不同碳源条件下草菇内切型纤维素酶基因（eg1）转录表达的分析

利用Northernblot方法分析了不同碳源条件下草菇切型纤维素酶基因(eg1)的表达.结果发现,在含有纤维素的液体培养基中生长10d,eg1在草菇菌丝中有高效表达;纤维二糖、α-乳糖、β-乳糖,也能诱导eg1的表达,但和纤维素相比,eg1的表达量相对较低,并且它们的诱导效应在加入这类糖12h后迅速减弱;槐糖和龙胆二糖的诱导作用非常弱.在天然稻草为基质的固体栽培料生长时,草菇eg1的表达和草菇菌丝生长与出菇相对应,在菌丝生长期(d8)可见eg1的表达,d12时菌丝已长满,表达减弱,在出菇及菇体的分化及增大期,eg1的表达量逐渐增强,在成熟期达到最高水平;表明在草菇菇体发育中需要更多碳源及能源的补充,eg1在这方面起着非常重要的作用.图4参14     

A novel approach to evaluation of adsorbents for sampling indoor volatile organic compounds associated with symptom reports

This article addresses problems that complicate attempts to compare methods when several factors may be associated with an effect, but it is not known which factors are relevant. Chemicals that may contribute to 'sick building syndrome' (SBS), and thus should be sampled in investigations of SBS, are not currently known. A study was undertaken to compare the utility of three adsorbents (Carbopack B, Chromosorb 106 and Tenax TA) for detecting differences in personal chemical exposure to volatile organic compounds in indoor air, between persons with and without SBS symptoms (cases and controls). On the basis of office workers' responses to a questionnaire, 15 cases and 15 controls were chosen. They simultaneously carried diffusive samplers with adsorbents during a week at work, and the acquired samples were analysed by gas chromatography/mass spectrometry (GC/MS). The adsorbents were then compared in terms of their ability to separate cases and controls in partial least square discriminant analysis (PLS-DA) models. This method of comparison takes into account detected differences in chemical exposure between cases and controls measured with the different adsorbents. Tenax TA gave the best PLS-DA models for separating cases and controls, but a combination of measurements with Tenax TA and Carbopack B gave better PLS-DA models than models based on measurements from either adsorbent alone. Adding measurements from Chromosorb 106 did not improve the results.     

Capillary GC-MS analysis of PAH emissions from combustion of peat and wood in a hot water boiler

A preliminary investigation has been made on the emissions of Polynuclear Aromatic Hydrocarbons (PAH) when burning wood chips and peat in a modified commercial hot water boiler. The amount of the investigated eighteen PAH that were filter trapped from peat combustion averaged 2.7 times greater than that from wood combustion per cubic meter flue gas. The total emitted amount (particulate plus gas phase PAH) was 9.7 times greater than from wood combustion. The corresponding values for benzo(a)pyrene only were 1.7 and 3.5 times greater, respectively. The comparison of PAH emitted by the combustion of wood and peat showed a pronounced tendency towards the emission of high molecular weight PAH by the latter.Particulate phase-gas phase distribution ourves are presented for PAH in the boiling point range 336°C – 525°C. In addition, the emission of a polynuclear aromatic ketone is shown.     

Assessing state-wide biodiversity in the Florida Gap analysis project

The Florida Gap (Fl-Gap) project provides an assessment of the degree to which native animal species and natural communities are or are not represented in existing conservation lands. Those species and communities not adequately represented in areas being managed for native species constitute 'gaps' in the existing network of conservation lands. The United States Geological Survey Gap Analysis Program is a national effort and so, eventually, all 50 states will have completed it. The objective of Fl-Gap was to provide broad geographic information on the status of terrestrial vertebrates, butterflies, skippers and ants and their respective habitats to address the loss of biological diversity. To model the distributions and potential habitat of all terrestrial species of mammals, breeding birds, reptiles, amphibians, butterflies, skippers and ants in Florida, natural land cover was mapped to the level of dominant or co-dominant plant species. Land cover was classified from Landsat Thematic Mapper (TM) satellite imagery and auxiliary data such as the national wetlands inventory (NWI), soils maps, aerial imagery, existing land use/land cover maps, and on-the-ground surveys. Wildlife distribution models were produced by identifying suitable habitat for each species within that species' range. Mammalian models also assessed a minimum critical area required for sustainability of the species' population. Wildlife species richness was summarized against land stewardship ranked by an area's mandates for conservation protection.     

