A model for the maximum credible hourly impact on any ground receptor from point sources with momentumdominated plume rise

A pollutant dispersion model is developed, allowing rapid evaluation of the maximum credible one-hour-average concentration on any given ground-level receptor, along with the corresponding critical meteorological conditions (wind speed and stability class) for stacks with momentum-dominated plume rise in urban or rural areas under buoyancy or no buoyancy induced dispersion. Site-specific meteorological data are not required, as the computed concentrations are maximized against all credible combinations of wind speed, stability class, and mixing height.The analysis is based on the dispersion relations of Pasquill-Gifford and Briggs for rural and urban settings respectively, the buoyancy induced dispersion correlation of Pasquill, the wind profile exponent values suggested by Irwin, the momentum plume rise relations of Briggs, as well as the Benkley and Schulman's model for the minimum mixing heights.The model is particularly suited for air pollution management studies, as it allows fast screening of the maximum impact on any selected receptor and evaluation of the ways to have this impact reduced. Also, for regulatory purposes, as it allows accurate setting of minimum stack height requirements as function of the exit gas volume and velocity, the pollutant emission rates and their hourly concentration standards, as well as the source location relative to sensitive receptors.     

An assessment of the risks associated with PCDDs and PCDFs following the application of sewage sludge to agricultural land in the UK

A model has been developed to describe the transfer of PCDDs and PCDFs from sludge-amended soils to the human foodchain. The model is conservative and assumes that all foods consumed by an individual are derived from sludge-amended soils. Predicted concentrations of PCDDs and PCDFs in potatoes, cereals, root vegetables and leafy vegetables were in close agreement with mean concentrations reported in the food survey conducted by MAFF in the UK. Predicted concentrations in milk were well below the Maximum Tolerable Concentration adopted by MAFF. Assuming a half-life of ten years in sludge-amended soils, the maximum estimated incremental daily intake (IDI) predicted by the model following ten applications of sludge to agricultural land was 0.80 pg I-TEQ kg⁻¹ day⁻¹, representing an increase of approximately 45% on current levels of background exposure. For an individual whose diet is solely derived from sludge-amended soils, the total exposure is predicted to be approximately 181 pg I-TEQ day⁻¹ or 2.6 pg I-TEQ kg⁻¹ day⁻¹. This compares with an average background exposure of approximately 2 pg I-TEQ kg⁻¹ day⁻¹, well within the TDI of 10 pg I-TEQ kg⁻¹ day⁻¹ and indicates that the application of sewage sludge to agricultural land under the conditions assumed would not appear to present a significant health risk under the conservative scenarios considered in this assessment.     

A rapid approach to rational water pollution control strategies

The formulation of rational wastewater control strategies is becoming increasingly important in many countries where, exploding urbanization, industrialization and/or tourism, often combined with improved standards of living and better awareness of the environmental problems, are resulting in enlarged pollution problems, but also in the availability of expanding financial resources for environmental protection. However, more often than one tends to believe, lack of planning, or planning with limited understanding of the principles involved, has resulted in solutions that are both expensive and incapable of addressing the key problems.As rigorous planning is extremely resource intensive, and for this reason impractical for most study areas, the development of a much simplified analysis procedure, capable of generating rational, near-optimum, strategies and detailed action programs, is required, if proper environmental management is to be widely practiced.In an effort to achieve the above objectives, a systems analysis approach is selected as the most suitable at rationalizing the allocation of available resources and at producing detailed action programs that promote implementation. In the context of this approach, new, easy to use models have been developed, while others, have been selected, adapted and streamlined in their use. The entire problem analysis and strategy synthesis procedures have thus been simplified and defined to a degree appropriate for widespread use, and the resultant procedure is actively promoted by WHO and UNEP.     

A methodology for optimal MSW management,with an application in the waste transportation of Attica Region,Greece

The paper describes a software system capable of formulating alternative optimal Municipal Solid Wastes (MSWs) management plans, each of which meets a set of constraints that may reflect selected objections and/or wishes of local communities. The objective function to be minimized in each plan is the sum of the annualized capital investment and annual operating cost of all transportation, treatment and final disposal operations involved, taking into consideration the possible income from the sale of products and any other financial incentives or disincentives that may exist. For each plan formulated, the system generates several reports that define the plan, analyze its cost elements and yield an indicative profile of selected types of installations, as well as data files that facilitate the geographic representation of the optimal solution in maps through the use of GIS. A number of these reports compare the technical and economic data from all scenarios considered at the study area, municipality and installation level constituting in effect sensitivity analysis. The generation of alternative plans offers local authorities the opportunity of choice and the results of the sensitivity analysis allow them to choose wisely and with consensus.The paper presents also an application of this software system in the capital Region of Attica in Greece, for the purpose of developing an optimal waste transportation system in line with its approved waste management plan. The formulated plan was able to: (a) serve 113 Municipalities and Communities that generate nearly 2 million t/y of comingled MSW with distinctly different waste collection patterns, (b) take into consideration several existing waste transfer stations (WTS) and optimize their use within the overall plan, (c) select the most appropriate sites among the potentially suitable (new and in use) ones, (d) generate the optimal profile of each WTS proposed, and (e) perform sensitivity analysis so as to define the impact of selected sets of constraints (limitations in the availability of sites and in the capacity of their installations) on the design and cost of the ensuing optimal waste transfer system. The results show that optimal planning offers significant economic savings to municipalities, while reducing at the same time the present levels of traffic, fuel consumptions and air emissions in the congested Athens basin.     

