The use of technology to address patterns of risk among teenage drivers

INTRODUCTION: The crash risk of teens is high, with fatal crash rates of teen drivers higher than any other age group. New approaches to reduce teen traffic fatalities are clearly needed. METHOD: A possible approach to reduce the incidence of teen driver crashes and fatalities is through the use of vehicle-based intelligent driver support systems. To be most effective, the system should address the behaviors associated with an overwhelming number of teen fatal crashes: speed, low seatbelt use, and alcohol impairment. In-vehicle technology also offers an opportunity to address the issue of inexperience through enforcement of certain Graduated Driver's License provisions. RESULTS: To fully understand the capability of such technologies, there should be a concerted effort to further their development, and human factors testing should take place to understand their effects on the driver. IMPACT: If successfully implemented, a Teen Driver Support System (TDSS), such as the one described here, could significantly decrease the number of teens killed in traffic crashes.     

Acid generation upon thermal concentration of natural water: The critical water content and the effects of ionic composition

Thermal evaporation of a variety of simulated pore waters from the region of Yucca Mountain, Nevada, produced acidic liquids and gases during the final stages of evaporation. Several simulated pore waters were prepared and then thermally distilled in order to collect and analyze fractions of the evolved vapor. In some cases, distillates collected towards the end of the distillation were highly acidic; in other cases the pH of the distillate remained comparatively unchanged during the course of the distillation. The results suggest that the pH values of the later fractions are determined by the initial composition of the water. Acid production stems from the hydrolysis of magnesium ions, especially at near dryness. Near the end of the distillation, magnesium nitrate and magnesium chloride begin to lose water of hydration, greatly accelerating their thermal decomposition to form acid. Acid formation is promoted further when precipitated calcium carbonate is removed. Specifically, calcium chloride-rich pore waters containing moderate (10–20 ppm) levels of magnesium and nitrate and low levels of bicarbonate produced mixtures of nitric and hydrochloric acid, resulting in a precipitous drop in pH to values of 1 or lower after about 95% of the original volume was distilled. Waters with either low or moderate magnesium content coupled with high levels of bicarbonate produced slightly basic fractions (pH 7–9). If calcium was present in excess of bicarbonate, waters containing moderate levels of magnesium produced acid even in the presence of bicarbonate, due to the precipitation of calcium carbonate. Other salts such as halite and anhydrite promote the segregation of acidic vapors from residual basic solids. The concomitant release of wet acid gas has implications for the integrity of the alloys under consideration for containers at the Yucca Mountain nuclear waste repository. Condensed acid gases at very low pH, especially mixtures of nitric and hydrochloric acid, are capable of corroding even alloys, such as nickel-based Alloy 22, which are considered to be corrosion-resistant under milder conditions.     

Assisting Australian indigenous resource management and sustainable utilization of species through the use of GIS and environmental modeling techniques

Information on distribution and relative abundance of species is integral to sustainable management, especially if they are to be harvested for subsistence or commerce. In northern Australia, natural landscapes are vast, centers of population few, access is difficult, and Aboriginal resource centers and communities have limited funds and infrastructure. Consequently defining distribution and relative abundance by comprehensive ground survey is difficult and expensive. This highlights the need for simple, cheap, automated methodologies to predict the distribution of species in use, or having potential for use, in commercial enterprise. The technique applied here uses a Geographic Information System (GIS) to make predictions of probability of occurrence using an inductive modeling technique based on Bayes' theorem. The study area is in the Maningrida region, central Arnhem Land, in the Northern Territory, Australia. The species examined, Cycas arnhemica and Brachychiton diversifolius, are currently being 'wild harvested' in commercial trials, involving sale of decorative plants and use as carving wood, respectively. This study involved limited and relatively simple ground surveys requiring approximately 7 days of effort for each species. The overall model performance was evaluated using Cohen's kappa statistics. The predictive ability of the model for C. arnhemica was classified as moderate and for B. diversifolius as fair. The difference in model performance can be attributed to the pattern of distribution of these species. C. arnhemica tends to occur in a clumped distribution due to relatively short distance dispersal of its large seeds and vegetative growth from long-lived rhizomes, while B. diversifolius seeds are smaller and more widely dispersed across the landscape. The output from analysis predicts trends in species distribution that are consistent with independent on-site sampling for each species and therefore should prove useful in gauging the extent of resource availability. However, some caution needs to be applied as the models tend to over predict presence which is a function of distribution patterns and of other variables operating in the landscape such as fire histories which were not included in the model due to limited availability of data.     

Degradation rates of CFC-11, CFC-12 and CFC-113 in anoxic shallow aquifers of Araihazar, Bangladesh

Chlorofluorocarbons CFC-11 (CCl(3)F), CFC-12 (CCl(2)F(2)), and CFC-113 (CCl(2)F-CClF(2)) are used in hydrology as transient tracers under the assumption of conservative behavior in the unsaturated and saturated soil zones. However, laboratory and field studies have shown that these compounds are not stable under anaerobic conditions. To determine the degradation rates of CFCs in a tropical environment, atmospheric air, unsaturated zone soil gas, and anoxic groundwater samples were collected in Araihazar upazila, Bangladesh. Observed CFC concentrations in both soil gas and groundwater were significantly below those expected from atmospheric levels. The CFC deficits in the unsaturated zone can be explained by gas exchange with groundwater undersaturated in CFCs. The CFC deficits observed in (3)H/(3)He dated groundwater were used to estimate degradation rates in the saturated zone. The results show that CFCs are degraded to the point where practically no (<5%) CFC-11, CFC-12, or CFC-113 remains in groundwater with (3)H/(3)He ages above 10 yr. In groundwater sampled at our site CFC-11 and CFC-12 appear to degrade at similar rates with estimated degradation rates ranging from approximately 0.25 yr(-1) to approximately 6 yr(-1). Degradation rates increased as a function of reducing conditions. This indicates that CFC dating of groundwater in regions of humid tropical climate has to be carried out with great caution.     

