Concentration of trace elements in feathers of waterfowl,Korea

Cadmium (Cd), lead (Pb), chromium (Cr), copper (Cu), manganese (Mn), zinc (Zn), and iron (Fe) were analyzed in the breast feather of white-fronted geese (Anser albifrons, n?=?15), mallards (Anas platyrhynchos, n?=?4), and spot-billed ducks (Anas poecilorhyncha, n?=?13) found dead in Gimpo, Korea. All of the mallards and eight of the 13 spot-billed ducks had embedded shot. Concentrations of Pb, Cr, Cu, Mn, Zn, and Fe were significantly different among waterfowl species. Mallards with embedded shot had relatively higher Pb, Cr, Mn, and Fe concentrations than the other species. Cd and Cr in feathers of waterfowl species were within the range reported for other birds, and no specimen exceeded the tentative threshold effect levels of Cd (2 μg/g dry weight (dw)) and Cr (2.8 μg/g dw) for birds. However, Pb in feathers of all four mallards and two spot-billed ducks exceeded the threshold for deleterious effects (>4 μg/g dw). Essential elements such as Cu, Mn, Zn, and Fe in the feather of waterfowl species were not at toxic levels and within the background or normal range for the homeostatic mechanisms.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Hydro-thermal reaction according to the CaO/SiO2 mole-ratio in silico-manganese slag

Journal of Material Cycles and Waste Management - SiMn slag is a by-product of the production of ferroalloy, and has a chemical composition that could be used as a cement admixture. It is not...     

Lead and cadmium contaminations in feathers of heron and egret chicks

In birds, concentrations of heavy metal contaminants were associated with their diet and environmental quality. This study presents concentrations of lead and cadmium in feathers and the relationship between concentrations in the feather and stomach content of three species of heron and egret chicks. Cadmium concentrations were higher in the Little Egret (geomean 0.75 μg/g dry weight) and Black-crowned Night Heron (geomean 0.88 μg/g dry weight) chicks than in Grey Heron chicks (geomean 0.48 μg/g dry weight). Lead and cadmium concentrations had significant correlations between feathers and stomach contents of heron and egret chicks. The mean lead and cadmium concentrations in feathers were within the background levels for wild birds. Heron and egret species forage around breeding colony (4–7 km). Lead and cadmium concentrations in heron and egret chicks were moderately associated with those of prey concentrations. These results suggest that contaminant concentrations such as lead and cadmium in feathers of heron and egret chicks can reflect local heavy metal contaminations and serve as a great biological indicator for monitoring heavy metal contamination. In addition, the feathers can be a routine monitoring tool over time and space without harming the wild birds.     

Analysis of underlying causes of investigated loss of containment incidents in Dutch Seveso plants using the Storybuilder method

In the Netherlands there are around 400 “Seveso” sites that fall under the Dutch Major Hazards Decree (BRZO) 1999. Between 2006 and 2010 the Dutch Labour Inspectorate's Directorate for Major Hazard Control completed investigations of 118 loss of containment incidents involving hazardous substances from this group. On the basis of investigation reports the incidents were entered in a tailor-made tool called Storybuilder developed for the Dutch Ministry of Social Affairs and Employment for identifying the dominant patterns of technical safety barrier failures, barrier task failures and underlying management causes associated with the resulting loss of control events. The model is a bow-tie structure with six lines of defence, three on either side of the central loss of containment event. In the first line of defence, failures in the safety barriers leading to loss of control events were primarily equipment condition failures, pre start-up and safeguarding failures and process deviations such as pressure and flow failures. These deviations, which should have been recovered while still within the safe envelope of operation, were missed primarily because of inadequate indication signals that the deviations have occurred. Through failures of subsequent lines of defence they are developing into serious incidents. Overall, task failures are principally failures to provide adequate technical safety barriers and failures to operate provided barriers appropriately. Underlying management delivery failures were mainly found in equipment specifications and provisions, procedures and competence. The competence delivery system is especially important for identifying equipment condition, equipment isolation for maintenance, pre-start-up status and process deviations. Human errors associated with operating barriers were identified in fifty per cent of cases, were mostly mistakes and feature primarily in failure to prevent deviations and subsequently recover them. Loss of control associated with loss of containment was primarily due to the containment being bypassed (72% of incidents) and less to material strength failures (28%). Transfer pipework, connections in process plant and relief valves are the most frequent release points and the dominant release material is extremely flammable. It is concluded that the analysis of a large number of incidents in Storybuilder can support the quantification of underlying causes and provide evidence of where the weak points exist in major hazard control in the prevention of major accidents.     

