Occurrence of phenols in leachates from municipal solid waste landfill sites in Japan

The concentrations of 41 phenols in leachates from 38 municipal solid waste (MSW) landfill sites in Japan were measured. The main phenols detected in leachates were phenol, three cresols, 4-tert-butylphenol, 4-tertoctylphenol, 4-nonylphenol, bisphenol A, and some chlorophenols. The concentration levels of phenols were affected by the pH values of the leachates and the different types of landfill waste. The origins of phenol and p-cresol were considered to be incineration residues, and the major origin of 4-tert-butylphenol, bisphenol A, and 2,4,6-trichlorophenol was considered to be solidified fly ash. In contrast, the major origins of 4-tert-octylphenol and 4-nonylphenol were considered to be incombustibles. The discharge of leachates to the environment around MSW landfill sites without water treatment facilities can cause environmental pollution by phenols. In particular, the disposal of incineration residues including solidified fly ash and the codisposal of solidified fly ash and incombustibles might raise the possibility of environmental pollution. Moreover, the discharge of leachates at pH values of 9.8 or more could pollute the water environment with phenol. However, phenol, 4-nonylphenol, and bisphenol A can be removed to below the con centration levels that impact the environment around landfill sites by a series of conventional water treatment processes.     

Leaching characteristics of stabilized/solidified fly ash generated from ash-melting plant

This study was designed to elucidate the leaching characteristics of stabilized/solidified (S/S) fly ash generated by ash-melting. For this study, pH-dependent leaching tests, sequential extraction procedures, and column leaching tests were carried out. The pH-dependent leaching test results for Pb, Cu, and Zn showed that the heavy metal concentrations in the high-pH range were lower than the predicted values for hydroxide and carbonate. During sequential extraction, Cu and Pb were principally distributed in the S/S ashes' organic matter fraction in the chelating agent, suggesting that metals bind to the chelating agent. The percentage of the water-soluble fraction for Pb and Cu was low (<0.2 %). The fly ashes treated with a chelating agent and cement had low leachability potential for metals in the high-pH range. Column tests for S/S fly ashes showed that two leaching stages were distinguishable: one for short time, corresponding to faster metal leaching, and another for the leaching rate. Kinetic speciation was then applied to data obtained from column leaching tests. The first-order reaction/diffusion model showed a better fit for Ca, Pb, and Cu, suggesting that the initial dissolution of soluble compounds, such as metal chloride, was controlled by the first-order reaction (surface wash off). Subsequently, insoluble compounds such as hydroxide or carbonate might penetrate into the porous matrix by diffusion.     

Investigation of 1,4-dioxane originating from incineration residues produced by incineration of municipal solid waste

As a groundwater contaminant, 1,4-dioxane is of considerable concern because of its toxicity, refractory nature to degradation, and rapid migration within an aquifer. Although landfill leachate has been reported to contain significant levels of 1,4-dioxane, the origin of 1,4-dioxane in leachate has not been clarified until now. In this study, the origins of 1,4-dioxane in landfill leachate were investigated at 38 landfill sites and three incineration plants in Japan. Extremely high levels of 1,4-dioxane 89 and 340 microg l(-1), were detected in leachate from two of the landfill sites sampled. Assessments of leachate and measurement of 1,4-dioxane in incineration residues revealed the most likely source of 1,4-dioxane in the leachate to be the fly ash produced by municipal solid waste incinerators. Effective removal of 1,4-dioxane in leachate from fly ash was achieved using heating dechlorination systems. Rapid leaching of 1,4-dioxane observed from fly ash in a sequential batch extraction indicated that the incorporation of a waste washing process could also be effective for the removal of 1,4-dioxane in fly ash.     

