Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

环境污染纠纷调处与环境行政处罚之区别浅析——兼与章锦华同志商榷

指出了环境污染纠纷调处与环境行政处罚的性质，程序，结果等均不相同，在理论上不能将两者混一谈，实践中应区别对待。     

战略环境评价的工作程序

介绍了战略环境评价（法规、政策、计划和规划层次）工作程序的三个环节：评价方案的制定、评价实施和评价总结。并提出了战略环境评价指标体系制定的原则、战略环境评价的具体步骤及战略环境评价报告书的基本内容。     

确定不同保证率下的中国酸沉降临界负荷

在进行中国酸沉降临界负荷区划时 ,通常以 1°× 1°(经纬度 )的网格为单位进行计算 ,难以反映网格内不同生态系统对酸沉降敏感性的差异 .为了便于决策者根据临界负荷确定酸沉降控制对策 ,也为了使 1°× 1°的结果更具代表性和实用性 ,本研究确定了 0 1°× 0 1°网格为单位计算的中国酸沉降临界负荷 ,并在此基础上通过引入保证率的概念 ,得到了一系列与一定的经济技术水平相适应的、允许有一定损失的 1°× 1°的中国酸沉降临界负荷图 .利用累积分布函数 ,本研究还确定了不同保证率下的中国酸沉降超临界负荷分布和各省、市、自治区的酸沉降临界负荷 .     

阿尔山——柴河旅游区环境本底情况、主要污染物种类、排放水平及污染防治对策

文章根据柴河旅游区自然地理概况及环境质量现状调查以及一些现场调研。结合阿尔山市市区环境大气、哈拉哈河、绰尔河水质监测数据，对柴河旅游区污染物种类、排放进行全面详细分析。并提出了污染防治对策。     

冷轧带钢轧辊温度场及其控制

分析了冷轧过程中工作辊的温度变化及热凸度的形成 ,提出了控制热凸度的有效手段 ,对完善板型控制系统具有重要的意义     

A review of atmospheric mercury emissions,pollution and control in China

Mercury, as a global pollutant, has significant impacts on the environment and human health. The current state of atmospheric mercury emissions, pollution and control in China is comprehensively reviewed in this paper. With about 500-800 t of anthropogenic mercury emissions, China contributes 25%-40% to the global mercury emissions. The dominant mercury emission sources in China are coal combustion, non-ferrous metal smelting, cement production and iron and steel production. The mercury emissions from natural sources in China are equivalent to the anthropogenic mercury emissions. The atmospheric mercury concentration in China is about 2-10 times the background level of North Hemisphere. The mercury deposition fluxes in remote areas in China are usually in the range of 10-50μg·m^-2·yr^-1. To reduce mercury emissions, legislations have been enacted for power plants, non-ferrous metal smelters and waste incinerators. Currently mercury contented in the flue gas is mainly removed through existing air pollution control devices for sulfur dioxide, nitrogen oxides, and particles. Dedicated mercury control technologies are required in the future to further mitigate the mercury emissions in China.     

TiO2@palygorskite composite for the efficient remediation of oil spills via a dispersion-photodegradation synergy

• A novel and multi-functional clay-based oil spill remediation system was constructed. • TiO₂@PAL functions as a particulate dispersant to break oil slick into tiny droplets. • Effective dispersion leads to the direct contact of TiO₂ with oil pollutes directly. • TiO₂ loaded on PAL exhibits efficient photodegradation for oil pollutants. • TiO₂@PAL shows a typical dispersion-photocatalysis synergistic remediation. Removing spilled oil from the water surface is critically important given that oil spill accidents are a common occurrence. In this study, TiO₂@Palygorskite composite prepared by a simple coprecipitation method was used for oil spill remediation via a dispersion-photodegradation synergy. Diesel could be efficiently dispersed into small oil droplets by TiO₂@Palygorskite. These dispersed droplets had an average diameter of 20–30 mm and exhibited good time stability. The tight adsorption of TiO₂@Palygorskite on the surface of the droplets was observed in fluorescence and SEM images. As a particulate dispersant, the direct contact of TiO₂@Palygorskite with oil pollutants effectively enhanced the photodegradation efficiency of TiO₂ for oil. During the photodegradation process, •O₂⁻and •OH were detected by ESR and radical trapping experiments. The photodegradation efficiency of diesel by TiO₂@Palygorskite was enhanced by about 5 times compared with pure TiO₂ under simulated sunlight irradiation. The establishment of this new dispersion-photodegradation synergistic remediation system provides a new direction for the development of marine oil spill remediation.     

湿地生态地球化学研究进展

湿地生态地球化学研究是湿地研究的核心内容之一, 是研究其物理过程、化学过程和生物过程及其相互关系以及这些过程与湿地功能的关系.回顾了近年来国内外湿地生态地球化学方面的研究成果,介绍了它的概念,并评述了湿地的生态功能、元素地球化学、生物地球化学、湿地模型和3S技术等新技术在湿地研究中的应用等方面的研究进展.提出了中国湿地生态地球化学研究的优先领域,应加强湿地基础理论研究及在湿地的演化、生态过程、界面过程、预测与评价、信息系统等方面的研究.     

Assessment of population exposure to particulate matter pollution in Chongqing, China

To determine the population exposure to PM(10) in Chongqing, China, we developed an indirect model by combining information on the time activity patterns of various demographic subgroups with estimates of the PM(10) concentrations in different microenvironments (MEs). The spatial and temporal variations of the exposure to PM(10) were illustrated in a geographical information system (GIS). The population weighted exposure (PWE) for the entire population was 229, 155 and 211 microg/m(3), respectively, in winter, summer and as the annual average. Indoor PM(10) level at home was the largest contributor to the PWE, especially for the rural areas where high pollution levels were found due to solid fuels burning. Elder people had higher PM(10) exposure than adults and youth, due to more time spent in indoor MEs. The highest health risk due to particulate was found in the city zone and northeast regions, suggesting that pollution abatement should be prioritized in these areas.