Characterization of titanium oxide optical band gap produced from leachate sludge treatment with titanium tetrachloride

Environmental Science and Pollution Research - This study investigated the coagulation performance of titanium tetrachloride (TiCl4) for leachate treatment and preparation of titanium oxide (TiO2)...     

Spatial distribution and ecological risk assessment of sediment metals in a highly industrialized coastal zone southwestern Taiwan

Spatial variations of Cr, Cu, Hg, Ni, Pb, and Zn in the surface sediments from 34 stations of the Kaohsiung coastal zone southwestern Taiwan were studied to address the current pollution status, sediment quality, and potential ecological risk. The study revealed that the concentrations of sediment metals in Kaohsiung Harbor were alarmingly high compared to the other region of Kaohsiung coast. The concentrations of Cr, Cu, Hg, Ni, Pb, and Zn in the harbor sediments were as high as 351, 247, 1.93, 61.8, 60.9, and 940 mg kg⁻¹, respectively. The current situation of metal pollution was assessed by different pollution indices and results showed moderate to severe enrichment of Cu, Hg, and Zn in the harbor sediments. According to the degree of contamination, pollution load index, and contamination severity index, the sediments from the inner Kaohsiung Harbor show high degree and high severity of metal contamination, while the rest of Kaohsiung coastal areas show uncontaminated or low-level pollution. Results of mean ERM quotient and potential ecological risk index also indicated that the harbor sediments posed a 49% probability of biological toxicity and very high ecological risk. The toxic units indicated that the negative biological effects of the six metals in the harbor sediments were Zn > Cu > Cr > Ni > Hg > Pb. In contrast to Kaohsiung Harbor as a trap where considerable amount of anthropogenic metal loadings accumulated in sediments, low metal concentrations were observed in most Kaohsiung coastal sediments. It probably resulted from the limited fine-grained sediment deposition. In the wave-dominated Kaohsiung coastal zone, fine-grained sediments associated with polluted metals tend to be easily resuspended and transported offshore via waves and wave-induced currents. The results of this study can provide valuable information for river and coastal zone management.

     

Sources and seasonal variation of PAHs in the sediments of drinking water reservoirs in Hong Kong and the Dongjiang River (China)

The main objective of this study was to investigate occurrence of polycyclic aromatic hydrocarbons (PAHs) in the sources of the drinking water supply of Hong Kong. The main emphasis was on the Dongjiang River in mainland China which is the major source, supplying 80% of the total consumption in Hong Kong (the remaining 20% is obtained from rain water). Sediments were collected from four sites along the Dongjiang River and four reservoirs in Hong Kong during both the dry and wet weather seasons. The concentrations of total PAHs in the sediments ranged between 36 and 539 microg/kg dry wt. The lower levels were detected at the upstream site on the Dongjiang River and at the reservoirs in Hong Kong (44-85 microg/kg dry wt), while the mid- and downstream sites on the Dongjiang River were more polluted (588-658 microg/kg dry wt). Examination of the PAH profiles revealed that the mid- and downstream sections of the Dongjiang River contained high percentages of 4,5,6-ring PAHs, similar to the amounts of atmospheric particulate matter and road dust collected during the dry weather season from the Pearl River Delta region as reported in the literature. Seasonal changes were revealed in the reservoirs of Hong Kong, with higher PAH levels in the wet weather season than in the dry weather season. For those reservoirs in Hong Kong that store water from the Dongjiang River, a distinct seasonal pattern was also observed, namely, that under dry weather season conditions the PAHs found in the sediments were primarily from petrogenic source, while under wet weather season conditions they were from pyrolytic sources. No such pattern was detected in the reservoirs which stored only rain water.     

Statistical analysis of aerosol species, trace gasses, and meteorology in Chicago

Both canonical correlation analysis (CCA) and principal component analysis (PCA) were applied to atmospheric aerosol and trace gas concentrations and meteorological data collected in Chicago during the summer months of 2002, 2003, and 2004. Concentrations of ammonium, calcium, nitrate, sulfate, and oxalate particulate matter, as well as, meteorological parameters temperature, wind speed, wind direction, and humidity were subjected to CCA and PCA. Ozone and nitrogen oxide mixing ratios were also included in the data set. The purpose of statistical analysis was to determine the extent of existing linear relationship(s), or lack thereof, between meteorological parameters and pollutant concentrations in addition to reducing dimensionality of the original data to determine sources of pollutants. In CCA, the first three canonical variate pairs derived were statistically significant at the 0.05 level. Canonical correlation between the first canonical variate pair was 0.821, while correlations of the second and third canonical variate pairs were 0.562 and 0.461, respectively. The first canonical variate pair indicated that increasing temperatures resulted in high ozone mixing ratios, while the second canonical variate pair showed wind speed and humidity’s influence on local ammonium concentrations. No new information was uncovered in the third variate pair. Canonical loadings were also interpreted for information regarding relationships between data sets. Four principal components (PCs), expressing 77.0 % of original data variance, were derived in PCA. Interpretation of PCs suggested significant production and/or transport of secondary aerosols in the region (PC1). Furthermore, photochemical production of ozone and wind speed’s influence on pollutants were expressed (PC2) along with overall measure of local meteorology (PC3). In summary, CCA and PCA results combined were successful in uncovering linear relationships between meteorology and air pollutants in Chicago and aided in determining possible pollutant sources.     