Male scent-marking pheromone of <Emphasis Type="Italic">Bombus ardens ardens</Emphasis> (Hymenoptera; Apidae) attracts both conspecific queens and males

To explore the role of the volatiles emitted from male labial gland (LG) of the bumblebee Bombus ardens ardens, we investigated the responses of virgin queens and males to volatiles using a gas chromatography–electroantennographic detector (GC–EAD) system and Y-tube olfactometer. GC–EAD analysis revealed that citronellol, the main compound detected in the male LG, caused clear electrophysiological responses in the antennae of B. a. ardens virgin queens and males although two minor compounds elicited antennal responses when applied in a high concentration. Behavioral tests using a Y-tube olfactometer showed that queens and males were significantly attracted to both LG extracts and citronellol more than to the solvent alone. This is the first study to demonstrate that citronellol as a major compound of male scent-marking pheromone in B. a. ardens functions as a sex attractant for queens. The results also suggest that this compound has another function as a trail marker used by males.     

Effectiveness of resistivity monitoring for interpreting temporal changes in landfill properties

It is always possible for impermeable layers to exist in landfills. When they do, the properties of the solution at the exit of the leachate-collection system might not accurately reflect the overall properties of the landfill. This study examines whether resistivity monitoring is effective for determining the influence of impermeable layers on the leachate. The test cell used in this study was filled with waste made up mainly of incinerator ash and shredded incombustible material. Three lines of resistivity sensors were laid in the uppermost layer of the fill. A resistivity profile was recorded periodically from each of these lines. The water-table level and leachate properties were measured concurrently. Leachate conductivity was mainly controlled by concentrations of the main ions, and it correlated inversely to variations in resistivity. Temporal changes in the resistivity of the fills are an excellent means of assessing the leaching in fills. Monitoring the properties of leachate, combined with resistivity profiling, is extremely useful for interpreting the temporal changes of properties in landfills containing impermeable layers.     

Application of a combined measurement and modeling method to quantify windblown dust emissions from the exposed playa at Mono Lake, California

Particulate matter < or =10 microm (PM10) emissions due to wind erosion can vary dramatically with changing surface conditions. Crust formation, mechanical disturbance, soil texture, moisture, and chemical content of the soil can affect the amount of dust emitted during a wind event. A refined method of quantifying windblown dust emissions was applied at Mono Lake, CA, to account for changing surface conditions. This method used a combination of real-time sand flux monitoring, ambient PM10 monitoring, and dispersion modeling to estimate dust emissions and their downwind impact. The method identified periods with high emissions and periods when the surface was stable (no sand flux), even though winds may have been high. A network of 25 Cox sand catchers (CSCs) was used to measure the mass of saltating particles to estimate sand flux rates across a 2-km2 area. Two electronic sensors (Sensits) were used to time-resolve the CSC sand mass to estimate hourly sand flux rates, and a perimeter tapered element oscillating microbalance (TEOM) monitor measured hourly PM10 concentrations. Hourly sand flux rates were related by dispersion modeling to hourly PM10 concentrations to back-calculate the ratio of vertical PM10 flux to horizontal sand flux (K-factors). Geometric mean K-factor values (K(f)) were found to change seasonally, ranging from 1.3 x 10(-5) to 5.1 x 10(-5) for sand flux measured at 15 cm above the surface (q15). Hourly PM10 emissions, F, were calculated by applying seasonal K-factors to sand flux measurements (F = K(f) x q15). The maximum hourly PM10 emission rate from the study area was 76 g/m2 x hr (10-m wind speed = 23.5 m/sec). Maximum daily PM10 emissions were estimated at 450 g/m2 x day, and annual emissions at 1095 g/m2 x yr. Hourly PM10 emissions were used by the U.S. Environmental Protection Agency (EPA) guideline AERMOD dispersion model to estimate downwind ambient impacts. Model predictions compared well with monitor concentrations, with hourly PM10 ranging from 16 to over 60,000 microg/m3 (slope = 0.89, R2 = 0.77).     

Effect of Aging on Brain Injury Prediction in Rotational Head Trauma—A Parameter Study with a Rat Finite Element Model

Objective: The aim of this study was to investigate the possible effects of age-related intracranial changes on the potential outcome of diffuse axonal injuries and acute subdural hematoma under rotational head loading.

