Water vapor permeability of biodegradable polymers

The water vapor transmission rates (WVTR) of several biodegradable polymers were evaluated to determine their suitability as water-resistant coatings and to understand WVTR better in terms of polymer structure. Values of WVTR at 25‡C ranged from 13 to 2900 g/m² /day and increased in the order PHBV PLA (cryst.) PLA (amorph.) PCL Bionolle BAK 1095 CAP CA. Values of WVTR were positively correlated with higher polymer solubility parameters, lower crystallinities, and higher free volumes. Although the WVTR of biodegradable polymers are much higher than those of good barrier materials such as low-density polyethylene, they are sufficient for short-term (hours to days) protection of polysaccharide-based materials against water. Product names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Anatomical localization and stereoisomeric composition of <Emphasis Type="Italic">Tribolium castaneum</Emphasis> aggregation pheromones

We report that the abdominal epidermis and associated tissues are the predominant sources of male-produced pheromones in the red flour beetle, Tribolium castaneum and, for the first time, describe the stereoisomeric composition of the natural blend of isomers of the aggregation pheromone 4,8-dimethyldecanal (DMD) in this important pest species. Quantitative analyses via gas chromatography–mass spectrometry showed that the average amount of DMD released daily by single feeding males of T. castaneum was 878 ± 72 ng (SE). Analysis of different body parts identified the abdominal epidermis as the major source of aggregation pheromone; the thorax was a minor source, while no DMD was detectable in the head. No internal organs or obvious male-specific glands were associated with pheromone deposition. Complete separation of all four stereoisomers of DMD was achieved following oxidation to the corresponding acid, derivatization with (1R, 2R)- and (1S, 2S)-2-(anthracene-2,3-dicarboximido)cyclohexanol to diastereomeric esters, and their separation on reversed-phase high-performance liquid chromatography at −54°C. Analysis of the hexane eluate from Porapak-Q-collected volatiles from feeding males revealed the presence of all four isomers (4R,8R)/(4R,8S)/(4S,8R)/(4S,8S) at a ratio of approximately 4:4:1:1. A walking orientation bioassay in a wind tunnel with various blends of the four synthetic isomers further indicated that the attractive potency of the reconstituted natural blend of 4:4:1:1 was equivalent to that of the natural pheromone and greater than that of the 1:1 blend of (4R,8R)/(4R,8S) used in commercial lures.     

Sequential anaerobic-aerobic treatment of an aquifer contaminated by halogenated organics: field results

In situ, sequential, anaerobic to aerobic treatment of groundwater removed perchloroethene (PCE, 1.1 microM) and benzene (0.8 microM) from a contaminated aquifer. Neither aerobic nor anaerobic treatment alone successfully degraded both the chlorinated and non-chlorinated organic contaminants in the aquifer. After the sequential treatment, PCE, trichloroethene (TCE), vinyl chloride (VC), chloroethane (CA), and benzene were not detectable in groundwater. Desorption of residual aquifer contaminants was tested by halting the groundwater recirculation and analyzing the groundwater after 3 and 7 weeks. No desorption of the chlorinated contaminants or daughter products was observed in the treated portion of the aquifer. Sequential anaerobic to aerobic treatment was successful in remediating the groundwater at this test site and may have broad applications at other contaminated sites. Over the 4-year course of the project, the predominant microbial environment of the test site varied from aerobic to sulfate-reducing, to methanogenic, and back to aerobic conditions. Metabolically active microbial populations developed under all conditions, demonstrating the diversity and robustness of natural microbial flora in the aquifer.     

Mineral licks: motivational factors for visitation and accompanying disease risk at communal use sites of elk and deer

Free-ranging cervids acquire most of their essential minerals through forage consumption, though occasionally seek other sources to account for seasonal mineral deficiencies. Mineral sources occur as natural geological deposits (i.e., licks) or as anthropogenic mineral supplements. In both scenarios, these sources commonly serve as focal sites for visitation. We monitored 11 licks in Rocky Mountain National Park, north-central Colorado, using trail cameras to quantify daily visitation indices (DVI) and soil consumption indices (SCI) for Rocky Mountain elk (Cervus elaphus) and mule deer (Odocoileus hemionus) during summer 2006 and documented elk, mule deer, and moose (Alces alces) visiting licks. Additionally, soil samples were collected, and mineral concentrations were compared to discern levels that explain rates of visitation. Relationships between response variables; DVI and SCI, and explanatory variables; elevation class, moisture class, period of study, and concentrations of minerals were examined. We found that DVI and SCI were greatest at two wet, low-elevation licks exhibiting relatively high concentrations of manganese and sodium. Because cervids are known to seek Na from soils, we suggest our observed association of Mn with DVI and SCI was a likely consequence of deer and elk seeking supplemental dietary Na. Additionally, highly utilized licks such as these provide an area of concentrated cervid occupation and interaction, thus increasing risk for environmental transmission of infectious pathogens such as chronic wasting disease, which has been shown to be shed in the saliva, urine, and feces of infected cervids.     

Solvent-Free Polymerization of l-Aspartic Acid in the Presence of d-Sorbitol to Obtain Water Soluble or Network Copolymers

l-Aspartic acid was thermally polymerized in the presence of d-sorbitol with the goal of synthesizing new, higher molecular weight water soluble and absorbent copolymers. No reaction occurred when aspartic acid alone was heated at 170 or 200 °C. In contrast, heating sorbitol and aspartic acid neat or with ammonium hydroxide gave a mixture of water soluble and insoluble copolymers of polysuccinimide and sorbitol. In the presence of phosphoric acid, sorbitol aspartate ester copolymers having both water soluble and highly swollen gel components were formed. These results indicate that polysaccharides such as sorbitol can readily react to form copolymer ester/amides with aspartic acid and such copolymers may have utility as biodegradable water soluble and swellable polyampholytes.     

