Laboratory and field evaluation of crystallized DOW 704 oil on the performance of the Well Impactor Ninety-Six fFine particulate matter fractionator

Subsequent to the 1997 promulgation of the Federal Reference Method (FRM) for monitoring fine particulate matter (PM2.5) in ambient air, U.S. Environmental Protection Agency (EPA) received reports that the DOW 704 diffusion oil used in the method's Well Impactor Ninety-Six (WINS) fractionator would occasionally crystallize during field use, particularly under wintertime conditions. Although the frequency of occurrence on a nationwide basis was low, uncertainties existed as to whether crystallization of the DOW 704 oil may adversely affect a sampling event's data quality. In response to these concerns, EPA and the State of Connecticut Department of Environmental Protection jointly conducted a series of specialized tests to determine whether crystallized oil adversely affected the performance of the WINS fractionator. In the laboratory, an experimental setup used dry ice to artificially induce crystallization of the diffusion oil under controlled conditions. Using primary polystyrene latex calibration aerosols, standard size-selective performance tests of the WINS fractionator showed that neither the position nor the shape of the WINS particle size fractionation curve was substantially influenced by the crystallization of the DOW 704 oil. No large particle bounce from the crystallized impaction surface was observed. During wintertime field tests, crystallization of the DOW 704 oil did not adversely affect measured PM2.5 concentrations. Regression of measurements with crystallized DOW 704 versus liquid dioctyl sebacate (DOS) oil produced slope, intercept, and R2 values of 0.98, 0.1, and 0.997 microg/m3, respectively. Additional field tests validated the use of DOS as an effective impaction substrate. As a result of these laboratory and field tests, DOS oil has been approved by EPA as a substitute for DOW 704 oil. Since the field deployment of DOS oil in 2001, users of this alternative oil have not reported any operational problems associated with its use in the PM2.5 FRM. Limited field evaluation of the BGI very sharp cut cyclone indicates that it provides a viable alternative to the WINS fractionator.     

1987 Joint EPRI/EPA Symposium on Stationary Combustion NOX Control

From March 23rd to 26th, 1987, the city of New Orleans hosted 350 attendees, including representatives from 15 foreign countries, at the 1987 Joint Symposium on Stationary Combustion NO_x Control. Cosponsored by the Electric Power Research Institute (EPRI) and the U.S. Environmental Protection Agency (EPA), the symposium provided attendees the opportunity to hear 49 papers in nine sessions covering technological and regulatory developments on NO_x control in the United States and abroad since the May 1985 symposium in Boston. Session topics included general environmental issues, low-NO_x combustion equipment (i.e., low-NO_x burners, reburning, etc.), flue gas treatment, fundamental combustion research, and special issues for cyclone coal-fueled boilers, oil- and gas-fired boilers, and industrial combustion applications.

Advances to the state-of-the-art presented at this symposium include: improved and/or newly applied combustion modifications for pulverized coal-fired boilers; further analyses of reburning, the leading combustion modification option for cyclone-equipped boilers; initial experiences with catalytic flue gas treatment in Europe; studies of NO_x control retrofit options for oil- and gas-fired utility systems; and new technology developments for coal, oil, and gas fueled utility and industrial combustors.

This paper summarizes those presentations that discussed significant changes since May 1985 in areas of potential interest to EPRI and its utility members. Where appropriate, they include our perspectives on the applicability of these newly disclosed findings to utility systems.     

Assessment of Dry Sorbenf Emission Control Technologies Part II. Applications

The injection of dry alkaline compounds into the furnace or post-furnace regions of utility boilers to reduce SO₂ is currently under development as a lower cost option to conventional flue gas desulfurization technology. Part I of this paper focused on the science and process development of the various dry sorbent technologies. Part II will address applications of these technologies, including SO₂ removals in full-scale boilers, methodologies for designing sorbent injection systems, power plant impacts, process integration issues, and cost.

Because the dry technologies use the furnace and/or ducts as the chemical contactor, potential impacts on power plant operation and reliability are as critical in assessing the commercial applicability of each technology as SO₂ removal and sorbent utilization. Consequently, the technical and economic feasibility of the various dry processes is highly site specific.     