Methods: A simulation-based parametric study was conducted using an updated and validated finite element model of a rat head. The validation included a comparison of predicted brain cortex sliding with respect to the skull. Further, model material properties were modified to account for aging; predicted tissue strains were compared with experimental data in which groups of rats in 2 different lifecycle stages, young adult and mature adult, were subjected to rotational trauma. For the parameter study, 2 age-dependent factors—brain volume and region-specific brain material properties—were implemented into the model. The models young adult and old age were subjected to several injurious and subinjurious sagittal plane rotational acceleration levels.

Results: Sequential analysis of the simulated trauma progression indicates that an increase in acute subdural hematoma injury risk indicator occurs at an early stage of the trauma, whereas an increase in diffuse axonal injury risk indicators occurs at a later stage. Tissue stiffening from young adult to mature adult rats produced an increase in strain-based thresholds accompanied by a wider spread of strain distribution toward the rear part of the brain, consistent with rotational trauma experiments with young adult and mature adult rats. Young adult to old age brain tissue softening and brain atrophy resulted in an increase in diffuse axonal injuries and acute subdural hematoma injury risk indicators, respectively.

Conclusions: The findings presented in this study suggest that age-specific injury thresholds should be developed to enable the development of superior restraint systems for the elderly. The findings also motivate other further studies on age-dependency of head trauma.     

Assessment of pesticide residues in freshwater areas affected by rice paddy effluents in Southern Japan

Pesticide residues in five freshwater areas that are directly affected by rice paddy effluents in southern Japan were measured to determine their maximum concentrations and temporal variations. Water samples were collected every week during the 2005 rice planting season in Kagoshima Prefecture and stations were established in Amori River, Sudo River, Nagaida River (that drains into the bigger Kotsuki River), rice paddy drainage canal, and wastewater reservoir (that collects effluents from rice paddy fields). Of the 14 target pesticides examined, a total of 11 were detected in all stations. Mefenacet, fenobucarb, and flutolanil were the three pesticides with the highest maximum concentrations and were also detected frequently. Analysis of temporal variations of pesticides showed that herbicides had relatively higher concentrations in the earlier stages of the rice planting season, while insecticides and fungicides had relatively higher concentrations at the later stages. There was no significant difference among stations with regards to the temporal patterns of the top three pesticides. The calculated toxic units were less than 1 in all stations, implying low or negligible environmental risk of pesticides detected to freshwater organisms.     

Systematic biases in measured PM10 values with U.S. Environmental Protection Agency-approved samplers at Owens Lake, California

From 1993 through 1998, Wedding or Graseby high-volume PM10 samplers were collocated with tapered element oscillating microbalance (TEOM) samplers at three sites at Owens Lake, CA. The study area is heavily impacted by windblown dust from the dry Owens Lake bed, which was exposed as a result of water diversions to the city of Los Angeles. A dichotomous (dichot) sampler and three collocated Partisol samplers were added in 1995 and 1999, respectively. U.S. Environmental Protection Agency (EPA) operating procedures were followed for all samplers, except for a Wedding sampler that was not cleaned for the purpose of this study. On average, the TEOM and Partisol samplers agreed to within 6%, and the dichot, Graseby, and Wedding samplers measured lower PM10 concentrations by about 10, 25, and 35%, respectively. Surprisingly, the "clean" Wedding sampler consistently measured the same concentration as the "dirty" Wedding sampler through 85 runs without cleaning. The finding that the Graseby and Wedding high-volume PM10 samplers read consistently lower than the TEOM, Partisol, and dichot samplers at Owens Lake is consistent with PM10 sampler comparisons done in other fugitive dust areas, and with wind tunnel tests showing that sampler cut points can be significantly lower than 10 microns under certain conditions. However, these results are opposite of the bias found for TEOM samplers in areas that have significant amounts of volatile particles, where the TEOM reads low due to the vaporization of particles on the TEOM's heated filter. Coarse particles like fugitive dust are relatively unaffected by the filter temperature. This study shows that in the absence of volatile particles and in the presence of fugitive dust, a different systematic bias of up to 35% exists between samplers using dichot inlets and high-volume samplers, which may cause the Graseby and Wedding PM10 samplers to undermeasure PM10 by up to 35% when the PM10 is predominantly from coarse particulate sources.