Particulate matter,nitrogen oxides,ozone, and select volatile organic compounds during a winter sampling period in Logan,Utah, USA

Particulate matter mass (PM), trace gaseous pollutants, and select volatile organic compounds (VOCs) with meteorological variables were measured in Logan, Utah (Cache Valley), for >4 weeks during winter 2017 as part of the Utah Winter Fine Particle Study (UWFPS). Higher PM levels for short time periods and lower ozone (O₃) levels were present due to meteorological and mountain valley conditions. Nitrogenous pollutants were relatively strongly correlated with PM variables. Diurnal cycles of NO_x, O₃, and fine PM(PM 2.5) (aerodynamic diameter <2.5 μm [PM_2.5]) suggested formation from NO_x. O₃ levels increased from early morning into midafternoon, and NO_x and PM_2.5 increased throughout the morning, followed by sharp decreases. Toluene/benzene and xylenes/benzene ratios and VOC correlations with nitrogenous and PM species were indicative of local traffic sources. Wind sector comparisons suggested that pollutant levels were lower when winds were from nearby mountains to the east versus winds from northerly or southerly origins.

Implications: The Cache Valley in Idaho and Utah has been designated a PM_2.5 nonattainment area that has been attributed to air pollution buildup during winter stagnation events. To inform state implementation plans for PM_2.5 in Cache Valley and other PM_2.5 nonattainment areas in Utah, a state and multiagency federal research effort known as the UWFPS was conducted in winter 2017. As part of the UWFPS, the U.S. Environmental Protection Agency (EPA) measured ground-based PM species and their precursors, VOCs, and meteorology in Logan, Utah. Results reported here from the EPA study in Logan provide additional understanding of wintertime air pollution conditions and possible sources of PM and gaseous pollutants as well as being useful for future PM control strategies in this area.     

Impacts of farmer field schools on productivity of vegetable farming in Indonesia

This study assesses the impact of farmer field schools (FFS) on the productivity of vegetable farming in vegetable‐producing areas of East Java and Bali, Indonesia. The FFS have equipped over 3,000 vegetable farmers with integrated crop management knowledge applicable to chilies and tomatoes. The FFS are expected to enhance farmers’ capacity such that they can increase production. This study employs a difference‐in‐differences (DiD) method to overcome selection bias. A survey of 250 FFS‐graduated farmers and 250 non‐FFS farmers were purposively randomly selected from the overall community of farmers. Focus group discussion was used to support the survey. The results indicate that FFS were successful for enhancing farmers’ capability in vegetable farming. Farmers who participated in FFS have higher productivity than those who did not. Farmers also could adapt and adopt the knowledge gained from FFS as they underwent a process of learning by doing. The impacts of the increase in farmers’ capacity can be more evident if weaknesses during the FFS preparation and implementation can be overcome, to ensure more participation, flexibility to fit different conditions/needs and continuous learning.     

Publisher’s Note

Editorial

Publisher’s Note     

Field method comparison between passive air samplers and continuous monitors for Vocs and NO2 in El Paso, Texas

This study evaluates the performance of Model 3300 Ogawa Passive Nitrogen Dioxide (NO2) Samplers and 3M 3520 Organic Vapor Monitors (OVMs) by comparing integrated passive sampling concentrations to averaged hourly NO2 and volatile organic compound (VOC) measurements at two sites in El Paso, TX. Sampling periods were three time intervals (3-day weekend, 4-day weekday, and 7-day weekly) for three consecutive weeks. OVM concentrations were corrected for ambient pressure to account for higher elevation. Precise results (< 5% relative standard deviation, RSD) were found for NO2 measurements from collocated Ogawa samplers. Reproducibility was lower from duplicate OVMs for BTEX (benzene, toluene, ethylbenzene, and xylene isomers) VOCs (> or = 77% RSD for 2-day samples) with better precision for longer sampling periods. Comparison of Ogawa NO2 samplers with chemiluminescence measurements averaged over the same time period suggested potential calibration problems with the chemiluminescence analyzer. For BTEX species, generally good agreement was obtained between OVMs and automated-gas chromatograph (auto-GC) measurements. The OVMs successfully tracked increasing levels of VOCs recorded by the auto-GCs. However, except for toluene, OVM BTEX measurements generally exceeded their continuous counterparts with a mean bias of 5-10%. Although interpretation of the study results was limited due to small sample sizes, diffusion barrier influences caused by shelters that housed OVMs and differences in sampling heights between OVMs and auto-GC inlet may explain the overestimation.     

A Short-Term Air Quality Model for Sulfur Dioxide in Louisville,Kentucky

The conventional gausslan plume equation for ground level concentrations was used to estimate hourly average sulfur dioxide concentrations at selected points in Louisville, KY, on specific days during 1973. Area emission sources were not included in the model since they are not substantial. The trajectory of the emissions from each continuous point source was calculated by a procedure that allowed for spatial variability in wind direction. All other meteorological parameters were held constant during each hour. The twenty-four individual hourly estimates at each location for a given day were arithmetically averaged yielding a daily mean. The model predictions were compared to actual measurements conducted by Jefferson County Air Pollution Control District personnel using the West-Gaeke sampling procedure. The sample correlation coefficient for all predictions was low, but after only about 30% of the predictions were eliminated on statistical grounds, the sample correlation coefficient was increased to 0.72. The statistical analysis appeared to discard a reasonable number of predictions on the basis of observed variability in the measured air quality.     

Sulfur speciation monitored in situ with solid state gold amalgam voltammetric microelectrodes: polysulfides as a special case in sediments, microbial mats and hydrothermal vent waters

Sulfur speciation was determined in real time in salt marsh microbial mats, subtidal sediments and hydrothermal vent diffuse flow waters using solid state gold-amalgam voltammetric microelectrodes. Chemical species were measured in situ without any sample manipulation or processing. The partially oxidized sulfur species detected were polysulfides, thiosulfate, elemental sulfur and tetrathionate. Fe(III) oxidation of hydrogen sulfide does not occur within the mats where microbially mediated processes are responsible for oxidation of H2S. In sediments and diffuse flow vent waters, Fe(III) phases are the direct oxidant of H2S. Sulfur speciation determined in this work is due to in situ biogeochemical processes and is not due to artefacts of sample manipulation. The voltammetric data show that polysulfides are the first detectable intermediate during sulfide oxidation which is consistent with previous laboratory studies.     

Field Method Comparison between Passive Air Samplers and Continuous Monitors for VOCs and NO2 in El Paso,Texas

Abstract

This study evaluates the performance of Model 3300 Ogawa Passive Nitrogen Dioxide (NO₂) Samplers and 3M 3520 Organic Vapor Monitors (OVMs) by comparing integrated passive sampling concentrations to averaged hourly NO₂ and volatile organic compound (VOC) measurements at two sites in El Paso, TX. Sampling periods were three time intervals (3-day weekend, 4-day weekday, and 7-day weekly) for three consecutive weeks. OVM concentrations were corrected for ambient pressure to account for higher elevation. Precise results (<5% relative standard deviation, RSD) were found for NO₂ measurements from collocated Ogawa samplers. Reproducibility was lower from duplicate OVMs for BTEX (benzene, toluene, ethylbenzene, and xylene isomers) VOCs (≥7% RSD for 2-day samples) with better precision for longer sampling periods. Comparison of Ogawa NO₂ samplers with chemiluminescence measurements averaged over the same time period suggested potential calibration problems with the chemiluminescence analyzer. For BTEX species, generally good agreement was obtained between OVMs and automated-gas chromatograph (auto-GC) measurements. The OVMs successfully tracked increasing levels of VOCs recorded by the auto-GCs.