考虑屈曲行为的钢筋力学性能数值仿真分析

为评估考虑结构中纵筋受压屈曲形态的力学性能,采用ABAQUS有限元软件对长径比(L/D)不同的纵向钢筋在轴向压缩和循环荷载下强度和刚度的变化情况进行数值仿真,同时考虑加载历史和加载方式对钢筋力学性能的影响。结果表明,屈曲对纵向钢筋力学性能影响比较显著,纵向钢筋压缩性能取决于L/D,与钢筋屈服强度无关;钢筋在循环荷载作用下其力学性能受到加载历史、塑性变形、累积损伤以及L/D的影响,拉伸超过屈服应变后将导致钢筋压缩强度的损失,塑性变形和循环加载共同导致了钢筋累积损伤,钢筋屈曲行为造成了受压时钢筋强度和刚度的退化,并且随着L/D的增加钢筋强度和刚度退化越显著。     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

太空环境下锂离子电池热失控与火灾的研究展望

综述了锂离子电池的热失控机理,介绍了由于电池内部电解液、电池隔膜和电极材料分解的链式热反应过程而引发的热失控和火灾现象。同时,讨论了锂离子电池在微重力太空环境中可能产生的烟黑浓度倍增,加速火蔓延,火焰喷射等极端火行为。进而探讨了开展锂离子电池的低压、落塔和抛物飞行等地面实验模拟太空微重力燃烧的方法可行性,建立数值模型预测太空微重力环境下锂离子电池热失控临界条件与火灾行为的必要性,以及如何通过基础研究科学地指导空间站电池热管理和消防系统的设计。     

全白土催化剂生产废水的处理

用4种无机絮凝剂和3种有机絮凝剂进行了脱除全白土催化剂生产废水（简称废水）中固体悬浮物（SS）的实验研究。实验结果表明：在废水pH6．8条件下,无机絮凝剂和有机絮凝剂脱除废水中SS的效果均较差,用无机絮凝剂时的SS去除率低于26％,用有机絮凝剂时的SS去除率低于18％;废水pH对SS去除率的影响较大,当调节废水pH为8．0时,无机絮凝剂中硫酸铝脱除废水中的SS效果最好,在硫酸铝加入量为0．02mg／L、沉降时间为2h的最佳操作条件下,SS的去除率可达93％。     

Effect of alginate on the aggregation kinetics of copper oxide nanoparticles (CuO NPs): bridging interaction and hetero-aggregation induced by Ca<Superscript>2+</Superscript>

The stability of CuO nanoparticles (NPs) is expected to play a key role in the environmental risk assessment of nanotoxicity in aquatic systems. In this study, the effect of alginate (model polysaccharides) on the stability of CuO NPs in various environmentally relevant ionic strength conditions was investigated by using time-resolved dynamic light scattering. Significant aggregation of CuO NPs was observed in the presence of both monovalent and divalent cations. The critical coagulation concentrations (CCC) were 54.5 and 2.9 mM for NaNO₃ and Ca(NO₃)₂, respectively. The presence of alginate slowed nano-CuO aggregation rates over the entire NaNO₃ concentration range due to the combined electrostatic and steric effect. High concentrations of Ca²⁺ (>6 mM) resulted in stronger adsorption of alginate onto CuO NPs; however, enhanced aggregation of CuO NPs occurred simultaneously under the same conditions. Spectroscopic analysis revealed that the bridging interaction of alginate with Ca²⁺ might be an important mechanism for the enhanced aggregation. Furthermore, significant coagulation of the alginate molecules was observed in solutions of high Ca²⁺ concentrations, indicating a hetero-aggregation mechanism between the alginate-covered CuO NPs and the unabsorbed alginate. These results suggested a different aggregation mechanism of NPs might co-exist in aqueous systems enriched with natural organic matter, which should be taken into consideration in future studies.

