Economic growth and CO<Subscript>2</Subscript> emissions

This article considers a planner’s optimum control exercise with environmental pollution and derives a testable link between the growth rates of consumption and pollution. The link is then empirically estimated for the case of CO₂ emissions for a sample consisting of the union of top 25 countries in terms of CO₂ emissions, population and per capita GNP. The analysis suggests that the interrelationship between the growth rates of CO₂ emission and economic development is mostly significant for countries that have a high level of CO₂ emissions and population.     

A mathematical model for type II profile of concentration distribution in turbulent flows

This paper presents a mathematical model to investigate type II profile of suspension concentration distribution (i.e., the concentration profile where the maximum concentration appears at some distance above the bed surface) in a steady, uniform turbulent flow through open-channels. Starting from the mass and momentum conservation equations of two-phase flow, a theoretical model has been derived. The distribution equation is derived considering the effects of fluid lift force, drag force, particle inertia, particle–particle interactions, particle velocity fluctuations and drift diffusion. The equation is solved numerically and is compared with available experimental data as well as with other models existing in the literature. Good agreement between the observed value and computed result, and minimum error in comparison to other models indicate that the present model can be applied in predicting particle concentration distribution for type II profile for a wide range of flow conditions. The proposed model is also able to show the transition from type I profile to type II profile.     

An ergonomic study on posture-related discomfort among preadolescent agricultural workers of West Bengal, India.

In India, particularly in West Bengal, preadolescents are primarily associated with agricultural work in rural areas. Owing to poor socio-economic conditions, they are compelled to carry out a considerable number of manual, rigorous tasks in agricultural fields. The main aim of this study was to investigate postures adopted by preadolescent agricultural workers during individual agricultural activities and to analyze the causes of discomfort related to those postures. Fifty male and 50 female preadolescent agricultural workers were randomly selected and a detailed posture analysis was performed with the Ovako Working Posture Analysis System (OWAS). It was observed that those workers worked continuously in awkward postures during certain agricultural activities. Consequently they suffered from discomfort in different parts of their body. Even though they were very young, they were likely to suffer from serious musculoskeletal disorders in the future.     

An Ergonomie Study on Posture-Related Discomfort Among Preadolescent Agricultural Workers of West Bengal,India

In India, particularly in West Bengal, preadolescents are primarily associated with agricultural work in rural areas. Owing to poor socio-economic conditions, they are compelled to carry out a considerable number of manual, rigorous tasks in agricultural fields. The main aim of this study was to investigate postures adopted by preadolescent agricultural workers during individual agricultural activities and to analyze the causes of discomfort related to those postures. Fifty male and 50 female preadolescent agricultural workers were randomly selected and a detailed posture analysis was performed with the Ovako Working Posture Analysis System (OWAS). It was observed that those workers worked continuously in awkward postures during certain agricultural activities. Consequently they suffered from discomfort in different parts of their body. Even though they were very young, they were likely to suffer from serious musculoskeletal disorders in the future.     

Comparison of the effects of variable site temperatures and constant incubation temperatures on the biodegradation of petroleum hydrocarbons in pilot-scale experiments with field-aged contaminated soils from a cold regions site

Temporal atmospheric temperature changes during summers at sub-Arctic sites often cause periodic fluctuations in shallow landfarm and surface soil temperatures. However, little information is available on the effect of site-relevant variations on biodegradation performance in cold climates. This study compares the rate and extents of biodegradation of petroleum hydrocarbons at variable site temperatures (1-10 °C) representative of summers at a sub-Arctic site reported previously with those obtained under a constant average temperature of 6 °C. The biodegradation was evaluated in pilot-scale landfarming experiments with field-aged petroleum-contaminated soils shipped from Resolution Island (61°30′N, 65°00′W), Nunavut, Canada. Under the variable site temperature conditions biodegradation rate constants of semi- (F2) and non-volatile (F3) hydrocarbon fractions were enhanced by over a factor of two during the 60-d experiment, compared to the constant temperature mode. The decrease in total petroleum hydrocarbons (TPH) under the variable site temperature mode was 55% compared to only 19% under the constant average temperature mode. The enhanced biodegradation is attributable to the non-linear acceleration of microbial activity between 4.7 and 10 °C and faster growth of indigenous hydrocarbon-degrading microbial populations. The first-order biodegradation rate constants of 0.018, 0.024 and 0.016 d⁻¹ for TPH, F2 and F3 fractions at the variable site temperature were in agreement with those determined by an on-site experiment at the same site.     

Assessment of transport of two polyelectrolyte-stabilized zero-valent iron nanoparticles in porous media

