Adsorption and desorption characteristics of several herbicides on sediment

The objective of this study was to clarify the adsorption and desorption characteristics of several herbicides in sediment. Five herbicides, esprocarb, thiobencarb, dimethametryn, pretilachlor, and simetryn were examined in this study. The adsorption ratio on the sediment increased in the following order: pretilachlor < dimethametryn < simetryn < thiobencarb < esprocarb. On the other hand, the adsorption ratio on the sediment without organic matter increased in the following order: thiobencarb < esprocarb < pretilachlor < dimethametryn < simetryn. Furthermore, the amounts of simetryn, dimethametryn, and pretilachlor adsorbed on the sediment without organic matter increased, while those of esprocarb and thiobencarb decreased in comparison to the original sediment. These results strongly suggested that the mineral surface in the sediment was very important as the adsorption site for the herbicide, especially in the case of simetryn, dimethametryn, and pretilachlor. All the adsorption and desorption data fitted well with the Freundlich equation. The hysteresis in the adsorption-desorption phenomena in the sediment was observed for all the herbicides, and it was affected by the organic matter in sediment, especially in the case of dimethametryn and pretilachlor.     

Leachability of municipal solid waste ashes in simulated landfill conditions

In Japan the volume of municipal solid waste is reduced by incineration, with fly ash and bottom ash disposed in controlled landfills. The leachability of anions and heavy metal cations, Zn, Cu and Pb, from MSW fly ash and bottom ash at different pHs was examined using batch- and column-leaching tests. The MSW ashes had a high capacity for neutralizing acids. Behaviour during leaching depended on the pH of the solution. For the volumes applied, the leachabilities of MSW fly ash were very similar at pHs from 3 to 6. Due to its amphoteric nature, Pb is leachable at pHs of approximately 10 or more, with leachate concentrations of about 3 and 3-10mg/L for the fly ash and bottom ash, respectively, much higher than for Zn and Cu. Pb concentrations for most leaching solutions were 1 and 3mg/L for the fly ash and bottom ash, respectively. Zn, and Cu leached at low concentrations for solutions of pH 3-6. Na and K ions leached at high concentrations of approximately 5000 mg/L in the first batch leaching test, decreasing to 10mg/L by the fourth leach. Ca and Mg ions leached more gradually than Na and K. Cl(-) and SO(4)(2+) ions were the major anions in the MSW ash. The high pH and cation leaching are expected to have negative impacts on the performance of clay liners.     

Selection of palm oil mill effluent treatment for biogas generation or compost production using an analytic hierarchy process

Palm oil mill effluent (POME) is the liquid waste from palm oil mills, and is generally treated using open lagoon technology. However, open lagoons can also be combined with more environmentally friendly technologies. In this study, the analytic hierarchy process (AHP) was used to determine the best combination open lagoon of technology (COLT) for POME treatment. The selected criteria were benefit, opportunity, risk, and cost, with sub-criteria further determined based on these criteria. The sub-criteria were revenue, greenhouse gas reduction, employment absorption, corporate social responsibility, co-processing, environmental risk, marketing risk, technology reliability, investment cost, operation and maintenance cost, and opportunity cost. The alternatives were COLT-composting for fertilizer purpose and COLT-biogas for energy generation purpose. Calculation and analysis was performed on questionnaire data using Expert Choice^®. COLT-composting proved to be the superior COLT using tentative performance of alternative in this research, with advantages in benefit, opportunity, and risk. The priority weight for COLT-composting was 0.636. Sensitivity analysis was performed by changing criteria priorities. For COLT-biogas to be considered better than COLT-composting, the cost would need to be weighted more than 0.954.     

In situ gradostat for the study of a natural phytoplankton community with an experimental nutrient gradient

A new in situ gradostat was devised to study the dynamics of natural communities having nutrient gradients within aquatic habitats. This semi-enclosed mesocosm consisted of three components: i.e. three transparent, concentric cylindrical culture chambers, with diameters of 70, 60 and 40 cm, and 20 cm deep, supported by four flotation buoys, a medium reservoir, and a pump to supply the medium to the mesocosm. Water exchange between compartments was achieved via holes in the cylindrical walls, the number and size of the holes being chosen to regulate the rate of exchange. Sterile culture medium was pumped into the central (first) chamber and diffused outwards into the second and third chambers through the perforated walls. Suitable perforations could achieve a concentration gradient of up to 9.5 times between the first and third chambers within 12 h. The system was designed with the following characteristics: (1) an experimental semi-enclosed system in the natural environment; (2) to maintain equivalence with the external water except for the experimental factors; and (3) to form a manipulable gradient of experimental factors across the mesocosm. Using the in situ gradostat, the response of a natural phytoplankton community to a nitrate gradient was determined. A gradient from oligotrophic to eutrophic was maintained for 10 days in an oligotrophic pond. The mean growth rate of phytoplankton was lower in the eutrophic zone than that in the mesotrophic zone, where the highest mean growth rate was observed. The growth rate of each dominant phytoplankter showed its own pattern, but all rates were highest in the mesotrophic environment of the second chamber.     

