Feasibility study of a passive aeration reactor equipped with vertical pipes for compost stabilization of cow manure.

Pilot-scale composting was carried out with cow manure to evaluate the performances of two passive aeration systems: a conventional passive aeration system equipped with horizontal pipes and an unusual passive aeration method based on air delivery by means of vertical pipes. The effects of both types of passive aeration apparatus were investigated in order to determine the degree of composting rate by continuously monitoring temperature, moisture content, organic matter, electrical conductivity, pH and C/N ratio in the piles. Temperatures in the range of thermophily (55-65 degrees C) were reached in all runs within 1-2 days then lasting for about 1 week, a span long enough for pathogen abatement. Results suggest that passive aeration carried out by vertical pipes is more effective for air delivery into compost piles than conventional passive aeration of air adduction with horizontal pipes. The variation in the number of vertical pipes was revealed to be an important parameter for the control of composting rate and temperature. Composting rates estimated from the heat balance equation were substantially in agreement with those computed through the conversion ratio of total organic matter decrement. The conversion ratios and composting rates obtained in this study using passive aeration with vertical pipes were well aligned with those found using forced air delivery systems.     

低浓度臭氧在含钴盐硅胶上的吸附研究

常压下对含钴盐硅胶进行低浓度臭氧的吸附实验，吸附达到饱和后用氮气作为载气加热解吸。结果显示，含钴盐的硅胶对臭氧具有较强的吸附能力；臭氧解吸量随着解吸温度的上升而增加；吸附了臭氧的含钴硅胶粒子在常温(313．15K)下可在60min内不问断解吸出臭氧。     

Perfluorosulfonates and perfluorocarboxylates in snow and rain in Dalian,China

Samples of precipitation events (snow and rain) in Dalian, a typical coastal town in China, were analyzed for perfluorosulfonates (PFSAs) and perfluorocarboxylates (PFCAs) to investigate atmospheric contamination by these compounds. In the snow event on December 16, 2006, samples were collected from 21 different sites and in another 6 precipitation events, samples were collected from a single location. Four PFSAs (C4, C6, C8, C10) and seven PFCAs (C6–12) were analyzed. Among the homologues, perfluorooctane sulfonate (PFOS) concentrations were the highest with a geometric mean (GM) of 145 ng/L (n = 21) during the snow event on December 16, 2006, followed by perfluorooctanoate (PFOA) with a GM of 24.7 ng/L (n = 21). Concentrations of perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS) and perfluoroheptanoate (PFHpA) were more than two orders of magnitude lower than that of PFOS. Other PFSAs and PFCAs were found to be below the limit of detection in all the samples. In other 6 precipitation events, PFSAs and PFCAs were detected approximately in the same order of magnitude in both snow and rain. The results indicate that wet deposition may be a potential transport mechanism of perfluorinated chemicals in the environment.     

Crystallization Behavior and Dynamic Mechanical Properties of Poly(l-Lactic Acid) with Poly(Ethylene Glycol) Terminated by Benzoate

Effect of the addition of poly(ethylene glycol) terminated by benzoate (PEG-BA) on the crystallization behavior and dynamic mechanical properties of poly(l-lactic acid) PLLA is studied as compared with poly(ethylene glycol) (PEG-OH). It is found that PEG-BA is miscible with PLLA and shows good plasticizing effect. Because PEG-OH having the same degree of polymerization is immiscible with PLLA, the end group in PEG-BA, i.e., benzoate, plays an important role in the miscibility. Furthermore, PEG-BA does not induce the PLLA degradation at melt-processing, whereas PEG-OH leads to the hydrolysis degradation. Finally, the addition of PEG-BA pronounces the crystallization rate of PLLA at low crystallization temperatures and thus enhances the degree of crystallinity at conventional processing. Consequently, the temperature dependence of dynamic mechanical properties are similar to that for isotactic polypropylene.     

Hydrothermal synthesis of meso/macroporous BiVO4 hierarchical particles and their photocatalytic degradation properties under visible light irradiation

An ordered hierarchical meso/macroporous monoclinic bismuth vanadate (BiVO₄) particle was fabricated for the first time by a simple two-step melamine template hydrothermal method followed by calcination. The physiochemical parameters of as-prepared porous materials were characterized by means of X-ray diffraction, scanning electron microscopy, high-resolution transmission electron microscopy, Raman, Barrett–Emmett–Teller, and UV–vis techniques. The nitrogen adsorption–desorption measurement and pore size distribution curve suggest that meso/macropores exist in these hierarchical microarchitectures. Further, it is found that melamine plays a significant role in the formation of porous BiVO₄ particles, and when a known amount of melamine was added, the surface area and pore size of such porous BiVO₄ particles were increased. The photocatalytic activities of the as-prepared hierarchical BiVO₄ samples were measured for the photodegradation of Congo red aqueous dye solution under visible light irradiation. Surprisingly, the porous BiVO₄ particles showed outstanding photocatalytic activities than polycrystalline BiVO₄ sample. The possible enhancement of such catalytic performance has also been further discussed.     

