再燃脱硝的动力学模拟和组分影响分析

采用Gear算法模拟了再燃脱硝再燃区中化学反应过程，反应的热力学和动力学参数采用GRI3．0,模拟结果和实验结果作比较，说明该模拟可以用于预测再燃脱硝的基本过程。在模拟的基础上讨论了不同再燃燃料及其中的不同组分如HCN、NH3、H2和CO等对脱硝效果的影响。     

再燃法烟气脱硝技术

综述了再燃法烟气脱硝技术及其主要影响因素。通过对几种脱硝技术的分析比较，认为再燃脱硝是一种很有前景的脱硝技术，其投资和运行费用界于低NO。燃烧器和选择性催化还原技术之间，有喷氨条件下的先进再燃脱硝效率接近于选择性催化还原技术。总结了国内外对先进再燃脱硝技术各种参数影响条件的研究结果，并论述了该技术的应用要点。     

利用废旧锌锰电池制备光催化剂净化甲苯

针对废旧锌锰电池回收利用难,以及光催化剂 TiO2活性低的问题,以废旧锌锰电池和商业二氧化钛为原料,通过球磨法制备了新型复合光催化剂.在紫外光灯照射下,进行了废旧锌锰电池复合改性TiO2对甲苯的光催化氧化实验,并重点探究空速、光照强度、相对湿度和氧气体积分数等关键实验条件对甲苯净化效率的影响.结果表明,改性后的催化剂对甲苯的净化能力大幅提高;当TiO2与废电池芯粉的质量比为2:1时,催化剂的催化效果最好,甲苯的净化效率提高了近45％;空速越大,催化剂对甲苯的净化效率越低;净化效率随光照强度的增加呈现先增加后保持不变的规律;催化剂在相对湿度为30％的条件下具有最佳的催化活性,氧气体积分数为15％时为净化效率达到最大.本研究结果可为废旧锌锰电池的回收利用提供新的思路.     

Mn-CeOx/钛基层柱粘土(Ti-PILCs)低温选择性催化还原催化剂的钙中毒研究

以钛基层柱粘土(Ti-PILCs)为载体,制备了Mn-Ceox/Ti-PILCs低温选择性催化还原(SCR)催化剂,采用浸溃法模拟了催化剂钙中毒,研究了不同含钙量对催化剂活性的影响,并运用NH3-程序升温脱附(TPD)、H2-程序升温还原(TPR)及X射线光电子能谱(XPS)表征,分析了钙对催化剂的失活作用.结果表明:...     

Iron-doped Mn-Ce/TiO2 catalyst for low temperature selective catalytic reduction of NO with NH3

The catalysts of iron-doped Mn-Ce/TiO 2(Fe-Mn-Ce/TiO 2) prepared by sol-gel method were investigated for low temperature selective catalytic reduction(SCR) of NO with NH 3.It was found that the NO conversion over Fe-Mn-Ce/TiO 2 was obviously improved after iron doping compared with that over Mn-Ce/TiO 2.Fe-Mn-Ce/TiO 2 with the molar ratio of Fe/Ti = 0.1 exhibited the highest activity.The results showed that 96.8% NO conversion was obtained over Fe(0.1)-Mn-Ce/TiO 2 at 180°C at a space velocity of 50,000 hr 1.Fe-Mn-Ce/TiO 2 exhibited much higher resistance to H 2 O and SO 2 than that of Mn-Ce/TiO 2.The properties of the catalysts were characterized using X-ray diffraction(XRD),N 2 adsorption,temperature programmed desorption(NH 3-TPD and NOx-TPD),and Xray photoelectron spectroscopy(XPS) techniques.BET,NH3-TPD and NOx-TPD results showed that the specific surface area and NH3 and NOx adsorption capacity of the catalysts increased with iron doping.It was known from XPS analysis that iron valence state on the surface of the catalysts were in Fe3+ state.The doping of iron enhanced the dispersion and oxidation state of Mn and Ce on the surface of the catalysts.The oxygen concentrations on the surface of the catalysts were found to increase after iron doping.Fe-Mn-Ce/TiO2 represented a promising catalyst for low temperature SCR of NO with NH3 in the presence of H2 O and SO2.     

Removal of elemental mercury by KI-impregnated clay

This study described the use of clay impregnated by KI in gas phase elemental mercury (Hg^o) removal in flue gas. The effects of KI loading, temperature, O₂, SO₂ and H₂O on Hg^o removal were investigated using a fixed bed reactor. The Hg^o removal efficiency of KI-clay with 3% KI loading could maintain at a high level (approximately 80 %) after 3 h. The KI-clay demonstrated to be a potential adsorbent for Hg^o removal when compared with activated carbon based adsorbent. O₂ was found to be an important factor in improving the Hg^o removal. O₂ was demonstrated to assist the transfer of KI to I₂ on the surface of KI-clay, which could react with Hg^o directly. NO and SO₂ could slightly improve Hg^o removal, while H₂O inhibited it greatly. The results indicated that after adsorption, most of the mercury escaped from the surface again. Some of the mercury may have been oxidized as it left the surface. The results demonstrated that the chemical reaction primarily occurred between KI and mercury on the surface of the KI-clay.     

