First Detection of Hepatitis E Virus in Shellfish and in Seawater from Production Areas in Southern Italy

Shellfish samples (n = 384) from production areas, water samples from the same areas (n = 39) and from nearby sewage discharge points (n = 29) were analyzed for hepatitis E virus (HEV) by real-time and nested RT-PCR. Ten shellfish samples (2.6%) and five seawater samples (12.8%) tested positive for HEV; all characterized strains were G3 and showed high degree of sequence identity. An integrated surveillance in seafood and waters is relevant to reduce the risk of shellfish-associated illnesses.     

Prenatal diagnosis of femur-fibula-ulna complex by ultrasonography in a male fetus at 24 weeks of gestation

We present a case of ultrasonographic prenatal diagnosis at 24 weeks of femur—fibula—ulna (FFU) complex. To our knowledge, this is the first report of an early prenatal diagnosis of FFU.     

Lettuce plants as bioaccumulators of trace elements in a community of central Italy

A survey, based on the use of vascular plants to describe the distribution of selected elements (21 in total) was performed in 11 sites in the area of Castelfiorentino (Tuscany, Central Italy) differing for land use, from urban to industrial and rural areas. Lettuce plants grown under standardized conditions were positively used as biodeposimeters of airborne trace elements. Washing was found to be highly significant in reducing concentrations of many elements in the samples, suggesting a general surface contamination of leaves. The typical crustal element Al showed good correlations with Co, Fe, Li and V; on the contrary, Zn and Cd were intercorrelated and showed no connection with crustal indicators. Lead was still a relevant environmental presence, as the experiments were carried out before the ban of leaded gasoline. Source apportionment by factor analysis put in evidence a major contribution of crustal materials, followed by man-related activities; a minor role was ascertained for marine aerosol. A comparison was made between analytical data of lettuce plants grown in our experimental sites and a bulk of commercial lettuce purchased at a local supermarket. It should be stressed how Cu concentrations of commercial material were significantly higher than those found in our plants; this is likely caused by phytosanitary treatments.     

Secondary sexual characters signal fighting ability and determine social rank in Alpine ibex (Capra ibex)

Social dominance is a fundamental aspect of male evolutionary ecology in polygynous mammals because it determines access to estrous females. As it is rarely possible to monitor marked individuals of known morphology, little is known about the determinants of male dominance. We studied the social structure of Alpine ibex males in Gran Paradiso National Park, Italy in 2003, 2006, and 2007. Dominance interactions produced a linear social hierarchy. In ibex males, body mass and horn length are key traits in male-male combat, and both increase with age. We explored the links between age, body mass, horn length, and social rank. Ibex males showed much age-independent phenotypic heterogeneity and rapidly growing males reached high rank at a younger age than slow-growing males. Because there is no trade-off between horn growth and longevity, fast-growing males may face weak potential costs of rapid growth and high fitness benefit of achieving high rank. Violent interactions were more likely to occur between males similar in both mass and horn length, independently of age. We suggest that only high-quality individuals can afford a strategy of rapid growth for both secondary sexual characters, and likely reap substantial fitness benefits.     

Temporal and spatial variability in settlement of the sea urchin<Emphasis Type="Italic"> Paracentrotus lividus</Emphasis> in the NW Mediterranean

Settlement into the benthic habitat may be an important process in regulating sea urchin abundance, which potentially modifies the structure of benthic communities. Strong settlement events may increase sea urchin abundance beyond a certain threshold, leading to the formation of coralline barrens (overgrazed communities with a dominance of encrusting coralline algae). To understand the role of settlement in regulating sea urchin populations we first need to determine settlement variability. Temporal variation in settlement of the sea urchin Paracentrotus lividus was monitored at three sites in the Medes Islands, NW Mediterranean, during three settlement seasons (March 1998 through October 2000). Spatial variation in settlement was studied in 1999 at 50 sites along a gradient of exposures to waves and currents, inside and outside the archipelago, and separated by distances from tens to thousands of meters. Bathymetric distribution of settlement was also studied in 2000 at six sites at 5, 10, 15 and 20 m depths. Settlement of P. lividus occurred in a single annual peak within 3 weeks in May–June. Differences in settlement between years were more than two orders of magnitude. Spatial variability was found at all scales investigated, showing strong patchiness at the smallest spatial scales (tens of meters). Sea urchins settled preferentially at depths between 5 and 10 m. Substratum type, level of protection, and adult population densities were not significant in determining settlement. However, settlement was found to be related to the degree of exposure to waves and currents, indicating that physical processes are very important at the spatial scales investigated. This greatly variable settlement is a necessary, although not sufficient, condition to create gradients of adult P. lividus abundance. Further studies should be designed to investigate the interaction between settlement strength and post-settlement mortality.Communicated by O. Kinne, Oldendorf/Luhe     

Material and energy recovery in integrated waste management systems: the potential for energy recovery

