Sorption of linear alcohol ethoxylate surfactant homologs to soils

Sorption onto five saturated soils of the homologs within the commercial surfactant mixture Brij 35 (registered trademark of ICI Americas) was investigated. Brij 35 is a mixture of linear ethoxylated alcohols, having an average of 23 ethoxy (EO) groups per molecule and alcohol chain of primarily 12 carbons in length (C₁₂H₂₅(OCH₂CH₂)₂₃OH). In experiments, saturated soils were exposed to various concentrations of the surfactant mixture for specified times, the slurries were centrifuged to separate the phases, the aqueous phases were extracted with 1,2-dichloroethane, and the residual homologs were derivatized with 3,5-dinitrobenzoyl chloride and analyzed by normal phase HPLC. Homologs containing 4–43 EO groups were chromatographically separated at near baseline. At aqueous Brij 35 concentrations below the critical micelle concentration (cmc), the proportion of each homolog sorbed to each of the soils increased with increasing EO chain length through the homologous series. As a result, in experiments where a significant proportion of the surfactant adsorbed, significant shifts in the aqueous phase compositions occurred to mixtures with lower mean EO numbers. A sharp break in the adsorption isotherms occurs at the cmc.     

Measuring the flux at the interface of coal-tar impacted sediment and river water near a former MGP site

Determining water movement through contaminated sediment is critical for characterizing transport of chemicals from the sediment to the overlying water. Field studies to characterize the water flow across the sediment-water interface within a river adjacent to a former manufactured gas plant site were conducted. For this purpose, a new design of an interfacial flow meter was developed and tested. The in situ components of the system consisted of: a cylinder with an interfacial area of 2342 cm2; a dome attached to the cylinder; and a flow tube that allows water to flow from inside the dome to the river at the rate equal to the specific discharge across the sediment-water boundary. A 'heat-pulse' method was used to measure flow by heating the center of the flow tube for a brief time period and measuring the temperature profile within the tube over time. The system was calibrated to measure volumetric flux in the range 1.5-4.0 cm d(-1), however using a flow-addition method, the measurement of lower velocities also was accomplished, and calibration at higher fluxes is possible. From the groundwater flow at the interface of the coal-tar impacted sediment and information on the sediment pore water concentrations of several PAHs (poly-cyclic aromatic hydrocarbons), the mass flux of these PAHs to the river were estimated. Information on PAH mass flux at the sediment-water interface is useful for site assessment, including the evaluation of remediation alternatives and longer term site characterization.     

Surfactant-assisted UV-photolysis of nitroarenes

Photochemical transformations (lambda-254 nm) of 2,4-dinitrotoluene (2,4-DNT) in aqueous solutions containing the cationic surfactant cetyltrimethylammonium (CTA) and the anionic nucleophile borohydride (BH4-) were investigated. The overall decay rate was enhanced at CTA concentrations above the critical micelle concentration (cmc) when stoichiometric excess BH4- was present in solution. A kinetic model that separates the overall reaction rate into micellar and aqueous pseudo-phase components indicates transformation in micelles is 17 times faster that in the homogeneous water phase under those conditions investigated. Intermediate products were identified by comparing the HPLC retention times and ultraviolet-visible absorption spectra of product peaks to those of analytical standards. 2-Methyl-5-nitroaniline, 4-nitrotoluene, 2-nitrotoluene, 4-methyl-3-nitroaniline, 2,4-diaminotoluene, o-toluidine, 1,3-dinitrobenzene, 3-nitroaniline, p-cresol, and 2,4-diaminophenol were identified as photo-transformation intermediates or products.     

Partitioning of mono- and polycyclic aromatic hydrocarbons in a river sediment adjacent to a former manufactured gas plant site

The equilibrium distributions, between water and coal-tar contaminated sediment, of 16 monocyclic and polycyclic aromatic hydrocarbons were measured and evaluated for consistency with a Raoult's Law-based quantitative relationship. The quantitative relationship calculates the pore water concentration as the product of the aqueous solubility (or for compounds that are solid at room temperature, the aqueous super-cooled liquid solubility) and the mole fraction concentration of the compound within the liquid coal tar. Sediment was collected at five locations at two depths within a 120 m stretch of a river adjacent to a former manufactured gas plant, and all samples contained non-aqueous phase liquid (NAPL) coal tar. Although the amount of coal tar varied between samples by over an order of magnitude, the Raoult's Law-based NAPL-water partition coefficients for each monocyclic or 2- or 3-ring polycyclic aromatic hydrocarbon measured in this study generally varied within a factor of 2 over all sediments.     

Laboratory studies to characterize the efficacy of sand capping a coal tar-contaminated sediment

Placement of a microbial active sand cap on a coal tar-contaminated river sediment has been suggested as a cost effective remediation strategy. This approach assumes that the flux of contaminants from the sediment is sufficiently balanced by oxygen and nutrient fluxes into the sand layer such that microbial activity will reduce contaminant concentrations within the new benthic zone and reduce the contaminant flux to the water column. The dynamics of such a system were evaluated using batch and column studies with microbial communities from tar-contaminated sediment under different aeration and nutrient inputs. In a 30-d batch degradation study on aqueous extracts of coal tar sediment, oxygen and nutrient concentrations were found to be key parameters controlling the degradation rates of polycyclic aromatic hydrocarbons (PAHs). For the five PAHs monitored (naphthalene, fluorene, phenanthrene, anthracene, and pyrene), degradation rates were inversely proportional to molecular size. For the column studies, where three columns were packed with a 20-cm sand layer on the top of a 5 cm of sediment layer, flow was established to sand layers with (1) aerated water, (2) N(2) sparged water, or (3) HgCl(2)-sterilized N(2) sparged water. After steady-state conditions, PAH concentrations in effluents were the lowest in the aerated column, except for pyrene, whose concentration was invariant with all effluents. These laboratory scale studies support that if sufficient aeration can be achieved in the field through either active and passive means, the resulting microbially active sand layer can improve the water quality of the benthic zone and reduce the flux of many, but not all, PAHs to the water column.     