工业燃煤锅炉烟气循环方式下飞灰的汞吸附特性

为探究燃煤锅炉烟气循环方式下飞灰汞的吸附特性,利用固定床汞吸附装置,对立式煤粉沉降炉不同模拟烟气循环工况条件下形成的飞灰汞吸附特性进行了研究,重点考察了烟气循环比例、煤种、关键燃烧气体组分等因素的影响.结果表明:①烟气循环工况条件下形成的飞灰汞吸附能力明显优于非烟气循环工况（空气燃烧）条件下形成的飞灰,并且随烟气循环比例的增加,飞灰汞吸附量呈逐渐增加趋势.褐煤在净烟气循环比例为60%、40%、20%的条件下形成的飞灰汞吸附量分别是非烟气循环条件下的3.0、2.3和1.6倍.②烟气循环引起燃烧气体氛围中ρ（SO₂）与ρ（NO）的变化会影响飞灰的物化特性及其汞吸附性能.随燃烧氛围中ρ（SO₂）的提高,飞灰汞吸附量先增后减.烟气循环比例为40%且燃烧气体氛围中ρ（NO）为803 mg/m3条件下,ρ（SO₂）为2 857 mg/m3时褐煤与烟煤燃烧形成的飞灰汞吸附量较高（分别为0.45和0.75 μg/g）,分别较ρ（SO₂）为1 428和4 286 mg/m3时提高了25%~300%和53%~78%.随燃烧氛围中ρ（NO）的提高,飞灰汞吸附量呈逐渐增加趋势.烟气循环比例为40%且燃烧气体氛围中ρ（SO₂）为2 857 mg/m3条件下,ρ（NO）为1 205 mg/m3时褐煤和烟煤燃烧形成的飞灰汞吸附量较高,分别较ρ（NO）为803和402 mg/m3时提高了1.2~3.6和1.1~1.6倍.③飞灰中UBC（未燃尽碳）、CaO、MgO及Fe₂O₃可促进飞灰对汞的吸附.与褐煤飞灰相比,烟煤飞灰表现出更优的汞吸附性能,与UBC、CaO、MgO及Fe₂O₃在飞灰中的含量存在一定的正相关性.研究显示,烟气循环方式下飞灰汞吸附特性发生明显变化,煤质的合理选择、烟气循环比例、循环气体成分及浓度参数的优化控制可显著改善燃煤锅炉烟气中汞的排放控制效果.      

Emission control strategies of hazardous trace elements from coal-fired power plants in China

China's energy dependents on coal due to the abundance and low cost of coal. Coal provides a secure and stable energy source in China. Over-dependence on coal results in the emission of Hazardous Trace Elements (HTEs) including selenium (Se), mercury (Hg), lead (Pb), arsenic (As), etc., from Coal-Fired Power Plants (CFPPs), which are the major toxic air pollutants causing widespread concern. For this reason, it is essential to provide a succinct analysis of the main HTEs emission control techniques while concurrently identifying the research prospects framework and specifying future research directions. The study herein reviews various techniques applied in China for the selected HTEs emission control, including the technical, institutional, policy, and regulatory aspects. The specific areas covered in this study include health effects, future coal production and consumption, the current situation of HTEs in Chinese coal, the chemistry of selected HTEs, control techniques, policies, and action plans safeguarding the emission control. The review emphasizes the fact that China must establish and promote efficient and clean ways to utilize coal in order to realize sustainable development. The principal conclusion is that cleaning coal technologies and fuel substitution should be great potential HTEs control technologies in China. Future research should focus on the simultaneous removal of HTEs, PM, SOx, and NOx in the complex flue gas.     

以粉煤灰和电石渣为催化剂的聚丙烯裂解模型研究

对粉煤灰和电石渣为催化剂的聚丙烯裂解进行模型研究.通过模型计算了裂解反应的表观活化能、频率因子、反应级数等.模型计算表明随着反应温度的升高反应速率增加,达到相同转化率所需反应时间减少.当剂塑比从0增加到30%时,聚丙烯裂解的活化能呈现降低的趋势,特别当剂塑比为30%时,其活化能降低约50%.说明粉煤灰和电石渣对聚丙烯裂解具有一定的催化效果.     

废轮胎热解炭黑及其改性后的特性研究

对废轮胎热解炭黑(简称热解炭黑)采用硝酸酸洗及酸洗后加入硬脂酸2种改性方法,制备出热解炭黑、酸洗炭黑及硬脂酸改性酸洗炭黑3种炭黑。运用SEM、XPS等分析手段进行了表征。研究表明,硝酸酸洗后热解炭黑的灰分从20.5%降到了4.0%,BET表面积从54.92 m2/g增大到69.62 m2/g,DBP吸收值从123 mL/100g提高到170 mL/100 g。加入硬脂酸后BET表面积和DBP吸收值略有下降。XPS结果显示:热解炭黑表面覆盖有碳质沉积物,表面官能团极性较低;酸洗炭黑表面C—C,C—H含量降低,C—OR、C—OEt和COOR、COOH官能团含量增加;硬脂酸改性后表面含碳官能团基本没有变化,但其表面双键氧的含量高于热解炭黑和酸洗炭黑。