Toxicity of tire debris leachates

Data on the indicators of environmental impact of tire debris, originated from the tire abrasion on roads, are extremely scarce, while it is well known that tires may produce deleterious effects. Tire debris contains significant quantities of zinc (Zn) which may be released by tire rubber. We have used tire particles (TD) produced in laboratory from new rubber. Two sets of experiments were set up to obtain eluates. One set used 50 and 100 g/L TD to produce eluates at pH 3-7. The Zn quantity was measured with a Inductively Coupled Plasma-Atomic Emission Spectrometry. The eluates at 1%,10%,50%,100% concentrations in culture media were tested on Raphidocelis subcapitata, Daphnia magna and Xenopus laevis embryos (FETAX test). The other set of experiments was performed putting 250 mg/L TD in a column with glass beads to control particle dispersion during the elution process. We demonstrate that factors such as pH, size and particles aggregation deeply influence the elution process, that the amount of Zn leached from particles is related to their aggregation rather than their quantity. These results, even though do not reflect the real environmental toxicity of the leachates, can be successfully used for comparative purposes allowing an initial assessment of the potential effect of tire derived particles.     

Dragutin T. Mihailović, Igor Balaž and Darko Kapor: Time and methods in environmental interfaces modelling: personal insights

Environmental Fluid Mechanics -     

Tire debris organic extract affects Xenopus development

Tire debris (TD) and its organic components were identified as a main source of PM10 atmospheric and water pollution. Because few data are available on the embryotoxic effects of TD organic components, the lethal and teratogenic potential of tire debris organic extract (TDOE) was evaluated using the frog embryo teratogenesis assay-Xenopus (FETAX), coupled with a histopathological screening of the survived larvae. From stage 8 to stage 47, Xenopus laevis embryos were exposed to TDOE at concentrations of 50, 80, 100, 120 and 140 mg/L. The results showed 50 mg/L TDOE to be the non-observable effect concentration (NOEC). TDOE mortality at 80 mg/L was significantly higher than the control, but did not increase further with higher concentrations. A good concentration-response was observed for percentages of malformed larva and from 80 mg/L on these percentages were significantly higher than the control. Therefore, probit analysis gave a 144.6 mg/L TC50. At 120 and 140 mg/L, many larvae were plurimalformed. The most frequent alterations observed were abnormal gut coiling, microphthalmia, monolateral anophthalmia, and narrowing eyes. The histological screening mainly revealed ocular malformations such as double retina, retina nervous cell layer coiling, and altered lens. Moreover severe vacuolisation and necrosis were scored in liver and axial musculature. These results strongly support the assumption that TDOE is a powerful teratogen for X. laevis.     

RANS-based simulation of transverse turbulent mixing in a 2D geometry

Although transverse mixing is a significant process in river engineering when dealing with the discharge of pollutants from point sources or the mixing of tributary inflows, no theoretical basis exists for the prediction of its rate, which is indeed based upon the results of experimental works carried on in laboratory channels or in streams and rivers. The paper presents the preliminary results of a numerical study undertaken to simulate the transverse mixing of a steady-state point source of a tracer in a two-dimensional rectangular geometry, which is expected to reproduce a shallow flow. This geometry is that of Lau and Krishnappan (J Hydraul Div 13(HY10):1173–1189, 1977), who collected turbulent mixing data for a shallow flow. In the numerical study an approach based on the Reynolds Averaged Navier–Stokes (RANS) equations was applied, where the closure problem was solved by using turbulent viscosity concept. Particularly, the classical two-equations k–? model was used. Two methods were applied to the model results to evaluate the turbulent transverse mixing coefficient. The effect on transverse mixing of a grid located upstream the tracer source was also studied. Numerical results were generally higher than the experimental data. This overestimation could be explained considering the hypothesis of isotropic turbulence underlying the k–? model, which can lead to large turbulent viscosities and rate of mixing. However, RANS-based results may still be considered acceptable also providing the large uncertainties associated with literature predictive equations.     

Experimental study of a positive surge. Part 1: basic flow patterns and wave attenuation

A positive surge results from a sudden change in flow that increases the depth. It is the unsteady flow analogy of the stationary hydraulic jump and a geophysical application is the tidal bore. Positive surges are commonly studied using the method of characteristics and the Saint-Venant equations. The article presents the results from new experimental investigations conducted in a large rectangular channel. Detailed unsteady velocity measurements were performed with a high temporal resolution using acoustic Doppler velocimetry and non-intrusive free-surface measurement devices. Several experiments were conducted with the same initial discharge (Q = 0.060 m³/s) and six different gate openings after closure resulting in both non-breaking undular and breaking bores. The analysis of undular surges revealed wave amplitude attenuation with increasing distance of surge propagation were in agreement with Ippen and Kulin theory. Also, undular wave period and wave length data were relatively close to the values predicted by the wave dispersion theory for gravity waves in intermediate water depths.     

