Arsenic speciation in human hair: a new perspective for epidemiological assessment in chronic arsenicism

The analysis for arsenic in hair is commonly used in epidemiological studies to assess exposure to this toxic element. However, poor correlation between total arsenic concentration in hair and water sources have been found in previous studies. Exclusive determination of endogenous arsenic in the hair, excluding external contamination has become an analytical challenge. Arsenic speciation in hair appears as a new possibility for analytical assessing in As-exposure studies. This study applied a relative simple method for arsenic speciation in human hair based on water extraction and HPLC-HG-ICP-MS. The concentration of arsenic species in human hair was assessed in chronically As(V)-exposed populations from two villages (Esqui?a and Illapata) of the Atacama Desert, Chile. The arsenic concentrations in drinking water are 0.075 and 1.25 mg L(-1), respectively, where As(V) represented between 92 and 99.5% of the total arsenic of the consumed waters. On average, the total arsenic concentrations in hair from individuals of Esqui?a and Illapata were 0.7 and 6.1 microg g(-1), respectively. Four arsenic species, As(III), DMA(V), MMA(V) and As(V), were detected and quantified in the hair extracts. Assuming the found species in extracts represent the species in hair, more than 98% of the total arsenic in hair corresponded to inorganic As. On average, As(III) concentrations in hair were 0.25 and 3.75 microg g(-1) in Esqui?a and Illapata, respectively; while, the As(V) average concentrations were 0.15 and 0.45 microg g(-1) in Esqui?a and Illapata, respectively. Methylated species represent less than 2% of the extracted As (DMA(V)+ MMA(V)) in both populations. As(III) in hair shows the best correlation with chronic exposure to As(V) in comparison to other species and total arsenic. In fact, concentrations of As(total), As(III) and As(V) in hair samples are correlated with the age of the exposed individuals from Illapata (R= 0.65, 0.69, 0.57, respectively) and with the time of residence in this village (R= 0.54, 0.71 and 0.58, respectively).     

Effect of an industrial discharge on water quality and periphyton structure in a pampeam stream

Seasonal sampling was carried out at four sites on a pampeanstream that receives industrial effluent from two textile factories. To evaluate water quality, several physical and chemical parameters were examined and the periphyton growing oncattail (Typha latifolia L.) were analyzed.Water quality and periphyton structure differed significantlybetween sites upstream and downstream of the discharge. Differences in temperature and also in concentrations of phosphate, dissolved oxygen, and phaeopigment were detected. At the same time, changes in the dominant algae groups wereobserved. Downstream of the industrial discharge, the numberof Bacillariophyta decreased, while species of Cianophyta andEuglenophyta were more abundant. This abundance correlated withincreased phosphate and organic matter content and decreased oxygen concentration. Although this study did not detect a reduction in the number of species, similarity between stands decreased downstream of the industrial discharge. Changes incommunity structure were readily detected in this situation because the communities of the polluted and unpolluted zones were qualitatively different. Periphyton growing naturally on Typha latifolia is a useful indicator of the impact of waste waters on the biota and can also be used to evaluate water body recovery.     

Glyphosate concentrations in global freshwaters: are aquatic organisms at risk?

Environmental Science and Pollution Research - Glyphosate is the most used herbicide worldwide. Many studies have reported glyphosate risks to aquatic organisms of different trophic levels....     

Electrochemical degradation applied to the metabolites of Acid Orange 7 anaerobic biotreatment

The electrochemical oxidation of the biotic degradation products of the textile dye C.I. Acid Orange 7 (AO7) was achieved using a boron doped diamond electrode (BDD). Tests were performed with model solutions of the biotic degradation products, sulphanilic acid (SA) and 1-amino-2-naphthol (AN), and also with real effluents obtained in experiments carried out in an up-flow anaerobic sludge blanket (UASB) reactor, fed with a simulated textile effluent containing AO7, working in mesophilic or thermophilic conditions. Bulk electrolysis was studied using two different supporting electrolytes - NaCl and Na(2)SO(4). The influence of initial metabolite concentration and current density on the electrodegradation rates of the biotic products was investigated. For the UASB effluents, oxidation tests were carried out for different electrolytes and at different current densities. Samples were collected at pre-selected intervals and absorbance measurements, chemical oxygen demand (COD) and total organic carbon (TOC) tests and high performance liquid chromatography (HPLC) analysis were performed. Results have shown an almost complete elimination of the persistent pollutants and a COD removal higher than 70% for both AN and SA. For the UASB effluents, COD removals between 45% and 90% and TOC removals varying from 19% to 41% were obtained.     

Production of soybean ethanol-based biodiesel using CaO heterogeneous catalysts promoted by Zn,K and Mg

This article focuses on the optimization of the production of fatty acid ethyl esters from soybean oil using CaO-based heterogeneous catalysts. Three different catalytic promoters were evaluated: Magnesium, zinc, and potassium. The reaction has evaluated the promoter content (promoter to calcium molar ratio), catalyst load, alcohol to oil molar ratio, and temperature. Response surface methodology (RSM) was used to evaluate the influence of each variable on the yield of biodiesel. The addition of K₂O or MgO in the catalyst has enhanced the yield in fatty acid ethyl esters, while the use of ZnO as a promoter was not successful.     

