排序方式: 共有35条查询结果,搜索用时 15 毫秒
1.
Runzhi Gong Tim C. Keener 《Journal of the Air & Waste Management Association (1995)》2013,63(6):864-872
The effects of water vapor on binary vapor adsorption of toluene and methylene chloride by activated carbon were investigated on a bench-scale experimental system. Three levels of relative humidity (15, 65 and 90 percent) in conjunction with different concentrations of individual adsorbates (from 400 to 1200 ppmv) were tested by tracing the breakthrough curves of each adsorbate eluted from a fixed-bed adsorber. The adsorption capacities of the activated carbon tested for each adsorbate under the various conditions were obtained from calculations based on area integration of the breakthrough curves. It was found that with increasing relative humidity, the shape of breakthrough curves was asymmetrically distorted and the width of the breakthrough curves was broadened for toluene and steepened for methylene chloride. The adsorption capacities for both toluene and methylene chloride were decreased with the increase of relative humidity. The magnitude of the effect of water vapor is greater at the lower toluene concentration and at the higher concentration of methylene chloride. The mechanisms of water vapor influence on the process of multicomponent vapor adsorption are discussed. 相似文献
2.
3.
An entrained-flow system has been designed and constructed to simulate in-flight mercury capture by sorbents in ducts of coal-fired
utility plants. The test conditions of 1.5 s residence time, 140°C temperature, 4.5 ppbv inlet Hg0 concentration, and 0–20 lb/MMacf sorbent injection rates were chosen to simulate conditions in the ducts. Novel oxidants
developed in previous fixed-bed tests and novel sorbents derived from the novel oxidants were tested for their Hg0 capture in the entrained-flow system to examine the possibility of using those sorbents in a full-scale system. Darco-FGD
and Darco Hg-LH served as benchmark sorbents with which mercury control capability of the novel oxidants and novel sorbents
could be compared. The test results showed that the novel oxidants have remarkable Hg0 oxidation capability, and the novel sorbents showed a better performance in Hg0 removal than Darco Hg-LH. 相似文献
4.
Soil loss rates from construction sites can be 1000 times the average of natural soil erosion rates and 20 times that from agricultural lands. Silt fence (SF) is the current industry standard used to control sediment originating from construction activities. Silt fences are designed to act as miniature detention ponds. Research has indicated that SF sediment filtering efficiency is related to its ability to detain and pond water, not necessarily the filtration ability of the fabric. Design capacity and spacing is based on flow-through rate and design height. In addition, increased detention of runoff and pressure from ponding may increase the likelihood of overtopping or failure of SF in field application. Testing was conducted on compost silt socks (SS) and SF to determine sediment filtering efficiency, flow-through rate, ponding depth, overtopping point, design height, and design capacity. Results indicate flow-through rate changes with time, as does ponding depth, due to the accumulation of solids on/in the sediment filters. Changes in depth with time were a linear function of flow rate after 10 min of flow, up to the time the sediment filter is overtopped. Predicting the capacity of SF and SS to handle runoff without the filter being overtopped requires consideration of both runoff rate and length of runoff time. Data show SS half the heights of SF were less likely to overtop than SF when sediment-laden runoff water flow rates are less than 1.03 L(-1) s(-1) m(-1) (5 gpm/ft, gal per minute per lineal foot). Ponded depth behind a 61.0-cm (24 in) SF increased more rapidly than behind a 30.5-cm diam. (12 in) SS, and at the end of the thirty minutes, the depth behind the SF was 75% greater than that behind the SS. Removal of solids by the SF and the SS were not shown to be statistically different. Results were used to create a Microsoft Excel-based interactive design tool to assist engineers and erosion and sediment control planners on how to specify compost SS relative to SF in perimeter sediment control applications. 相似文献
5.
Torres-Jardón R Keener TC 《Journal of the Air & Waste Management Association (1995)》2006,56(3):322-333
Ambient concentrations of ozone (O3), nitrogen oxides (NOx), total reactive nitrogen (NOy), nitric acid (HNO3), and hydrogen peroxide (H2O2) were measured during September 2003 at an urban site of Cincinnati, OH. The aim of this study was two-fold: to investigate whether O3 formation in this population exposure-type site is NOx, sensitive or volatile organic compound (VOC) sensitive and to test the practicality of using two combined observational-based methods to identify the sensitivity of O3 formation in midlevel polluted locations. The evaluation of the indicator species: NOy, O3/NOy, O3/HNO3, H2O2/ HNO3, and O3/(estimated NOx reaction products), as well as the combined hypothesis testing analysis of the weekend/weekday (WE/WD) differences of 1-hr and 8-hr average maximum O3 and of the 6:00 a.m.-9:00 a.m. average nitric oxide and NOx concentrations, show evidence that Cincinnati is likely VOC sensitive. Average WE 1-hr and 8-hr maximum O3, as well as duration of WE O3 accumulation, were not lower than the corresponding WD levels in spite of the observed significant reduction in NO, emissions on WE, a typical situation in VOC-sensitive locations. The possibility that the seasonal transition from summer to autumn could have influenced the results was also investigated through an exploratory analysis of the afternoon O3 maximum/NOx measured and of the WE/WD differences of peak O3 and morning average NO and NO, concentrations observed at this site from June through September 2003. The results suggest that a VOC-sensitive chemistry regime dominated along the summer season. The findings of this study suggest that additional reductions in regional NO, emissions in Cincinnati, a potential nonattainment area under the 8-hr O3 standard, may cause an increase in local O3. Future strategies to reduce O3 in Southwest Ohio should be further evaluated carefully. The combination of observational-based methods might provide a consistent complementary approach in the identification of the NO,-VOC sensitive characteristics of mid-to-moderate polluted urban areas. 相似文献
6.