Modeling kelp forest distribution and biomass along temperate rocky coastlines

We address the global deficit of data describing kelp forest distribution, relative covers and biomass by testing the ability of species distribution models to predict these attributes at locations where data are currently limited. We integrated biological ground truth data with high-resolution environmental datasets to develop generalized additive models that accurately predict the structure of Laminaria forests within the Bay of Morlaix (48°42′42″N, 3°55′40″W). Forest distribution and proportional covers were predicted using water depth, light availability, wave exposure and sediment dynamics. The biomass of individual kelp species was modeled by supplementing these same variables with measures of seafloor slope and benthic position. Biomass predictions for Laminaria digitata and Laminaria hyperborea contrast the physiological tolerances of these species to light and wave exposure gradients. As a direct management output, we produced high-resolution maps (25 m² grids) that closely match independent field data and provide vital information for marine spatial planning.     

Remediation procedure used for contaminated soil and underground water: A case study from the chemical industry

This is a case study of contamination by a non-aqueous phase liquid (NAPL) that leaked from a chemical plant. The remediation procedure adopted for the initial phase of the plume migration was a plastic diaphragm wall coupled with a series of water extraction wells designed to avoid environmental impact on the surrounding ecosystems. Monitoring has shown that the containment is successful, and additional measures that contribute to accelerating remediation have been adopted. The authors wished to investigate how remediation might be further enhanced. The use of in situ aeration coupled with a system of soil vapor extraction (AS/SVE) has been chosen, since the remediation of sites with characteristics similar to those in this study, if based exclusively on dissolved-phase control, would take several decades to be completed. The transport of contaminant plumes has been simulated by using an analytical model to evaluate the effectiveness of the natural attenuation of the contaminant. The results of the simulation have confirmed the limited effectiveness of the natural attenuation of the contaminant, as well as the effective increase of remediation that would occur if the AS/SVE system is applied. A sensitivity analysis that included several combinations of increments of parameters that correspond to the decay rate of the source and the dissolved plume has simulated what might happen if the AS/SVE system is implemented.     

Choosing an appropriate soil-gas survey method

Three types of soil-gas surveys were performed over the same location at an industrial facility. The surveys performed were (1) a passive technique using buried collectors, (2) an active technique in which samples were collected in the field by pumping with subsequent analysis at a field laboratory, and (3) a screening technique that employed a hand-held survey instrument. Each of the surveys had desirable features, but there was considerable variability in the quality of data obtained, cost, and ease of performance. The passive and active surveys provided excellent detection limits, but the passive technique does not provide data in real time. The active survey was also time-consuming and required an analytical chemist in the field. Neither the active nor the passive survey were able to delineate the plume of contaminated groundwater. Consequently, the results from the rapid and inexpensive reconnaissance technique provided functionally equivalent data.Publication No. 3672, Environmental Sciences Division, ORNL.Operated by Martin Marietta Energy Systems, Inc. for the U.S. Department of Energy under Contract No. DE-AC05-840R21400.     

Quantifying progress toward a conservation assessment for all plants

The Global Strategy for Plant Conservation (GSPC) set an ambitious target to achieve a conservation assessment for all known plant species by 2020. We consolidated digitally available plant conservation assessments and reconciled their scientific names and assessment status to predefined standards to provide a quantitative measure of progress toward this target. The 241,919 plant conservation assessments generated represent 111,824 accepted land plant species (vascular plants and bryophytes, not algae). At least 73,081 and up to 90,321 species have been assessed at the global scale, representing 21–26% of known plant species. Of these plant species, at least 27,148 and up to 32,542 are threatened. Eighty plant families, including some of the largest, such as Asteraceae, Orchidaceae, and Rubiaceae, are underassessed and should be the focus of assessment effort if the GSPC target is to be met by 2020. Our data set is accessible online (ThreatSearch) and is a baseline that can be used to directly support other GSPC targets and plant conservation action. Although around one‐quarter of a million plant assessments have been compiled, the majority of plants are still unassessed. The challenge now is to build on this progress and redouble efforts to document conservation status of unassessed plants to better inform conservation decisions and conserve the most threatened species.     

Relationship of Destruction Parameters to the Destruction/Removal Efficiency of PCBs

The destruction/removal efficiency (DRE), and the ability to accurately measure it, is a function of the concentration of the chemical compound in the input waste, the incinerator design and operation, sampling methods, and the analytical procedures. All of these are interrelated. This paper discusses the basic DRE equation [DRE = W_In W_out)/W_in × 100] and how it relates to some of the other destruction parameters. Some example data from the literature are presented. While PCBs have been used as the example, the equations and graphs are equally valid for some other hazardous compounds (POHCs), with the substitution of the 99.99% DRE requirement in lieu of the 99.9999% DRE for PCBs. The use of the relationships discussed in this paper should allow incinerator operators to more efficiently plan demonstration test burns which will adequately demonstrate the DRE.     

Formulation of cleanup standards for trace elements with probability plots

Probability plots of trace element concentrations may be used to partition, or segregate, sample data into its constituent populations. Two populations are typically present in data from sites requiring remedial action, one representing clean, uncontaminated soil or sediment (background) and the other representing contaminated ground. The use of such plots in the analysis and evaluation of environmental data permits a statistical characterization of the background populations, from which defensible cleanup criteria may be developed. These criteria will be environmentally conservative, yet will minimize the amount of soil removed in a remedial action. An example is given from a successful cleanup of a surface impoundment.