Seasonal fluctuations in sand temperature: effects on the incubation period and mortality of loggerhead sea turtle (<Emphasis Type="Italic">Caretta</Emphasis><Emphasis Type="Italic">caretta</Emphasis>) pre-emergent hatchlings in Minabe,Japan

Incubation period, hatching success, and emergence percentage in loggerhead (Caretta caretta) nests were quantified during the 1993 and 1995 nesting seasons and following incubation seasons in Minabe, Wakayama, Japan. Sand and nest temperatures were also monitored. Over the seasons, daily mean sand temperature at nest depth fluctuated between 18.0°C and 33.3°C, with a steep increase in the second week of July and a peak in late August. Temperatures inside the nest chambers were a few degrees above those of the surrounding sand at the end of incubation. The incubation period ranged from 46 to 82 days. A significant negative correlation was found between mean sand temperature and incubation period. The relationship conformed to the day-degree concept. There was no significant seasonal trend in hatching success, but many pre-emergent hatchlings were found dead in most of the clutches during the warmest part of the season. Emergence percentage was correlated with mean sand temperature calculated for 4 days before emergence, suggesting that mortality may be due to heat. This heat-related mortality is considered to be a common phenomenon at our study site, because the peak in emergences coincides with the peak in high temperatures. These temperature effects on hatchling mortality must be taken into account in estimates of hatchling sex ratios. Because sand temperatures already exceed the optimal thermal range for incubation, this population is vulnerable to even small temperature increases resulting from global warming.     

The effectiveness of the e-money incentive mechanism in promoting separation of recyclables at source in Malaysia

Journal of Material Cycles and Waste Management - A new concept of a reward system by two e-money-incentive systems aimed at improving separation at source toward reducing residual waste generation...     

Analytical survey of arsenic in geothermal waters from sites in Kyushu,Japan, and a method for removing arsenic using magnetite

The objective of this study was to survey the cation and anion contents of geothermal waters to gather fundamental information on geographical variations. Sixteen sites in hot spring areas on the island of Kyushu in Japan were studied. The study focused on the arsenic content of the samples. Very high arsenic concentrations (more than 0.1 mg/l) were detected in most of the geothermal waters sampled. High contents of boron and fluoride (more than 1.0 mg/l) were also detected in some samples. Arsenic removal was performed on a laboratory scale using columns packed with a magnetite-type adsorbent. The reduction of arsenic contamination to a concentration of less than 0.01 mg/l could be achieved in the early stages of adsorption (bed volume = 200).     

Evaluating the technical efficiencies of fishing vessels to achieve effective management of overexploited fisheries

Global marine capture fisheries are undergoing serious stress, with overfishing as one of the major problems. In order to mitigate the overexploitation of capture fisheries, government regulation or fisheries management is necessary. Among various management approaches, vessel quantity control is being widely employed. To achieve effective governance of fisheries, the technical efficiency (TE) issue needs to be considered in the implementation of vessel quantity control. Using the Pacific saury (Cololabis saira) stick-held dip net fishery in Japan as a case study, this paper estimated the TE of sampled fishing vessels and explored the possible factors affecting the gap in efficiency. This paper aims to provide suggestions for a better implementation of vessel quantity control in global Pacific saury fishery, and also to serve as an empirical example of integrating TE analysis into management of overexploited fisheries for achieving satisfactory effects. Results show the TE score of the sampled fishery averaged around 0.7 from 2009 to 2014, and factors concerning owners/skippers’ motivation such as vessel ownership and specialization, vessel tonnage as well as skippers’ age show positive effects on the TE. Our findings in the present work provide important strategies for mitigating overexploitation in fisheries. Conducting technical efficiency analysis of targeted fisheries is a vital issue to be considered for designing and realizing an effective implementation of fisheries management approaches. The large vessels and the enthusiasm of vessel owners/skippers need to be particularly addressed when vessel quantity limit is considered to mitigate the problem of overfishing.     

