Indoor and outdoor formaldehyde concentrations in homes in residential areas in Greater Cairo

Indoor and outdoor measurements of formaldehyde were conducted at seven flats located in residential areas in Greater Cairo, during spring and summer seasons 1999. The mean daytime formaldehyde concentrations in kitchens, bedrooms and living rooms were 89, 100 and 100 ppb, respectively, in the seven flats. Significant positive correlations were found between the concentrations of formaldehyde found in these three rooms. On the other hand, no significant differences were found between the mean formaldehyde concentrations in these three rooms. The maximum mean concentration of formaldehyde (147 ppb) was recorded in a new flat, while the minimum concentration (43 ppb) was observed in an old flat. The maximum hourly and daytime concentrations were 350 and 225 ppb, respectively. Air temperature, relative humidity and the age of the flat are factors affecting the emission and concentration of formaldehyde. The maximum indoor and outdoor formaldehyde concentrations were recorded during the summer season. During the spring, 38% of the samples indicated that the concentration of formaldehyde in the seven flats exceeded 0.1 ppm, the American Society of Heating, Refrigerating, and Air Conditioning Engineers' (ASHRAE) standard; in the summer, this figure increased to 53%.     

Current status and research on E-waste issues in Asia

Rapid economic growth in Asia and the increasing transboundary movement of secondary resources will increasingly require both 3R endeavors (reduce, reuse, recycle) in each country and appropriate control of international material cycles. Recently, managing electrical and electronic waste (E-waste) has become an important target for domestic and international material cycles from the viewpoints of environmental preservation and resource utilization efficiency. To understand the current status of E-waste issues in the context of international material cycles and to discuss the future tasks related to achieving 3R in the region, we organized the National Institute for Environmental Studies (NIES) E-waste Workshop in December 2004. This article reviews past studies on E-waste and briefly describes the topics presented and discussions held at the workshop. The topics at the workshop included E-waste generation, recycling systems, international trade, and environmental impacts. In addition, we discussed various issues such as terminology, current environmental concerns, and possible solutions. Transboundary shipments of E-waste should be conducted taking into consideration the concept of sustainable development. The direction of future research and possible collaborations are also discussed.     

Reuse of secondhand TVs exported from Japan to the Philippines

The trade of secondhand electrical and electronic equipment (EEE) from developed to developing countries has become a growing environmental issue owing to concerns about improper recycling of these goods in developing countries. We followed a 12-m cargo container of cathode-ray-tube color TVs exported from Japan to the Philippines in February 2008. We surveyed the number of TVs damaged in transport, as well as the number of malfunctioning TVs from this shipment. In addition, we present the results of interviews with 113 Filipino consumers who intended to buy secondhand EEE at nine secondhand shops in Metro Manila. Approximately 3% of the imported TVs were damaged upon arrival. The importer sold some of the units directly to local dealers, and kept the rest to repair, refurbish and resell. Approximately 40% of the imported TVs malfunctioned and needed repair in addition to basic reconditioning. Most interviewees indicated that they prefer to buy secondhand EEE because the prices are lower than those of brand-new products. Consumers indicated that they planned on using the product for an average of about 5 years, but the actual period of use may be lower. Most end-of-life EEE in the Philippines is dismantled and recycled by unregulated companies and untrained individuals in markets or near landfill sites, and it is clear that a proper collection system and treatment methods are needed for e-waste. In addition to the material flow of secondhand TVs, we also discuss several economic aspects and appropriate control measures of the international reuse of secondhand TVs.     

