Novel mesoporous microspheres of Al and Ni doped LMO spinels and their performance as cathodes in secondary lithium ion batteries

A facile, scalable, and solution-based technique is used to fabricate Al and Ni-doped (LiAl_0.1Mn_1.9O₄ and LiAl_0.1Ni_0.1Mn_1.8O₄) microspheres of lithium manganese oxide (LMO) spinels for use as reversible cathode materials for lithium ion batteries (LIBs). The spheres of the two samples exhibit different porosities. Cells with these LMO-based cathodes are then cycled between 4.5 V and 2 V to study their stabilities while simultaneously being subjected to the undesirable Jahn-Teller distortion that occurs around the ~3 V regime. The LiAl_0.1Mn_1.9O₄ (LAMO) and the LiAl_0.1Ni_0.1Mn_1.8O₄ (LANMO) cells exhibit comparable open circuit voltages (OCV) of 2.94 V and 2.97 V, respectively. During cell cycling, the LAMO cell exhibits a maximum specific capacity of 122.51 mAh g^?1 with a capacity fade of 65.35% after 75 cycles. The LiAl_0.1Ni_0.1Mn_1.8O₄ (LAMO) sample fares better and exhibits a maximum of 140.49 mAh g^?1 and a capacity drop of 52.59%. Detailed structural studies indicate that Ni doping and the greater degree of porosity of the LANMO sample to be a stabilizing factor. This is further confirmed by cyclic voltammetry (CV) and AC impedance spectra analysis.     

Evaluation of Dust Generated from Basic Oxygen Furnace Steel Making

Abstract

A detailed characterization has been made of the dust generated during steel making in basic oxygen furnaces (BOF). Chemical composition and particle size distribution have been analyzed. X-ray diffraction, scanning electron microscopy, and electron probe micro-analysis techniques have been used to identify the morphology and the nature of the major iron-bearing phases as well as the gangue constituents. The dust characteristics have been found to be widely different, depending on the type of process used in BOF steel making, namely, suppressed combustion or total combustion. The type of dust abatement system (dry or wet) additionally influences the nature of the gangue constituents. The possibility of utilizing the iron-bearing major phases has been examined.     

Diffusion mechanism of lindane into wood charcoal

Abstract

The wood charcoal treated by 1N HNO₃ (WCT) was used to remove toxic chlorinated pesticide lindane (y‐HCH) residue from water by the sorption process. Using a simple first order reversible kinetics constants and half time equations, the film and pore diffusion coefficients were determined. Film diffusion was found to be rate limiting step in sorbing lindane by WCT. This was further authenticated by kinetics studies at different initial sorbate concentrations, different sorbent sizes, and different agitation speeds besides interruption test. A pore diffusion model was used to fit the data of kinetics in continuously mixed batch reactors (CMBR), and the tortuosity, external resistance, and surface diffusion effects on lindane sorption by WCT were noticed. The tortuosity values of 15 to 28 were obtained for WCT‐lindane system.     

Anaerobic treatment of atrazine bearing wastewater.

Performance of mixed microbial anaerobic culture in treating synthetic waste-water with high Chemical Oxygen Demand (COD) and varying atrazine concentration was studied. Performance of hybrid reactors with wood charcoal as adsorbent, with a dose of 10 g/l and 40 g/l, along with the microbial mass was also studied. All the reactors were operated in sequential mode with Hydraulic Retention Time (HRT) of 5 days. In all the cases, COD removal after 5 days was found to be above 81%. Initial COD was above 1,000 mg/l. From a hybrid reactor COD removal after 2 days was observed to be 90%. Atrazine reduction after 5 days by microbial mass alone was 43.8%, 40% and 33.2% with an initial concentration of 0.5, 1.0 and 2.0 mg/l respectively. MLSS on all the cases were almost same. Increasing MLSS concentration by about 2 fold did not increase the atrazine removal efficiency significantly. Maximum atrazine removal was observed to be 64% from the hybrid reactor with 10 g/l of wood charcoal and 69.4% from the reactor with 40 g/l of wood charcoal. Atrazine removal from the hybrid reactors after 15 days were observed to be 35.7% and 38.7%, which showed that the higher dose of wood charcoal in hybrid reactor did not improve the atrazine removal efficiency significantly. Specific methanogenic activity test showed no inhibitory effect of atrazine on methane producing bacteria. The performance of anaerobic microorganisms in removing atrazine with no external carbon source and inorganic nitrogen source was studied in batch mode. With an initial concentration of 1.0 mg/l, reduction of atrazine by the anaerobic microorganisms in absence of external carbon source after 35 days was observed to be 61.8% where as in absence of external carbon and inorganic nitrogen source the reduction was only 44.2% after 150 days. Volatilization loss of atrazine was observed to be insignificant.     

