This article describes and assesses the impact of oil spillage and oil well fires on Kuwait and its surroundings. The marine
ecology of the Arabian Gulf is shown to be relatively resistant to damage from oil spillage. The risks of the contamination
of thermal desalination plants by oil and oil products are assessed, and remedies are suggested. Air pollution from burning
oil wells is described and its consequences are predicted.
Editor’s note: Professor Hosny Khordagui worked as a research scientist at the Environmental and Earth Science Department of the Kuwait
Institute for Scientific Research. The Iraqi invasion of Kuwait on August 2, 1990, led to the permanent loss of most of his
data, research reports, and laboratory equipment, and Prof. Khordagui was constrained to live under the Iraqi occupation for
a few weeks. His article “A Conceptual Approach to the Selection of a Control Measure for Residual Chlorine Discharge in Kuwait
Bay” will appear in a forthcoming issue ofEnvironmental Management. 相似文献
The concentrations of total petroleum hydrocarbons (TPH) were determined in nearshore sediment samples collected from 28 sampling sites along the United Arab Emirates shorelines on the Arabian Gulf, the Gulf of Oman and seven major creeks (khors) extending from them. Concentrations were highly variable and ranged between <0.4 and 212 microg g(-1) dry weight, and the highest values obtained were in the top sediment (1 cm) layer near a fuel filling station and port areas. Locally high levels of TPH were found in Dubai, Sharjah and Ajman semi-enclosed creeks where boat activities and land-based wastewater discharges are most common. Data support the premise that port activities, fuel filling stations and land-based wastewater discharges are major sources of pollution in the study area. Correlations with sediment grain size, total organic carbon (TOC) and distance from pollution sources are discussed. 相似文献
Climate change issues are calling for advanced methods to produce materials and fuels in a carbon–neutral and circular way. For instance, biomass pyrolysis has been intensely investigated during the last years. Here we review the pyrolysis of algal and lignocellulosic biomass with focus on pyrolysis products and mechanisms, oil upgrading, combining pyrolysis and anaerobic digestion, economy, and life cycle assessment. Products include oil, gas, and biochar. Upgrading techniques comprise hot vapor filtration, solvent addition, emulsification, esterification and transesterification, hydrotreatment, steam reforming, and the use of supercritical fluids. We examined the economic viability in terms of profitability, internal rate of return, return on investment, carbon removal service, product pricing, and net present value. We also reviewed 20 recent studies of life cycle assessment. We found that the pyrolysis method highly influenced product yield, ranging from 9.07 to 40.59% for oil, from 10.1 to 41.25% for biochar, and from 11.93 to 28.16% for syngas. Feedstock type, pyrolytic temperature, heating rate, and reaction retention time were the main factors controlling the distribution of pyrolysis products. Pyrolysis mechanisms include bond breaking, cracking, polymerization and re-polymerization, and fragmentation. Biochar from residual forestry could sequester 2.74 tons of carbon dioxide equivalent per ton biochar when applied to the soil and has thus the potential to remove 0.2–2.75 gigatons of atmospheric carbon dioxide annually. The generation of biochar and bio-oil from the pyrolysis process is estimated to be economically feasible.
It is estimated that some 17 metric tons of residual oxidants (chlorine) are discharged into the enclosed coastal seawater
of Kuwait on a daily basis from power-desalination plants alone. Alarmed by the unlimited number of reported cases of damage
to marine aquatic systems due to chlorine discharge around the world, several alternatives were proposed to control such a
massive discharge of residual oxidant into seawaters. Most of the proposed alternatives lacked the basic criteria necessary
for their evaluation, justification, and then selection.
The objective of this article is to provide a conceptual approach that can be used to select a control measure for residual
oxidant discharge in Kuwait coastal seawaters. This approach is based on state-of-the-art knowledge and the unique operational
and environmental factors involved. A matrix system was designed whereby the cost of residual chlorine control alternative,
its effectiveness, and environmental and public health impact, performance, and reliability in Kuwait can be compared and
evaluated. The selection approach considered currently operating power plants in terms of their engineering design and material
(cast iron or steel condensers), current operational conditions, operator's perception, acceptability, and projected problems
associated with the environmental management of proposed modifications.
The proposed approach revealed that in Kuwait, conventinal chlorination was marginally superseded only by chlorination/dechlorination
using SO2 and operation alteration using process optimization. The overall cost-effective assessment matrix classified other alternatives
as worse than chlorination by various degrees.
Ozone and UV were found to be the worst and the least desirable alternatives for biofouling control of seawater in Kuwait.