Biomonitoring in the Boulder River Watershed, Montana, USA: Metal Concentrations in Biofilm and Macroinvertebrates, and Relations with Macroinvertebrate Assemblage

Portions of the Boulder River watershed contain elevated concentrations of arsenic, cadmium, copper, lead, and zinc in water, sediment, and biota. We measured concentrations of As, Cd, Cu, Pb, and Zn in biofilm and macroinvertebrates, and assessed macroinvertebrate assemblage and aquatic habitat with the objective of monitoring planned remediation efforts. Concentrations of metals were generally higher in downstream sites compared with upstream or reference sites, and two sites contained metal concentrations in macroinvertebrates greater than values reported to reduce health and survival of resident trout. Macroinvertebrate assemblage was correlated with metal concentrations in biofilm and macroinvertebrates. However, macroinvertebrate metrics were significantly correlated with a greater number of biofilm metals (8) than metals in invertebrates (4). Lead concentrations in biofilm appeared to have the most significant impact on macroinvertebrate assemblage. Metal concentrations in macroinvertebrates were directly proportional to concentrations in biofilm, indicating biofilm as a potential surrogate for monitoring metal impacts in aquatic systems.     

A novel one-step synthesis for carbon-based nanomaterials from polyethylene terephthalate (PET) bottles waste

Nowadays our planet suffers from an accumulation of plastic products that have the potential to cause great harm to the environment in the form of air, water, and land pollution. Plastic water bottles have become a great problem in the environment because of the large numbers consumed throughout the world. Certain types of plastic bottles can be recycled but most of them are not. This paper describes an economical solvent-free process that converts polyethylene terephthalate (PET) bottles waste into carbon nanostructure materials via thermal dissociation in a closed system under autogenic pressure together with additives and/or catalyst, which can act as cluster nuclei for carbon nanostructure materials such as fullerenes and carbon nanotubes. This research succeeded in producing and controlling the microstructure of various forms of carbon nanoparticles from the PET waste by optimizing the preparation parameters in terms of time, additives, and amounts of catalyst.

Implications: Plastic water bottles are becoming a growing segment of the municipal solid waste stream in the world; some are recycled but many are left in landfill sites. Recycling PET bottles waste can positively impact the environment in several ways: for instance, reduced waste, resource conservation, energy conservation, reduced greenhouse gas emissions, and decreasing the amount of pollution in air and water sources. The main novelty of the present work is based on the acquisition of high-value carbon-based nanomaterials from PET waste by a simple solvent-free chemical technique. Thus, the prepared materials are considered to be promising, cheap, eco-friendly materials that may find use in different applications.     

Material cycles in Asia: especially the recycling loop between Japan and China

In this article, we clarify the current status of Japanese exports and Chinese imports of secondary resources. A total of around 10 million metric tons (t) of secondary resources are exported annually from Japan to China, Hong Kong, and Korea. Hong Kong plays the role of a transshipment point, especially regarding the trade in plastic waste, and China imports much from the USA and Japan, often through Hong Kong. The secondary resources exported from Japan include both byproducts from manufacturing processes and end-of-life products or materials. The great demand in China, and the difference in prices between countries, drive this transboundary shipment, although Japan has enacted various recycling laws that were implicitly intended to promote domestic recycling. In China, the imported secondary resources are recycled, usually by means of primitive and low-cost hand labor. The greatest concern is whether there are still improper (illegal or polluting) recycling activities in China. International material cycles should prevent environmental pollution and ensure efficient resource utilization. To that end, the following measures are needed: cooperative control of the trade of secondary resources between countries, the alignment of domestic laws with the regulations in other countries based on the actual trade activities, and the realization of sound practices for global resources management.     

Validation of QuEChERS-based method for determination of flusilazole residues in grape by high-performance liquid chromatography with photodiode array detector

A high-performance liquid chromatography with photodiode array detector analytical method was developed to determine the residue levels of flusilazole in grape and investigate the dissipation pattern and safety. The results showed that the mean recoveries were in the range of 86%–90%. Limits of detection and quantification were 0.008 and 0.02 mg/kg, respectively. The residue levels of flusilazole were best described by first-order rate kinetics and with half-lives ranging from 4.2 days (recommended dose) to 4.6 days (double the recommended dose). In conclusion, flusilazole at the recommended or even at double the recommended doses does not pose any apparent hazards to consumers.     

