板料液压成形技术的发展动态及应用

介绍了板料液压成形技术的发展 ,尤其是近几年发展起来的径向加压的液压成形、液压成对成形和粘性介质压力成形等 3种金属成形技术 ,以及近几年国外板料液压成形设备的开发和应用情况。     

Impacts of climate change on wheat development and production in the northern China

In this paper, impacts of climate change on wheat development rate and production in the northern China are discussed. The results show that the temperature is a controlling factor of development rate but the precipitation is not. The higher the temperature is. the faster the development and the shorter development period will be. Without consideration to varieties and cropping system, meteorological yield of winter wheat would decrease 170.40, 134.25, 98.70 and 97.20 kg/hm2 in the north China and 13.97, 7.95, 39.60 and 19.80 kg/hm2 in the northwest China compared with that in 1950s, 1960s, 1970s and 1980s, respectively, when the CO2 concentration in the atmosphere is doubled. In drought and semi-drought regions, the spring wheat yield would drop with the temperature rise in and raise with the precipitation increase. The influence of temperature on weight of leaf and stalk is also remarkable.     

工程菌处理高纯二甲醚生产废水的研究

工程菌LEY7是以假单胞菌D3 菌株 (Pseudomonassp.D3 )为受体 ,以缓慢牙孢杆菌 3RM2 菌株 (Bacilluslentus 3RM2 ) ,假单胞菌W1 (Pseudomonassp .W1 )和W2 (Pseudomonassp .W2 )为供体 ,用多基因转化原生质球构建而成。工程菌LEY7能同时降解 4种化合物。用工程菌LEY7处理化工废水 ,工艺采用二级氧化。处理效果 :进水COD =10 0 0mg/L ,处理后出水COD在 10 0mg/L以下。COD去除率达到 90 %以上。     

刺激性气体HCl在不同尺度火灾实验中的释放行为

火灾是一种灾害性燃烧现象 ,给人员和财产安全带来极大损失。氯化氢 (HCl)是火灾烟气中阻碍人员逃生的最重要的刺激性气体之一。以典型的小尺度和大尺度实验为例 ,分析了加热程度和通风供氧对常用有机材料起火后释放HCl的影响 ,发现不论小尺度还是大尺度 ,HCl的形成只与燃烧过程有关 ,与氧化过程无关 ,HCl的生成率不随通风情况不同而改变。实验中影响HCl释放的主要因素是热 (辐射加热热流密度或温度 )。当超过CCl键发生断裂的温度后 ,继续升温HCl释放速率不发生改变 ,出现稳定释放阶段。在反映HCl释放过程不同尺度间存在共性 ,因此 ,利用小尺度的结果进行释放规律内在机理的探索是合理的方法     

Improving Operational Planning and Management of National Parks in Turkey: A Case Study

The purpose this study was to improve operational planning and management of national parks in Turkey to balance conservation use and sustainable management. Souksu National Park (SNP) was chosen as the study area. The data were obtained from interviews of 182 visitor groups (in total, 819 people) and analyzed using correlation, factor, discriminant, and regression analyses. It was found that the most important factors affecting operational planning and management of SNP are (1) travel cost, (2) visitor welfare level, (3) intensity of use, (4) size of visitor group, (5) type of recreational demand. The main source of visitors to SNP is from a zone within a 0–90-km radius. This region comprised 53.85% of total visitors to the park. The capital of Turkey (Ankara) is the most important source of visitors from within this zone. The optimum activity mix in SNP is also determined. Picnicking, viewing the scenery, and nature walks or trekking comprised the main uses of the park. It is anticipated that these findings will help to improve operational planning and sustainable management of the national park and the environment.     