A numerical study of summer ozone concentration over the Kanto area of Japan using the MM5/CMAQ model

We assessed the ability of the MM5/CMAQ model to predict ozone (O3) air quality over the Kanto area and to investigate the factors that a ect simulation of O3. We find that the coupled MM5/CMAQ model is a useful tool for the analysis of urban environmental problems. The simulation results were compared with observational data and were found to accurately replicate most of the important observed characteristics. The initial and boundary conditions were found to have a significant e ect on simulated O3 concentrations. The results show that on hot and dry days with high O3 concentration, the CMAQ model provides a poor simulation of O3 maxima when using initial and boundary conditions derived from the CMAQ default data. The simulation of peak O3 concentrations is improved with the JCAP initial and boundary conditions. On mild days, the default CMAQ initial and boundary conditions provide a more realistic simulation. Meteorological conditions also have a strong impact on the simulated distribution and accumulation of O3 concentrations in this area. Low O3 concentrations are simulated during mild weather conditions, and high concentrations are predicted during hot and dry weather. By investigating the e ects of di erent meteorological conditions on each model process, we find that advection and di usion di er the most between the two meteorological regimes. Thus, di erences in the winds that govern the transport of O3 and its precursors are likely the most important meteorological drivers of ozone concentration over the central Kanto area.     

Evaluation of current material stock and future demolition waste for urban residential buildings in Jakarta and Bandung,Indonesia: embodied energy and CO<Subscript>2</Subscript> emission analysis

First, this paper evaluates the current building material stock and future demolition waste for urban residential buildings in the cities of Jakarta and Bandung using a material-flow analysis. The actual on-site building measurements were conducted in Jakarta (2012) and Bandung (2011), focusing particularly on unplanned houses, to obtain building material inventory data. A total of 297 houses were investigated in Jakarta, whereas 247 houses were measured in Bandung. Second, this paper analyses the embodied energy and CO₂ emissions of building materials through an input–output analysis. The results show that, overall, the total material input intensity for the houses is 2.67 ton/m² in Jakarta and 2.54 ton/m² in Bandung. Two scenarios with zero and maximum reuse/recycling rates were designed to predict future demolition waste and the embodied energy/CO₂ emissions of building materials in Jakarta. Closed- and open-loop material flows were applied. If the maximum reuse/recycling rates are applied to the closed- and open-loop material flows in Jakarta, then it would become possible to not only decrease the final disposal waste (from 123.9 to 2.1 million ton) but also reduce the corresponding embodied energy (from 247.8 to 192.1 PJ) and CO₂ emissions (from 24.3 to 19.2 million ton CO₂-eq) compared with the zero reuse/recycling scenario from 2012 to 2020.     

Degree-day accumulation controlling allopatric and sympatric variations in the sociality of sweat bees, <Emphasis Type="Italic">Lasioglossum</Emphasis> (<Emphasis Type="Italic">Evylaeus</Emphasis>) <Emphasis Type="Italic">baleicum</Emphasis> (Hymenoptera: Halictidae)

Halictine bees exhibit a wide range of social behaviour that varies both inter- and intraspecifically. Although previous studies suggested that the intraspecific variation might be attributed to temperature differences, there was no direct evidence to detect the relationships between temperature and socialities. Lasioglossum (Evylaeus) baleicum exhibited solitary behaviour in a cooler locality (Kawakita) because of the shorter breeding season; in a warmer locality (Nishioka Park), however, this bee species exhibited eusociality at sunny site and solitary behaviour at shady site, whereas a molecular phylogeny confirms that all of these colonies are evidently conspecific. Therefore, we examined the effect of degree-day accumulation on the sympatric social variation of L. baleicum by rearing the bees to calculate the threshold temperature. Whereas they showed high mortality, the threshold temperature was estimated to be 10.33°C and the expected degree-day accumulation was 340 degree days. When we use this value of a degree-day accumulation to estimate the expected eclosion date, the estimated dates were always consistent with observed eclosion dates. In any sites where the bees were solitary, the degree-day accumulation was not enough for the second eclosion by the end of the bee-active season. In Nishioka Park, sex ratio of the first brood was female biased, and daughters were smaller than mothers; in Kawakita, however, there was no sex bias, and daughters were as large as their mothers indicating that the foundresses seem to produce gyne-sized females in Kawakita but worker-sized females in Nishioka though these females do not become workers at shady site.