Technoeconomic aspects of alternative municipal solid wastes treatment methods

This paper considers selected treatment technologies for comingled domestic and similar wastes and provides technoeconomic data and information, useful for the development of strategic management plans. For this purpose, treatment technologies of interest are reviewed and representative flow diagrams, along with material and energy balances, are presented for the typical composition of wastes in Greece; possible difficulties in the use of treatment products, along with their management implications, are discussed, and; cost functions are developed, allowing assessment of the initial capital investment and annual operating costs. Based on the latter, cost functions are developed for predicting the normalized treatment costs of alternative methods (in €/t of MSW treated), as function of the quantity of MSW processed by plants built and operated (a) by municipality associations, and (b) by private enterprises. Finally, the alternative technologies considered are evaluated on the basis of their cost aspects, product utilization and compatibility with the EU waste framework Directive 2008/98.     

Air pollution in Athens basin and health risk assessment

An inventory of air pollution sources within the Athens basin is carried out for the years 1989, 1992 and 1998 and the results areinputted in a climatological model for predicting ambient concentrations. Despite of the significant growth in the numberof road vehicles and the deteriorating traffic, the emissions andambient concentrations of fine particulates, CO, NO_x and VOCappear to remain reasonably constant over for the period 1989 to 1998, while these of SO₂ and Pb are reduced, mainly due to the renewal of vehicle fleet, the use of catalytic technologies and the improved quality of the used fuel. The results further indicate that for CO, NO_x and VOC the major source is road traffic, while for PM_2.5 and SO₂ both space heating andtraffic share responsibility. The air pollutant concentrations monitored by the network of 11 stations are reviewed and statistics related to air quality guidelines are presented. As fine particulate levels are not monitored, approximate PM_2.5and PM₁₀ concentrations are derived from black smoke ones on basis of experimentally determined conversion factors. The computed and monitored air pollution levels are compared and found in reasonable agreement. The results of the above analysisshow that the levels of all `classical' pollutants, with the exception of SO₂ and Pb, exceed significantly the WHO guidelines and are thus expected to exert a significant healthimpact. The latter could be quantified in relation to the PM_2.5 or PM₁₀ levels on the basis of risk assessment information developed by the World Health Organization (WHO). The results show that the existing levels of fine particle concentrations in Athens increase significantly the mortality and morbidity, and reduce the average longevity of the entirepopulation from 1.3 to 1.7 years.     

A model for the maximum credible hourly impact on any ground receptor from point sources with thermal plume rise

A pollutant dispersion model is developed, allowing fast evaluation of the maximum credible 1-h average concentration on any given ground-level receptor, along with the corresponding critical meteorological conditions (wind speed and stability class) for stacks with buoyant plumes in urban or rural areas. Site-specific meteorological data are not required, as the computed concentrations are maximized against all credible combinations of wind speed, stability class, and mixing height. The analysis is based on the dispersion relations of Pasquill-Gifford and Briggs for rural and urban settings, respectively, the buoyancy induced dispersion correlation of Pasquill, the wind profile exponent values suggested by Irwin, the buoyant plume rise relations of Briggs, as well as the Benkley and Schulman's model for the minimum mixing heights. The model is particularly suited for air pollution management studies, as it allows fast screening of the maximum impact on any selected receptor and evaluation of the ways to have this impact reduced. It is also suited for regulatory purposes, as it can be used to define the minimum stack size requirements for a given source as a function of the exit gas volume and temperature, the pollutant emission rates and their hourly concentration standards, as well as the source location relative to sensitive receptors.     

Planning effective industrial liquid waste controls in developing nations

The environmental planning principles described in this study address a problem which many developing nations face at some point along their industrialization process; alarming levels of water pollution, and limited background, expertize and organization to combat it effectively.A rapid pollution assessment methodology has been recently developed [1], [2], [3] enabling such countries to conduct valuable waste source inventories within reasonable time, with few people and little support. The present study describes how to use such inventory data in order to derive high priority waste control measures, formulate an effective national strategy for industrial waste control, organize meaningful industrial effluent survey and water monitoring programs, as well as lay down a rational land-use planning policy for industrial expansion.     

Dispersion of Traffic and Space Heating Emissions In Urban Settings

A long-term dispersion model is presented for traffic and space heating emissions in urban areas, allowing fast assessment of the spatial-averaged and center-maximum pollutant concentrations.

The assumption of study areas with circular shape and normal emissions density profiles is made for the purpose of streamlining model inputs with the inventory data normally available. In addition, the rather typical assumptions of Gaussian dispersion, narrow plume, flat or gently rolling terrain, homogeneous wind field and nonreactive pollutants are made. Values of σz from Briggs correlation are used with an initial value of 30 to account for building effects.

Meterological data inputs are reduced to six parameters, inventory data inputs to two, while computations are simplified to a degree that use of a digital computer is not required.

The model is well suited to yield separate assessments for individual types of sources and control measures, as well as to reveal sensitivities from parameters such as city size, or emission density levels and distribution patterns. Its predictions are virtually identical to those of the CDM-2 UNAPMAR model for study areas with circular shape and normal emissions density profiles, and as results do not appear overly sensitive to shape and distribution patterns, the model is believed to be valid for most urban areas.