Atrazine sorption-desorption hysteresis by sugarcane mulch residue

Sorption and desorption kinetics are essential components for modeling the movement and retention of applied agricultural chemicals in soils and the fraction of chemicals susceptible to runoff. In this study, we investigated the retention characteristics of sugarcane (Saccharum spp. hybrid) mulch residue for atrazine (2-chloro-4-ethylamino-6-isopropylamino-1,3,5-triazine) based on studies of sorption-desorption kinetics. A sorption kinetic batch method was used to quantify retention of the mulch residue for a wide range of atrazine concentrations and reaction times. Desorption was performed following 504 h of sorption using successive dilutions, followed by methanol extraction. Atrazine retention by the mulch residue was well described using a linear model where the partitioning coefficient (K(d)) increased with reaction time from 10.40 to 23.4 cm3 g(-1) after 2 and 504 h, respectively. Values for mulch residue K(d) were an order of magnitude higher than those found for Commerce silt loam (fine-silty, mixed, superactive, nonacid, thermic Fluvaquentic Endoaquepts) where the sugarcane crop was grown. A kinetic multireaction model was successful in describing sorption behavior with reaction time. The model was equally successful in describing observed hysteretic atrazine behavior during desorption for all input concentrations. The model was concentration independent where one set of model parameters, which was derived from all batch results, was valid for the entire atrazine concentration range. Average atrazine recovery following six successive desorption steps were 63.67 +/- 4.38% of the amount adsorbed. Moreover, a hysteresis coefficient based on the difference in the area between sorption and desorption isotherms was capable of quantifying hysteresis of desorption isotherms.     

Equilibrium and kinetic studies on biosorption of Hg(II), Cd(II) and Pb(II) ions onto microalgae Chlamydomonas reinhardtii

The microalgae Chlamydomonas reinhardtii was used for the biosorption of Hg(II), Cd(II) and Pb(II) ions. The maximum adsorption of Hg(II) and Cd(II) ions on Chlamydomonas reinhardtii biomass was observed at pH 6.0 and the corresponding value for Pb(II) ions was 5.0. The biosorption of Hg(II), Cd(II) and Pb(II) ions by microalgae biomass increased as the initial concentration of Hg(II), Cd(II) and Pb(II) ions increased in the biosorption medium. The maximum biosorption capacities of microalgae for Hg(II), Cd(II) and Pb(II) ions were 72.2+/-0.67, 42.6+/-0.54 and 96.3+/-0.86 mg/g dry biomass, respectively. The affinity order for algal biomass was Pb(II)>Hg(II)>Cd(II). FT-IR analysis of algal biomass revealed the presence of amino, carboxyl, hydroxyl and carbonyl groups, which were responsible for biosorption of metal ions. Biosorption equilibrium was established in about 60 min and the equilibrium was well described by the Freundlich biosorption isotherms. Temperature change in the range of 5-35 degrees C did not affect the biosorption capacity. The microalgae could be regenerated using 0.1 M HCl, with up to 98% recovery, which allowed the reuse of the biomass in six biosorption-desorption cycles without any considerable loss of biosorption capacity.     

北京春季城区与远郊区不同大气粒径颗粒物中水溶性离子的分布特征

为比较北京城区与远郊区大气颗粒物中水溶性无机离子的组成特征,2012年4月,利用Andersen分级撞击式采样器同时在2个采样点进行大气颗粒物分级采样,样品采用离子色谱分析.结果表明,城区和上甸子大气颗粒物中水溶性无机离子总浓度分别为(83.7±48.9)μg·m-3和(75.5±52.9)μg·m-3,NO-3、SO2-4和NH+4是最主要的水溶性无机离子,分别占总离子浓度的81.2%和84.2%.粒径分布显示,Mg2+和Ca2+在5.8～9.0μm的粒径范围出现峰值,Na+、NH+4、Cl-在0.43～1.1μm和4.7～9.0μm的粒径范围出现双峰,K+、NO-3和SO2-4在0.65～2.1μm的粒径范围出现峰值.后向轨迹簇分析表明,气团来自南方时,城区和上甸子二次离子浓度分别为(92.4±40.0)μg·m-3和(95.0±35.4)μg·m-3,来自其他方向时,分别为(24.0±10.8)μg·m-3和(13.3±10.6)μg·m-3.     

液晶显示器液晶处理与铟回收技术

在实验室条件下,对液晶显示器回收的各个重要环节作了初步的探索,提出了一整套回收工艺.其中包括利用丙酮常温浸取去除偏光片、分离玻璃基板、溶解液晶,还包括利用硫酸溶液和二氧化锰联合浸取玻璃基板,铟的浸取率达89%.得到的铟的酸液经过萃取、置换和电解,可以得到铟的产品,为液晶显示器的资源化和无害化提供实验数据和技术支持.     

千层塔扦插繁殖研究

通过扦插试验,采用不同浓度水平的吲哚丁酸、萘乙酸、生根粉和吲哚丁酸＋萘乙酸等药剂处理千层塔插条,研究对插条的生根量、生根率、成活率等的影响和插条萌芽状况及扦插基质对插条生根的影响,为千层塔资源快速再生提供有效的繁殖途径。