Effect of silica sand on activation energy for diffusion of sodium ions in montmorillonite and silica sand mixture

The effect of silica sand on the diffusion of sodium ions in mixtures of montmorillonite and silica sand was studied by measuring the apparent diffusion coefficients, activation energies for diffusion, and the basal spacing of the mixed samples. These diffusion experiments suggest that the apparent diffusion coefficients of sodium ions in the mixed samples were almost the same as those of pure montmorillonite samples having the same partial dry densities of montmorillonite. The activation energy dependence for diffusion of sodium ions on the partial dry density was different between the mixed samples and the pure montmorillonite samples. The activation energy increased by adding silica sand at the partial dry density of 1.0 Mg m(-3), and decreased by adding silica sand at the partial dry densities higher than 1.2 Mg m(-3). A change in the XRD profile was observed after adding silica sand at the partial dry density of 1.6 Mg m(-3). Here, a three-water-layer hydrate state of montmorillonite was found in the mixed sample whereas only a two-water-layer hydrate state was observed in the pure montmorillonite sample. These experimental results suggest that silica sand changed the montmorillonite microstructure in the mixed samples, which then altered the sodium-ion diffusion process.     

Removal of aqueous lead by poorly-crystalline hydroxyapatites

The use of a phosphorus amendment in altering Pb to a chemically less mobile phase is a promising strategy based on minimizing ecotoxicological risk and improving time and cost efficiency. This study evaluated crystalline and poorly-crystalline hydroxyapatite sorbents on removal of aqueous Pb in response to reaction time, solution pH, and Pb concentration. Batch experiments were conducted using a commercially-available crystalline hydroxyapatite (HA), and two poorly-crystalline hydroxyapatites synthesized from gypsum waste (CHA) and incinerated ash of poultry waste (MHA). Poorly-crystalline hydroxyapatites had greater capacity for Pb removal from a solution with a wider pH range as compared to a crystalline hydroxyapatite. The maximum sorption capacity of Pb determined by the Langmuir model was 500 mg g⁻¹ for CHA, 277 mg g⁻¹ for MHA and 145 mg g⁻¹ for HA. Removal of aqueous Pb by CHA was not dependent on solution pH, with a 98.8% reduction throughout the solution pH range of 2–9, whereas aqueous Pb removal by HA and MHA was pH-dependent with less removal in the neutral solution pH. Poorly-crystalline hydroxyapatites may provide an effective alternative to existing remediation technologies for Pb-contaminated sites.     

Spatial distribution and vertical profile of polybrominated diphenyl ethers and hexabromocyclododecanes in sediment core from Tokyo Bay, Japan

Brominated flame retardants (BFRs), hexabromocyclododecanes (HBCDs) and polybrominated diethyl ethers (PBDEs) were detected in three sediment cores and six surface sediments of Tokyo Bay, Japan. HBCDs were detected for the first time in this region with concentrations ranging from 0.056 to 2.3 ng/g dry wt, implying their widespread contamination, even though their concentrations were lower than summation operatorPBDEs (di- to nona-BDEs) and BDE-209. Levels of these compounds were higher near to the highly populated industrial area of the bay implicating industrial and human activities as sources of these compounds. Summation operatorPBDEs increased in the sediment layer up to the mid-1990s and decreased afterwards, whereas BDE-209 showed an increasing trend until now, following the usage of different commercial BDE mixtures. HBCDs first appeared in the mid-1970s and increased until today. The annual surficial flux of HBCDs (0.62-2.4 ng/cm2/yr) is equal to summation operatorPBDEs (0.95-2.6 ng/cm2/yr) but lower than that of BDE-209 (17-58 ng/cm2/yr).     

苏州垃圾填埋生命周期清单分析

采用理论计算和实测相结合的方法,求得了苏州七子山垃圾填埋埋场的生命周期清单。实践证明,理论计算和实测相结合是清单分析的有效方法,对今后的同类研究具有参考意义。研究中获得的清单包括生活垃圾的收集和运输、垃圾填埋的物耗和能耗,以及每吨填埋垃圾所排放的大气和水污染物的量,并考察了填埋气用于发电后对清单的影响。这些结果可以为众多的产品生命周期评价提供数据支持。     

土壤酸化及天然土壤溶液中铝的形态

采用真空式土壤溶液采样器收集了宜昌、巫山松树林中天然土壤溶液,采用高效液相色谱法Al－Lumogallion柱后荧光检测,分析测试了土壤溶液中可溶性铝的形态,研究了由于土壤酸化引起天然土壤溶液中不同形态铝的迁移转化结果表明,天然土壤溶液中含有不同形态的铝,主要是有机铝、 AISO₄⁺、AIF₂⁺、Al（OH）²⁺、Al³⁺等．宜昌、巫山地区土壤溶液中活性铝（Al³⁺、AlOH^2+F）的含量比较低．土壤的酸化使得天然土壤溶液中总铝含量增加、铝形态的优势态发生变化,即土壤的酸化使得天然土壤溶液中活性铝－Al³⁺、AlOHF²⁺含量和比例增加．土壤酸化还降低了大然土壤溶液中的BC/Al比值,这些变化的结果都增加了对森林潜在的危害．