The use of zero‐valent iron injection to remediate groundwater: Results of a pilot test at the Marshall Space Flight Center

In situ treatability studies are being conducted to evaluate various in situ technologies to manage groundwater contamination at the NASA Marshall Space Flight Center in Huntsville, Alabama. The focus of these studies is to evaluate remediation options for contaminated (mostly aerobic) groundwater occurring within the basal portion of a clayey residuum called the rubble zone. The tension‐saturated media and unsaturated media lying above the rubble zone are also being treated where they make up a significant component of the contaminant mass. An in situ chemical reduction field pilot test was implemented (following bench‐scale tests) during July and August 2000. The test involved the injection of zero‐valent iron powder in slurry form, using the Ferox^SM process patented by ARS Technologies, Inc. The pilot test focused on trichloroethene (TCE)‐contaminated groundwater within the rubble zone. Maximum pre‐injection concentrations of about 72,800 micrograms per liter (μg/l) were observed and no secondary sources are believed to exist beneath the area. The potential presence of unexploded ordnance forced an implementation strategy where source area injections were completed, as feasible, followed by overlapping injections in a down gradient alignment to create a permeable reactive zone for groundwater migration. Eight post‐injection rounds of groundwater performance monitoring were completed. The results are encouraging, in terms of predicted responses and decreasing trends in contaminant levels. © 2003 Wiley Periodicals, Inc.     

HYDROLOGIC CONSIDERATIONS OF THE UPPER ST. JOHNS RIVER BASIN,FLORIDA1

ABSTRACT: Since the early 1900's the Upper St. Johns River Basin, Florida, has been experiencing rapid agricultural development, through reclamation of the low-lying marshland by organized drainage districts, private land owners and corporations. These low-lying marsh areas, which constitute the floodplain, have been altered by the creation of levees, thereby reducing the natural storage capacity and permanently altering the regime of the system. This floodplain encroachment has resulted in both higher and lower water levels occurring in the upper basin area, and an increase in hydroperiod. This paper discusses the history and background of the basin accompanied by a hydrologic discussion, and suggests recommendations for a water management plan that could improve the overall operation and management of the Upper St. Johns River basin.     

PCB congener distributions in muscle,liver and gonad of Fundulus heteroclitus from the lower Hudson River Estuary and Newark Bay

Gradients in sediment polychlorinated biphenyl (PCB) concentrations and PCB congener profiles exist along the Hudson River (NY, USA). We evaluated site and tissue differences in PCB concentration and congener profiles in resident mummichog (Fundulus heteroclitus) collected from PCB-contaminated sites in the lower Hudson River and the New York/New Jersey Harbor Estuary. Fish were collected from three PCB-contaminated sites Piermont Marsh (P), Iona Marsh (I), and Newark Bay (NB), and from two reference sites (Flax Pond, NY; Succotash Salt Marsh, RI). Congener profiles were statistically analyzed using principal component analysis (PCA) and general linear model (GLM) profile analysis. Contaminated fish had PCB tissue concentrations approximately 10-fold higher than those of reference fish. There were no site differences in PCB body burden (all tissues combined) among the contaminated site fish. However, relative PCB concentration did differ between organs: NB fish (gonad=liver>muscle); I and P fish (gonad>liver>muscle). In contrast to PCB content, PCB congener profiles did show site differences; NB mummichog being depleted in the less chlorinated congeners relative to I and P fish, likely reflecting different PCB sources to these populations. Within a site, however, PCB congener patterns were similar between liver, gonad and muscle. In conclusion, PCA and GLM analyses gave complementary results, both analyses indicating differences in site, but not tissue, distributions of PCB congeners. This study also demonstrates that unlike congener profiles, total PCB content does differ dramatically amongst tissues and further, that PCB differences among tissues (gonad vs. liver vs. muscle) can vary with site.     