Selection of non-dioxin-like PCBs for in vitro testing on the basis of environmental abundance and molecular structure

The non-dioxin-like polychlorinated biphenyls (NDL-PCBs) constitute the major proportion of PCBs found in food and human tissues. It is important to improve our understanding of the toxicity, environmental and human risks associated with the NDL-PCBs, since their toxicology is incompletely characterized and a human health risk assessment is required. This paper discusses the selection of a training set of 20 tri- to hepta-chlorinated biphenyls, PCBs 19,28,47,51,52,53,74,95,100,101,104,118,122,128,136,138,153,170,180, and 190. Suggested for comprehensive screening using in vitro assays to identify critical mechanisms of toxicological action. The selected PCBs form a balanced basis for developing of quantitative structure-activity relationship (QSAR) models for prediction of physicochemical and toxicological properties of non-tested PCB congeners. Chemical and physical properties, environmental abundance and toxicological activities of the congeners were considered during the selection process. A complementary set of PCBs, a reference set, was selected using D-optimal onion design including PCBs 18,20,28,30,37,40,50,54,60,77,82,99,122,132,153,161,170,188,192, and 193. Congeners of this set are well suited for validation of QSAR models developed using the training set. For visualization of the chemical diversity of environmentally abundant PCBs and congeners of the training and reference sets, principal component analysis (PCA) was used. Statistical molecular design was used to verify the structural representation. As a reference structure for dioxin-like PCBs, PCB 126 was added in the training set. The selected set of NDL-PCBs is proposed for use in toxicological testing programs to provide rational basis for risk assessment of the NDL-PCBs.     

Linking patch-use behavior, resource density, and growth expectations in fish

Optimality theory rests on the assumptions that short-term foraging decisions are driven by variation in environmental quality, and that these decisions have important implications for long-term fitness. These assumptions, however, are rarely tested in a field setting. We linked behavioral foraging decisions in food patches with measures of environmental quality covering larger spatial (resource density) or temporal (growth parameters) scales. In 10 lakes, we measured the food density at which benthic fish give up foraging in experimental food patches (giving-up density, GUD), quantified the biomass of benthic invertebrates, and calculated the maximum individual size (L(infinity)) of bream (Abramis brama L.), a typical benthivore in these lakes. We found positive relationships between resource density and both GUD and L(infinity), and a positive relationship between L(infinity) and GUD. Prey characterized as vulnerable to predation contributed most to the relationships between resource density and either GUD or L(infinity). A path analysis showed that resource density and L(infinity) directly explained 54% and 28%, respectively, of the variation in GUD, whereas 86% of the variation in L(infinity) was explained by resource density, with mostly indirect contribution from GUD. We conclude that the short-term foraging behavior of benthivores matched our expectations based on optimality theory by being positively linked to variables on environmental quality operating at both a larger spatial scale and a longer temporal scale.     

Multivariate toxicity profiles and QSAR modeling of non-dioxin-like PCBs--an investigation of in vitro screening data from ultra-pure congeners

The non-dioxin-like PCBs (NDL-PCBs) found in food and human samples have a complex spectrum of adverse effects, but lack a detailed risk assessment. The toxicity profiles of 21 carefully selected PCBs (19 NDL-PCBs) were identified by in vitro screening in 17 different assays on specific endpoints related to neurotoxicity, endocrine disruption and tumor promotion. To ensure that the test results were not affected by polychlorinated dioxins, dibenzofurans or DL-PCB contaminants, the NDL-PCB congeners were thoroughly purified before testing. Principal component analysis (PCA) was used to derive general toxicity profiles from the in vitro screening data. The toxicity profiles indicated different structure-activity relationships (SAR) and distinct mechanisms of action. The analysis also indicated that the NDL-PCBs could be divided into two groups. The first group included generally smaller, ortho-substituted congeners, comprising PCB 28, 47, 51, 52, 53, 95, 100, 101, 104 and 136, with PCB 95, 101 and 136 as generally being most active. The second group comprising PCB 19, 74, 118, 122, 128, 138, 153, 170, 180 and 190 had lower biological activity in many of the assays, except for three endocrine-related assays. The most abundant congeners, PCB 138, 153, 170, 180 and 190, cluster in the second group, and thereby show similar SAR. Two quantitative structure-activity relationship (QSAR) models could be developed that added information to the SAR and could aid in risk assessments of NDL-PCBs. The QSAR models predicted a number of congeners as active and among these e.g., PCB 18, 25, 45 and 49 have been found in food or human samples.