Adsorption/desorption of arsenite and arsenate on chitosan and nanochitosan

Equilibrium sorption studies of anionic species of arsenite, As(III) ions and arsenate As(V) ions onto two biosorbents, namely, chitosan and nanochitosan, have been investigated and compared. The results and trends in the sorption behavior are novel, and we have observed during the sorption process of the As(III) and As(V) on chitosan, a slow process of desorption occurred after an initial maximum adsorption capacity was achieved, before reaching a final but lower equilibrium adsorption capacity. The same desorption trend, however, is not observed on nanochitosan. The gradual desorption of As(III) and As(V) in the equilibrium sorption on chitosan is attributed to the different fractions of the dissociated forms of arsenic on the adsorbent surface and in solution and the extent of protonation of chitosan with the changing of solution pH during sorption. The change of solution pH during the sorption of arsenite ions on chitosan was also influenced by the interaction between the buffering effect of the arsenite species in the aqueous medium and the physical properties of chitosan. The final equilibrium adsorption capacity of chitosan for As(III) and As(V) was found to be around 500 and 8000 μg/g, respectively, whereas the capacities on nanochitosan are 6100 and 13,000 μg/g, respectively.

     

Experimental Verification of Diffusion Battery Theory

The diffusion battery, an assembly of circular tubes or rectangular channels, is one of the best devices available for measuring the size and size distribution of submicron aerosols in the diameter range 0.002 to 0.2 µ m. The performance of these batteries is known from molecular diffusion theory, but until now has not been checked experimentally in this size range because of the lack of the necessary monodisperse aerosols. Experimental measurements on singly charged monodisperse aerosols from 0.01 µm to 0.1 µ m are described using a General Electric and a Pollak condensation nucleus counter to measure the aerosol penetration through the stages of a set of portable diffusion batteries in series. Particle sizes in the range tested could be selected at will by adjusting the voltage of an electric mobility classifier. The fraction of aerosol of a given size passing through each battery stage was found to agree closely with the penetration calculated from molecular diffusion theory for that size. This shows that the theory is correct and confirms that the aerosol produced by the electric mobility classifier was monodisperse. In addition, it was found that the difference in penetration between a charged versus a neutralized aerosol was insignificant except for the smallest aerosols used.     

A device for sampling the mud‐water interface in eutrophic lakes and bogs for residue analysis

Abstract

A tubular device has been developed making it possible to obtain layered samples of loosely aggregated, flocculent material from bogs or eutrophic lakes. The samples are up to 50 cm long and 15 cm in diameter. The sampler is free from protuberances and intact, layered samples can be taken. The tubular part of the sampler is about 85 em long, the walls of the lower 25‐cm portion harbouring a pneumatic closing mechanism which is controlled from above the water surface. An extendible handle for manipulating the sampler and for guiding it into place, is fastened to the upper end of the sampling tube. The performance and the operation of the sampler in the field are described.     

Treatment of Perchlorate‐Contaminated Groundwater Using Highly Selective,Regenerable Ion‐Exchange Technology: A Pilot‐Scale Demonstration

Treatment of perchlorate‐contaminated groundwater using highly selective, regenerable ion‐exchange technology has been recently demonstrated at Edwards Air Force Base, California. At an influent concentration of about 450 μg/l ClO₄^?, the bifunctional anion‐exchange resin bed treated approximately 40,000 empty bed volumes of groundwater before a significant breakthrough of ClO₄^? occurred. The presence of relatively high concentrations of chloride and sulfate in site groundwater did not appear to affect the ability of the bifunctional resin to remove ClO₄^?. The spent resin bed was successfully regenerated using the FeCl₃^?HCl regeneration technique recently developed at the Oak Ridge National Laboratory, and nearly 100 percent of sorbed ClO₄^? was displaced or recovered after elution with as little as about two bed volumes of the regenerant solution. In addition, a new methodology was developed to completely destroy ClO₄^? in the FeCl₃^?HCl solution so that the disposal of perchlorate‐containing hazardous wastes could be eliminated. It is therefore anticipated that these treatment and regeneration technologies may offer an efficient and cost‐effective means to remove ClO₄^? from contaminated groundwater with significantly reduced generation of waste requiring disposal. © 2002 Wiley Periodicals, Inc.