排序方式: 共有15条查询结果,搜索用时 46 毫秒
1.
Gerald P. Huffman Frank E. Huggins Naresh Shah Robert Huggins William P. Linak C. Andrew Miller 《Journal of the Air & Waste Management Association (1995)》2013,63(7):1106-1114
ABSTRACT Combustion experiments were carried out on four different residual fuel oils in a 732-kW boiler. PM emission samples were separated aerodynamically by a cyclone into fractions that were nominally less than and greater than 2.5 |j.m in diameter. However, examination of several of the samples by computer-controlled scanning electron microscopy (CCSEM) revealed that part of the PM2.5 fraction consists of carbonaceous cenospheres and vesicular particles that range up to 10 |j.m in diameter. X-ray absorption fine structure (XAFS) spectroscopy data were obtained at the S, V, Ni, Fe, Cu, Zn, and As K-edges and at the Pb L-edge. Deconvolution of the X-ray absorption near edge structure (XANES) region of the S spectra established that the dominant molecular forms of S present were sulfate (26-84% of total S) and thiophene (13-39% of total S). Sulfate was greater in the PM2.5 samples than in the PM25+ samples. Inorganic sulfides and elemental sulfur were present in lower percentages. The Ni XANES spectra from all of the samples agreed fairly well with that of NiSO4, while most of the V spectra closely resembled that of vanadyl sulfate (VO?SO4?xH2O). The other metals investigated (i.e., Fe, Cu, Zn, and Pb) also were present predominantly as sulfates. Arsenic was present as an arsen-ate (As+5). X-ray diffraction patterns of the PM2.5 fraction exhibit sharp lines due to sulfate compounds (Zn, V, Ni, Ca, etc.) superimposed on broad peaks due to amorphous carbons. All of the samples contain a significant organic component, with the loss on ignition (LOI) ranging from 64 to 87% for the PM2.5 fraction and from 88 to 97% for the PM2.5+ fraction. Based on 13C nuclear magnetic resonance (NMR) analysis, the carbon is predominantly condensed in graphitic structures. Aliphatic structure was detected in only one of seven samples examined. 相似文献
2.
The concentration of As, Cr and Ni and their speciation (As3+;5+, Cr3+;6+ and Ni0;2+) in milled coal, bottom ash and ash collected by electrostatic precipitator (ESP) from a coal fired-power plant in western Canada were determined using HGAAS, ICP-AES and XANES. The chemical fractionation of these elements was also determined by a sequential leaching procedure, using deionized water, NH4OAC and HCI as extracting agents. The leachate was analyzed by ICP-AES. Arsenic in the milled coal is mostly associated with organic matter, and 67% of this arsenic is removed by ammonium acetate. This element is totally removed from milled coal after extraction with HCI. Arsenic occurs in both the As3+ and the As5+ oxidation states in the milled coal, while virtually all (>90%) of the arsenic in bottom ash and fly ash appears to be in the less toxic arsenate (As5+) form. Both Ni and Cr in the milled coal are extracted by HCI, indicating that water can mobilize Ni and Cr in an acidic environment. The chromium is leached by water from fly ash as a result of the high pH of the water, which is induced during the leaching. Ammonium acetate removes Ni from bottom ash through an ion exchange process. Chromium in milled coal is present entirely as Cr3+, which is an essential human trace nutrient. The Cr speciation in bottom ash is a more accentuated version of the milled coal and consists mostly of the Cr3+ species. Chromium in fly ash is mostly Cr3+, with significant contamination by stainless-steel from the installation itself. 相似文献
3.
Streamflow Depletion Modeling: Methods for an Adaptable and Conjunctive Water Management Decision Support Tool
下载免费PDF全文
![点击此处可从《Journal of the American Water Resources Association》网站下载免费的PDF全文](/ch/ext_images/free.gif)
Xander Huggins Tom Gleeson Hailey Eckstrand Ben Kerr 《Journal of the American Water Resources Association》2018,54(5):1024-1038
Groundwater pumping depletes streamflow, which can have significant ecological impacts depending on the magnitude of depletion relative to environmental flow needs. Streamflow depletion estimates from groundwater pumping have been quantified using both analytical and numerical methods, but are not routinely compared to environmental flow needs or used in practical water management tools. Decision support tools that incorporate groundwater dynamics are becoming increasingly necessary for water managers as groundwater regulations become more important in environmental policy, particularly concerning the preservation of environmental flow needs. We develop and apply methods for a web‐based decision support tool for conjunctive groundwater and surface water management, demonstrated using a case study watershed in British Columbia, Canada. Open‐source data are analyzed with a combination of spatial algorithms and previously developed analytical models, such that the tool can be applied to other regions. Streamflow depletion estimates are calculated in four regions in the largely undeveloped Bulkley Valley, British Columbia. Our transparent methodology has geographic and data input flexibility which is a significant improvement on currently existing water management tool methods. 相似文献
4.