Industrial point source CO<Subscript>2</Subscript> emission strength estimation with aircraft measurements and dispersion modelling

CO₂ remains the greenhouse gas that contributes most to anthropogenic global warming, and the evaluation of its emissions is of major interest to both research and regulatory purposes. Emission inventories generally provide quite reliable estimates of CO₂ emissions. However, because of intrinsic uncertainties associated with these estimates, it is of great importance to validate emission inventories against independent estimates. This paper describes an integrated approach combining aircraft measurements and a puff dispersion modelling framework by considering a CO₂ industrial point source, located in Biganos, France. CO₂ density measurements were obtained by applying the mass balance method, while CO₂ emission estimates were derived by implementing the CALMET/CALPUFF model chain. For the latter, three meteorological initializations were used: (i) WRF-modelled outputs initialized by ECMWF reanalyses; (ii) WRF-modelled outputs initialized by CFSR reanalyses and (iii) local in situ observations. Governmental inventorial data were used as reference for all applications. The strengths and weaknesses of the different approaches and how they affect emission estimation uncertainty were investigated. The mass balance based on aircraft measurements was quite succesful in capturing the point source emission strength (at worst with a 16% bias), while the accuracy of the dispersion modelling, markedly when using ECMWF initialization through the WRF model, was only slightly lower (estimation with an 18% bias). The analysis will help in highlighting some methodological best practices that can be used as guidelines for future experiments.     

Contact Tank Design Impact on Process Performance

In this study three-dimensional numerical models were refined to predict reactive processes in disinfection contact tanks (CTs). The methodology departs from the traditional performance assessment of contact tanks via hydraulic efficiency indicators, as it simulates directly transport and decay of the disinfectant, inactivation of pathogens and accumulation of by-products. The method is applied to study the effects of inlet and compartment design on contact tank performance, with special emphasis on turbulent mixing and minimisation of internal recirculation and short-circuiting. In contrast to the conventional approach of maximising the length-to-width ratio, the proposed design changes are aimed at addressing and mitigating adverse hydrodynamic structures, which have historically led to poor hydraulic efficiency in many existing contact tanks. The results suggest that water treatment facilities can benefit from in-depth analyses of the flow and kinetic processes through computational fluid dynamics, resulting in up to 38 % more efficient pathogen inactivation and 14 % less disinfection by-product formation.     

Experimental study of a positive surge. Part 2: comparison with literature theories and unsteady flow field analysis

A positive surge is a unsteady open channel flow resulting from the rapid rise of the free-surface. The phenomenon may be observed in water supply canals and channels as well as in some estuaries during spring tidal conditions. The formation and development of positive surges can be predicted using the method of characteristics and shallow water equations. The paper is the second part of a study presenting the results from new experimental investigations conducted in a large rectangular channel. Detailed unsteady velocity measurements were performed with a high temporal resolution using acoustic Doppler velocimetry and non-intrusive free-surface measurement devices. Several experiments were conducted with the same initial discharge (Q = 0.060 m³/s) and six different gate openings after closure resulting in both non-breaking undular and breaking bores. A comparison between main features of the undular surges with literature theories demonstrated that the experimental data were mostly in agreement with Andersen’s theory. The analysis of unsteady flow field including Reynolds stresses confirmed and extended previous findings about positive surge hydrodynamics.     

Organic compounds in tire particle induce reactive oxygen species and heat-shock proteins in the human alveolar cell line A549

Debris produced from the attrition of tires of motor vehicles constitutes 5-7% of the atmospheric particulate matter (PM10). Debris particles are indeed small enough to enter human lung and thus morphological and chemical characterization has been performed. We demonstrated that the organic fraction of tire debris induces a dose-dependent increase in cell mortality, DNA damage, as well as a significant modification of cell morphology at the dose of 60 microg/ml, which may correspond to the quantity present in the air humans inhale daily. The present research aims at investigating if reactive oxygen species (ROS) production and Hsp70 expression are involved in the cascade of toxic effects produced on the A549 cell line, as it has been suggested for the ultrafine atmospheric particles and diesel exhaust. To this end, cells were exposed at the doses of 10, 50, 60, 75 microg/ml of TD organic extract (TDOE) and analyzed at different exposure time. ROS were detected by the oxidation of 2'7'-dichlorodihydrofluorescein diacetate to dichlorofluorescein, and fluorescence was measured by flow cytometry. Hsp70 protein expression was determined by immunochemical analysis, and protein expression quantification performed by optical densitometry. ROS production was analysed after 2 h of treatment. A statistically significant increase in fluorescence was observed and the intensity of the stress response was parallel to the increasing concentrations used. An evident increase of Hsp70 expression at lower doses (10, 50 microg/ml) and at longer exposure times (72 h) was observed, during the time that our previous studies showed that cell viability, plasma membrane integrity, and DNA molecules were not affected. Thus it can be deduced that the increase in Hsp70 expression protected the cells from those damages, which became evident at the higher doses, and that this parameter might be used as a sensitive indicator of exposure. These data suggest that ROS production may be the first event caused by A549 exposure to TDOE and this result is in line with other evidences provided for the role of ROS generation in ultrafine PM toxicity. It can be suggested that this event induces an overexpression of Hsp70 only at the lower doses and longer exposure time, when cells still appear unaffected. Subsequently when ROS generation reaches high levels, a general inhibition of protein synthesis probably occurs, culminating in cell toxicity.