Perfluorosulfonates and perfluorocarboxylates in snow and rain in Dalian,China

Samples of precipitation events (snow and rain) in Dalian, a typical coastal town in China, were analyzed for perfluorosulfonates (PFSAs) and perfluorocarboxylates (PFCAs) to investigate atmospheric contamination by these compounds. In the snow event on December 16, 2006, samples were collected from 21 different sites and in another 6 precipitation events, samples were collected from a single location. Four PFSAs (C4, C6, C8, C10) and seven PFCAs (C6–12) were analyzed. Among the homologues, perfluorooctane sulfonate (PFOS) concentrations were the highest with a geometric mean (GM) of 145 ng/L (n = 21) during the snow event on December 16, 2006, followed by perfluorooctanoate (PFOA) with a GM of 24.7 ng/L (n = 21). Concentrations of perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS) and perfluoroheptanoate (PFHpA) were more than two orders of magnitude lower than that of PFOS. Other PFSAs and PFCAs were found to be below the limit of detection in all the samples. In other 6 precipitation events, PFSAs and PFCAs were detected approximately in the same order of magnitude in both snow and rain. The results indicate that wet deposition may be a potential transport mechanism of perfluorinated chemicals in the environment.     

Model prediction on the rise of pCO2 in uniform flows by leakage of CO2 purposefully stored under the seabed

A numerical study was conducted to predict pCO₂ change in the ocean on a continental shelf by the leakage of CO₂, which is originally stored in the aquifer under the seabed, in the case that a large fault connects the CO₂ reservoir and the seabed by an earthquake or other diastrophism. The leakage rate was set to be 6.025 × 10⁻⁴ kg/m²/sec from 2 m × 100 m fault band, which corresponds to 3800 t-CO₂/year, referring to the monitored seepage rate from an existing EOR field. The target space in this study was limited to the ocean above the seabed, the depth of which was 200 or 500 m. The computational domain was idealistically rectangular with the seabed fault-band perpendicular to the uniform flow. The CO₂ takes a form of bubbles or droplets, depending on the depth of water, and their behaviour and dissolution were numerically simulated during their rise in seawater flow. The advection–diffusion of dissolved CO₂ was also simulated. As a result, it was suggested that the leaked CO₂ droplets/bubbles all dissolve in the seawater before spouting up to the atmosphere, and that the increase in pCO₂ in the seawater was smaller than 500 μ atm.     

Leachability of municipal solid waste ashes in simulated landfill conditions

In Japan the volume of municipal solid waste is reduced by incineration, with fly ash and bottom ash disposed in controlled landfills. The leachability of anions and heavy metal cations, Zn, Cu and Pb, from MSW fly ash and bottom ash at different pHs was examined using batch- and column-leaching tests. The MSW ashes had a high capacity for neutralizing acids. Behaviour during leaching depended on the pH of the solution. For the volumes applied, the leachabilities of MSW fly ash were very similar at pHs from 3 to 6. Due to its amphoteric nature, Pb is leachable at pHs of approximately 10 or more, with leachate concentrations of about 3 and 3-10mg/L for the fly ash and bottom ash, respectively, much higher than for Zn and Cu. Pb concentrations for most leaching solutions were 1 and 3mg/L for the fly ash and bottom ash, respectively. Zn, and Cu leached at low concentrations for solutions of pH 3-6. Na and K ions leached at high concentrations of approximately 5000 mg/L in the first batch leaching test, decreasing to 10mg/L by the fourth leach. Ca and Mg ions leached more gradually than Na and K. Cl(-) and SO(4)(2+) ions were the major anions in the MSW ash. The high pH and cation leaching are expected to have negative impacts on the performance of clay liners.     

Removal of aqueous lead by poorly-crystalline hydroxyapatites

The use of a phosphorus amendment in altering Pb to a chemically less mobile phase is a promising strategy based on minimizing ecotoxicological risk and improving time and cost efficiency. This study evaluated crystalline and poorly-crystalline hydroxyapatite sorbents on removal of aqueous Pb in response to reaction time, solution pH, and Pb concentration. Batch experiments were conducted using a commercially-available crystalline hydroxyapatite (HA), and two poorly-crystalline hydroxyapatites synthesized from gypsum waste (CHA) and incinerated ash of poultry waste (MHA). Poorly-crystalline hydroxyapatites had greater capacity for Pb removal from a solution with a wider pH range as compared to a crystalline hydroxyapatite. The maximum sorption capacity of Pb determined by the Langmuir model was 500 mg g⁻¹ for CHA, 277 mg g⁻¹ for MHA and 145 mg g⁻¹ for HA. Removal of aqueous Pb by CHA was not dependent on solution pH, with a 98.8% reduction throughout the solution pH range of 2–9, whereas aqueous Pb removal by HA and MHA was pH-dependent with less removal in the neutral solution pH. Poorly-crystalline hydroxyapatites may provide an effective alternative to existing remediation technologies for Pb-contaminated sites.