Radon gas distribution in natural gas processing facilities and workplace air environment

Evaluation was made of the distribution of radon gas and radiation exposure rates in the four main natural gas treatment facilities in Syria. The results showed that radiation exposure rates at contact of all equipment were within the natural levels (0.09-0.1 microSvh(-1)) except for the reflex pumps where a dose rate value of 3 microSvh(-1) was recorded. Radon concentrations in Syrian natural gas varied between 15.4 Bq m(-3) and 1141 Bq m(-3); natural gas associated with oil production was found to contain higher concentrations than the non-associated natural gas. In addition, radon concentrations were higher in the central processing facilities than the wellheads; these high levels are due to pressurizing and concentrating processes that enhance radon gas and its decay products. Moreover, the lowest 222Rn concentration was in the natural gas fraction used for producing sulfur; a value of 80 Bq m(-3) was observed. On the other hand, maximum radon gas and its decay product concentrations in workplace air environments were found to be relatively high in the gas analysis laboratories; a value of 458 Bq m(-3) was observed. However, all reported levels in the workplaces in the four main stations were below the action level set by IAEA for chronic exposure situations involving radon, which is 1000 Bq m(-3).     

Vertical distribution and inventories of 137Cs in the Syrian soils of the eastern Mediterranean region

Vertical distribution and inventories of (137)Cs have been determined using radiocesium distributions in presumably undistributed soil profiles, collected from 36 sites distributed all over Syria (eastern Mediterranean region). Vertical distributions of (137)Cs in the collected profiles were found to be strongly correlated with soil type and five groups were identified. Based on these profiles, total (137)Cs inventory (bomb test and Chernobyl) varied between 320 Bq m(-2) and 9,647 Bq m(-2). Geographical mapping of (137)Cs inventories showed that the highest values were found in the coastal, middle and north-east regions of Syria indicating that Chernobyl atmospheric contribution to the total (137)Cs deposition in the region is predominant. In contrast, the lowest values were found in the south-east region (Syrian Badia), where a relatively uniform distribution was observed, which may only be attributed to the past global nuclear bomb test. The measured inventories were also compared with a mathematical model for estimating bomb derived (137)Cs reference inventories.     

Speciation of 210Po and 210Pb in air particulates determined by sequential extraction

Speciation of (210)Po and (210)Pb in air particulates of two Syrian phosphate sites with different climate conditions has been studied. The sites are the mines and Tartous port at the Mediterranean Sea. Air filters were collected during September 2000 until February 2002 and extracted chemically using different selective fluids in an attempt to identify the different forms of these two radionuclides. The results have shown that the inorganic and insoluble (210)Po and (210)Pb (attached to silica and soluble in mineral acids) portion was found to be high in both sites and reached a maximum value of 94% and 77% in the mine site and Tartous port site, respectively. In addition, only 24% of (210)Pb in air particulates was found to be associated with organic materials probably produced from the incomplete burning of fuel vehicle and similar activities. Moreover, the (210)Po/(210)Pb activity ratio in air particulates was higher than that in all samples at both sites and varied between 3.85 in November 2000 at Tartous port site and 20 in April 2001 at the mine area. These activity ratios were also higher than the natural levels. The (210)Po/(210)Pb activity ratio was also determined in each portion resulting from the selective extraction and found to be higher than that in most samples. The sources of (210)Po excess in these portions are discussed. Soil suspension, which is common in the dry climate dominant in the area, sea water spray and heating of phosphate ores were considered; polonium is more volatile than the lead compounds at even moderate temperature. Furthermore, variations in the chemical forms of (210)Po and (210)Pb during the year were also investigated. However, the results of this study can also be utilized for dose assessment to phosphate industry workers.     

The impact of phosphate loading activities on near marine environment: the Syrian coast.

The impact of loading cargoes of phosphate ore into ships on the near marine environment at the Syrian coast has been evaluated. Results have shown a significant enhancement of 210Po, 210Pb and other natural radionuclides in sediment and surface water inside the port area. The highest 210Po and 210Pb concentrations observed in sediment were found to be 170 and 64 Bq kg(-1) respectively, while 210Pb and 210Po concentrations in surface water ranged from 5 to 20 mBq l(-1) and 0.93 to 3.23 mBq l(-1). In addition, comparable values of 210Po and 210Pb for all marine organisms (algae, crab and fish) suggest that their use as indicators for phosphate pollution is not recommended. However, the effect of loading cargoes on the port marine environment of Tartous was found to be mainly related to wind direction where radioactive air particulate are either being dispersed to land or sea.     

