低浓度臭氧在含钴盐硅胶上的吸附研究

常压下对含钴盐硅胶进行低浓度臭氧的吸附实验，吸附达到饱和后用氮气作为载气加热解吸。结果显示，含钴盐的硅胶对臭氧具有较强的吸附能力；臭氧解吸量随着解吸温度的上升而增加；吸附了臭氧的含钴硅胶粒子在常温(313．15K)下可在60min内不问断解吸出臭氧。     

Formation of mutagens by photolysis of amino acids in neutral aqueous solution containing nitrite or nitrate ion

Nine amino acids, i.e., alanine, threonine, cysteine, glutamic acid, arginine, proline, tryptophan, phenylalanine and tyrosine, were irradiated with UV light in water containing nitrite or nitrate ion under neutral conditions. The mutagenicities of the ether extracts and the residual water layers of the reaction mixtures were assayed with and without S-9 mix using $\text{Salmonella typhimurium}$ TA98 and TA100. Three aromatic amino acids, tryptophan, phenylalanine and tyrosine, were found to give direct-acting and frameshift mutagens by irradiation in aqueous nitrite solution. Among them, the ether extract of tryptophan exhibited the strongest mutagenicity toward TA98. In the case of irradiation in aqueous nitrate solution, only the ether extract of tryptophan exhibited weak mutagenicity toward TA98 without S-9 mix. The effects of nitrite concentration, irradiation time and pH on mutagen formation from tryptophan and some characteristics of the produced mutagens were examined.     

CDNA microarray assessment for ozone-stressed Arabidopsis thaliana

Various detrimental factors in the environment damage plants, resulting in growth inhibition or withering. However, it is not easy to identify causal factors by visually inspecting the damaged plants. Therefore, we have developed a sensitive and reliable method for plant diagnosis, based on measuring changes in expression of a set of genes in a DNA microarray. With this method, we have been able to detect and discriminate between plants stressed by ozone, drought, or wounding.     

Variation in CO2 assimilation rate induced by simulated dew waters with different sources of hydroxyl radical (*OH) on the needle surfaces of Japanese red pine (Pinus densifora Sieb. et Zucc.)

The hydroxyl radical (*OH) is generated in polluted dew on the needle surfaces of Japanese red pine (Pinus densiflora Sieb. et Zucc.). This free radical, which is a potent oxidant, is assumed to be a cause of ecophysiological disorders of declining trees on the urban-facing side of Mt. Gokurakuji, western Japan. Mists of *OH-generating N(III) (HNO2 and NO2-) and HOOH + Fe + oxalate solutions (50 and 100 microM, pH 5.1-5.4) simulating the dew water were applied to the foliage of pine seedlings grown in open-top chambers in the early morning. Needles treated with 100 microM N(III) tended to have a greater maximum CO2 assimilation rate (Amax), a greater stomatal conductance (g(s)) and a greater needle nitrogen content (Nneedle), suggesting that N(III) mist acts as a fertilizer rather than as a phytotoxin. On the other hand, needles treated with 100 microM HOOH + Fe + oxalate solution showed the smallest Amax, g(s), and Nneedle, suggesting that the combination of HOOH + Fe + oxalate caused a decrease in needle productivity. The effects of HOOH + Fe + oxalate mist on pine needles were very similar to the symptoms of declining trees at Mt. Gokurakuji.     

Leaching characteristics of stabilized/solidified fly ash generated from ash-melting plant

This study was designed to elucidate the leaching characteristics of stabilized/solidified (S/S) fly ash generated by ash-melting. For this study, pH-dependent leaching tests, sequential extraction procedures, and column leaching tests were carried out. The pH-dependent leaching test results for Pb, Cu, and Zn showed that the heavy metal concentrations in the high-pH range were lower than the predicted values for hydroxide and carbonate. During sequential extraction, Cu and Pb were principally distributed in the S/S ashes' organic matter fraction in the chelating agent, suggesting that metals bind to the chelating agent. The percentage of the water-soluble fraction for Pb and Cu was low (<0.2 %). The fly ashes treated with a chelating agent and cement had low leachability potential for metals in the high-pH range. Column tests for S/S fly ashes showed that two leaching stages were distinguishable: one for short time, corresponding to faster metal leaching, and another for the leaching rate. Kinetic speciation was then applied to data obtained from column leaching tests. The first-order reaction/diffusion model showed a better fit for Ca, Pb, and Cu, suggesting that the initial dissolution of soluble compounds, such as metal chloride, was controlled by the first-order reaction (surface wash off). Subsequently, insoluble compounds such as hydroxide or carbonate might penetrate into the porous matrix by diffusion.     

