Biodiesel production from vegetable oil and waste animal fats in a pilot plant

In this study, corn oil as vegetable oil, chicken fat and fleshing oil as animal fats were used to produce methyl ester in a biodiesel pilot plant. The FFA level of the corn oil was below 1% while those of animal fats were too high to produce biodiesel via base catalyst. Therefore, it was needed to perform pretreatment reaction for the animal fats. For this aim, sulfuric acid was used as catalyst and methanol was used as alcohol in the pretreatment reactions. After reducing the FFA level of the animal fats to less than 1%, the transesterification reaction was completed with alkaline catalyst. Due to low FFA content of corn oil, it was directly subjected to transesterification. Potassium hydroxide was used as catalyst and methanol was used as alcohol for transesterification reactions. The fuel properties of methyl esters produced in the biodiesel pilot plant were characterized and compared to EN 14214 and ASTM D6751 biodiesel standards. According to the results, ester yield values of animal fat methyl esters were slightly lower than that of the corn oil methyl ester (COME). The production cost of COME was higher than those of animal fat methyl esters due to being high cost biodiesel feedstock. The fuel properties of produced methyl esters were close to each other. Especially, the sulfur content and cold flow properties of the COME were lower than those of animal fat methyl esters. The measured fuel properties of all produced methyl esters met ASTM D6751 (S500) biodiesel fuel standards.     

Utilization of red mud as catalyst in conversion of waste oil and waste plastics to fuel

The aim of this study was to investigate the possibilities of using a by-product (red mud) from alumina production as a catalyst for recovery of waste. The conversion of waste mineral oil (WMO) and waste mineral oil/municipal waste plastic (WMO/MWP) blends over red mud (RM), a commercial hydrocracking catalyst (silica–alumina), and a commercial hydrotreating catalyst (Ni–Mo/alumina) to fuel has been studied. The effect of the catalyst and the temperature on the product distribution (gas, liquid, and wax) and the properties of liquid products were investigated. In the case of hydrotreatment of WMO, the liquids obtained over RM at both 400° and 425°C had larger amounts of low-boiling hydrocarbons than that of thermal or catalytic treatment with hydrotreating catalyst. Gas chromatography and nuclear magnetic resonance analysis of the liquid products showed that RM had hydrogenation and cracking activity in hydrotreatment of WMO. In coprocessing of WMO with municipal waste plastics, temperature had an important effect as well as the amount of MWP in the blend and the catalyst type. The hydrocracking at 400°C produced no liquid product. In hydrocracking at 425°C, the product distribution varied with catalyst type and MWP amount. The commercial hydrocracking catalyst had more cracking ability in the conversion of WMO/MWP to liquid and gas fuel than RM. In the case of hydrocracking over RM, the largest amount of liquid having satisfactory quality was obtained only from the blend containing 20% MWP.     

Production and Purification of Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) Degrading Enzyme from Streptomyces sp. AF-111

A poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) degrading bacterial strain designated as AF-111 was isolated from sewage sludge sample. The bacterium was identified by 16S rRNA gene sequencing. The results revealed that strain AF-111 showed 99 % similarity with Streptomyces althioticus strain NRRL B-3981 and designated as Streptomyces sp. strain AF-111. An extracellular PHBV depolymerase enzyme was produced under optimized conditions and purified through ammonium sulphate fractionation and column chromatography. The enzyme was purified to homogeneity, indicated by sodium dodecyl sulfate–polyacrylamide gel electrophoresis and molecular weight was found to be approximately 51 kDa. Effect of temperature, pH, metal ions and inhibitors on the PHBV depolymerase activity was determined. The enzyme was stable at wide range of temperature (35–55 °C) and pH (6–8). PHBV depolymerase was stable in the presence of different metal ions except iron and zinc which had inhibitory effect on depolymerase activity. Both ethylenediamine teteracetic acid and phenylmethyl sulphonyl fluoride strongly inhibited enzyme activity which indicates that this enzyme belongs to the serine hydrolase family like other polyhydroxyalkanoate depolymerases. The results show that a depolymerase from strain AF-111 can effectively degrade PHBV, therefore, it can be applied in the process of biochemical monomer recycling.     