Birnessite mediated debromination of decabromodiphenyl ether

Decabromodiphenyl ether (BDE-209) is a major component of a commercial flame retardant formulation; however, there is limited information on the fate of BDE-209 in the environment, including metal oxide mediated degradation. Laboratory experiments were conducted to investigate the birnessite (delta-MnO(2))-promoted debromination of BDE-209 in tetrahydrofuran (THF)-water systems as well as catechol solutions. Up to 100% (0.1044 micromol initial charge) of BDE-209 disappeared upon reaction with birnessite in THF/H(2)O (4:6-9:1). The formation of aqueous Br(-) from BDE-209 reduction was determined and up to 16 mole% of initial bromine was released over the course of the reaction indicating approximately 1.7 Br-C bonds were reduced per BDE-209 molecule. The distribution of debrominated congeners, however, indicated a much greater extent of debromination for some products than what was inferred from an average bromine mass balance. The produced congeners varied from tetra- to nona-bromodiphenyl ether, including BDE-47 and -99, during the 24 h reaction. Experiments with deuterated water indicated that water was not the major hydrogen donor in the reduction but rather THF provided the reducing power. This conclusion was supported by the presence of succinic acid, which was produced from oxidation of THF. The reactions with aqueous catechol, rather than THF-water mixtures, were performed to assess the possible role that compounds found in natural environments, such a tannin-like phenols, might have on the chemistry. These experiments indicated that birnessite mediated debromination of BDE-209 might occur in natural settings.     

The Ythan Project: A Case Study on Improving Catchment Management through Community Involvement

Increased participation in resource management decisions by a wide range of stakeholders has been widely advocated, and has recently been formally incorporated into the European Water Framework Directive. However, achieving such participation has generally proved to be problematical. In response to locally perceived needs, a project was set up in the Ythan catchment in northeast Scotland, to undertake catchment management actions with increased public involvement. This paper outlines the methods used to increase public participation in such actions, and some preliminary assessments of the effectiveness of these. The experience of the project and the lessons learnt, including some of the difficulties of ensuring fully representative stakeholder involvement, are discussed in relation to published criteria for public participation in resource management.     

Removal of phenylurea herbicide monuron via riboflavin-mediated photosensitization

Photodegradation of the phenylurea herbicide monuron by using riboflavin (Rf), a sensitizer, was investigated by varying the doses of monuron and Rf in this work. An enhanced photochemical effect was observed in the process compared with the direct photolysis by using UV irradiation only. The reaction time was greatly shortened from more than 60 min (direct photolysis) to 8-30 min depending on the doses of initial concentration of monuron ([M]0) and Rf. A modified hyperbola model was found to be useful to determine the reaction kinetics and thereafter the performance on the photodegradation of monuron sensitized by Rf. Two measurable characteristic constants (initial decay rate and total removal index) were used to quantify the reaction. The maximum removal difference compared with the direct photolysis and Rf-sensitization was investigated. It was found that the improvement of the process depended on both the [M]0 and the doses of Rf.     

Hydrogen peroxide-assisted UV photodegradation of Lindane

Aqueous solutions of gamma-hexachlorocyclohexane (Lindane) were photolyzed (lambda=254 nm) under a variety of solution conditions. The initial concentrations of hydrogen peroxide (H(2)O(2)) and Lindane varied from 0 to 20 mM and 0.21 to 0.22 microM, respectively, the pH ranged from 3 to 11, and several concentration ratios of Suwannee River humic acid and fulvic acid were dissolved in the irradiated solutions. Lindane rapidly reacted, and the maximum reaction rate constant (9.7 x 10(-3) s(-1)) was observed at pH 7 and initial [H(2)O(2)]=1 mM. Thus, 90% of the Lindane is destroyed in approximately 4 min under these conditions. In addition, within 15 min, all chlorine atoms were converted to chloride ion, indicating that chlorinated organic by-products do not accumulate. The reactor was characterized by measuring the photon flux (7.04 x 10(-6) E s(-1)) and the cumulative production of *OH during irradiation. The cumulative *OH production during irradiation was fastest at an initial [H(2)O(2)]=5 mM (k=0.77 micro M s(-1)).     

Role of pH in partitioning and cation exchange of aromatic amines on water-saturated soils

Predicting the reversible interactions between aromatic amines and soil is essential for assessing the mobility, bioavailability and exposure from contaminated sites. Reversible sorption mechanisms of aniline and alpha-naphthylamine were investigated by using single and binary solute sorption to five soils at several pH values, and by applying a distributed parameter (DP) model. The DP model assumes linear partitioning of the neutral species into soil organic matter domains and organic cation binding on negative-charged sites with the exchange coefficients represented by a Gaussian probability distribution. Sorption nonlinearity was attributed to cation exchange with varying site affinities, which was adequately simulated using the DP model. Greater uptake by hydrophobic partitioning and selectivity for cation exchange sites was observed for alpha-naphthylamine compared to aniline. Sorption of alpha-naphthylamine was not impacted quantitatively by aniline under those conditions examined; however, aniline sorption was reduced by alpha-naphthylamine with the largest reduction occurring in the soil with the lowest pH. DP model simulations showed that although hydrophobic partitioning increases with soil-solution pH, cation exchange still contributes significantly to the total sorption even at soil-solution pH values greater than pKa + 2.