Speciation of organotin compounds in sediments of semi-closed areas along the Mediterranean coast of Alexandria

Organotin compounds were measured in sediments of four different semi-closed areas of the Mediterranean coast of Alexandria: the Eastern Harbour, Western Harbour, El-Max Bay, and Abu-Qir Bay. Due to the commercial trade activity inside the Western Harbour, in addition to the effect of wastes discharged from El Noubaria canal, it shows the highest concentrations of total tin (6.34 μg g^-1 dry weight), dibutyl tin (1.63 μg g^-1 wet weight), tributyl tin (0.33 μg g^-1 wet weight) and diphenyl tin (1.06 μg g^-1 wet weight) compared with other locations. The concentrations of TBT species showed the highest contents compared with DBT and DPhT compounds in all sampling areas. This trend might be due to the worldwide use of TBT not only as biocides in antifouling paints but also as preserving agents for wood, fungicides in agricultural activities, and heat and UV stabilizers of PVC, which results in a direct release of TBT into the water body, accumulation in aquatic fauna. There is also precipitation into sediments and a decrease in degradation rate into its derivatives. Variations, types, concentrations, and distribution of different organotin compounds are discussed in the areas under investigation. The study reveals a new record of organotin compounds along the Alexandria coast and makes comparisons with other surrounding areas of interest.     

Benefits of protected areas for nonbreeding waterbirds adjusting their distributions under climate warming

Climate warming is driving changes in species distributions and community composition. Many species have a so-called climatic debt, that is, shifts in range lag behind shifts in temperature isoclines. Inside protected areas (PAs), community changes in response to climate warming can be facilitated by greater colonization rates by warm-dwelling species, but also mitigated by lowering extirpation rates of cold-dwelling species. An evaluation of the relative importance of colonization-extirpation processes is important to inform conservation strategies that aim for both climate debt reduction and species conservation. We assessed the colonization-extirpation dynamics involved in community changes in response to climate inside and outside PAs. To do so, we used 25 years of occurrence data of nonbreeding waterbirds in the western Palearctic (97 species, 7071 sites, 39 countries, 1993–2017). We used a community temperature index (CTI) framework based on species thermal affinities to investigate species turnover induced by temperature increase. We determined whether thermal community adjustment was associated with colonization by warm-dwelling species or extirpation of cold-dwelling species by modeling change in standard deviation of the CTI (CTI_SD). Using linear mixed-effects models, we investigated whether communities in PAs had lower climatic debt and different patterns of community change than communities outside PAs. For CTI and CTI_SD combined, communities inside PAs had more species, higher colonization, lower extirpation, and lower climatic debt (16%) than communities outside PAs. Thus, our results suggest that PAs facilitate 2 independent processes that shape community dynamics and maintain biodiversity. The community adjustment was, however, not sufficiently fast to keep pace with the large temperature increases in the central and northeastern western Palearctic. Our results underline the potential of combining CTI and CTI_SD metrics to improve understanding of the colonization-extirpation patterns driven by climate warming.     

Residues and dissipation of the pesticide emamectin benzoate under Egyptian field condition: a case study

A simple, rapid analytical procedure for the quantification of emamectin benzoate in tomato was developed using high performance liquid chromatography with fluorescence detector (HPLC-FLD). Emamectin benzoate residues were extracted from tomato samples with n-hexane:ethyl acetate (1:1, v/v). The method involved derivatization using trifluoroacetic anhydride and 1-methylimidazole, prior to analysis by HPLC-FLD. Limit of quantification of this method was found to be 0.01 mg/kg, while limit of detection was 0.005 mg/kg. The dissipation of emamectin benzoate on tomato was studied, and half-life (t_1/2) was estimated in a field study carried out at three different locations. Emamectin benzoate was sprayed on tomato at recommended dosage. Samples of tomato were collected at 0, 1, 3, 7, 10, and 15 days after treatment. The t_1/2 of emamectin benzoate when applied at the recommended doses in tomato was approximately 2.5 days. The residue of emamectin benzoate reached below the maximal residue limit (MRL) 10 days after spraying at the tested dosage. Hence, a safe pre-harvest interval of 10 days is suggested before harvesting of tomato. This study would also be helpful for the Egypt government to establish the MRL of emamectin benzoate in tomatoes and provide guidance on the proper and safe use of this insecticide.