Environmental threats to buried archaeological remains

The last century's environmental pollution has created health problems, acidification of ground and lakes, and serious damage to our cultural heritage. Outdoor monuments suffer from this pollution, but so do buried archaeological remains. However, research on the deterioration of archaeological artifacts underground has so far been limited, and it is important to draw attention to this neglected field. This article presents results obtained at the Swedish National Heritage Board on the degradation of archaeological objects of bronze and iron and of bones from prehistoric graves, materials of which seem to be most affected by pollutants. The investigation methods, which were employed, are described. Other relevant studies are briefly reviewed. It is obvious that the deterioration rate of archaeological artifacts, especially of inorganic materials, has accelerated in recent years, and that this increased deterioration to a large part can be attributed to anthropogenic pollution. Regions that might be endangered are exemplified.     

Gradient ion chromatography of environmentally relevant anions in scrubbers of waste incinerators

Improved separations of a wide range of anions of environmental importance in scrubbers of waste incinerators were achieved by applying a Na₂B₄O₇/NaOH composition gradient of low electrical conductivity in combination with suppressed ion chromatography. Fluoride, Acetate, Formiate and 16 other ions including Iodide could be separated within the same run in less than 20 minutes. The selective detection of small amounts of several anions in presence of excessive amounts of Chloride and Sulfate is discussed. Furtheron various adsorbents were tested for the removal of Phenol as a potential trouble shooting source in 5 ion chromatography. Depending on the analytical task and circumstances several adsorbents reveiled promising properties.     

Large-scale green synthesis of Cu nanoparticles

This article reports a novel, eco-friendly herbal method to synthesize Cu nanoparticles in large scales. Cu nanoparticles are an alternative to Ag and Au nanoparticles and have potential applications in many industrial areas. Many synthetic routes have been documented for the preparation of copper nanoparticles, but very few routes are eco-friendly and large-scale. We report here the preparation of Cu nanoparticles from aqueous CuSO₄ using non-toxic and inexpensive materials like curd, milk, and herbal extracts such as tamarind and lemon juice as capping agents. X-ray diffraction and transmission electron microscopy show that produced particles are nanocrystalline copper 20–50 nm in size with a face-centered cubic structure. Fourier-transformed infrared spectroscopy evidences the role of organic acids in the capping process. The novelty of this work is the synthesis of Cu nanoparticles from CuSO₄ without electricity and using non-toxic, cheap capping agents.     

Ions species size distribution in particulate matter associated with VOCs and meteorological conditions over an urban region

Airborne particulate matter (PM10, PM2.5, PM1) and volatile organic compounds (benzene, toluene, m,p-xylene, o-xylene) samples were collected during winter and summer seasons of 2005 at two sites, representing an urban and a suburban region of the Greater Athens Area. Urban site traffic emissions were the major contributor to the concentration of PM2.5, PM10, toluene, and xylenes, while benzene and PM1 concentrations were presented in significant spatial variations. K+, Na+, Mg2+, Ca2+, NO3-, Cl- and SO42- ions were analyzed for the chemical characterization of the collected PM samples. The results showed that Na+ cations and SO42- anions were the dominant species, during winter and summer, respectively, in both sites. The analysis of the synoptic scale and mesoscale atmospheric circulation during the experimental periods demonstrated that the meteorological conditions play a key role, not only in the variation but also in the distribution of the ionic concentrations at the three fractions of particulates and the dominant character (alkaline/acidic/neutral) of the particulates at the two sampling sites.     

Statistical thermodynamics of adsorption of dye DR75 onto natural materials and its modifications: double-layer model with two adsorption energies

In this article, adsorption modelling was presented to describe the sorption of textile dye, Direct Red 75 (DR75), from coloured wastewater onto the natural and modified adsorbent, Posidonia oceanica. The formulation of the double-layer model with two energy levels was based on statistical physics and theoretical considerations. Thanks to the grand canonical ensemble in statistical physics some physico-chemical parameters related to the adsorption process were introduced in the analytical model expression. Fitting results show that the dye molecules are adsorbed in parallel position to the adsorbent surface. The magnitudes of the calculated adsorption energies show that the DR75 dye is physisorbed onto Posidonia. Both Van der Waals and hydrogen interactions are implicated in the adsorption process. Despite its simplicity, the model fits a wide range of experimental data, thereby supporting the underlying data that the grafted groups facilitate the parallel anchorage of the anionic dye molecule. Thermodynamic parameters, such as adsorption energy, entropy, Gibbs free adsorption energy and internal energy were calculated according to the double-layer model. Results suggested that the DR75 adsorption onto Posidonia was a spontaneous and exothermic process.     

Potential use of Caulerpa fastigiata biomass for removal of lead: kinetics, isotherms, thermodynamic, and characterization studies

The present study attempts to analyze the biosorption trend of biosorbent Caulerpa fastigiata (macroalgae) biomass for removal of toxic heavy metal ion Pb (II) from solution as a function of initial metal ion concentration, pH, temperature, sorbent dosage, and biomass particle size. The sorption data fitted with various isotherm models and Freundlich model was the best one with correlation coefficient of 0.999. Kinetic study results revealed that the sorption data on Pb (II) with correlation coefficient of 0.999 can best be represented by pseudo-second-order. The biosorption capacity (q _e ) of Pb (II) is 16.11?±?0.32 mg g^?1 on C. fastigiata biomass. Thermodynamic studies showed that the process is exothermic (ΔH° negative). Free energy change (ΔG°) with negative sign reflected the feasibility and spontaneous nature of the process. The SEM studies showed Pb (II) biosorption on selective grains of the biosorbent. The FTIR spectra indicated bands corresponding to –OH, COO^?, –CH, C?=?C, C?=?S, and –C–C– groups were involved in the biosorption process. The XRD pattern of the C. fastigiata was found to be mostly amorphous in nature.