal cell concentrations. Results showed a close relation between gut clearance and filtration rate. From the experimental results and a qualitative analysis of the Ciona-pump it was concluded that the ciliary beat frequency is proportional to the water flow through the sea squirt and that changes in pumping caused by temperature or algal cell concentration are under nervous control or governed by enzyme kinetics, rather than being a result of physico-mechanical properties, i.e. pump efficiency versus flow resistance, of the ascidian pump. Received: 6 October 1997 / Accepted: 8 October 1998     

Synthesis of [14C]biphenyl and of some chlorinated [14C]biphenyls containing 4-chloro-, 2,4-dichloro- and 2,3,6-trichlorophenyl nuclei from the corresponding labelled anilines

The preparation of ¹⁴C-labelled biphenyl, 2,5-dichlorobiphenyl, 2,4′,5-trichlorobiphenyl, 2,2′,4,5′-tetrachlorobiphenyl, 2′,3,4,4′,5-pentachlorobiphenyl, 2,2′,3,4,4′-pentachlorobiphenyl, 2,3,3′,4′,6-pentachlorobiphenyl and 2,2′,3,3′,6-pentachlorobiphenyl is described [¹⁴C]Aniline hydrogen sulfate used as a starting material was acetylated, chlorinated and deacetylated followed by coupling to benzene or an appropriate chlorobenzene to give the biphenyls labelled in the phenyl nuclei having chlorine atoms at the 4-, 2,4- or 2,3,6-positions, respectively. The structures of the labelled compounds were established by comparison with authentic samples among which 2′,3,4,4′,5- and 2,2′,3,4,4′-pentachlorobiphenyl were not earlier described.A simple method for the preparation of 2,3,6-trichloroacetanilide, unlabelled and labelled, was worked out. 2,6-Dichloroacetanilide in concentrated hydrochloric acid gave the $\text{meta}$ substituted product when treated with chlorine.An improved thin layer chromatographic technique utilizing plates impregnated with certain tetraalkylammonium salts was used for separation of some of the labelled compounds prepared.