Evaluation of ecological restoration success in mining‐degraded lands

This review article analyzes the importance of assessing the success of ecological restoration by using four indicators: assemblage of the plant and animal communities; enzyme activity; litter accumulation and decomposition; and the improvement of soil quality. These indicators can be used alone or in combinations. Even though the Society for Ecological Restoration International provided a primer containing nine attributes to use as standards for measuring ecological restoration, only three of these attributes could be easily applied due to their low costs and low time requirements. These three attributes include: diversity, vegetation structure, and ecological processes. This review article emphasizes that the criteria for the selection of the indicator species should be based upon: habitat types, abundance of species, ease of measuring, quantifying and interpreting the results, gradual enhancement with time and cost‐effectiveness, sensitivity, variability of response, size, residential status, and requirements of the area. Principal component analysis was applied to calculate the reclaimed mine soil quality index (RMSQI) and the forest soil quality index (FSQI) and the RMSQI value was compared with FSQI (optimum index value of reference ecosystem) to evaluate the restoration success. Available phosphorus, exchangeable magnesium, organic carbon, clay content, field moisture, available nitrogen, electrical conductivity, and pH are identified as the most influential parameters that regulate the health of reclaimed mine soil. Exchangeable calcium, magnesium, cation exchange capacity, sand, silt, clay content, field moisture, available phosphorus, and pH are the controlling properties for forest soil. The observed values of the above‐stated soil indicator properties were converted into a unitless score (0–1.00) and integrated into index calculations (RMSQI and FSQI). The contribution of each soil indicator properties on the calculated index was analyzed, which provides insight into the reason for the measured index. A higher RMSQI indicates better ecological restoration success. The calculated RMSQI was found to be 0.473 in the reclaimed dump, which is 6% lower than the reference ecosystem.     

Shoreline shifting and its prediction using remote sensing and GIS techniques: a case study of Sagar Island,West Bengal (India)

The shoreline position is difficult to predict but the trend of erosion or accretion can be determined by geospatial and statistical techniques which may help in reducing the loss of property. The study aims to assess the shoreline changes and prediction in Sagar Island, a delta of the Ganges, situated in West Bengal, India. Shorelines have been delineated by using Tasseled Cap Transformation techniques from the Landsat MSS (1975), Landsat TM (1989, 1991) and Landsat ETM+ (1999, 2002, 2005, 2008, and 2011) images. The uncertainty was calculated for every year for assessing the positional error related to shoreline extraction. Total shoreline change rate/year has also been calculated and the uncertainty of total shoreline change rate was found ±3.20 m/year. In the present study, End Point Rate (EPR) and Linear Regression (LR) methods have been used for shoreline change rate calculation and prediction of shoreline. Long term (1975–2002) and short term (2002–2011) erosion and accretion rates were calculated for the study area. Sagar is the biggest island of the Sundarban region; so, it was divided into three segments in order to analyze the change on a segment basis. It was observed that the most of erosion occurred in the Segment B (south Sagar). The rate of erosion was ?7.91 and ?7.01 m/year for the periods 1975–2002 and 2002–2011 respectively. The mean shoreline change rate was high in Segment B (South Sagar) with values of ?6.46 m/year (1975–2002) but the rate was decreased into ?5.25 m/year during the later period (2002–2011). The study reveals that most of the southern part of Sagar Island is vulnerable to high rate of shoreline erosion.     

The impact of detritivorous fishes on a mangrove estuarine system

Sundarban mangrove ecosystem in India is one of the largest detritus based ecosystem of the world and it supplies the detritus and nutrients to the adjacent Hooghly-Matla estuarine complex. In this estuary a group of fish completely detritivorous in nature, belonging to the genus Mugil spp. is present. This group of fish is expected to have important effects on the trophic dynamics of ecosystems, but exact nature of these effects is not known. In order to study the impact that detritivory by fish may have on the estuarine food chain, we developed mathematical formulations. We run two models, one with phytoplankton, zooplankton, carnivorous fish, detritus and nutrient and without this group of fish and a second one after including this fish in the system. In our model this group of fish has no major impact on primary productions of the estuarine system but has extensive role in total fish production. Coexistence of detritivorous fish and carnivorous fish occurs within reasonable parameter range. We have tested different growth rates of phytoplankton, grazing rates and predation rates of zooplankton, detritivorous fish and carnivorous fish for total system equilibrium. Carnivorous fish predation rate on detritivorous fish and detritivorous fish grazing rate on detritus are very important. Different foraging ratios are also tested in this study. Foraging preference of carnivorous fish on detritivorous fish appears significant for the system equilibrium.     

Assessment of energy balance against the nutritional status of women carriers in the brickfields of West Bengal

The Indian brick industry is an unorganized sector in which large numbers of migrant women workers are employed. A survey was conducted on 62 women workers working in different brickfields of West Bengal to assess their physiological workload, nutritional profile, total energy expenditure and energy balance. Energy intake was calculated using physiological fuel values of carbohydrate, fat and protein. From the results it is seen that 13% of the sample population falls under severe (grade III) chronic energy deficiency. The average daily consumption of the workers was comparatively lower than their daily energy expenditure, considering the nature of the job which falls under heavy to extremely heavy categories. This negative energy balance is effectively observed in the nutritional anthropometry data. Thus, an immediate ergonomics intervention with better nutrition should be implemented to improve the health status of the workers so they can safely continue to work for a longer period.