Richard Huggins Wen-Han Hwang Jakub Stoklosa 《Environmental and Ecological Statistics》2018,25(4):495-522
A presence–absence map consists of indicators of the occurrence or nonoccurrence of a given species in each cell over a grid, without counting the number of individuals in a cell once it is known it is occupied. They are commonly used to estimate the distribution of a species, but our interest is in using these data to estimate the abundance of the species. In practice, certain types of species (in particular flora types) may be spatially clustered. For example, some plant communities will naturally group together according to similar environmental characteristics within a given area. To estimate abundance, we develop an approach based on clustered negative binomial models with unknown cluster sizes. Our approach uses working clusters of cells to construct an estimator which we show is consistent. We also introduce a new concept called super-clustering used to estimate components of the standard errors and interval estimators. A simulation study is conducted to examine the performance of the estimators and they are applied to real data. 相似文献
5.
Galbreath KC Toman DL Zygarlicke CJ Huggins FE Huffman GP Wong JL 《Journal of the Air & Waste Management Association (1995)》2000,50(11):1876-1886
The chemical speciation of Ni in fly ash produced from approximately 0.85 wt % S residual (no. 6 fuel) oils in laboratory (7 kW)- and utility (400 MW)-scale combustion systems was investigated using X-ray absorption fine structure (XAFS) spectroscopy, X-ray diffraction (XRD), and acetate extraction [1 M NaOAc-0.5 M HOAc (pH 5) at 25 degrees C]-anodic stripping voltammetry (ASV). XAFS was also used to determine the Ni speciation of ambient particulate matter (PM) sampled near the 400-MW system. Based on XAFS analyses of bulk fly ash and their corresponding acetate extraction residue, it is estimated that > 99% of the total Ni (0.38 wt %) in the experimentally produced fly ash occurs as NiSO4.xH2O, whereas > 95% of the total Ni (1.70 and 2.25 wt %) in two fly ash samples from the 400-MW system occurs as NiSO4.xH2O and Ni-bearing spinel, possibly NiFe2O4. Spinel was also detected using XRD. Acetate extracts most of the NiSO4.xH2O and concentrates insoluble NiFe2O4 in extraction residue. Similar to fly ash, ambient PM contains NiSO4.xH2O and NiFe2O4; however, the proportion of NiSO4.xH2O relative to NiFe2O4 is much greater in the PM. Results from this and previous investigations indicate that residual oil ash produced in the 7-kW combustion system lack insoluble Ni (e.g., NiFe2O4) but are enriched in soluble NiSO4.xH2O relative to fly ash from utility-scale systems. This difference in Ni speciation is most likely related to the lack of additive [e.g., Mg(OH)2] injection and residence time in the 7-kW combustion system. 相似文献
6.
7.
Huffman GP Huggins FE Shah N Huggins R Linak WP Miller CA Pugmire RJ Meuzelaar HL Seehra MS Manivannan A 《Journal of the Air & Waste Management Association (1995)》2000,50(7):1106-1114
Combustion experiments were carried out on four different residual fuel oils in a 732-kW boiler. PM emission samples were separated aerodynamically by a cyclone into fractions that were nominally less than and greater than 2.5 microns in diameter. However, examination of several of the samples by computer-controlled scanning electron microscopy (CCSEM) revealed that part of the PM2.5 fraction consists of carbonaceous cenospheres and vesicular particles that range up to 10 microns in diameter. X-ray absorption fine structure (XAFS) spectroscopy data were obtained at the S, V, Ni, Fe, Cu, Zn, and As K-edges and at the Pb L-edge. Deconvolution of the X-ray absorption near edge structure (XANES) region of the S spectra established that the dominant molecular forms of S present were sulfate (26-84% of total S) and thiophene (13-39% of total S). Sulfate was greater in the PM2.5 samples than in the PM2.5+ samples. Inorganic sulfides and elemental sulfur were present in lower percentages. The Ni XANES spectra from all of the samples agreed fairly well with that of NiSO4, while most of the V spectra closely resembled that of vanadyl sulfate (VO.SO4.xH2O). The other metals investigated (i.e., Fe, Cu, Zn, and Pb) also were present predominantly as sulfates. Arsenic was present as an arsenate (As+5). X-ray diffraction patterns of the PM2.5 fraction exhibit sharp lines due to sulfate compounds (Zn, V, Ni, Ca, etc.) superimposed on broad peaks due to amorphous carbons. All of the samples contain a significant organic component, with the loss on ignition (LOI) ranging from 64 to 87% for the PM2.5 fraction and from 88 to 97% for the PM2.5+ fraction. Based on 13C nuclear magnetic resonance (NMR) analysis, the carbon is predominantly condensed in graphitic structures. Aliphatic structure was detected in only one of seven samples examined. 相似文献
8.