The Kyoto Protocol calls for greenhouse gas emission reductions which could affect the use of coal for producing electricity. Carbon credits are being explored as a method for countries to meet their reduction commitments. Carbon dioxide removal in flue gas desulfurization (FGD) systems should be considered if and when the concept of carbon credits are implemented. This paper addresses the factors affecting sulfur dioxide removal, including the reaction of carbon dioxide, occurring during convective pass sorbent injection with high temperature filtration for a typical coal-fired power plant. Significant carbonation is found to occur, and the levels are found to depend on injection/filtration temperatures and the residence time on the filter. Ca/S stoichiometry during sorbent injection is found to affect not only the sorbent conversions in the convective pass sorbent injection stage but also the final sorbent conversions in the filtration stage. Even though high sorbent carbonation hinders the sorbent utilization for SO2 removal, slight alterations in CO2 concentration are found to have no significant effects on the SO2 removal of the process. 相似文献
7.
Saiyasitpanich P Lu M Keener TC Liang F Khang SJ 《Journal of the Air & Waste Management Association (1995)》2005,55(7):993-998
The effect of sulfur content on diesel particulate matter (DPM) emissions was studied using a diesel generator (Generac Model SD080, rated at 80 kW) as the emission source to simulate nonroad diesel emissions. A load simulator was used to apply loads to the generator at 0, 25, 50, and 75 kW, respectively. Three diesel fuels containing 500, 2100, and 3700 ppm sulfur by weight were selected as generator fuels. The U.S. Environmental Protection Agency sampling Method 5 "Determination of Particulate Matter Emissions from Stationary Sources" together with Method 1A "Sample and Velocity Traverses for Stationary Sources with Small Stacks or Ducts" was adopted as a reference method for measurement of the exhaust gas flow rate and DPM mass concentration. The effects of various parameters on DPM concentration have been studied, such as fuel sulfur contents, engine loads, and fuel usage rates. The increase of average DPM concentrations from 3.9 mg/Nm3 (n cubic meter) at 0 kW to 36.8 mg/Nm3 at 75 kW is strongly correlated with the increase of applied loads and sulfur content in the diesel fuel, whereas the fuel consumption rates are only a function of applied loads. An empirical correlation for estimating DPM concentration is obtained when fuel sulfur content and engine loads are known for these types of generators: Y = Zm(alphaX + beta), where Y is the DPM concentration, mg/m3, Z is the fuel sulfur content, ppm(w) (limited to 500-3700 ppm(w)), X is the applied load, kW, m is the constant, 0.407, alpha and beta are the numerical coefficients, 0.0118 +/- 0.0028 (95% confidence interval) and 0.4535 +/- 0.1288 (95% confidence interval), respectively. 相似文献
8.
Arijit Pakrasi Wayne T. Davis Gregory D. Reed Timothy C. Keener 《Journal of the Air & Waste Management Association (1995)》2013,63(7):987-992
The removal of SO2 with atomization of a slaked lime slurry and supplemental injection of gaseous NH3 were tested in a conventional spray dryer/baghouse system for SO2 concentrations of 2000 ppm and 3000 ppm and a 30° F approach to saturation. Results at 3000 ppm of SO2 showed an average SO2 removal efficiency of 90.3 percent at a combined stoichiometric ratio of 0.95-1.10 and an average overall sorbent utilization of 91.6 percent. The overall molal ratio of NH3/SO2 reaction was found to be 2:1 under the test conditions Particle size analyses, and EP toxicity tests were conducted on the products of the reactions. 相似文献
9.
Wild rodents were collected using live snap traps in pistachio gardens of Kerman Province, Southeast Iran from 2007 to 2009, then some physiological parameters of them were measured. The samples were identified as follow: Nesokia indica, Meriones persicus, Meriones lybicus and Tatera indica. Blood samples were obtained from the heart, then the blood parameters (glucose, cholesterol, triglyceride, total protein, HDL, red and white blood cell number) in wild species of rodents and laboratory rat were compared. The results showed that there were no significant differences in serum glucose, triglyceride, HDL and total protein levels among different experimental groups. The concentration of cholesterol in T. indica was more than that in N. indica (P < 0.01). The total numbers of red blood cells also showed significant difference between wild garden rodent species and laboratory rat (P < 0.01), while the numbers of white blood cells showed no significant difference. 相似文献
10.
Unapumnuk K Keener TC Lu M Khang SJ 《Journal of the Air & Waste Management Association (1995)》2006,56(5):618-627
Pyrolytic product distribution rates and pyrolysis behavior of tire-derived fuels (TDF) were investigated using thermogravimetric analyzer (TGA) techniques. A TGA was designed and built to investigate the behavior and products of pyrolysis of typical TDF specimens. The fundamental knowledge of TGA analysis and principal fuel analysis are applied in this study. Thermogravimetry of the degradation temperature of the TDF confirms the overall decomposition rate of the volatile products during the depolymerization reaction. The principal fuel analysis (proximate and ultimate analysis) of the pyrolytic char products show the correlation of volatilization into the gas and liquid phases and the existence of fixed carbon and other compounds that remain as a solid char. The kinetic parameters were calculated using least square with minimizing sum of error square technique. The results show that the average kinetic parameters of TDF are the activation energy, E = 1322 +/- 244 kJ/mol, a pre-exponential constant of A = 2.06 +/- 3.47 x 10(10) min(-1), and a reaction order n = 1.62 +/- 0.31. The model-predicted rate equations agree with the experimental data. The overall TDF weight conversion represents the carbon weight conversion in the sample. 相似文献