Trophoblast deportation is known to occur in normal human pregnancy, but it is not yet clear whether these cells routinely enter the maternal peripheral circulation and are available as a source of fetal DNA for non-invasive prenatal diagnosis of genetic disorders. To resolve this issue requires an efficient method of enriching trophoblast from maternal blood combined with a means to confirm its identity. Five different techniques were tested on ten retroplacental blood samples to determine the most sensitive and operator-efficient method. Lysis of red cells alone gave the best recovery of trophoblast but had to be discounted, together with Ficoll density gradient centrifugation, due to the very low purity and the excessive time required. Fluorescence-activated cell sorting (FACS) of pre-enriched trophoblast resulted in the lowest recovery rate (8 per cent) despite a 3250-fold enrichment and a very high purity. Immunomagnetic beads (Dynabeads) coated with anti-CD 16 antibody proved to be the best method for the subsequent immunocytochemical characterization of deported trophoblast. However, IO beads coated with anti-CD45 antibody may be more useful for isolating trophoblast for prenatal diagnosis due to the high purity, enrichment (32-fold), and recovery rate (78 per cent) obtained with this method. 相似文献
This study deals with 2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO)-mediated oxidation of cellulose. Softwood and hardwood pulp fibers were suspended in water and oxidized to various extents at pH 10 and 22 °C using sodium hypochlorite in the presence of TEMPO radical and sodium bromide. This reaction system is known to be the most efficient one for the introduction of both surface carboxyl and aldehyde groups. Important relationships between formation of these functional groups and the fibrillation yield, light transmittance of the water dispersions and degree of polymerization of the oxidized softwood and hardwood pulps were established in the present study. A birefringence test confirmed the presence of nanofibers which according to atomic force microscopy analyses had diameters in the 1.6–3.8 nm range. 相似文献
Sandy beach habitat where sea turtles nest will be affected by multiple climate change impacts. Before these impacts occur, knowledge of how nest site selection and hatching success vary with beach microhabitats is needed to inform managers on how to protect suitable habitats and prepare for scientifically valid mitigation measures at beaches around the world. At a highly successful green turtle (Chelonia mydas) rookery at Akumal, Quintana Roo, Mexico, we measured microhabitat characteristics along the beach crawl (rejected sites) and related nest site conditions (selected sites) to subsequent hatching success rates for 64 nesting events. To our knowledge, this is the first study to report environmental data along the nesting crawl for a green turtle population and the first to use natural breaks in the data to describe their preferred habitat ranges. Our results indicate that turtles were likely using a combination of cues to find nest sites, mainly higher elevations and lower sand surface temperatures (Kruskal-Wallis test, H?=?19.84, p?<?0.001; H?=?10.78, p?<?0.001). Hatching success was significantly and negatively correlated to sand temperature at cloaca depth (Spearman’s ρ?=??0.27, p?=?0.04). Indeed, the preferred range for cloaca sand temperatures at the nest site (26.3–27.5 °C) had significantly higher hatching success rates compared to the highest temperature range (Tukey HSD?=?0.47, p?=?0.05). Sand temperatures at various depths were intercorrelated, and surface and cloaca depth sand temperatures were correlated to air temperature (ρ?=?0.70, p?=?0.00; ρ?=?0.26, p?=?0.04). Therefore, rising air temperatures could alter sand temperature cues for suitable nest sites, preferred nest site ranges, and produce uneven sex ratios or lethal incubating temperatures. Elevation cues and preferred ranges (1.4–2.5 m) may also be affected by sea level rise, risking inundation of nests. 相似文献
