三峡库区中低产土壤重金属含量及其与小麦吸收的关系

三峡库区中低产土壤的Hg,As,Cr,Pb,Cu五个重金属含量（除渝北区外），均在国家土壤环境质量标准内，属自然背景值一级标准。Cd和Zn高于全国土壤中的平均含量和背景值含量，属二级标准。土壤的重金属含量与土壤母质类型，pH值，阳离子交换量，有机质，无定形铁和物理性粘粒有关，同时存在一定的地域分布。重庆近郊的土壤所有重金属含量相对较高。土壤重金属的可给态或有效性含量极低，锌和铜不是过量，而是不足。小麦籽粒中As,Cr,Pb,Zn,Cu含量低于国家食品对重金属限量标准和小麦籽粒背景值标准，Hg,Cd含量高于国家规定标准。籽粒中的Cu,Zn含量是小麦茎叶中的2.0-2.2倍，而茎叶中的Hg,Pb,As,Cr,Cd含量明显高于籽粒。     

Exploration of Science Parks

1 DEVELOPMENT OF SCIENCE PARKSThe concept of science park originated in the US. Manyterms are used to describe science parks, such as researchpark, technology park, science centre, research centre,innovation centre, and with various combination of these(MacDonald, 1987). The first science park in the worldis Stanford Industrial Park established in 1951. In 1955,only seven companies were located in the park. By 1980there were ninety companies including Hewlett PackardCompany, whic…     

有机废物厌氧发酵生物合成己酸研究进展

厌氧发酵处理有机废物并合成高价值羧酸盐的技术日趋成熟。尤其是己酸作为产物之一,因其附加值高,易于分离,用途广泛,越来越受到关注。微生物合成己酸需要电子供体及受体。详细介绍了乙醇、乙酸分别作为电子供体、受体合成己酸的机理——逆β氧化反应,总结合成己酸底物以及影响合成的因素（温度、pH值、水力停留时间、竞争路径、氢气分压、底物比例、氮源等）。目前采用科氏梭菌以乙醇为电子供体来合成己酸的技术较成熟,探索了利用乳酸为电子供体合成己酸的代谢机理,并指出开发乳酸转化合成己酸的技术可成为未来发展方向。     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

Ozone pollution characteristics and sensitivity analysis using an observation-based model in Nanjing, Yangtze River Delta Region of China

Ground-level ozone (O₃) has become a critical pollutant impeding air quality improvement in Yangtze River Delta region of China. In this study, we present O₃ pollution characteristics based on one-year online measurements during 2016 at an urban site in Nanjing, Jiangsu Province. Then, the sensitivity of O₃ to its precursors during 2 O₃ pollution episodes in August was analyzed using a box model based on observation (OBM). The relative incremental reactivity (RIR) of hydrocarbons was larger than other precursors, suggesting that hydrocarbons played the dominant role in O₃ formation. The RIR values for NO_X ranged from –0.41%/% to 0.19%/%. The O₃ sensitivity was also analyzed based on relationship of simulated O₃ production rates with reductions of VOC and NO_X derived from scenario analyses. Simulation results illustrate that O₃ formation was between VOCs-limited and transition regime. Xylenes and light alkenes were found to be key species in O₃ formation according to RIR values, and their sources were determined using the Positive Matrix Factorization (PMF) model. Paints and solvent use was the largest contributor to xylenes (54%), while petrochemical industry was the most important source to propene (82%). Discussions on VOCs and NO_X reduction schemes suggest that the 5% O₃ control goal can be achieved by reducing VOCs by 20%. To obtain 10% O₃ control goal, VOCs need to be reduced by 30% with VOCs/NO_X larger than 3:1.     