In light of the available information on the consequences of the Gulf War on the marine environment, and the potential formation
of additional halogenated organic compounds through the reaction of residual chlorine with the released petroleum hydrocarbons,
it is essential to control residual chlorine discharged into the nearshore environment of Kuwait. 相似文献
Access to drinkable water is becoming more and more challenging due to worldwide pollution and the cost of water treatments. Water and wastewater treatment by adsorption on solid materials is usually cheap and effective in removing contaminants, yet classical adsorbents are not sustainable because they are derived from fossil fuels, and they can induce secondary pollution. Therefore, biological sorbents made of modern biomass are increasingly studied as promising alternatives. Indeed, such biosorbents utilize biological waste that would otherwise pollute water systems, and they promote the circular economy. Here we review biosorbents, magnetic sorbents, and other cost-effective sorbents with emphasis on preparation methods, adsorbents types, adsorption mechanisms, and regeneration of spent adsorbents. Biosorbents are prepared from a wide range of materials, including wood, bacteria, algae, herbaceous materials, agricultural waste, and animal waste. Commonly removed contaminants comprise dyes, heavy metals, radionuclides, pharmaceuticals, and personal care products. Preparation methods include coprecipitation, thermal decomposition, microwave irradiation, chemical reduction, micro-emulsion, and arc discharge. Adsorbents can be classified into activated carbon, biochar, lignocellulosic waste, clays, zeolites, peat, and humic soils. We detail adsorption isotherms and kinetics. Regeneration methods comprise thermal and chemical regeneration and supercritical fluid desorption. We also discuss exhausted adsorbent management and disposal. We found that agro-waste biosorbents can remove up to 68–100% of dyes, while wooden, herbaceous, bacterial, and marine-based biosorbents can remove up to 55–99% of heavy metals. Animal waste-based biosorbents can remove 1–99% of heavy metals. The average removal efficiency of modified biosorbents is around 90–95%, but some treatments, such as cross-linked beads, may negatively affect their efficiency.
This article provides an objective integrated environmental impact assessment of the Gulf War consequences. The environmental
damage was evaluated and found to be significantly exaggerated by the media and speculators. The total amount of burned crude
oil was calculated to be 52.5 million metric tons. Most air pollution field measurements were comparable to those found in
Western cities. The health impact associated with such exposure was found to be minimal. The total amount of oil released
into the marine environment ranged between 2 and 4 million barrels, much less than the early estimation of 12–14 million barrels.
The marine environment is expected to recover much faster than earlier anticipations. Unlike water and air, soil pollution
is likely to persist for some years to come. 相似文献
Microplastic pollution is becoming a major issue for human health due to the recent discovery of microplastics in most ecosystems. Here, we review the sources, formation, occurrence, toxicity and remediation methods of microplastics. We distinguish ocean-based and land-based sources of microplastics. Microplastics have been found in biological samples such as faeces, sputum, saliva, blood and placenta. Cancer, intestinal, pulmonary, cardiovascular, infectious and inflammatory diseases are induced or mediated by microplastics. Microplastic exposure during pregnancy and maternal period is also discussed. Remediation methods include coagulation, membrane bioreactors, sand filtration, adsorption, photocatalytic degradation, electrocoagulation and magnetic separation. Control strategies comprise reducing plastic usage, behavioural change, and using biodegradable plastics. Global plastic production has risen dramatically over the past 70 years to reach 359 million tonnes. China is the world's top producer, contributing 17.5% to global production, while Turkey generates the most plastic waste in the Mediterranean region, at 144 tonnes per day. Microplastics comprise 75% of marine waste, with land-based sources responsible for 80–90% of pollution, while ocean-based sources account for only 10–20%. Microplastics induce toxic effects on humans and animals, such as cytotoxicity, immune response, oxidative stress, barrier attributes, and genotoxicity, even at minimal dosages of 10 μg/mL. Ingestion of microplastics by marine animals results in alterations in gastrointestinal tract physiology, immune system depression, oxidative stress, cytotoxicity, differential gene expression, and growth inhibition. Furthermore, bioaccumulation of microplastics in the tissues of aquatic organisms can have adverse effects on the aquatic ecosystem, with potential transmission of microplastics to humans and birds. Changing individual behaviours and governmental actions, such as implementing bans, taxes, or pricing on plastic carrier bags, has significantly reduced plastic consumption to 8–85% in various countries worldwide. The microplastic minimisation approach follows an upside-down pyramid, starting with prevention, followed by reducing, reusing, recycling, recovering, and ending with disposal as the least preferable option.
The increasing production and use of plastic in the Arabian Gulf combined with shipping and waste disposal practices, have increased the concentration of plastic particles on the sea's surface and beaches. The objective of this investigation was to provide an assessment of the abundance, distribution, potential sources and significance of industrial plastic on the western beaches of the United Arab Emirates on the Arabian Gulf and on the eastern beaches on the Gulf of Oman. The abundance of stranded plastic pellets was highly uneven. By early 1992 alarming levels of fresh plastic pellets were noticed on the Arabian Gulf beaches of the UAE. Large numbers of 25 kg sacks of white plastic spherules manufactured by (SABIC) in Jubail, Saudi Arabia were washed ashore. When compared to the west coast on the Arabian Gulf, the east coast on the Gulf of Oman exhibited much lower levels of plastic pellets. When compared to other parts of the world, the beaches of the UAE on the Arabian Gulf are considered to be heavily polluted with industrial plastic. 相似文献