Methyl methacrylate (MMA) and alumina recovery from waste artificial marble powder pyrolysis

Journal of Material Cycles and Waste Management - Owing to various advantages of artificial marble compared to natural marble, its application has been rising exponentially, which has resulted in...     

Development of monitoring technology for airborne particulate matter

Particulate matter suspended in the air has adverse effects onhuman health. Its level of concentration is an important parameter in evaluating the degree of hazard it poses to the atmosphere. Conventional methods used in measuring particulatematter are often filter-based, which indicates some disadvantagesbecause such a base requires labor and time. In this study, to achieve real-time measurements, a new electrical method was developed for measuring PM10 and PM2.5 concentrations. The basicprinciple is to electrically charge particles passing through thePM inlet using a corona charger and measure the currents createdby charged particles to obtain the number concentration of particulate matter. A new type inlet based on the particle cupimpactor configuration was designed and its performance was evaluated. A unipolar diffusion charger was developed and thecharger's efficiency was determined experimentally in terms ofPn, which represents the penetration through the charger,P, times the average charge number acquired by a particle,n, for different particle sizes. The correlation was constructed between the PM10 (or the PM2.5) mass concentrationsand the electrical currents due to particles, which were chargedby the diffusion charger.     

有机磷酸酯诱导迟发性神经毒性及其对神经毒性酯酶(NTE)活性影响的动态研究

以成年产卵来航母鸡为试验动物，研究了三甲基苯基磷酸酯诱导的迟发性神经毒性。试验发现，母鸡口服ＴＯＣＰ后经过大约８－１０ｄ的潜伏期开始出现中毒症状，其表现为以步态失调为主要特征的运动障碍呈进行性加重，至２１ｄ开始便发展为瘫痪。     

Design of a representative and cost-effective sampling programs for industrial wastewater with examples from bleached kraft pulp and paper mills

The diagram constructed for selection of sampling methods indicates that, for a systematic error, E ≤ 13%, grab sampling (GS) may be used to characterize effluents with variation coefficient of flow ≤ 120% and of contaminant concentrations ≤ 10%. For the whole studied range of variation coefficient of contaminant concentrations (2–82%), time-proportional compositing (TC) method may be applied with E ≤ 10% for effluents characterized by variation coefficients in flow < 90%. The more complicated flow-proportional compositing (FC) method is required only for effluents with larger variation coefficients or to produce more precise results. The diagram constructed for selection of sampling frequencies indicates that sequential sampling at intervals of approximately 60 min may be applied with E ≤ 10% for effluents characterized by variation coefficients ≤ 30%. Practical application of the diagrams, constructed using normal series, was checked against monitoring data from two pulp and paper mills in Vietnam. The two diagrams provided results on sampling methods and frequencies in good agreement with those obtained from actual monitoring data with percentages of agreement cases of 80 and 75%, respectively. The approach was applied in design of a monitoring program at the Bai Bang integrated pulp and paper mill in Vietnam.     

Comparative studies on toluene removal and pressure drop in biofilters using different packing materials

To select the best available packing material for malodorous organic gases such as toluene and benzene, biofilter performance was compared in biofilters employed different packing materials including porous ceramic (celite), Jeju scoria (lava), a mixture of granular activated carbon (GAC) and celite (GAC/celite), and cubic polyurethane foam (PU). A toluene-degrading bacterium, Stenotrophomonas maltophilia T3-c, was used as the inoculum. The maximum elimination capacities in the celite, lava, and GAC/celite biofilters were 100, 130, and 110 gm(-3) hr(-1), respectively. The elimination capacity for the PU biofilter was approximately 350 g m(-3) hr(-1) at an inlet loading of approximately 430 g m(-3) hr(-1), which was 2 to 3.5 times higher than for the other biofilters. The pressure drop gradually increased in the GAC/ celite, celite and lava biofilters after 23 day due to bacterial over-growth, and the toluene removal efficiency remarkably decreased with increasing pressure drop. Backwashing method was not effective for the control of biomass in these biofilters. In the PU biofilter however, backwashing allowed maintenance of a pressure drop of 1 to 3 mm H2O m(-1) and a removal efficiency of > 80%, indicating that the PU was the best packing material for toluene removal among the packing materials tested.     

Kinetics of phenol and chlorophenol utilization by Acinetobacter species

Although microbial transformations via cometabolism have been widely observed, the few available kinetic models of cometabolism have not adequately addressed the case of inhibition from both the growth and nongrowth substrates. The present study investigated the degradation kinetics of self-inhibitory growth (phenol) and nongrowth (4-chlorophenol, 4-CP) substrates, present individually and in combination. Specifically, batch experiments were performed using an Acinetobacter isolate growing on phenol alone and with 4-CP present. In addition, batch experiments were also performed to evaluate the transformation of 4-CP by resting, phenol-induced Acinetobacter cultures. The Haldane kinetic model adequately predicted the biodegradation of phenol alone, although a slight discrepancy was noted in cases of higher initial phenol concentrations. Similarly, a Haldane model for substrate utilization was also able to describe the trends in 4-CP transformation by the resting cell cultures. The 4-CP transformation by the Acinetobacter species growing on phenol was modeled using a competitive kinetic model of cometabolism, which included growth and nongrowth substrate inhibition and cross-inhibition terms. Excellent agreement was obtained between the model predictions using experimentally estimated parameter values and the experimental data for the synchronous disappearance of phenol and 4-CP.     

Bioleaching of metals from spent lithium ion secondary batteries using Acidithiobacillus ferrooxidans

Bioleaching of spent lithium ion secondary batteries, containing LiCoO2, was attempted in this investigation. The present study was carried out using chemolithotrophic and acidophilic bacteria Acidithiobacillus ferrooxidans, which utilized elemental sulfur and ferrous ion as the energy source to produce metabolites like sulfuric acids and ferric ion in the leaching medium. These metabolites helped dissolve metals from spent batteries. Bio-dissolution of cobalt was found to be faster than lithium. The effect of initial Fe(II) concentration, initial pH and solid/liquid (w/v) ratio during bioleaching of spent battery wastes were studied in detail. Higher Fe(II) concentration showed a decrease in dissolution due co-precipitation of Fe(III) with the metals in the residues. The higher solid/liquid ratio (w/v) also affected the metal dissolution by arresting the cell growth due to increased metal concentration in the waste sample. An EDXA mapping was carried out to compare the solubility of both cobalt and lithium, and the slow dissolution rate was clearly found from the figures.     

Oxidation of elemental mercury using atmospheric pressure non-thermal plasma

The oxidation of gas phase elemental mercury (Hg0) by atmospheric pressure non-thermal plasma has been investigated at room temperature, employing both dielectric barrier discharge (DBD) of the gas mixture of Hg0 and injection of ozone (O3) into the gas mixture of Hg0. Results have shown that the oxidative efficiencies of Hg0 by DBD and the injection of O3 are 59% and 93%, respectively, with energy consumption of 23.7 J L(-1). This combined approach has indicated that O3 plays a decisive role in the oxidation of gas phase Hg0. Also the oxidation of Hg0 by injecting O3 into the gas mixture of Hg0 proceeds with better efficiency than DBD of the gas mixture of Hg0. These results have been explained by the incorporation of the competitive reaction pathways between the formation of HgO by O3 and the decomposition of HgO back to Hg0 in the plasma environment.