This study investigated the breakthrough patterns of carboxymethyl cellulose- and polyacrylic acid-stabilized zero-valent iron (Fe(0)) nanoparticles (NZVI) from packed sand columns under a range of pore water velocities of 0.02, 0.2 and 1 cm min(-1) and NZVI influent concentrations of 0.1, 0.5 and 3 g L(-1). The NZVI effluent relative concentrations of both types of particles decreased with slower flow velocities and increasing particle concentrations. PAA-NZVI exhibited slower elution from the columns than CMC-NZVI under identical experimental conditions, and this is attributed to more rapid aggregation kinetics of PAA-NZVI. The elution patterns of PAA-NZVI showed a stronger trend of gradually increasing effluent concentrations with flushing of additional pore volumes, especially at low flushing velocities and higher influent particle concentrations and this phenomenon too can be attributed to increasing aggregate sizes with time which caused decreases in the values of the single collector efficiency and thus the deposition rate constant. A 7 nm increase in CMC-NZVI aggregate size over 60 min was observed using nanoparticle tracking analysis. The reduction in colloidal stability due to aggregation of CMC- and PAA-NZVI was verified using sedimentation tests, and it was found that PAA-NZVI were less stable than CMC-NZVI. There were also notable inherent differences in the two NZVI particles. The CMC-NZVI were monodisperse with a mean diameter of 5.7 ± 0.9 nm, whereas PAA-NZVI had a bimodal particle size distribution with a small sub-population of particles with mean size of 30 ± 21 nm and a more abundant population of 4.6 ± 0.8 nm diameter particles. Furthermore, PAA-NZVI had a lower surface potential. These characteristics are also responsible for the different elution patterns CMC- and PAA-NZVI.     

Study on the Thermo-Mechanical and Biodegradable Properties of Shellac Films Grafted with Acrylic Monomers by Gamma Radiation

Shellac (SL) films were prepared by casting and were grafted with various acrylic monomers of different functionalities using gamma radiation. Different formulations of shellac with varying concentrations (3, 5 and 7%) of these acrylic monomers such as 2-hydroxyethyl methacrylate (HEMA), 2-ethylhexyl acrylate (EHA) and 1,4-butanediol diacrylate (BDDA) in methanol were prepared. The pure shellac and other treated films were then irradiated under gamma radiation (Co-60) at different doses (0.5–5 kGy) at a dose rate of 3.5 kGy/h where 1 Gy = 1 J/kg = 100 rads. The mechanical properties like tensile strength (TS) and elongation at break (Eb) of the prepared films were studied. The mechanical properties of the irradiated shellac films demonstrated superior values. Among the formulations, shellac grafted with BDDA (SL-g-BDDA) showed the highest TS and Eb values which were 543 and 168% higher than those of raw shellac films, respectively. The water uptake behavior of raw and treated films was also studied. The raw film showed 11% water uptake but HEMA containing film showed 67%. In the soil burial test, HEMA containing shellac film was rapidly degraded than other raw, EHA and BDDA grafted films. Thermal properties indicated that grafting of acrylic monomers decreased the melting temperature of the pure shellac films.     

The role of interfacial films in the mass transfer of naphthalene from creosotes to water

Viscous, semi-rigid interfacial films that are formed at the interface of certain multi-component non-aqueous phase liquid (NAPLs) and water can significantly reduce the rates of mass transfer of solutes. Creosote-water systems were investigated for their ability to form interfacial films. The effects of these films on the creosote-water partition and on mass transfer of a representative solute, naphthalene, were investigated in a series of experiments. The area-independent mass transfer coefficient of naphthalene contained in creosote decreased by 30% over a 1-week period in systems containing creosote and water. Further aging for up to 21 days did not result in significant additional decreases in the mass transfer coefficient. The creosote-water partition coefficient, however, did not change with extended contact. The presence of viscous interfacial films in creosote-water systems was demonstrated in pendant drop tests. These interfacial films most likely caused the reduction in solute mass transfer coefficients by providing significant resistance to the diffusion of solutes through the interfacial film. Results from mass transfer experiments conducted under different system conditions suggested that hindered diffusion of naphthalene through the bulk creosote phase, changes in composition of creosote as a result of extended dissolution, or changes in creosote-water interfacial area did not contribute to the decrease in naphthalene mass transfer coefficient.     

Theoretical modeling of suspended grain-size distribution in fluvial environment by stratification and secondary current approaches

Here we propose a theoretical model to compute the suspended grain-size distribution in fluvial environment. We derive the model based on the Reynolds averaged Navier–Stokes equation and the continuity equation of sediment phase. The model includes the effects of secondary current and stratification which are the cause of complex interaction between turbulence and grain-size distribution in the sediment-laden flow. Due to an immense importance of particle–particle and particle-turbulence interactions near the channel bed, we include their impacts in the boundary condition of the model. The present model has noteworthy contribution to demonstrate the phenomena of suspended grain-size distribution in the real world. Reported experimental data in literature shows well agreement with the numerical solution computed from the suggested model. The better computational accuracy of the present model is ascertained when the upper bound of calculated error between observed experimental data and computed values is found to be lowest for our model in comparison to a large number of existing models developed from different mathematical viewpoints.     

Removal of Volatile Organic Compounds from polluted air

Volatile Organic Compounds (VOCs) are among the most common air pollutants emitted from chemical, petrochemical, and allied industries. VOCs are one of the main sources of photochemical reaction in the atmosphere leading to various environmental hazards; on the other hand, these VOCs have good commercial value. Growing environmental awareness has put up stringent regulations to control the VOCs emissions. In such circumstances, it becomes mandatory for each VOCs emitting industry or facility to opt for proper VOCs control measures. There are many techniques available to control VOCs emission (destruction based and recovery based) with many advantages and limitations. Therefore, deciding on a particular technique becomes a difficult task. This article illustrates various available options for VOCs control. It further details the merits, demerits and applicability of each option. The authors hope that this article will help in critically analysing the requirements and accordingly decide on the appropriate strategy to control VOCs.