Climate of the earth: an overview

Climate has varied over a large range in the recent history of the Earth, with extremes represented by equable environments of the Cretaceous and Eocene and the comparatively frigid conditions of the ice ages that punctuated the past few million years. It is suggested that major shifts in climate are controlled largely by variations in CO(2) with related fluctuations in modes of ocean circulation. Changes in climate can proceed rapidly, on time scales as short as centuries or even decades, as indicated by data for the Younger Dryas (a period of globally cold conditions interrupting recovery of the Earth from the last ice age) and the Little Ice Age (a cold snap extending from about 1250 to about 1850 ad). Rapid fluctuations in climate appear to be linked to changes in production of deep water in the North Atlantic, possibly also to variations in circulation of intermediate waters in the Pacific. Mechanisms are discussed whereby changes in ocean circulation can result in shifts of climate on a global scale. A 10 000 year record of climate from Norway is used to provide context for a discussion of possible changes in climate today arising as a result of the build-up of industrially related greenhouse gases. Brief, somewhat pessimistic, comments are offered concerning the prospects for meaningful near-term predictions of the response of climate to increased concentrations of greenhouse gases. Studies of past climates, by drawing attention to important processes and feedbacks, can play a valuable role in the development of credible models for the future.     

Methodology for designing air quality monitoring networks: II. Application to Las Vegas,Nevada, for carbon monoxide

An objective methodology presented in a companion paper (Liu et al., 1986) for determining the optimum number and disposition of ambient air quality stations in a monitoring network for carbon monoxide is applied to the Las Vegas, Nevada, area. The methodology utilizes an air quality simulation model to produce temporally-varying air quality patterns for each of a limited number of meteorological scenarios representative of the region of interest. These air quality patterns in turn serve as the data base in a two-step procedure for the identification and ranking of the most desirable monitoring locations (step 1) and the removal of redundancies in spatial coverage among the desired locations (step 2.)The performance of the air quality simulation model, a key element in the design methodology, was evaluated in the Las Vegas area in a special field measurement program. In the Las Vegas demonstration for carbon monoxide, 19 stations covering concentration maxima and 3 stations covering background concentrations in rural areas were identified and ranked. A 10-station network, for example, consisting of 7 stations for peak average concentrations and 3 stations for background concentrations, was selected for a desired minimum detection capability of 50% of concentration variations. Networks with fewer stations would be selected if smaller minimum detection capabilities of concentration variations are acceptable, and vice versa. Background stations could, of course, be deleted for networks with the sole purpose of discerning peak concentrations.Although the research described in this article has been funded wholly or in part by the United States Environmental Protection Agency through Contract No. 68-03-2446 to Systems Application, Inc., it has not been subjected to Agency review and therefore does not necessarily reflect the views of the Agency and no official endorsement should be inferred.     

Methodology for designing air quality monitoring networks: I. Theoretical aspects

An objective methodology is presented for determining the number and disposition of ambient air quality stations in a monitoring network for the primary purpose of compliance with air quality standards. The methodolgy utilizes a data base with real or simulated data from an air quality dispersion model for application with a two-step process for ascertaining the optimal monitoring network. In the first step, the air quality patterns in the data base are collapsed into a single composite pattern through a figure-of-merit (FOM) concept. The most desirable locations are ranked and identified using the resultant FOM fields. In the second step the network configuration is determined on the basis of the concept of spheres of influence (SOI) developed from cutoff values of spatial correlation coefficients between potential monitoring sites and adjacent locations. The minimum number of required stations is then determined by deletion of lower-ranked stations whose SOIs overlap. The criteria can be set to provide coverage of less than some fixed, user-provided percentage of the coverage of tha SOIs of the higher ranked stations and for some desired level of minimum detection capability of concentration fluctuations.The methodology is applied in a companion paper (McElroy et al., 1986) to the Las Vegas, Nevada, metropolitan area for the pollutant carbon monoxide.Although the research described in this article has been funded wholly or in part by the United States Environmental Protection Agency through Contract No. 68-03-2446 to Systems Applications, Inc., it has not been subjected to Agency review and therefore does not necessarily reflect the views of the Agency and no official endorsement should be inferred.