Four decades of glacier mass balance observations in the Indian Himalaya

Understanding the glacier mass balance is necessary to explain the rate of shrinkage and to infer the impact of climate change. The present study provides an overview of the glacier mass balance records by glaciological, geodetic, hydrological and accumulation-area ratio (AAR) and specific mass balance relationship methods in the Indian Himalaya since 1970s. It suggests that the mass balance measurements by glaciological methods have been conducted for ten glaciers in the western Himalaya, four glaciers in the central Himalaya and one in the eastern Himalaya. Hydrological mass balance has been conducted only on Siachen Glacier from 1987 to 1991. Geodetic method has been attempted for the Lahaul–Spiti region for a short time span during 1999–2011 and Hindu Kush–Karakoram–Himalaya region from 2003 to 2008. We compared in situ specific balance data series with specific mass balance derived from AAR and specific mass balance relationship. The results derived from existing and newly presented regression model based on AAR and specific mass balance relationship induced unrealistic specific mass balance for several glaciers. We also revised AAR0 and ELA0 based on available in situ AAR and specific mass balance data series of Indian Himalayan glaciers. In general, in situ specific and cumulative specific mass balance observed over different regions of the Indian Himalayan glaciers shows mostly negative mass balance years with a few positive ones during 1974–2012. On a regional level, the geodetic studies suggest that on the whole western, the central and the eastern Himalaya experienced vast thinning during the last decade (2000s). Conversely, Karakoram region showed slight mass gain during almost similar period. However, the glaciological, hydrological and geodetic mass balance data appear to exhibit short time series bias. We therefore recommend creation of benchmark glaciers network for future research to determine the impact of climate change on the Himalayan cryosphere.     

Fuel efficiency improvement of a dual-fuel engine fuelled with Honge oil methyl ester (HOME)–bioethanol and producer gas

Renewable and alternative fuels have numerous advantages compared with fossil fuels as they are renewable and biodegradable and provide food and energy security and foreign exchange savings besides addressing environmental concerns and socio-economic issues (Yaliwal et al. 2013. International Journal of Sustainable Engineering, doi:10.1080/19397038.2013.801530. Zhu et al. 2011a, Applied Thermal Engineering 31 (14–15): 2271–2278; Zhu et al. 2011b, Fuel 90: 1743-1750; Banapurmath, Tewari, and Hosmath 2008, Renewable Energy 33: 2007-2018; Banapurmath 2009, “Performance, Combustion and Emission Characteristics of a Single Cylinder Direct Injection CI Engine Operated on Dual Fuel Mode Using Honge Oil and Producer Gas.” PhD thesis, 1–195; Banapurmath et al. 2011, Waste and Biomass Valorization 2: 1–11). In this context, the main objective of the present work is to study methods of biofuel production such as Honge oil methyl ester (HOME) using a conventional transesterification process and bioethanol from the Calliandra calothyrsus shrub using a new pretreatment method known as hydrothermal explosion. Further, experimental investigations were carried out on a single-cylinder, four-stroke, direct-injection stationary diesel engine operating in a dual-fuel mode using HOME, bioethanol and producer gas combinations to determine its performance, combustion and emission characteristics. The performance of the dual-fuel engine was analyzed at optimized engine conditions. HOME-Bioethanol (BE) blends such as HOME+ 5% bioethanol (BE5), HOME+ 10% bioethanol (BE10) and HOME+ 15% bioethanol (BE15) were prepared by adding bioethanol to HOME (on volume basis) in different proportions ranging from 5 to 15% with an increment of 5%. In this present work, the effect of different BE blends on the performance of producer gas fuelled dual fuel engine was studied. Experimental investigation on dual fuel engine using BE5-Producer gas operation resulted in up to 4–9% increased brake thermal efficiency with decreased hydrocarbon (HC), carbon monoxide (CO) and marginally increased nitric oxide (NOx) emission levels compared to HOME-Producer gas, BE10-producer gas and BE15-producer gas mode of operation. However, it was observed that, the overall performance of BE-producer gas operation was found to be lower compared to diesel-producer gas operation.     

Performance,combustion and emission characteristics of a single-cylinder,four-stroke,direct injection diesel engine operated on a dual-fuel mode using Honge oil methyl ester and producer gas derived from biomass feedstock of different origin

Renewable and alternative fuels have numerous advantages compared with fossil fuels, as they are renewable and biodegradable, and provide food and energy security and foreign exchange savings besides addressing environmental concerns and socio-economic issues. In this context, present work was carried out to investigate the feasibility of alternative and renewable fuels derived from biomass feedstock of different origin for engine applications. The present study was also extended to study the effect of producer gas composition derived from different biomass feedstock on the performance, combustion and emission characteristics of a single-cylinder, four-stroke, direct injection stationary diesel engine operated on a dual-fuel mode using Honge oil methyl ester (HOME) and producer gas induction. The performance of the engine was evaluated with a constant injection timing of 27° before top dead centre, an injection pressure of 205 bar for the diesel–producer gas combination and 230 bar for the HOME–producer gas combination and a compression ratio of 17.5. The results showed that the performance of the dual-fuel engine varies with the composition of the producer gas and depends on the type of biomass feedstock used in the gasifier. Experimental investigations on the dual-fuel engine showed that brake thermal efficiency values for the engine operated using HOME–producer gas derived from babul, neem and honge woods were found to be 17.2, 14.3 and 11.56% respectively, compared to 23.8% for diesel–producer gas operation at 80% load. However, the results showed better engine performance with lower exhaust emission levels for the operation of HOME–producer gas derived from the ordinary or babul wood compared with the operation of that derived from the neem and Honge woods. In view of this, present study reveals that use of alternative and renewable fuels for dual fuel engine can be considered as an immediate solution for the development of rural areas and emergency use in the event of severe diesel fuel shortage.     

