TPH-contaminated Mexican Refinery Soil: Health Risk Assessment and the First Year of Changes

The soil of a coastal Mexican refinery is quite contaminated, especially by hydrocarbons, with detected concentrations up to 130000 mg kg(-1) as TPHs (total petroleum hydrocarbons). The main sources of contamination are pipelines, valves, and old storage tanks, besides the land disposal of untreated hydrocarbon sediments derived from the cleaning of storage tanks. A health risk assessment (HRA) was carried out in order to measure the risk hazard indexes and clean-up standards for the refinery soil. HRA suggested the following actions to be taken: benzene concentrations must be reduced in eight of the 16 studied refinery zones to 0.0074-0.0078 mg kg(-1). Also, vanadium concentration must be reduced in two zones up to a concentration of 100 mg kg(-1). In only one of all of the studied zones, benzo(a)pyrene concentration must be reduced to 0.1 mg kg(-1). After 1 yr, TPHs showed a diminution of about 52%. Even though TPHs concentrations were variable, during 1999 the average concentrations were as much as 15.5 times the goal concentration. For year 2000, TPHs concentrations were only 7.4-fold the proposed value. For the 1999-2000 period, PAHs (polycyclic aromatic hydrocarbons) concentrations decreased by 82%. Some PAHs with 2, 3, 4, and 5 aromatic rings were removed up to 100% values.     

Leaf and fruit necroses associated with vanadium-rich ash emitted from a power plant burning fossil fuel

Necrotic brown lesions developing on leaves and fruits of lemon, and other plants, near fossil-fuel-burning power plants emitting vanadium-rich ash, were reproduced experimentally by inoculating leaves with this type of ash, which is strongly acidic. Comparable lesions were formed when drops of vanadium oxide, dissolved in NaOH, were put on leaves and fruits. Neutralizing, or adding excess H₂SO₄ (to pH 3), did not alter lesion formation. The histology of these lesions was similar to that of lesions attributed to vanadium-rich ash.     

Prenatal confirmation of trisomy 12 mosaicism by fetal skin biopsy

Trisomy 12 mosaicism diagnosed at 16 weeks' amniocentesis in a 42-year-old woman was not confirmed at 18 weeks' gestational age in amniotic fluid or fetal blood. Fetal skin biopsy performed at the same time did, however, allow the detection of trisomy 12 in 1 of 14 fibroblasts analysed. Fetal skin biopsy can be included within the diagnostic procedures to be performed when a level III mosaicism is found in the amniotic fluid.     

工程菌处理高纯二甲醚生产废水的研究

工程菌LEY7是以假单胞菌D3 菌株 (Pseudomonassp.D3 )为受体 ,以缓慢牙孢杆菌 3RM2 菌株 (Bacilluslentus 3RM2 ) ,假单胞菌W1 (Pseudomonassp .W1 )和W2 (Pseudomonassp .W2 )为供体 ,用多基因转化原生质球构建而成。工程菌LEY7能同时降解 4种化合物。用工程菌LEY7处理化工废水 ,工艺采用二级氧化。处理效果 :进水COD =10 0 0mg/L ,处理后出水COD在 10 0mg/L以下。COD去除率达到 90 %以上。     

Cardiovascular effects of arsenic: clinical and epidemiological findings

Several population studies relate exposure to high levels of arsenic with an increased incidence of ischemic heart disease and cardiovascular mortality. An association has been shown between exposure to high levels of arsenic and cardiovascular risk factors such as hypertension and diabetes mellitus, and vascular damage such as subclinical carotid atherosclerosis. The mechanisms underlying these phenomena are currently being studied and appear to indicate an alteration of vascular function. However, the effects of low levels of exposure to arsenic and their potential detrimental cardiovascular effect are less explored. The article provides an overview of the pathophysiologic mechanisms linking low-level arsenic exposure to the occurrence of cardiovascular disease and its complications, and some potential preventive strategies to implement.     

Diminution of migration of phthalic acid esters in tequila beverage by the year of production

Abstract

The presence of diethyl-phthalate (DEP), dibutyl-phthalate (DBP), butylbenzyl-phthalate (BBP), diethylhexyl-phthalate (DEHP) and diisononyl-phthalate (DINP) was determined in 295 tequila samples. They were grouped by age of maturation (white, aged, extra aged or ultra aged) and year of production (between 2013 and 2018). Gas Chromatography coupled with Mass Spectrometry was used for identification and quantification. The results showed that 65 samples (22% of the total) were phthalate free. DEP (0.13-0.27?mg/kg), BBP (0.05–2.91?mg/kg) and DINP (1.64–3.43?mg/kg) were detected in 11 (3.73%), 37 (12.54%) and 5 (1.69%) samples, respectively. But, these concentrations did not exceed the maximum permitted limits (MPL) of phthalates for alcoholic beverages. DBP (0.01–2.20?mg/kg) and DEHP (0.03–4.64?mg/kg) were detected in 96 (32.54%) and 224 (75.93%) samples, from them only 10 (3.39%) and 15 (5.08%) samples, respectively, exceeded the MPL for alcoholic beverages and they were few tequilas produced in the year 2014 or before. DEHP was the most frequent phthalate found in tequila and observed DEHP concentrations were 2-times higher in ultra aged tequilas compared to those in white tequilas. We concluded that all tequilas produced in 2015 and after, satisfied the international standards for these compounds.     

Molten carbonate fuel cells fed with biogas: Combating H2S

The use of biomass and waste to produce alternative fuels, due to environmental and energy security reasons, is a high-quality solution especially when integrated with high efficiency fuel cell applications. In this article we look into the coupling of an anaerobic digestion process of organic residues to electrochemical conversion to electricity and heat through a molten carbonate fuel cell (MCFC). In particular the pathway of the exceedingly harmful compound hydrogen sulphide (H₂S) in these phases is analysed. Hydrogen sulphide production in the biogas is strongly interrelated with methane and/or hydrogen yield, as well as with operating conditions like temperature and pH. When present in the produced biogas, this compound has multiple negative effects on the performance and durability of an MCFC. Therefore, there are important issues of integration to be solved.Three general approaches to solve the sulphur problem in the MCFC are possible. The first is to prevent the formation of hydrogen sulphide at the source: favouring conditions that inhibit its production during fermentation. Secondly, to identify the sulphur tolerance levels of the fuel cell components currently in use and develop sulphur-tolerant components that show long-term electrochemical performance and corrosion stability. The third approach is to remove the generated sulphur species to very low levels before the gas enters the fuel cell.     

Photoactivation and photoregeneration of TiO2/PAC mixture applied in suspension in water treatments: approach to a real application

Environmental Science and Pollution Research - The process TiO2/PAC/UV-vis has been under study and compared with the isolated treatments of adsorption and photocatalysis determining possible...     

Delayed association of acute particulate matter 2.5 air pollution exposure with loss of complexity in cardiac rhythm dynamics: insight from detrended fluctuation analysis

Environmental Science and Pollution Research - There is a delayed (lag 1 to 2 days) correlation between acute PM 2.5 (particulate matter <?2.5 μm in aerodynamic...