Use of waste gypsum to replace natural gypsum as set retarders in portland cement

The present study is focused on clarifying the influence of waste gypsum (WG) in replacing natural gypsum (NG) in the production of ordinary Portland cement (OPC). WG taken from slip casting moulds in a ceramic factory was formed from the hydration of plaster of paris. Clinker and 3–5 wt% of WG was ground in a laboratory ball mill to produce cement waste gypsum (CMWG). The same procedure was repeated with NG to substitute WG to prepare cement natural gypsum (CMNG). The properties of NG and WG were investigated via X-ray Diffraction (XRD), X-ray fluorescence (XRF) and differential scanning calorimetry (DSC)/thermogravimetric (TG) to evaluate the properties of CMNG and CMWG. The mechanical properties of cement were tested in terms of setting time, flexural and compressive strength. The XRD result of NG revealed the presence of dihydrate while WG contained dihydrate and hemihydrate. The content of dihydrate and hemihydrates were obtained via DSC/TG, and the results showed that WG and NG contained 12.45% and 1.61% of hemihydrate, respectively. Furthermore, CMWG was found to set faster than CMNG, an average of 15.29% and 13.67% faster for the initial and final setting times, respectively. This was due to the presence of hemihydrate in WG. However, the values obtained for flexural and compressive strength were relatively the same for CMNG and CMWG. Therefore, this result provides evidence that WG can be used as an alternative material to NG in the production of OPC.     

Estimation of crop residue in China based on a Monte Carlo analysis

Accurate crop residue resource estimation is important for bioenergy development.This is done by the ratio of residue to grain(R/G),which is usually regarded constant and is widely used for crop residue estimation though uncertainty is inevitable in practice.In this study,a Monte Carlo algorithm was applied to estimate national crop residue by R/G taken from published reports in China.The estimated result was further mapped in pixels by geographic information system.In2009,the amount of crop residue was found to be 802.32 million tons(Mt),with 679.36 and 947.28 Mt as the lower and upper limits for 95%confidence limits.Chinese crop residue was dominated by rice,wheat,and corn,accounting for74.57%(598.29 Mt).From 1949 to 2009,the amount of crop residue increased by four times,accompanied by component change.The spatial distribution of crop residue in China is markedly heterogeneous.Compared to the shortage of crop residue in northwest China,there is an abundant crop residue of about 334 Mt in eastern China,attracting 90%of the country's electricity or heat generation plants.