Open image in new window

Graphical abstract Hetero-aggregation mechanism of CuO nanoparticles and alginate under high concentration of Ca²⁺

     

3种运行模式下CAST工艺脱氮性能

以模拟城市污水为处理对象,采用循环式活性污泥法（CAST）反应器,对3种运行模式（M1：常规模式,M2：缺氧好氧模式、M3：缺氧好氧交替模式）下系统的脱氮性能进行了研究,比较了各模式下CAST反应器的氨氮和总氮的去除效率,并对各模式下典型周期内氮基质浓度变化进行了考察,以确定系统的脱氮模式。结果表明,在氨氮去除不成为限制条件（去除率〉90％）的条件下,3种运行模式下系统总氮的平均去除率分别为67．3％、70．6％和82．4％,以缺氧好氧交替模式下的最高;M1、M2和M3均可实现亚硝酸型硝化,但随着温度的升高,亚硝酸型硝化逐渐消失。静态实验分析表明,3种模式下系统的氨氧化速率大小次序为：vN：M1〉vN：M2〉vN：M3,反硝化速率大小次序为：vDN,M2〉vDN,M3〉vDN,M1。     

单级与二级BAF工艺除碳硝化效能的对比研究

在总曝气量、HRT、水温、进水水质相同的条件下,对比研究了单级(BAF C/N)和二级曝气生物液池(BAF C+N)处理生活污水的除碳硝化效能。结果表明,将除碳和硝化分级有利于提高BAF工艺的处理效能。分级后,C柱较C/N柱具有更高的COD去除容积负荷,且出水COD浓度稳定低于50 mg/L;二级BAF工艺出水NH4+-N浓度由单级BAF的5～12 mg/L降至5 mg/L以下,且N柱在pH<6.3时依然能够进行硝化;N柱中下部具有较高的微生物活性,平均比耗氧速率为32 mg O2/(g VAS·h)。二级BAF中C柱的反冲洗周期和强度与单级BAF相同,而N柱的反冲洗周期则延长至5～7 d,能够降低反冲洗能耗和用水量。     

常规运行模式下循环式活性污泥工艺除磷性能的研究

研究了常规运行模式下循环式活性污泥(CAST)工艺对磷酸盐的去除,考察了运行周期内反应器选择区和主反应区中磷酸盐、硝酸盐的浓度变化,并分析了CAST反应器的除磷途径和限制性因素,在此基础上测定了系统内反硝化聚磷菌所占的比例。研究表明,系统运行稳定后,出水磷酸盐的平均值为1.9mg/L,平均去除率约为62%;系统除磷是在聚磷菌和反硝化聚磷菌的共同作用下完成的,其中反硝化聚磷菌所占比例为81.1%。     

树脂固载纳米铁对偶氮染料直接湖蓝5B的脱色性能研究

以FeSO4和NaBH4水溶液为前驱溶剂,以聚苯乙烯型阳离子交换树脂为载体,制备了树脂固载的纳米铁,室温下用于对偶氮染料直接湖蓝5B水溶液进行脱色研究。研究结果发现,脱色反应遵循准一级反应动力学,在初始pH为3~10的范围内,反应进行14 m in时,50 mg/L的染料溶液脱色率均能达到83%以上。固载的纳米铁材料可多次重复利用,溶液中释放的铁离子浓度不超过0.1 mg/L。     

CPB改性沸石对磷酸盐的吸附-解吸性能研究

采用溴化十六烷基吡啶(CPB)对天然沸石进行改性,并考察了CPB改性沸石对磷酸盐的吸附-解吸性能。结果表明,CPB改性沸石对磷酸盐具备一定的吸附能力,且吸附行为满足Langmuir等温吸附模型;粒径、改性剂投加量、反应温度、pH值及共存阴离子等因素均会影响CPB改性沸石对磷酸盐的吸附能力;减小粒径和降低反应温度均有利于CPB改性沸石对磷酸盐的吸附去除;粒径≤0.18 mm CPB改性沸石吸附磷酸盐较优的改性剂投加量为250 mmol/kg;当溶液的初始pH值位于4~10之间时CPB改性沸石对磷酸盐的吸附能力随pH值的增加而增强;SO42-的存在会明显降低CPB改性沸石对磷酸盐的吸附效率,而提高溶液的pH值有助于消除SO42-存在对CPB改性沸石吸附磷酸盐的负面影响;HCO3-的存在会一定程度上抑制CPB改性沸石对磷酸盐的吸附去除,而提高溶液的pH值无法消除HCO3-存在对CPB改性沸石吸附磷酸盐的负面影响;CPB改性沸石吸附磷酸盐后一定条件下可以重新解吸出来,且随着解吸液SO42-浓度的增加解吸率明显增大。