Transfer of (40)K, (238)U, (210)Pb, and (210)Po from soil to plant in various locations in south of Syria

Transfer factors of (40)K, (238)U, (210)Pb, and (210)Po from soil to some agriculture crops in various locations in south of Syria (Dara'a and Assuwaydaa districts) have been determined. Soil and vegetable crops (green pepper, cucumber, tomato, and eggplant), legumes crops (lentil, chickpea, and broad bean), fruit trees (apple, grape, and olives) and cereals (barley and wheat) were collected and analyzed for (238)U, (210)Pb, and (210)Po. The results have shown that higher transfer factors (calculated as Bqkg(-1) dry wt. plant material per Bqkg(-1) dry wt. soil) for (210)Po, (210)Pb and (238)U were observed in vegetable leaves than fruits and cereals leaves; the highest values of transfer factor (TF) for (238)U were found to be 0.1 for straw of chickpea. Transfer factors for (210)Po varied between 2.8x10(-2) and 2 in fruits of eggplant and grain of barley, respectively. In addition, several parameters affecting transfer factors of the radionuclides were evaluated. The results can be considered as base values for TF of natural radionuclides in the region.     

Geochemistry of uranium and thorium in phosphate deposits at the Syrian coastal area (Al-Haffah and Al-Qaradaha) and their environmental impacts

Environmental Geochemistry and Health - The aim of this research was to study the geochemistry of uranium and thorium in phosphate deposits in the upper Cretaceous phosphate deposits in the Syrian...     

Transfer factors of Polonium from soil to parsley and mint

Transfer factors of ²¹⁰Po from soil to parsley and mint have been determined. Artificial polonium isotope (²⁰⁸Po) was used as a tracer to determine transfer factor of Po from soil to plant in pot experiments. Two plant growing systems were used for this study namely, an outdoor system and a sheltered system by a polyethylene tent. ²⁰⁸Po and ²¹⁰Po were determined in soil and different parts of the studied plants (stem and leaf), using alpha spectroscopy. The results have shown that there was a clear uptake of ²⁰⁸Po by roots to leaves and stems of both plants. Higher values of transfer factors using the ²¹⁰Po activity concentrations than the ²⁰⁸Po activity concentration were observed. Transfer factors of ²¹⁰Po from soil to parsley varied between 20 × 10⁻² and 50 × 10⁻² and 22 × 10⁻³ and 67 × 10⁻³ in mint, while ²⁰⁸Po transfer factors varied between 4 × 10⁻² and 12 × 10⁻² for parsley and 10 × 10⁻² and 22 × 10⁻² in mint. Transfer factors of Po were higher in those plants grown in the sheltered system than in the open system; about 75% of Po was transferred from atmosphere to parsley parts using the two systems. Ratios of transferred Po from soil to mint stem and leaf in the sheltered system were higher by 2 times from those in the open system.     

Experimental degradation of oil in permeable sand from the Gulf of Aqaba,Red Sea

Degradation rates of light and heavy oil in permeable carbonate sands from the Gulf of Aqaba were investigated to evaluate the ability of sediments to degrade oil compounds. Silicate sands that are less permeable and different properties from carbonate sands were used for comparison. Estimates of oil degradation rates were based on oxygen consumption rates, calculated by incubating natural carbonate sands with oil. The degradation rates of light oil were twofold higher than those of heavy oil, which may be attributed to the presence of a higher carbon number in heavy oil compared with light oil. Degradation rates of light oil in carbonate sands were twofold higher than in silicate sands. Oil degradation rates calculated using the bottle incubation technique were three- to fourfold higher than rates from chamber incubations, indicating the importance of adequate mixing between oil particles and sediments during degradation processes. This study suggests that permeable sands, through their chemical and physical properties, increase oil biodegradation rates by enhancing flow through sediment particles and positively impacting bioturbation processes.     

Radionuclides and trace metals in eastern Mediterranean Sea algae

Three types of sea alga distributed along the Syrian coast have been collected and analyzed for radioactivity and trace elements. Results have shown that (137)Cs concentrations in all the analyzed sample were relatively low (less than 1.2 Bq kg(-1) dry weight) while the levels of naturally occurring radionuclides, such as (210)Po and (210)Pb, were found to be high in most samples; the highest observed value (27.43 Bq kg(-1) dry weight) for (210)Po being in the red Jania longifurca alga. In addition, most brown alga species were also found to accumulate (210)Po, which indicates their selectivity to this isotope. On the other hand, brown alga (Cystoseira and Sargassum Vulgare) have shown a clear selectivity for some trace metals such as Cr, As, Cu and Co, this selectivity may encourage their use as biomonitor for pollution by trace metals. Moreover, the red alga species were found to contain the highest levels of Mg while the brown alga species were found to concentrate Fe, Mn, Na and K and nonmetals such as Cl, I and Br.