PBDEs in leachates from municipal solid waste dumping sites in tropical Asian countries: phase distribution and debromination

Polybrominated diphenyl ethers (PBDEs) are extensively used as flame retardants in many consumer products, and leachates from landfills have been identified as one of the possible sources of PBDEs in the environment. Meanwhile, the unprecedented economic and population growths of some Asian countries over the last decade have led to significant increases in the amount of waste containing PBDEs in that region. This study investigates the status of PBDEs in leachates from municipal solid waste dumping sites (MSWDS) in tropical Asian countries. A total of 46 PBDE congeners were measured, both in the adsorbed (n?=?24) and dissolved (n?=?16) phases, in leachate samples collected, from 2002 to 2010, from ten MSWDS distributed among the eight countries of Lao PDR, Cambodia, Vietnam, India, Indonesia, Thailand, the Philippines, and Malaysia. PBDEs were predominantly found in the adsorbed phase. Partitioning of PBDEs in the dissolved phase was associated with the presence of dissolved organic matter; the apparent organic carbon-normalized partition coefficients (K′_oc) of the BDE congeners were lower by two to four orders of magnitude than the K _oc predicted from the octanol–water partition coefficients (K _ow). The total PBDE concentrations from mono- to deca-BDEs ranged from 3.7 to 133,000 ng/L, and showed a trend toward higher concentrations in the more populous and industrialized Asian countries. The congener profiles in the leachates basically reflected the composition of PBDE technical mixtures. The occurrence of congeners not contained, or in trace concentrations, in technical products (e.g., BDEs 208, 207, 206, 202, 188, 179, 49, 17/25, 8, 1) was observed in most of the leachate samples, suggesting the debromination of technical mixtures, including BDE-209, in the MSWDS of tropical Asian countries. Moreover, the temporal trend indicated the reduction of BDE-209 over time, with a corresponding increase in and/or emergence of lower brominated PBDE congeners. The results indicated that MSWDS of tropical Asian countries are potential sources of environmental PBDEs, which may be transported to the aquatic environment via dissolution with dissolved organic matter. MSWDS could be amplifiers of PBDE toxicity in the environment, possibly through debromination.     

Surfactant Treatment for Efficient Gene Detection of Enteric Viruses and Indicators in Surface Water Concentrated by Ultrafiltration

Food and Environmental Virology - The hollow fiber ultrafiltration (HFUF)-based microbial concentration method is widely applied for monitoring pathogenic viruses and microbial indicators in...     

Comparison effect of feedstock to inoculum ratios on biogas yields of cafeteria,vegetable, fruit wastes with cattle manure using co-digestion process

Cafeteria, vegetable, fruit, and cattle manure are available year around at low cost and have the potential to complement each other for anaerobic digestion (AD). The objectives of this study were to determine the preferred mixing ratios and effects of feedstock to inoculum ratios for the optimal biogas production. The mesophilic digestion tests were performed with five mixing ratios of CW, VW, FW with CM and five feedstock to inoculum (F/I) ratios using batch anaerobic digesters. Co-digestion of CW, VW, FW with CM was carried out at F/I ratios of 1.0, 2.0, 3.0, 4.0, and 5.0. The results showed that the F/I ratio significantly affected the biogas production rate. Increasing the CW, VW, FW in the CM resulted in an increased methane yield by decreasing the F/I ratios in the reactors from 5.0 to 1.0. The highest biogas yields of 591.3, 432.9, and 450.6 L/kg VS_feed were obtained with CW/CM (50:50), VW/CM (25:75), and FW/CM (25:75) ratios, respectively. At five F/Is tested, after 45 days of AD, the total biogas yields were determined to be 629.74, 552.64, 501.87, 464.66, and 396.04 L and 496.93, 460.02, 420.5, 398.14, and 336.20 L, and 455.03, 382.81, 349.78, 340.95, and 298.53 L, respectively. However, the highest average CH₄ contents obtained at an F/I of 1.0 were 62.14%, 60.72%, and 61.08% that are 5.87%, 9.47%, and 10.17% higher than those obtained at F/I ratio of 5.0 for CW/CM (50:50), VW/CM (25:75), and FW/CM (25:75), respectively.