Energy profiles of an agricultural frontier: the American Great Plains, 1860–2000

Regional Environmental Change - Agro-ecosystem energy profiles reveal energy flows into, within, and out of US Great Plains farm communities across 140 years. This study evaluates external...     

Insights into hazardous solid waste generation during COVID-19 pandemic and sustainable management approaches for developing countries

Journal of Material Cycles and Waste Management - The recent emergence of the COVID-19 pandemic has contributed to the drastic production and use of healthcare and personal protective equipment,...     

Design and risk assessment tool for vegetative treatment areas receiving agricultural wastewater: Preliminary results

Vegetative treatment areas (VTAs) are commonly being used as an alternative method of agricultural process wastewater treatment. However, it is also apparent that to completely prevent discharge of pollutants to the surrounding environment, settling of particulates and bound constituents from overland flow through VTAs is not sufficient. For effective remediation of dissolved agricultural pollutants, VTAs must infiltrate incoming wastewater. A simple water balance model for predicting VTA soil saturation and surface discharge in landscapes characterized by sloping terrain and a shallow restrictive layer is presented and discussed. The model accounts for the cumulative effect of successive rainfall events and wastewater input on soil moisture status and depth to water table. Nash–Sutcliffe efficiencies ranged from 0.65 to 0.81 for modeled and observed water table elevations after calibration of saturated hydraulic conductivity. Precipitation data from relatively low, average, and high annual rainfall years were used with soil, site, and contributing area data from an example VTA for simulations and comparisons. Model sensitivity to VTA width and contributing area (i.e. barnyard, feedlot, silage bunker, etc.) curve number was also investigated. Results of this analysis indicate that VTAs should be located on steeper slopes with deeper, more-permeable soils, which effectively lowers the shallow water table. In sloping landscapes (>2%), this model provides practitioners an easy-to-use VTA design and/or risk assessment tool that is more hydrological process-based than current methods.     

Source apportionment of fine particles in Tennessee using a source-oriented model

Source apportionment of fine particles (PM2.5, particulate matter < 2 microm in aerodynamic diameter) is important to identify the source categories that are responsible for the concentrations observed at a particular receptor. Although receptor models have been used to do source apportionment, they do not fully take into account the chemical reactions (including photochemical reactions) involved in the formation of secondary fine particles. Secondary fine particles are formed from photochemical and other reactions involving precursor gases, such as sulfur dioxide, oxides of nitrogen, ammonia, and volatile organic compounds. This paper presents the results of modeling work aimed at developing a source apportionment of primary and secondary PM2.5. On-road mobile source and point source inventories for the state of Tennessee were estimated and compiled. The national emissions inventory for the year 1999 was used for the other states. U.S. Environmental Protection Agency Models3/Community Multi-Scale Air Quality modeling system was used for the photochemical/secondary particulate matter modeling. The modeling domain consisted of a nested 36-12-4-km domain. The 4-km domain covered the entire state of Tennessee. The episode chosen for the modeling runs was August 29 to September 9, 1999. This paper presents the approach used and the results from the modeling and attempts to quantify the contribution of major source categories, such as the on-road mobile sources (including the fugitive dust component) and coal-fired power plants, to observed PM2.5 concentrations in Tennessee. The results of this work will be helpful in policy issues targeted at designing control strategies to meet the PM2.5 National Ambient Air Quality Standards in Tennessee.     

A comparison of two techniques for studying sediment desorption kinetics of hydrophobic pollutants

A comparison of two techniques (gaseous purge and vial desorption) for studying the kinetics of desorption of hydrophobic pollutants from natural sediments was conducted using identical, pre-equilibrated pollutant-sediment suspensions. Desorption profiles for the two techniques [for Lindane, Aldrin, 2,2'-dichlorobiphenyl (2,2'-DCB), 4,4'-dichlorobiphenyl (4,4'-DCB), and 2,2',6,6'-tetrachlorobiphenyl (TCB)] were then compared, based on the distribution of pollutant mass between the labile (fast) and non-labile (slow) desorption phases and the release rate constants for each phase of release. The vial desorption technique shows many practical advantages over the gaseous purge technique, including its more realistic mixing conditions, the use of an independent sample for each data point (as opposed to a calculation of a cumulative mass purged at each time point), the fact that the vials constitute a closed system and are therefore less subject to ambient contamination, and the relatively low demands of time and money for the vial technique. No consistent trends in labile rate constants or in pollutant distribution between the labile and non-labile phase were observed between the two techniques. A comparison of kinetic parameters shows much faster non-labile rate constants for the gaseous purge technique, attributed to the violent, continuous agitation employed, which likely disrupted sediment aggregates and oxidized the natural organic matter associated with the sediment. Non-labile rate constants have implications for the long-term fate of compounds adsorbed to repetitively disturbed sediments. This study suggests that the traditionally less popular vial desorption technique may yield more realistic non-labile desorption rate constants.     

Overview of Environmental Hazards and Health Effects of Pollution in Developing Countries: A Case Study of Nigeria

Pollution has taken on a global dimension, and the effects are most obvious in developing countries. The effects take a toll on human health, animals, and vegetation, as well as on soil, air, and water quality. The objective of this article is to discuss the current relationships among pollution, environmental quality, and human health within the frame of anthropogenic activities in developing countries. In addition to personal observations, we review relevant literature on conditions throughout the developing world and case studies on conditions and activities in Nigeria. Key findings show the significant, adverse contributions to human health and environmental risk from current waste generation and handling practices, indoor and outdoor air pollution, wastewater and effluent generation and disposal, the hazardous nature and pollution potential of wastes, and the human behaviors that contribute to pollution in developing countries. There is an urgent need to create awareness among the various segments of society of the human health hazards posed by pollution as well as a need for the comprehensive development and enforcement of appropriate policies to prevent a descent into an abyss of deteriorating human and environmental health.     

Occurrence of PPCPs in the marine environment: a review

Little research has been conducted on the occurrence of pharmaceuticals and personal care products (PPCPs) in the marine environment despite being increasingly impacted by these contaminants. This article reviews data on the occurrence of PPCPs in seawater, sediment, and organisms in the marine environment. Data pertaining to 196 pharmaceuticals and 37 personal care products reported from more than 50 marine sites are analyzed while taking sampling strategies and analytical methods into account. Particular attention is focused on the most frequently detected substances at highest concentrations. A snapshot of the most impacted marine sites is provided by comparing the highest concentrations reported for quantified substances. The present review reveals that: (i) PPCPs are widespread in seawater, particularly at sites impacted by anthropogenic activities, and (ii) the most frequently investigated and detected molecules in seawater and sediments are antibiotics, such as erythromycin. Moreover, this review points out other PPCPs of concern, such as ultraviolet filters, and underlines the scarcity of data on those substances despite recent evidence on their occurrence in marine organisms. The exposure of marine organisms in regard to these insufficient data is discussed.