Comparison of real-time instruments and gravimetric method when measuring particulate matter in a residential building

This study used several real-time and filter-based aerosol instruments to measure PM_2.5 levels in a high-rise residential green building in the Northeastern US and compared performance of those instruments. PM_2.5 24-hr average concentrations were determined using a Personal Modular Impactor (PMI) with 2.5 µm cut (SKC Inc., Eighty Four, PA) and a direct reading pDR-1500 (Thermo Scientific, Franklin, MA) as well as its filter. 1-hr average PM_2.5 concentrations were measured in the same apartments with an Aerotrak Optical Particle Counter (OPC) (model 8220, TSI, Inc., Shoreview, MN) and a DustTrak DRX mass monitor (model 8534, TSI, Inc., Shoreview, MN). OPC and DRX measurements were compared with concurrent 1-hr mass concentration from the pDR-1500. The pDR-1500 direct reading showed approximately 40% higher particle mass concentration compared to its own filter (n = 41), and 25% higher PM_2.5 mass concentration compared to the PMI_2.5 filter. The pDR-1500 direct reading and PMI_2.5 in non-smoking homes (self-reported) were not significantly different (n = 10, R² = 0.937), while the difference between measurements for smoking homes was 44% (n = 31, R² = 0.773). Both OPC and DRX data had substantial and significant systematic and proportional biases compared with pDR-1500 readings. However, these methods were highly correlated: R² = 0.936 for OPC versus pDR-1500 reading and R² = 0.863 for DRX versus pDR-1500 reading. The data suggest that accuracy of aerosol mass concentrations from direct-reading instruments in indoor environments depends on the instrument, and that correction factors can be used to reduce biases of these real-time monitors in residential green buildings with similar aerosol properties.

Implications: This study used several real-time and filter-based aerosol instruments to measure PM_2.5 levels in a high-rise residential green building in the northeastern United States and compared performance of those instruments. The data show that while the use of real-time monitors is convenient for measurement of airborne PM at short time scales, the accuracy of those monitors depends on a particular instrument. Bias correction factors identified in this paper could provide guidance for other studies using direct-reading instruments to measure PM concentrations.     

Ecological literacy and beyond: Problem-based learning for future professionals

Ecological science contributes to solving a broad range of environmental problems. However, lack of ecological literacy in practice often limits application of this knowledge. In this paper, we highlight a critical but often overlooked demand on ecological literacy: to enable professionals of various careers to apply scientific knowledge when faced with environmental problems. Current university courses on ecology often fail to persuade students that ecological science provides important tools for environmental problem solving. We propose problem-based learning to improve the understanding of ecological science and its usefulness for real-world environmental issues that professionals in careers as diverse as engineering, public health, architecture, social sciences, or management will address. Courses should set clear learning objectives for cognitive skills they expect students to acquire. Thus, professionals in different fields will be enabled to improve environmental decision-making processes and to participate effectively in multidisciplinary work groups charged with tackling environmental issues.     

Great Basin Land Management Planning Using Ecological Modeling

This report describes a land management modeling effort that analyzed potential impacts of proposed actions under an updated Bureau of Land Management Resource Management Plan that will guide management for 20 years on 4.6 million hectares in the Great Basin ecoregion of the United States. State-and-transition models that included vegetation data, fire histories, and many parameters (i.e., rates of succession, fire return intervals, outcomes of management actions, and invasion rates of native and nonnative invasive species) were developed through workshops with scientific experts and range management specialists. Alternative restoration scenarios included continuation of current management, full fire suppression, wildfire use in designated fire use zones, wildfire use in resilient vegetation types only, restoration with a tenfold budget increase, no restoration treatments, and no livestock grazing. Under all the scenarios, cover of vegetation states with native perennial understory declined and was replaced by tree-invaded and weed-dominated states. The greatest differences among alternative management scenarios resulted from the use of fire as a tool to maintain native understory. Among restoration scenarios, only the scenario assuming a tenfold budget increase had a more desirable outcome than the current management scenario. Removal of livestock alone had little effect on vegetation resilience. Rather, active restoration was required. The predictive power of the model was limited by current understanding of Great Basin vegetation dynamics and data needs including statistically valid monitoring of restoration treatments, invasiveness and invasibility, and fire histories. The authors suggest that such computer models can be useful tools for systematic analysis of potential impacts in land use planning. However, for a modeling effort to be productive, the management situation must be conducive to open communication among land management agencies and partner entities, including nonprofit organizations.     

Development of an activated carbon impregnation process with iron oxide nanoparticles by green synthesis for diclofenac adsorption

The objective of this study was to impregnate the surface of palm coconut activated carbon with nanoparticles of iron compounds using Moringa oleifera leaf extracts and pomegranate leaf by a green synthesis method and to evaluate its adsorption capacity for sodium diclofenac. The adsorbent material was characterized by zeta potential, X-ray diffraction (XRD), N₂ adsorption/desorption (BET method), transmission electronic microscopy (TEM), and scanning electronic microscopy (SEM) coupled to dispersive energy spectrometry X-ray (EDX) methods. To evaluate the adsorption capacity of sodium diclofenac, the influence of pH, kinetics, isotherms, and thermodynamic properties were analysed. The impregnated adsorbents showed efficiency in the adsorption of sodium diclofenac. The kinetic model that best fit the experimental data was the pseudo-second-order model, and the equilibrium model was the Langmuir model. As for the thermodynamic study, it was verified that the adsorption reaction for all adsorbents occurs in a spontaneous, favourable way, and it is endothermic by physisorption. Therefore, this process is promising because it is a clean and non-toxic method when compared with chemical methods for the synthesis of nanoparticles.