Reversibility of stemflow-induced soil acidification in Swedish beech forest

Stemwater running down the trunks of beech (Fagus sylvatica L.) has an acidifying effect on soil near the stem. The deposition of acidifying substances may be two to four times higher close to the stem compared to in the stand in general. To study reversibility of soil acidification, 72 stumps of beech trees were chosen from five different year classes of felling (3, 6, 9, 14-15, 25-30), representing the years when stemflow ceased to affect the soil. The H(+) concentration (pH KCl) in the topsoil (0-5 cm) differed between the distances 10-30 cm and 230-250 cm from the stumps, the soil close to the stem being more acid. The longer the time since felling the smaller the differences in H(+) concentration became. This reduction in soil acidity amounted to ca. 50% after 15 years, and only small further changes occurred over the next ten years. This indicates that soil may not recover fully from acidification, or does so at a rather slow rate after the initial 15 years of recovery.     

Evaluation of a real-time monitoring system for river quality — a trade-off between risk attitudes,costs, and uncertainty

Uncertainty is definitely one of the key topics in environmental assessment and management. Typically, attempts to reduce uncertainty are subject to expenses. But how to compare and trade-off expenses and the reduced uncertainty? They only seldom allow the use of a single unit. Instead, the whole analysis and decision procedure is very subjective. This paper presents one approach to handle such problems, namely the combined use of Bayesian influence diagrams, and probabilistic risk attitude analysis. The approach was used in the evaluation of three alternatives for a real time river water quality forecasting system. A trade-off analysis of risk attitudes, costs and uncertainty indicated the levels of socioeconomic utility required for investments in the respective systems, and accordingly illuminated the impact of the uncertainties involved on inference and decision-making with various risk attitudes and discount rates.     

Successful DNA-based prenatal exclusion of juvenile neuronal ceroid lipofuscinosis

A family with two siblings, 10 and 8 years old, both with clinical and ultrastructural evidence of juvenile neuronal ceroid lipofuscinosis is described. The family was found to be informative for the restriction fragment length polymorphisms (RFLPs) detected by the probes pCJ52–95Ml (locus D16S148) and pCJ52-94Tl (locus D16S159) flanking the juvenile neuronal ceroid lipofuscinosis locus, CLN3. The parents were both heterozygous using these probes, while their two children with juvenile neuronal ceroid lipofuscinosis were both homozygous. Chorionic villi analysis showed that the fetus was heterozygous and had inherited the one allele of the mother which was not found in the two siblings. This suggested that the fetus had derived one healthy allele from the mother, the risk for a double crossing-over being less than 1 per cent. Electron microscopy showed no fingerprint inclusions in chorionic villi. The child was investigated at 6 months of age and found to be healthy, as new fingerprint inclusions were found at electron microscopy and no vacuolated lymphocytes were found in the blood smear. Due to the risk of heterogeneity, both DNA-based analysis and electron microscopy on chorionic villi are recommended for prenatal examination for juvenile neuronal ceroid lipofuscinosis.     

A new THOR shoulder design: a comparison with volunteers, the Hybrid III, and THOR NT

OBJECTIVE: Since the shoulders are rarely seriously injured in frontal or oblique collisions, they have been given low priority in the development of frontal impact crash test dummies. The shoulder complex geometry and its kinematics are of vital importance for the overall dummy kinematics. The shoulder complex also influences the risk of the safety belt slipping off the shoulder in oblique forward collisions. The first aim of this study was to develop a new 50th percentile male THOR shoulder design, while the second was to compare the new shoulder, mounted on a THOR NT dummy, with volunteer, THOR NT, and Hybrid III range of motion and stiffness data. The third aim was to test the repeatability of the new shoulder during dynamic testing and to see how the design behaves with respect to belt slippage in a 45 degrees far-side collision. METHODS: The new 50th percentile THOR shoulder design was developed with the aid of a shell model of the seated University of Michigan Transportation Research Institute (UMTRI) 50th percentile male with coordinates for joints and bony landmarks (Schneider et al., 1983). The new shoulder design has human-like bony landmarks for the acromion and coracoid processes. The clavicle curvature and length are also made similar to that of a male human, as is the range of motion in the anterior-posterior, superior-inferior, and medial-lateral directions. The new shoulder design was manufactured and tested under the same conditions that T?rnvall et al. (2005b) used to compare the shoulder range of motion for the volunteers, Hybrid III, and THOR Alpha. The new design was also tested in two dynamic test configurations: the first was a 0 degrees full-frontal test and the second was a 45 degrees far-side test. The dummy tests were conducted with an R-16 seat with a three-point belt, the Delta V was 27.0+/-0.5 km/h and the maximum peak acceleration was approximately 14.6+/-0.5 g for each test. RESULTS: A new shoulder design with geometry close to that of humans was developed to be retrofitted to the THOR NT dummy. The results showed that the range of motion for the new shoulder complex during static loading was larger by at least a factor of three, for the maximum load (200 N/arm), than that of either the Hybrid III or the THOR NT; this means it was more similar to the volunteers' range of motion. It was observed that the THOR NT with the new shoulder did not slide out of the shoulder belt during a far-side collision. The performance of the new shoulder was reasonably repeatable and stable during both the static tests and the sled tests. CONCLUSION: A new shoulder for the THOR NT has been designed and developed, and data from static range of motion tests and sled tests indicate that the new shoulder complex has the potential to function in a more human-like manner on the THOR dummy.     