Determination of Cadmium Levels in Agricultural Areas of Çarşamba and Bafra Plains

Cadmium pollution resulted from fertilizer applications were studied by determining cadmium levels in agricultural and non-agricultural soils of Bafra and Çar?amba plains. Soil samples of 68 were collected from agricultural (34) and non-agricultural (34) areas. The sample of 2 g was placed in a test tube and digested with hydrochloric acid and nitric acid mixture (3:1, v/v) in an aluminum block. Taking up the evaporated residue was dissolved in 1% nitric acid and total cadmium concentrations were determined with GF-AAS. Mean level of cadmium contents were found in agricultural areas 0.162?±?0.078 for Çar?amba and 0.433?±?0.288 mg kg^?1 for Bafra. The accuracy of the method was tested with determining cadmium contents of standard reference material and cadmium spiked soil samples.     

A study on the determination of the natural park’s sustainable tourism potential

The surface site of Yesilyuva Nature Park encompasses natural, social, economic, and cultural characteristics and has become a marker of the region’s natural and cultural heritage. To support the preservation of this site, promotional activities should be planned. In this study, because of tourism and related opinions of residents and visitors alike in terms of their natural determination, an important cultural and historical feature is aimed at evaluating the tourism potential of Yesilyuva Nature Park. This framework is designed to establish prospective tourism sustainability. As a result, Yesilyuva Nature Park’s natural and cultural properties have been determined to be suitable for sustainable tourism activities using geographic information systems (GIS). This protection in the field, which balances sustainability and landscape design, will provide for the development of tourism activities. In the Strengths, Weaknesses, Opportunities and Threats (SWOT) analysis and survey, residents and visitors reported that the most important feature of the Yesilyuva Nature Park was its natural beauty. Visitors often come to observe traditional and natural life and to engage in tourism activities. All the data, which includes maps derived from GIS, represents landscape planning for sustainable tourism areas in Yesilyuva Nature Park.     

Flue gas treatability studies: a tool for techno-economic control of industrial air pollution

Air pollution problems in developing countries have gained larger fraction in the last decade especially due to non functioning and non implementation of effective air pollutioncontrol devices in industries. In industrial wastewater management, adequate treatability studies are conducted to arrive at a techno-economic treatment option. However no suchstudies were done for reducing air pollution or emission fromindustries until now in India. Little information was availableabout such studies in other countries. This article provides information about a novel technique known asflue gas treatability studies and to undertake such studies, a pilot scale system is installed in Air Pollution Control Divisionof M/s National Environmental Engineering research Institute, NEERI, Nagpur-20, India. This study is a tool for techno-economicselection of air pollution control systems specially for small/medium scale industrial emissions.     

An Analogy on Assessment of Urban Air Pollution in Turkey Over the Turn of the Millennium (1992–2001)

Rapid industrialization and urbanization in Turkey, especially over the last twenty five years, has provided better living standards to its residents, but it also caused a decrease in environmental quality. In late 1970's, air quality monitoring activities were started in some major cities by individual researchers in Turkey. It was just around the 1990's that a countrywide program on continuous air pollution monitoring in major province centers and selected large towns was launched. The impact of air pollution on people depend on various factors, such as existence and magnitude of coal powered energy generation plants, type of urban heating and their efficiency, and the numbers and specifications of vehicles. In this study, current Turkish urban air quality over the turn of the Millennium (1992–2001) is studied in the light of the country's worst cities in terms of outdoor air quality, the number of upper respiratory diseases, sinusitis, bronchitis, and pneumonia cases in these provinces reported by the state medical treatment facilities in 2001. The population that is under outdoor urban air pollution hazard was computed. A comparative analysis between the provinces that use natural gas and others that use fossil fuels was also completed in order to project monetary gains if the studied provinces will transform their indoor heating and industrial operations to be run by natural gas or other cleaner energy sources. If natural gas use in air polluted urban centers could be realized in the near future, approximately 212 to 350 million US dollars per annum could to be saved just by reducing health related problems caused by outdoor air pollution.     

