Interlaboratory evaluation of endotoxin analyses in agricultural dusts--comparison of LAL assay and mass spectrometry

Endotoxin exposure is associated with wheeze and asthma morbidity, while early life exposure may reduce risk of allergy and asthma. Unfortunately, it is difficult to compare endotoxin results from different laboratories and environments. We undertook this study to determine if lipopolysaccharide (LPS) extraction efficiency could account for differences among laboratories. We generated and collected aerosols from chicken and swine barns, and corn processing. We randomly allocated side-by-side filter samples to five laboratories for Limulus assay of endotoxin. Lyophilized aliquots of filter extracts were analyzed for 3-hydroxy fatty acids (3-OHFAs) as a marker of LPS using gas chromatography-mass spectrometry. There were significant differences in endotoxin assay and GC-MS (LPS) results between laboratories for all dust types (p < 0.01). Patterns of differences between labs varied by dust type. Relationships between assay and GC/MS results also depended on dust type. The percentages of individual 3-OHFA chain lengths varied across labs (p < 0.0001) suggesting that each lab recovered a different fraction of the LPS available. The presence of large amounts of particle associated LPS and absence of a freezing thawing cycle were associated with lower correlations between LPS and bioactivity, consistent with an absence of Limulus response to cell-bound endotoxin. These data suggest that extraction methods affect endotoxin measurements. The LAL methods may be most suitable when comparing exposures within similar environments; GC-MS offers additional information helpful in optimizing sample treatment and extraction. GC-MS may be of use when comparing across heterogeneous environments and should be considered for inclusion in future studies of human health outcomes.     

Microwave extraction of incurred salinomycin from chicken tissues

Abstract

A rapid, accurate, environmentally friendly and cost‐effective microwave extraction technique was developed for the extraction of spiked and incurred salmomycin from chicken tissues (kidney, liver, muscle, ovarian yolk and fat). Extraction of salinomycin from various tissues was achieved by irradiating the sample in absolute ethanol and 2‐propanol (15+2) for 9 sec. in a common household microwave oven. The extract was analysed without further cleanup by HPLC on a C₁₈ column (5 μm) and detected at 592 nm via post‐column reaction with 4‐dimethylaminobenzaldehyde (DMABA) in a heated reactor coil at 86° C. Recoveries of salinomycin from spiked tissues at 30 ng/g level ranged between 87 and 100%. The limit of quantitation was found to be 10 ng/g. The developed method was applied for the analysis of incurred tissues and ovarian yolk of laying chickens given sodium salinomycin in feed at different levels for 14 consecutive days followed by withdrawal periods. Residues were detected in all tissues and ovarian yolk at 0 withdrawal time but declined during the withdrawal period. Highest residue were found in fat and ovarian yolk.     

Synthesis of isotopically modified ZnO nanoparticles and their potential as nanotoxicity tracers

Understanding the behavior of engineered nanoparticles in the environment and within organisms is perhaps the biggest obstacle to the safe development of nanotechnologies. Reliable tracing is a particular issue for nanoparticles such as ZnO, because Zn is an essential element and a common pollutant thus present at elevated background concentrations. We synthesized isotopically enriched (89.6%) with a rare isotope of Zn (⁶⁷Zn) ZnO nanoparticles and measured the uptake of ⁶⁷Zn by L. stagnalis exposed to diatoms amended with the particles. Stable isotope technique is sufficiently sensitive to determine the uptake of Zn at an exposure equivalent to lower concentration range (<15 μg g⁻¹). Without a tracer, detection of newly accumulated Zn is significant at Zn exposure concentration only above 5000 μg g⁻¹ which represents some of the most contaminated Zn conditions. Only by using a tracer we can study Zn uptake at a range of environmentally realistic exposure conditions.     

Emission factors and exposures from ground-level pyrotechnics

Potential exposures from ground-level pyrotechnics were assessed by air monitoring and developing emission factors. Total particulate matter, copper and SO₂ exposures exceeded occupational health guidelines at two outdoor performances using consumer pyrotechnics. Al, Ba, B, Bi, Mg, Sr, Zn, and aldehyde levels were elevated, but did not pose a health hazard based on occupational standards. Emission factors for total particulate matter, metals, inorganic ions, aldehydes, and polyaromatic hydrocarbons (PAHs) were determined for seven ground-supported pyrotechnics through air sampling in an airtight room after combustion. Particle generation ranged from 5 to 13% of the combusted mass. Emission factors (g Kg^?1) for metals common to pyrotechnics were also high: K, 23–45; Mg, 1–7; Cu, 0.05–7; and Ba, 0.03–6. Pb emission rates of 1.6 and 2.7% of the combusted mass for two devices were noteworthy. A high correlation (r² ≥ 0.89) between metal concentrations in pyrotechnic compositions and emission factors were noted for Pb, Cr, Mg, Sb, and Bi, whereas low correlations (r² ≤ 0.1) were observed for Ba, Sr, Fe, and Zn. This may be due to the inherent heterogeneity of multi-effect pyrotechnics. The generation of inorganic nitrogen in both the particulate (NO₂^?, NO₃^?) and gaseous (NO, NO₂) forms varied widely (<0.1–1000 mg Kg^?1). Aldehyde emission factors varied by two orders of magnitude even though the carbon source was carbohydrates and charcoal for all devices: formaldehyde (<7.0–82 mg Kg^?1), acetaldehyde (43–210 mg Kg^?1), and acrolein (1.9–12 mg Kg^?1). Formation of lower molecular weight PAHs such as naphthalene and acenaphthylene were favored, with their emission factors being comparable to that from the combustion of household refuse and agricultural debris. Ba, Sr, Cu, and Pb had emission factors that could produce exposures exceeding occupational exposure guidelines. Sb and unalloyed Mg, which are banned from consumer fireworks in the US, were present in significant amounts.     

中国煤中氟的含量及其分布

在全国主要产煤的26个省、市和自治区根据各煤田的地质储量、成煤时期和煤变质程度,兼顾各矿区的煤炭产量,采集305个煤样,用高温热水解-离子选择性电极法测定了全部样品的氟含量.煤中的氟主要以无机形态赋存,氟含量和变质程度之间没有必然的联系.成煤时代等单一因素对氟含量的影响可能为其它各种因素的综合作用所掩盖,对此有必要进行更深入、具体的研究研究了各省、市和自治区的煤氟含量的分布,有必要重新审视、甄别燃煤型氟中毒区氟的来源.全国煤的氟含量服从对数正态分布,90%的样品含氟范围为47～347mg/kg,宜用几何平均值136mg/kg作为全国平均煤氟含量.与世界煤相比,中国煤氟含量并无异常.     

Investigation of pathogenic Escherichia coli and microbial pathogens in pulp and paper mill biosolids.

Biosolids produced from pulp and paper mill wastewater treatment have excellent properties as soil conditioners, but often contain high levels of Escherichia coli. E. coli are commonly used as indicators of fecal contamination and health hazard; therefore, their presence in biosolids causes concern and has lead to restrictions in land-spreading. The objectives of this study were to determine the following: (1) if E. coli from the biosolids of a wastewater-free pulp and paper mill were enteric pathogens, and (2) if other waterborne microbial pathogens were present. E. coli were screened for heat-labile and heat-stable enterotoxin and verocytotoxin virulence genes using a polymerase chain reaction. Ten isolates were also screened for invasion-associated locus and invasion plasmid antigen H genes. None of the 120 isolates carried these genes. Tests for seven other microbial pathogens were negative. Effluents and biosolids from this mill do not contain common microbial pathogens and are unlikely to pose a health hazard.