The acute toxicity of monodispersed 6 nm and <100 nm poly-dispersed copper oxide nanoparticles toward Daphnia magna was assessed using 48 h immobilization tests. CuSO4 was used as a reference. Four different exposure conditions were tested, to study whether the toxicity of the nanoparticle suspensions changed in a way similar to what is known for dissolved Cu: first in ISO standard test conditions (pH 7.8), second with slight acidity (pH 6.5), third in the presence of citric acid, and fourth in the presence of humic acid. For all four exposure conditions, the toxicity of Cu employed in the three forms followed the same sequence, i.e., CuSO4 > monodispersed 6 nm CuO ? poly-dispersed CuO. The toxicity of all Cu forms decreased from pH 6.5, ? pH 7.8, > pH 7.8 + citric acid, to ? pH 7.8 + humic acid. This pattern is in agreement with concentrations of Cu2+ calculated using the equilibrium model MINTEQ. These findings show that the acute toxicity of copper oxide nanoparticles is governed by test water composition and the chemical species Cu2+. 相似文献
9.
Galbreath KC Schulz RL Toman DL Nyberg CM Huggins FE Huffman GP Zillioux EJ 《Journal of the Air & Waste Management Association (1995)》2005,55(3):309-318
Representative duplicate fly ash samples were obtained from the stacks of 400- and 385-MW utility boilers (Unit A and Unit B, respectively) using a modified U.S. Environmental Protection Agency (EPA) Method 17 sampling train assembly as they burned 0.9 and 0.3 wt % S residual (No. 6 fuel) oils, respectively, during routine power plant operations. Residual oil fly ash (ROFA) samples were analyzed for Ni concentrations and speciation using inductively coupled plasma-atomic emission spectroscopy, X-ray absorption fine structure (XAFS) spectroscopy, and X-ray diffraction (XRD). ROFA deionized H2O extraction residues were also analyzed for Ni speciation using XAFS and XRD. Total Ni concentrations in the ROFAs were similar, ranging from 1.3-1.5 wt%; however, stack gas Ni concentrations in the Unit A were 0.990 microg/Nm3 compared with 0.620 microg/Nm3 for Unit B because of the greater residual oil feed rates employed at Unit A to attain higher 400-MW load conditions with a lower heating value oil. Ni speciation analysis results indicated that ROFAs from Unit A contain approximately 3 wt % NiSO4 x xH2O (where x is assumed to be 6 for calculation purposes) and appoximately 4.5 wt% of a Ni-containing spinel compound, similar in composition to (Mg,Ni)(Al,Fe)2O4. ROFAs from Unit B contain on average 2 wt% NiSO4 x 6 H20 and 1.1 wt% NiO. XAFS and XRD analyses did not detect any nickel sulfide compounds, including carcinogenic nickel subsulfide (Ni3S2) (XAFS detection limit is 5% of the total Ni concentration). In addition, XAFS measurements indicated that inorganic sulfate and organic thiophene species accounted for > 97% of the total S in the ROFAs. Unit A ROFAs contained much lower thiophene proportions because cyclone-separated ROFA reinjection is employed on this unit to collect and reburn the larger carbonaceous particles. 相似文献
10.
In 1980 the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) was passed to instigate the cleanup of uncontrolled hazardous waste sites. CERCLA necessitated the development of a set of criteria for estimating the severity of the contamination at these sites, the potential impact on human health and the environment, and establishing appropriate cleanup levels for the contaminated media. The risk assessment (RA) format was developed to meet these challenges. Though RAs vary dramatically in their scope, emphasis, and regulatory application, there are two primary objectives common to all RAs: (1) to evaluate potential risks to human health and the environment posed by the release of hazardous substances and (2) to evaluate and establish safe cleanup levels based primarily on the number and type of potential receptors, the toxicity and mobility of the contaminants, and the types of exposure pathways present. Achieving these objectives may be a relatively simple task or an extremely complex and difficult one depending on the type of material released and our understanding of its behavior in the environment, the site conditions, and the governing regulations. This article presents an approach for establishing acceptable cleanup levels for subsurface soils and illustrates the application of this approach to three different regulated sites. 相似文献