Modeling of agricultural drought risk pattern using Markov chain and GIS in the western part of Bangladesh

The aim of the study is to assess the agricultural drought risk condition in the context of global climate change in the western part of Bangladesh that covers about 45% area of the country for the period of 1960–2011. Drought Index (DI) and Drought Hazard Index (DHI) have been calculated by Markov Chain analysis and that of Drought Vulnerability Index (DVI) from socioeconomic and physical indicators. The DI values show that the northern part in general is more drought-prone, having less crops prospect, whereas the southern part is less drought-prone with high crop potentiality. The probability of extreme drought occurrence increases in recent decades in some parts as a result the drought events become more frequent in the areas. The DHI ranges from 15 to 32, and northern part suffers from more extreme drought hazards than that of southern part. DVI also indicates that northern part is exposed to high to very high drought vulnerability as higher percentage of illiterate people are involved in agricultural practices and high percentage of irrigation to cultivable land, but southern part exposed to moderate to low vulnerability because of low values of vulnerability indicators. Finally, agricultural drought exists at high risk condition in northern part and low in southern parts and 21.63, 26.54 and 29.68% of the area poses very high, high and moderate risk, respectively. So, immediate adaptation measures are needed keeping in mind climate features like rainfall and temperature variability, drought risk and risk ranking to make viable adaptation measures.     

Determination of heavy metals and metals levels in five fish species from I??kl? Dam Lake and Karaca?ren Dam Lake (Turkey)

The concentrations of heavy metals and metals (Zn, Pb, Bi, Cd, Ni, Co, Fe, Mn, Mg, Cu, Cr, Ca, Sr, Na, Li, K) were measured in muscle of five species Cyprinus carpio (from I??kl? dam), Scardinius erythrophthalmus (from I??kl? dam), Tinca tinca (from I??kl? dam), C. carpio (from Karaca?ren dam), Carassius carassius (from Karaca?ren dam) caught from I??kl? and Karaca?ren. The highest metal was Na (466.95 μg/g) in C. carassius, while the lowest levels were Fe (0.37 μg/g) and Cu (0.37 μg/g) in C. carpio from I??kl? dam. The mean concentrations μg/g d.w. some of heavy metals in muscle of C. carpio (from I??kl? dam), S. erythrophthalmus (from I??kl? dam), T. tinca (from I??kl? dam), C. carpio (from Karaca?ren dam), C. carassius (from Karaca?ren dam) were as follows: Cd 2.00-2.10-1.95-2.06-2.27, Zn 4.36-2.64-13.13-13.33-24.47, Pb 1.65-1.24-1.90-2.37-2.41, Co 2.46-2.37-2.48-2.58-2.80, Mg 138.51-154.35-218.59-204.58-202.16, Fe 0.37-2.62-3.17-3.01-12.33, respectively.     

An approach to optimise nutrient management in environmental sanitation systems despite limited data

The material flow analysis method can be used to assess the impact of environmental sanitation systems on resource consumption and environmental pollution. However, given the limited access to reliable data, application of this data-intensive method in developing countries may be difficult. This paper presents an approach allowing to develop material flow models despite limited data availability. Application of an iterative procedure is of key importance: model parameter values should first be assessed on the basis of a literature review and by eliciting expert judgement. If model outputs are not plausible, sensitive input parameters should be reassessed more accurately. Moreover, model parameters can be expressed as probability distributions and variable uncertainty estimated by using Monte Carlo simulation. The impact of environmental sanitation systems on the phosphorus load discharged into surface water in Hanoi, Vietnam, is simulated by applying the proposed approach.