This article is part of a set of six coordinated papers reporting the main findings of a research project carried out by five Italian universities on "Material and energy recovery in Integrated Waste Management Systems (IWMS)". An overview of the project and a summary of the most relevant results can be found in the introductory article of the series. This paper describes the work related to the evaluation of mass and energy balances, which has consisted of three major efforts (i) development of a model for quantifying the energy content and the elemental compositions of the waste streams appearing in a IWMS; (ii) upgrade of an earlier model to predict the performances of Waste-to-Energy (WtE) plants; (iii) evaluation of mass and energy balances of all the scenarios and the recovery paths considered in the project. Results show that not only the amount of material available for energy recovery is significantly higher than the Unsorted Residual Waste (URW) left after Separate Collection (SC), because selection and recycling generate significant amounts of residues, but its heating value is higher than that of the original, gross waste. Therefore, the energy potential of what is left after recycling is always higher than the complement to 100% of the Source Separation Level (SSL). Also, increasing SSL has marginal effects on the potential for energy recovery: nearly doubling SSL (from 35% to 65%) reduces the energy potential only by one fourth. Consequently, even at high SSL energy recovery is a fundamental step of a sustainable waste management system. Variations of SSL do bring about variations of the composition, heating value and moisture content of the material fed to WtE plants, but these variations (i) are smaller than one can expect; (ii) have marginal effects on the performances of the WtE plant. These considerations suggest that the mere value of SSL is not a good indicator of the quality of the waste management system, nor of its energy and environmental outcome. Given the well-known dependence of the efficiency of steam power plants with their power output, the efficiency of energy recovery crucially depends on the size of the IWMS served by the WtE plant. A fivefold increase of the amount of gross waste handled in the IWMS (from 150,000 to 750,000 tons per year of gross waste) allows increasing the electric efficiencies of the WtE plant by about 6-7 percentage points (from 21-23% to 28.5% circa).     

Material and energy recovery in integrated waste management systems. An evaluation based on life cycle assessment

This paper reports the environmental results, integrated with those arising from mass and energy balances, of a research project on the comparative analysis of strategies for material and energy recovery from waste, funded by the Italian Ministry of Education, University and Research. The project, involving the cooperation of five University research groups, was devoted to the optimisation of material and energy recovery activities within integrated municipal solid waste (MSW) management systems. Four scenarios of separate collection (overall value of 35%, 50% without the collection of food waste, 50% including the collection of food waste, 65%) were defined for the implementation of energetic, environmental and economic balances. Two sizes of integrated MSW management system (IWMS) were considered: a metropolitan area, with a gross MSW production of 750,000 t/year and an average province, with a gross MSW production of 150,000 t/year. The environmental analysis was conducted using Life Cycle Assessment methodology (LCA), for both material and energy recovery activities. In order to avoid allocation we have used the technique of the expansion of the system boundaries. This means taking into consideration the impact on the environment related to the waste management activities in comparison with the avoided impacts related to the saving of raw materials and primary energy. Under the hypotheses of the study, both for the large and for the small IWMS, the energetic and environmental benefits are higher than the energetic and environmental impacts for all the scenarios analysed in terms of all the indicators considered: the scenario with 50% separate collection in a drop-off scheme excluding food waste shows the most promising perspectives, mainly arising from the highest collection (and recycling) of all the packaging materials, which is the activity giving the biggest energetic and environmental benefits. Main conclusions of the study in the general field of the assessment of the environmental performance of any integrated waste management scheme address the importance of properly defining, beyond the design value assumed for the separate collection as a whole, also the yields of each material recovered; particular significance is finally related to the amount of residues deriving from material recovery activities, resulting on average in the order of 20% of the collected materials.     

A preliminary investigation into the physical and chemical properties of biomass ashes used as aggregate fillers for bituminous mixtures

Fly and bottom ashes are the main by-products arising from the combustion of solid biomass. Since the production of energy from this source is increasing, the processing and disposal of the resulting ashes has become an environmental and economic issue. Such ashes are of interest as a construction material because they are composed of very fine particles similar to fillers normally employed in bituminous and cementitious mixtures. This research investigates the potential use of ash from biomass as filler in bituminous mixtures. The morphological, physical and chemical characteristics of 21 different ashes and two traditional fillers (calcium carbonate and “recovered” plant filler) were evaluated and discussed. Leaching tests, performed in order to quantify the release of pollutants, revealed that five ashes do not comply with the Italian environmental re-use limits. Experimental results show a wide range of values for almost all the investigated properties and a low correlation with biomass type in terms of origin and chemical composition. Furthermore, sieving and milling processes were found to improve the properties of the raw material in terms of grading and sample porosity. The effectiveness of these treatments and the low content of organic matter and harmful fines suggest that most of the biomass ashes investigated may be regarded as potential replacements for natural filler in bituminous mixtures.