Coupling mechanism of activated carbon mixed with dust for flue gas desulfurization and denitrification

To clarify the effect of coking dust, sintering dust and fly ash on the activity of activated carbon for various industrial flue gas desulfurization and denitrification, the coupling mechanism of the mixed activated carbon and dust was investigated to provide theoretical reference for the stable operation. The results show that coking dust had 34% desulfurization efficiency and 10% denitrification efficiency; correspondingly, sintering dust and fly ash had no obvious desulfurization and denitrification activities. For the mixture of activated carbon and dust, the coking dust reduced the desulfurization and denitrification efficiencies by blocking the pores of activated carbon, and its inhibiting effect on activated carbon was larger than its own desulfurization and denitrification activity. The sintering dust also reduced the desulfurization efficiency on the activated carbon while enhancing the denitrification efficiency. Fly ash blocked the pores of activated carbon and reduced its reaction activity. The reaction activity of coking dust mainly came from the surface functional groups, similar to that of activated carbon. The reaction activity of sintering dust mainly came from the oxidative property of Fe₂O₃, which oxidized NO to NO₂ and promoted the fast selectively catalytic reduction (SCR) of NO to form N₂. Sintering dust was activated by the joint action of activated carbon, and both had a coupling function. Sintering dust enhanced the adsorption and oxidation of NO, and activated carbon further promoted the reduction of NO_x by NH₃; thus, the denitrification efficiency increased by 5%-7% on the activated carbon.     

洱海北部入湖河流水质特征及其对北部湖区的影响

基于2016—2018年罗时江、弥苴河、永安江及洱海北部湖区监测数据分析,探讨洱海北部入湖河流污染变化特征及对北部湖区的影响。结果表明:1）"北三江"监测断面总磷、COD、氨氮浓度整体稳定在GB 3838—2002《地表水环境质量标准》Ⅱ—Ⅲ类标准限值内,年内污染物浓度变化表现出典型的农业面源污染特征,且受流域内产业模式等的综合影响;2）研究期间,河流首要污染物为TN,旱季次要污染物为COD,雨季为TP。雨季入湖负荷高于旱季,弥苴河污染负荷大于罗时江、永安江。"北三江"入湖TN和TP污染负荷分别占洱海允许负荷的50.1%和59.7%;3）入湖河流的磷元素输入是洱海北部湖区磷污染的重要来源。北部湖区污染物浓度对氮、磷入湖污染负荷相关性次月强于当月,响应存在延迟。筛选环境友好型种植模式,控制"北三江"氮磷入湖负荷,有利于保护洱海水环境。     

大气压纳秒负脉冲放电对水中大肠杆菌的灭活

采用自行研制的喷嘴-板-筒式反应器,研究了大气压纳秒负脉冲空气放电对水中大肠杆菌（Escherichia coli, E.coli）灭菌率的影响因素及规律。实验中空气自放电喷嘴电极进入反应器,气流带动放电生成的活性粒子流到达并作用于水中大肠杆菌。研究结果表明:本实验装置可有效实现对水中大肠杆菌的灭活,灭菌率随着放电电压和脉冲重复频率的增加、放电处理时间的延长而升高;随着鼓气速率的增大先增大后减小;随着喷嘴电极直径的增加先减小后增大。当采用1.30 mm喷嘴电极,在脉冲峰值电压为-32 kV、重复频率80 Hz,鼓气速率为80 mL/min时,连续放电处理12 min,灭菌率达到91%。     

圆红冬孢酵母利用生物柴油副产物粗甘油产油脂的影响因素分析

以餐饮废油制备生物柴油的副产物粗甘油为碳源,采用圆红冬孢酵母发酵生产微生物油脂。通过对发酵影响因素的优化,确定了最适发酵条件为:种子复苏时长24 h、富集时长10 h、接种量为6%、初始粗甘油浓度为60 g/L、C/N为60、有机氮占总氮比例为75%、发酵体积为100 mL、发酵温度为30 ℃、发酵时间为6 d,在此条件下,获得总产油量为10.56 g/L,油脂产率为0.229。与无机氮源硫酸铵相比,有机氮源蛋白胨的添加显著提高了油脂含量和总产油量。通过测定油脂的脂肪酸成分并利用Hoekman方程估算所得生物柴油的性能指标,表明其符合中国、美国及欧盟标准。该方法既为粗甘油的再利用提供了一条新途径,又为生物柴油的生产提供了廉价的原材料。