Improvement of an efficient separation method for chemicals in diesel exhaust particles: analysis for nitrophenols

GOAL, SCOPE, AND BACKGROUND: Diesel exhaust is believed to consist of thousands of organic constituents and is a major cause of urban pollution. We recently reported that a systematic separation procedure involving successive solvent extractions, followed by repeated column chromatography, resulted in the isolation of vasodilatory active nitrophenols. These findings indicated that the estimation of the amount of nitrophenols in the environment is important to evaluate their effect on human health. The isolation procedure, however, involved successive solvent extractions followed by tedious, repeated chromatography, resulting in poor fractionation and in a significant loss of accuracy and reliability. Therefore, it was crucial to develop an alternative, efficient, and reliable analytical method. Here, we describe a facile and efficient acid-base extraction procedure for the analysis of nitrophenols. MATERIALS AND METHODS: Diesel exhaust particles (DEP) were collected from the exhaust of a 4JB1-type engine (ISUZU Automobile Co., Tokyo, Japan). Gas chromatography-mass spectrometry (GC-MS) analysis was performed with a GCMS-QP2010 instrument (Shimadzu, Kyoto, Japan). RESULTS: A solution of DEP in 1-butanol was extracted with aqueous NaOH to afford a nitrophenol-rich oily extract. The resulting oil was methylated with trimethylsilyldiazomethane and subsequently subjected to GC-MS analysis, revealing that 4-nitrophenol, 3-methyl-4-nitrophenol, 2-methyl-4-nitrophenol, and 4-nitro-3-phenylphenol were present in significantly higher concentrations than those reported previously. DISCUSSION: Simple acid-base extraction followed by the direct analysis of the resulting extract by GC-MS gave only broad peaks of nitrophenols with a poor detection limit, while the GC-MS analysis of the sample pretreated with (trimethylsilyl)diazomethane gave satisfactorily clear chromatograms with sharp peaks and with a significantly lowered detection limit (0.5 ng/ml, approximately 100 times). CONCLUSION: The present method involving an acid-base extraction, in situ derivatization, and GC-MS analysis has shown to be a simple, efficient, and reliable method for the isolation and identification of the chemical substances in DEP.     

Spatial distribution and loading amounts of particle sorbed and dissolved perfluorinated compounds in the basin of Tokyo Bay

In this study, we analyzed over 30 types of PFCs, including precursors in both the dissolved phase and particle solid phase, in 50 samples of river water collected from throughout the Tokyo Bay basin. PFCs were detected in suspended solids (SSs) at levels ranging from <0.003-4.4 ng L(-1) (0.11-2470 ng g(-1) dry weight). The concentrations of PFCs in the SS were one to two order(s) of magnitude lower than those of PFCs in the dissolved phase. Relatively high levels of PFCs (total of 35 PFCs) in SS were observed in urbanized areas. The concentration of PFCAs, including PFOA and PFNA, were significantly correlated with the geographic index as artificial area (R(2) of the linear regression curve in a double logarithmic plot: 0.09-0.55). Conversely, PFOS and FOSA were significantly correlated with the arterial traffic area (R(2) in a double logarithmic plot: 0.29-0.55). Those spatial trends were similar to the trends in dissolved PFCs. We estimated the loading amount of PFCs into Tokyo Bay from six main rivers and found that more than 90% of the total PFCs reached Tokyo Bay in the dissolved phase. However, 40.0-83.5% of the long chain PFCAs (C12-C15), were transported as particle sorbed PFCs. Rain runoff events might increase the loading amount of PFCs in SS. Overall, the results presented herein indicate that greater attention should be given to PFCs, especially for longer chain PFCs in SS in addition to dissolved PFCs.     

Anthropogenic radionuclides in the Japan Sea: their distributions and transport processes

The anthropogenic radionuclides, (90)Sr, (137)Cs and (239+240)Pu, were measured in the water column of the Japan Sea/East Sea during 1997-2000. The vertical profiles of radionuclide concentrations showed: exponential decrease with depth for (90)Sr and (137)Cs, and surface minimum/subsurface maximum for (239+240)Pu. These results do not differ substantially from results reported previously. The area-averaged concentrations of radionuclides in the Japan Sea are higher than those found in the Northwest Pacific Ocean below surface layer showing the accumulation of the radionuclides in the deep waters in the Japan Sea. Concerning spatial distributions, the area of high (137)Cs inventory extends from the Japan Basin into the Yamato Basin. It is suggested that wintertime convection of water, occurring mainly in the Japan Basin, causes the radionuclides to sink. The nuclides then advect into the Yamato Basin after detouring around the Yamato Rise.     

Decomposition of poly(amide-imide) film enameled on solid copper wire using atmospheric pressure non-equilibrium plasma

The decomposition of a poly(amide-imide) thin film coated on a solid copper wire was attempted using atmospheric pressure non-equilibrium plasma. The plasma was produced by applying microwave power to an electrically conductive material in a gas mixture of argon, oxygen, and hydrogen. The poly(amide-imide) thin film was easily decomposed by argon-oxygen mixed gas plasma and an oxidized copper surface was obtained. The reduction of the oxidized surface with argon-hydrogen mixed gas plasma rapidly yielded a metallic copper surface. A continuous plasma heat-treatment process using a combination of both the argon-oxygen plasma and argon-hydrogen plasma was found to be suitable for the decomposition of the poly(amide-imide) thin film coated on the solid copper wire.