Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

Effects of calcium hydroxide and calcium chloride addition to bentonite in iron ore pelletization.

Pyrite ash is created as waste from the roasting of pyrite ores during the production of sulphuric acid. These processes generate great amounts of pyrite ash waste that is generally land filled. This creates serious environmental pollution due to the release of acids and toxic substances. Pyrite ash waste can be utilized in the iron production industry as a blast furnace feed to process this waste and prevent environmental pollution. The essential parameters affecting the pelletization process of pyrite ash were studied using bentonite as a binder. Experiments were then carried out using bentonite and a mixture of bentonite with calcium hydroxide and calcium chloride in order to make the bentonite more effective. The metallurgical properties of pyrite ash, bentonite, calcium hydroxide, calcium chloride, a mixture of these and sintered pellets were studied using X-ray analysis. The crushing strength tests were carried out to investigate the strength of pyrite ash waste pellets. The results of these analyses showed that pyrite ash can be agglomerated to pellets and used in the iron production industry as a blast furnace feed. The crushing strength of the pellets containing calcium hydroxide and calcium chloride in addition to bentonite was better than the strength of pellets prepared using only bentonite binder.     

Working backwards to move forwards: Graph-based connectivity metrics for reserve network selection

In this paper we apply graph theory in a reserve selection exercise to explore the tradeoffs between maintaining connectivity and minimizing the total area of a protected area network. Rather than focus on a single organism, we used a multi-species approach and looked at the tradeoff curves for organisms with varying dispersal abilities. We first generated the tradeoff curves using a graph-based metric to determine the importance of individual patches for maintaining connectivity. We then performed an analogous set of analyses using patch size as a surrogate measure of importance.     

Parameter values to model the soil ingestion pathway

Soil ingestion is an important exposure pathway for contaminants that are not otherwise very mobile in the environment. Health of both humans and animals can be affected. This paper summarizes the literature and recommends models and probabilistic parameter values for risk assessment applications. Models of the pathway require estimates of the amounts of soil ingested, the concentration of contaminants relative to the original soil, and the bioavailability in the gut of the contaminants ingested with soil. Using a lead-contaminated sandbox as an example, the modelling recommendations suggest that a child typically may consume 50 mg d^–1 of the sandbox soil, the soil ingested will have a tenfold higher lead concentration than the original soil, and the lead will be as bioavailable as if ingested as inorganic lead in water.The Canadian Government right to retain a non-exclusive, royalty free licence in and to any copyright is acknowledged.     

Paleolimnological assessment of Grove and Plow Shop Ponds, Ayer, Massachusetts, USA--a superfund site

Three sediment cores from each of severely polluted Grove and Plow Shop Ponds, Ayer, Massachusetts, USA, were dated using (210)Pb, characterized for plant macrofossil assemblages, and analyzed for H(2)O, loss-on-ignition, stable Pb isotopes, and concentrations of As, Ca, Cd, Cr, Cu, Fe, Hg, methyl-Hg, Ni, Pb, and Zn. A core from nearby kettle Spectacle Pond, Littleton, Massachusetts, was similarly characterized (except for plant macrofossil assemblages) to assess the regional air pollution signal in sediment for comparison with the six cores. Accumulation rates for metals (mass per area per year), the anthropogenic component (mass per area per year), and total accumulation of the anthropogenic component (mass per area) indicate that As, Cd, Cr, Cu, Hg, methyl-Hg, Ni, Pb, and Zn have accumulated in sediment as a consequence of point source pollution from within the drainage basins of Grove and Plow Shop Ponds. Three distinct sources of pollution are inferred. As is entering Plow Shop Pond via groundwater in the southwest. Cd, Ni, Pb, and Zn are entering the system predominantly at the eastern end of, or upstream from, Grove Pond. Pb also comes from the northwest corner of Grove Pond, the principal source of Cr, Cu, and Hg. These results are consistent with chemistry of modern surface sediments. The history of pollution extends back more than 100 years. Intra- and inter-core variability of concentrations and accumulation rates indicate that much of the pollution was likely in particulate form with little physical redistribution. Recently, concentrations and accumulation rates have generally decreased substantially for those elements present in excessive concentrations in the past. This is a consequence of accumulation of recent, less polluted sediment. In Spectacle Pond, the nearby reference lake, accumulation rates for As, Cd, Hg, and Pb, adjusted for background values and changes in sedimentation rate, increased above background starting in the late 19th century, peaked about 1980, and declined substantially to 2000. These decreases suggest that the anthropogenic (pollution) component of atmospheric deposition of these elements declined after 1980 by at least 50%(As), 80%(Cd), 80%(Hg), and 80%(Pb).     

Naphthalene and its biomarkers as measures of occupational exposure to polycyclic aromatic hydrocarbons

Polycyclic aromatic hydrocarbons (PAH) include compounds with two or more fused benzene rings, many of which are carcinogens. Industrial sources produce hundreds of PAH, notably in the coke- and aluminium-producing industries. Because PAH are distributed at varying levels between gaseous and particulate phases, exposure assessment has been problematic. Here, we recommend that occupational exposures to naphthalene be considered as a potential surrogate for occupational PAH exposure for three reasons. Naphthalene is usually the most abundant PAH in a given workplace; naphthalene is present almost entirely in the gaseous phase and is, therefore, easily measured; and naphthalene offers several useful biomarkers, including the urinary metabolites 1- and 2-hydroxynaphthalene. These biomarkers can be used to evaluate total-body exposure to PAH, in much the same way that 1-hydroxypyrene has been applied. Using data from published sources, we show that log-transformed airborne levels of naphthalene are highly correlated with those of total PAH (minus naphthalene) in several industries (creosote impregnation: Pearson r= 0.815, coke production: r= 0.917, iron foundry: r= 0.854, aluminium production: r= 0.933). Furthermore, the slopes of the log-log regressions are close to one indicating that naphthalene levels are proportional to those of total PAH in those industries. We also demonstrate that log-transformed urinary levels of the hydroxynaphthalenes are highly correlated with those of 1-hydroxypyrene among coke oven workers and controls (r= 0.857 and 0.876), again with slopes of log-log regressions close to one. These results support the conjecture that naphthalene is a useful metric for occupational PAH exposure. Since naphthalene has also been shown to be a respiratory carcinogen in several animal studies, it is also argued that naphthalene exposures should be monitored per se in industries with high levels of PAH.