The sorption and desorption behavior of benzidine in eight solvent-sediment systems were studied using a batch method. The solvents tested included deionized water (DI), calcium chloride solution (CaCl2), sodium hydroxide solution (NaOH), acetonitrile (ACN), a mixture of acetonitrile and ammonium acetate solution (ACN-NH4OAc), methanol (MeOH), ammonium acetate solution (NH4OAc) and hydrochloric acid solution (HCl). Three sets of sorption isotherm experiments were conducted separately in these eight solvents with seven days, three weeks, and two months of contact times, respectively. The results demonstrated nonlinear benzidine sorption phenomena in all eight solvents with higher sorption affinities for sediment sites in the aqueous solvents than in the organic solvents. The results from the desorption experiments revealed that the benzidine desorption efficiencies in the solvents decreased in an order, which was approximately the reverse order of its sorption affinity. Results also suggested that hydrophobic partitioning and covalent binding processes dominated in the desorption experiments, while cation exchange process had little effect on desorption of benzidine. A three-stage model was subsequently applied to simulate the desorption data in the selected solvents of ACN, ACN-NH4OAc and NaOH, respectively. The rapidly desorbing initial fractions were about 0.13-0.20, 0.15-0.26, and 0.18-0.25 for ACN, ACN-NH4OAc and NaOH, respectively. Finally, the sorbed concentrations of benzidine in slowly and very slowly desorbing domains in the selected solvents were correlated with the maximum sorption capacities obtained from the Langmuir sorption isotherm model. The maximum sorption capacities of benzidine were found to be comparable to the amount of benzidine residing in the slowly and very slowly desorbing domains. 相似文献
The influence of the presence of the so-called seed particles on the emission rate of Tris (1-chloroisopropyl) phosphate (TCIPP) from polyisocyanurate (PIR) insulation boards was investigated in this study. Two Field and Laboratory Emission Test cells (FLEC) were placed on the surface of the same PIR board and respectively supplied with clean air (reference FLEC) and air containing laboratory-generated soot particles (test FLEC). The behavior of the area-specific emission rates (SERA) over a time period of 10 days was studied by measuring the total (gas?+?particles) concentrations of TCIPP at the exhaust of each FLEC. The estimated SERA of TCIPP from the PIR board at the quasi-static equilibrium were found to be 0.82 μg m?2 h?1 in the absence of seed particles, while the addition of soot particles led to SERA of 2.16 μg m?2 h?1. This indicates an increase of the SERA of TCIPP from the PIR board with a factor of 3 in the presence of soot particles. The TCIPP partition coefficient to soot particles at the quasi-static equilibrium was 0.022?±?0.012 m3 μg?1. In the next step, the influence of real-life particles on TCIPP emission rates was investigated by supplying the test FLEC with air from a professional kitchen where mainly frying and baking activities took place. Similar to the reference FLEC outcomes, SERA was also found to increase in this real-life experiment over a time period of 20 days by a factor 3 in the presence of particles generated during cooking activities. The median value of estimated particle–gas coefficient for this test was 0.062?±?0.037 m3 μg?1.
Zinc oxide nanoparticles (ZnO NPs) are used in an array of products and processes, ranging from personal care products to antifouling paints, textiles, food additives, antibacterial agents and environmental remediation processes. Soils are an environment likely to be exposed to manmade nanoparticles due to the practice of applying sewage sludge as a fertiliser or as an organic soil improver. However, understanding on the interactions between soil properties, nanoparticles and the organisms that live within soil is lacking, especially with regards to soil bacterial communities. We studied the effects of nanoparticulate, non-nanoparticulate and ionic zinc (in the form of zinc chloride) on the composition of bacterial communities in soil with a modified pH range (from pH 4.5 to pH 7.2). We observed strong pH-dependent effects on the interaction between bacterial communities and all forms of zinc, with the largest changes in bacterial community composition occurring in soils with low and medium pH levels (pH 4.8 and 5.9). The high pH soil (pH 7.2) was less susceptible to the effects of zinc exposure. At the highest doses of zinc (2500 mg/kg dw soil), both nano and non-nano particulate zinc applications elicited a similar response in the soil bacterial community, and this differed significantly to the ionic zinc salt treatment. The results highlight the importance of considering soil pH in nanotoxicology studies, although further work is needed to determine the exact mechanisms controlling the toxicity and fate and interactions of nanoparticles with soil microbial communities. 相似文献