Effects of compression ratio,swirl augmentation techniques and ethanol addition on the combustion of CNG–biodiesel in a dual-fuel engine

The diminishing resources and continuously increasing cost of petroleum in association with their alarming pollution levels from diesel engines has led to an interest in finding alternative fuels to diesel. Emission control and engine efficiency are two of the most important parameters in current engine design. The impending introduction of emission standards such as Euro IV and Euro V has forced research towards developing new technologies for combating engine emissions. This paper examines the effects of compression ratio, swirl augmentation techniques and ethanol addition on the combustion of compressed natural gas (CNG) blended with Honge oil methyl esters (HOME) in a dual fuel engine. The present results show that the combustion of HOME and 15% ethanol blend with CNG induction in a dual-fuel engine operated in optimized parameters at an injection timing of 27° Before Top Dead Centre and a compression ratio of 17.5 resulted in acceptable combustion emissions and improved brake thermal efficiencies. The implementation of swirl augmentation techniques increased brake thermal efficiencies (BTEs) and considerably reduced combustion emissions such as smoke, HC, CO and NO_x. The addition of ethanol also increased BTEs. However, at more than 15% of ethanol in HOME, NO_x emissions increased dramatically.     

The effect of natural and anthropogenic disturbance in forest canopy and its effect on species richness in forests of Uttarakhand Himalaya,India

Pinus roxburghii (chir-pine) and Quercus leucothchophora (banj-oak) are dominant forests of mountainous part of the Uttarakhand Himalaya. The continued anthropogenic disturbance is opening the canopy, forming canopy gaps and as a result forest fragments are developing. Thus, the present study aims to analyze variations in species richness and vegetational parameters in relation to canopy gaps in forests. Total species richness was greater in open canopied forest compared to moderate and close canopied forests. In comparison between oak and pine forest, it was greater in oak forest while the proportion of common species was low between oak—pine forests. Mean species richness did not significantly vary from one canopy gap to another as well as in oak and pine dominated forest. This indicated that dominant forest types played an important role to form the community structure. The shrubs richness were greater in closed canopy and between the forests it was greater in pine forest. Tree and shrub density was low in open canopy while herb density was high in moderate canopy. Thus, this study indicated that the dominant canopy species play an important role in deciding the community structures especially the distribution of under canopy species. These parameters should be considered for conservation and maintenance of plant biodiversity of a region.     

Detecting diclofenac in livestock carcasses in India with an ELISA: a tool to prevent widespread vulture poisoning

Diclofenac, a non-steroidal anti-inflammatory drug (NSAID), has caused catastrophic vulture declines across the Indian sub-continent. Here, an indirect ELISA is used to detect and quantify diclofenac in 1251 liver samples from livestock carcasses collected across India between August 2007 and June 2008, one to two years after a ban on diclofenac manufacture and distribution for veterinary use was implemented. The ELISAs applicability was authenticated with independent data obtained using LC-ESI/MS. Of 1251 samples, 1150 (91.9%) were negative for diclofenac using both methods, and 60 (4.8%) were positive at 10-4348 and 10-4441 μg kg(-1) when analysed by ELISA and LC-ESI/MS, respectively. The residue level relationship in the 60 positive samples was highly significant (p < 0.001, r(2) = 0.644). Data suggest that this immunological assay could be used not only for cost effective sample screening, but also for residue level semi-quantification.     

Government Management of Village Commons: Comparing Two Forest Policies

When monitoring or enforcement is difficult, governments may find it impossible to manage village forest commons directly. Village-level institutions might be better able to manage these commons, yet villagers' management objectives may not coincide with those of the state. This article considers the effects of two different government policies on the local management of village commons. One policy tool attempts to induce villagers to conserve forest commons by giving them a share of the timber harvest. We investigate the question of whether or not this scheme Joint Forest Management (JFM) is preferred either by the villagers or the government to a simple benchmark policy, under which the government harvests at random. We show that, when villagers are sufficiently patient, for any equilibrium JFM policy there exists a benchmark policy which gives villagers the same level of utility. However, whether the government is similarly indifferent between these two arrangements depends on the villagers' ability to enforce collective agreements, and on the curvature of villagers' utility functions.     

Production of cellulases from Aspergillus niger NS-2 in solid state fermentation on agricultural and kitchen waste residues

Various agricultural and kitchen waste residues were assessed for their ability to support the production of a complete cellulase system by Aspergillus niger NS-2 in solid state fermentation. Untreated as well as acid and base-pretreated substrates including corn cobs, carrot peelings, composite, grass, leaves, orange peelings, pineapple peelings, potato peelings, rice husk, sugarcane bagasse, saw dust, wheat bran, wheat straw, simply moistened with water, were found to be well suited for the organism's growth, producing good amounts of cellulases after 96 h without the supplementation of additional nutritional sources. Yields of cellulases were higher in alkali treated substrates as compared to acid treated and untreated substrates except in wheat bran. Of all the substrates tested, wheat bran appeared to be the best suited substrate producing appreciable yields of CMCase, FPase and β-glucosidase at the levels of 310, 17 and 33 U/g dry substrate respectively. An evaluation of various environmental parameters demonstrated that appreciable levels of cellulases could be produced over a wide range of temperatures (20-50 °C) and pH levels (3.0-8.0) with a 1:1.5 to 1:1.75 substrate to moisture ratio.