Effect of Orientation on the Morphology and Mechanical Properties of PLA/Starch Composite Filaments

Polylactic acid (PLA)/starch fibers were produced by twin screw extrusion of PLA with granular or gelatinized starch/glycerol followed by drawing through a set of winders with an intermediate oven. At 30% starch, fibers drawn 2–5x were highly flexible (elongation 20–100%) while undrawn filaments were brittle (elongation 2–9%). Tensile strength and moduli increased with increasing draw ratio but decreased with increasing starch content. Mechanical properties were better for composites made with gelatinized starch/glycerol than granular starch. In conclusion, orientation greatly increases the flexibility of PLA/starch composites and this may be useful not only in fibers but also possibly in molded articles. Other advantages of starch addition could include fiber softness without added plasticizer, moisture/odor absorbency and as a carrier for active compounds.     

Biodegradation Behavior of Some Vegetable Oil-Based Polymers

The potential biodegradability of several vegetable oil-based polymers was assessed by respirometry in soil for 60–100 days at temperatures of 30–58°C. Films of soybean oil and linseed oil which were oxidatively polymerized (Co catalyst) on a kraft paper support were 90%–100% mineralized to CO₂ after 70 days at 30°C. Mineralization of polymerized tung oil to CO₂ was much slower than soy or linseed oils. Mineralization of epoxy resins made from epoxidized soybean oil (ESO) and aliphatic dicarboxylic acids was rapid while mineralization of similar resins made with a triacid (citric) was slower. There was no significant degradation of polyamine/ESO resins after 100 days at 58°C. Mineralization of the available carbon in vegetable oil polyurethanes and cationically polymerized ESO was less than 7.5% after 70 days at 30°C and 25 days at 55°C compared to 100% for soybean oil. From these results, it appears that triglycerides highly cross-linked with non-degradable linkages are not biodegradable to a significant extent while triglycerides cross-linked with hydrolysable bonds such as esters remain biodegradable.     

Soil water and particle size distribution influence laboratory-generated PM10

Management of soils to reduce the amount of PM₁₀ emitted during agricultural tillage operations is important for attainment of air quality standards in California's San Joaquin Valley (SJV). The purpose of this study was to improve and expand upon earlier work of predicting tillage-generated dust emissions based on soil properties. We focus on gravimetric soil water content (GWC) and soil texture. A mechanical laboratory dust generator was used to test 23 soils collected for this study. Averaged results showed PM₁₀ concentrations (mg m^?3) increased logarithmically as GWC decreased below soil water potentials of ?1500 kPa. Soils with clay contents less than about 10% by weight began to emit PM₁₀ at GWCs 1.5–4 times their GWC at ?1500 kPa. Soils with clay contents greater than about 10% began to emit PM₁₀ at GWC values closer to ?1500 kPa. We found no correlation between maximum PM₁₀ concentrations, measured at low GWC values, and the %sand, %silt, or %clay in a soil. However, there was a significant correlation between the %silt to %clay ratio and PM₁₀ concentrations. This not only suggests the dependence of dust emission magnitudes on the supply of particles of PM₁₀ size, but also the importance of clay in stabilizing aggregates and maintaining higher amounts of capillary water at lower water potentials. Based on modeled results of pooled data, PM₁₀ concentrations increased linearly (slope = 564) for every unit increase in the %silt to %clay ratio. However, when soils were separated into groups based on clay content, the slopes for PM₁₀ concentrations vs. %silt to %clay ratio were texture dependent. The slope for soils with <10% clay (slope = 727) was 3.3 times greater than for soils with >20% clay (slope = 221). Improved PM₁₀ emission prediction based on soil properties should improve management decisions aimed at reducing tillage-generated PM₁₀.     

Friends of the land and the rise of environmentalism, 1940–1954

The rise of the postwar environmental movement is rooted in the development of ecological consciousness within intellectual circles as well as the general public. Though many commentators cite the 1960s as the focal point of the new environmentalism, the ecological ethic had actually evolved by the 1930s in the writings and speeches of both scientists and public commentators. Agricultural conservationists led the way in broadcasting the message of ecology. Friends of the Land, an agriculturally-oriented conservation organization formed in 1940 and active through the 1950s, is an interesting example of how the agricultural community was an integral component in the rise of environmentalism. While Friends of the Land flourished only for a brief period, its goals and the ideas that the group represented illustrate how the ecological ethic was burgeoning by the early-1950s. Furthermore, the history of Friends of the Land is an important chapter in the ongoing quest for ecological agriculture and societal permanence.     

Developing an Ecological Land Classification for the Fundy Model Forest,southeastern New Brunswick,Canada

The methodology for developing and mapping a hierarchical Ecological Land Classification (ELC) is presented. The classification provided a systematic methodology that explained the distribution and composition of southern New Brunswick's forested landscape. The nested structure of the ELC identified and provided a hierarchical linkage between ecosystems from the size of forest stands to climate regions. This framework made the collection and analysis of data efficient and gave confidence that tree species distributions, which were central to understanding the influence of abiotic factors on the forest systems, were controlled by the factors examined at each level of the hierarchy. This ELC methodology, developed for the Fundy Model forest, was successful in describing and mapping the Climate, Geomorphologic, and Regolith controlled forest ecosystems. Preliminary classification indicates that spatial referencing of the Site Level is achievable.