Investigations of ash fouling with cattle wastes as reburn fuel in a small-scale boiler burner under transient conditions

Fouling behavior under reburn conditions was investigated with cattle wastes (termed as feedlot biomass [FB]) and coal as reburn fuels under a transient condition and short-time operation. A small-scale (30 kW or 100,000 Btu/hr) boiler burner research facility was used for the reburn experiments. The fuels considered for these experiments were natural gas (NG) for the ashless case, pure coal, pure FB, and blends of coal and FB. Two parameters that were used to characterize the ash "fouling" were (1) the overall heat-transfer coefficient (OHTC) when burning NG and solid fuels as reburn fuels, and (2) the combustible loss through ash deposited on the surfaces of heat exchanger tubes and the bottom ash in the ash port. A new methodology is presented for determining ash-fouling behavior under transient conditions. Results on the OHTCs for solid reburn fuels are compared with the OHTCs for NG. It was found that the growth of the layer of ash depositions over longer periods typically lowers OHTC, and the increased concentration of ash in gas phase promotes radiation in high-temperature zones during initial periods while decreasing the heat transfer in low-temperature zones. The ash analyses indicated that the bottom ash in the ash port contained a smaller percentage of combustibles with a higher FB percentage in the fuels, indicating better performance compared with coal because small particles in FB burn faster and the FB has higher volatile matter on a dry ash-free basis promoting more burn out.     

Biological monitoring of heavy metal contaminations using owls

Iron, manganese, copper, lead and cadmium were measured in the livers, muscles, kidneys and bones of Eurasian Eagle Owls (Bubo bubo), Brown Hawk Owls (Nixos scutulata) and Collared Scops Owls (Otus lempiji) from Korea. Iron concentrations by tissue within species did not differ, but there were significant differences among tissues across all species. Manganese and copper concentrations in muscles, kidneys and bones, but not livers, differed among species and also differed among tissues in the three owl species. We suggest that manganese and copper concentrations from this study were far below the level associated with their toxicity. Lead concentrations significantly differed among all species for livers and bones, and among tissues for each species. Cadmium concentrations were significantly different among species for all tissues and among tissues in Eurasian Eagle Owls and Collared Scops Owls. For most samples, lead concentrations in livers and bones, and cadmium in livers and kidneys, were within the background levels for wild birds. For some Eurasian Eagle Owls and Collared Scops Owls, lead concentrations were at an acute exposure level, whilst lead concentrations were at a chronic exposure level in Brown Hawk Owls. Cadmium concentrations were at a chronic exposure level in all three owl species. Acute and chronic poisoning was significantly correlated between indicator tissues. We suggest that lead and cadmium contamination in Eurasian Eagle Owls may reflect a Korean source, Brown Hawk Owls may reflect Korean and wintering sites, and Collared Scops Owls may reflect breeding and/or wintering sites.     

Accumulation of butyl- and phenyltin compounds in starfish and bivalves from the coastal environment of Korea

Triphenyltin (TPT) and tributyltin (TBT) concentrations were determined in two starfish species (Asteria pectinifera and Asterias amurensis), bivalves (Crassostrea gigas or Mytilus edulis), and seawater samples from sites around the coasts of Korea. Both TPT and TBT concentrations in starfish ranged from 8 to 1560 ng/g and from <2 to 797 ng/g as Sn on a dry weight basis, respectively. TPT concentration accounted for 75.4% and 86.4% of total phenyltin concentration in A. pectinifera and A. amurensis, respectively, while monobutyltin, a degradation product of TBT, accounted for 86.3% and 57.2% of total butyltin, respectively. Triphenyltin concentrations in A. pectinifera were significantly correlated to water and bivalve TPT concentrations, which implies that dietary uptake of TPT from contaminated prey as well as direct uptake from surrounding water contribute to TPT body residues in the starfish. Starfish could be target organisms for monitoring TPT compound in the marine environment, due to their high accumulation and low degradation capacity towards TPT.     

Distribution of diatoms in the surficial sediments of the Mangyung-Dongjin tidal flat,west coast of Korea (Eastern Yellow Sea)

The relationship between the distribution of benthic diatoms and sediment characteristics of the Mangyung-Dongjin tidal flat on the west coast of Korea was investigated during June and July 1988. Diatoms were collected from the upper 5 mm of sediments at 60 sites along eight transect lines running perpendicular to the shore line. Of the 371 taxa encountered in the study area, 88% were pennate diatoms. Genera represented by the greatest number of species were Navicula, Nitzschia, Amphora, Cocconeis, Fragilaria and Achnanthes. The most abundant species were Paralia sulcata, Navicula sp. #1, N. arenaria and Cymatosira belgica; all were broadly distributed across the tidal flats. The 60 sites could be assigned to eight clusters with respect to similarity in species composition. Discriminant analysis showed that separation cluster was primarily related to the mean grain size of the sediment. The species could not be separated into groups based on similarities in occurrence; a high degree of spatial overlap was observed. The preferences of the more abundant species for grain size were, therefore, analysed by plotting numerical abundance against mean grain size. There were at least four patterns: species groups could be associated with finegrained sediments, those of intermediate size and coarser sediments and the last group showed no discernible pattern.