Monitoring contaminants from oil production at sea by measuring gill EROD activity in Atlantic cod (Gadus morhua)

An ex vivo gill EROD assay was applied in Atlantic cod (Gadus morhua) as a biomarker for waterborne CYP1A-inducing compounds derived from oil production at sea. Exposure to nominal concentrations of 1 ppm or 10 ppm North Sea crude oil in a static water system for 24 h caused a concentration-dependent gill EROD induction. Further, exposure of cod for 14 days to environmentally relevant concentrations of produced water (PW, diluted 1:200 or 1:1000) from a platform in the North Sea using a flow-through system resulted in a concentration-dependent induction of gill EROD. Crude oil (0.2 ppm) from the same oil field also proved to induce EROD. Finally, gill EROD activity in cod caged for 6 weeks at 500-10 000 m from two platforms outside Norway was measured. The activities in these fish were very low and did not differ from those in fish caged at reference sites.     

Attempts to probe the ozone layer and the ultraviolet-B levels of the past

To get a proper perspective on the current status of atmospheric ozone, which protects the biosphere from ultraviolet-B (UV-B; 280-315 nm) radiation, it would be of value to know how ozone and UV-B radiation have varied in the past. The record of worldwide ozone monitoring goes back only a few decades, and the record of reliable UV-B measurements is even shorter. Here we review indirect methods to assess their status further back in time. These include variations in the Sun's emission and how these affect the atmosphere, changes in the Earth's orbit, geologic imprints of atmospheric ozone, effects of catastrophic events such as volcanic eruptions, biological proxies of UV-B radiation, the spectral signature of terrestrial ozone in old recordings of star spectra, and the modeling of UV-B irradiance from ozone data and meteorological recordings. Although reliable reconstructions do not yet extend far into the past, there is some hope for future progress.     

Techniques for the stabilization and assessment of treated copper-, chromium-, and arsenic-contaminated soil

Remediation mainly based on excavation and burial of the contaminated soil is impractical with regard to the large numbers of sites identified as being in need of remediation. Therefore, alternative methods are needed for brownfield remediation. This study was conducted to assess a chemical stabilization procedure of CCA-contaminated soil using iron (Fe)-containing blaster sand (BS) or oxygen-scarfing granulate (OSG). The stabilization technique was assessed with regard to the feasibility of mixing ameliorants at an industrial scale and the efficiency of the stabilization under different redox conditions. The stability was investigated under natural conditions in 1-m3 lysimeters in a field experiment, and the effect of redox conditions was assessed in a laboratory experiment (10 L). The treatments with high additions of ameliorant (8% and 17%) were more successful in both the laboratory and field experiments, even though there was enough Fe on a stochiometric basis even at the lowest addition rates (0.1% and 1%). The particle size of the Fe and the mixing influenced the stabilization efficiency. The development of anaerobic conditions, simulated by water saturation, increases the fraction of arsenic (AsIII) and, consequently, As mobility. The use of high concentrations of OSG under aerobic conditions increased the concentrations of nickel (Ni) and copper (Cu) in the pore water. However, under anaerobic conditions, it decreased the As leaching compared with the untreated soil, and Ni and Cu leaching was not critical. The final destination of the treated soil should govern the amendment choice, that is, an OSG concentration of approximately 10% may be suitable if the soil is to be landfilled under anaerobic conditions. Alternatively, the soil mixed with 1% BS could be kept under aerobic conditions in a landfill cover or in situ at a brownfield site. In addition, the treatment with BS appeared to produce better effects in the long term than treatment with OSG.     

Net methylmercury production as a basis for improved risk assessment of mercury-contaminated sediments

Sediments contaminated by various sources of mercury (Hg) were studied at 8 sites in Sweden covering wide ranges of climate, salinity, and sediment types. At all sites, biota (plankton, sediment living organisms, and fish) showed enhanced concentrations of Hg relative to corresponding organisms at nearby reference sites. The key process determining the risk at these sites is the net transformation of inorganic Hg to the highly toxic and bioavailable methylmercury (MeHg). Accordingly, Hg concentrations in Perca fluviatilis were more strongly correlated to MeHg (p < 0.05) than to inorganic Hg concentrations in the sediments. At all sites, except one, concentrations of inorganic Hg (2-55 microg g(-1)) in sediments were significantly, positively correlated to the concentration of MeHg (4-90 ng g(-1)). The MeHg/Hg ratio (which is assumed to reflect the net production of MeHg normalized to the Hg concentration) varied widely among sites. The highest MeHg/Hg ratios were encountered in loose-fiber sediments situated in southern freshwaters, and the lowest ratios were found in brackish-water sediments and firm, minerogenic sediments at the northernmost freshwater site. This pattern may be explained by an increased MeHg production by methylating bacteria with increasing temperature, availability of energy-rich organic matter (which is correlated with primary production), and availability of neutral Hg sulfides in the sediment pore waters. These factors therefore need to be considered when the risk associated with Hg-contaminated sediments is assessed.     

Recent advances in mercury speciation analysis with focus on spectrometric methods and enriched stable isotope applications

This paper discusses some recent advances in spectrometric methods and approaches for mercury speciation analysis of environmental samples with focus on isotope dilution techniques for determination of mercury species' concentrations in gaseous samples and reaction rates in soils and sediments. Such analytical data is important inter alia in fundamental research on mercury biogeochemistry and for risk assessments of mercury-contaminated soils and sediments and for designing effective remedial actions. The paper describes how the use of enriched stable isotope tracers in mercury speciation analysis can improve the traceability and accuracy of results, facilitate rational method developments, and be useful for studying biogeochemical processes, i.e. rate of reactions and fluxes, of mercury species. In particular the possibilities to study and correct for unwanted species transformation reactions during sample treatment and to study "natural" transformations of species in environmental samples, or micro- and mesocosm ecosystems, during incubations are highlighted. Important considerations to generate relevant data in isotope tracer experiments as well as reliability and quality assurance of mercury speciation analysis in general are also discussed.