不同碳源条件下草菇内切型纤维素酶基因（eg1）转录表达的分析

利用Northernblot方法分析了不同碳源条件下草菇切型纤维素酶基因(eg1)的表达.结果发现,在含有纤维素的液体培养基中生长10d,eg1在草菇菌丝中有高效表达;纤维二糖、α-乳糖、β-乳糖,也能诱导eg1的表达,但和纤维素相比,eg1的表达量相对较低,并且它们的诱导效应在加入这类糖12h后迅速减弱;槐糖和龙胆二糖的诱导作用非常弱.在天然稻草为基质的固体栽培料生长时,草菇eg1的表达和草菇菌丝生长与出菇相对应,在菌丝生长期(d8)可见eg1的表达,d12时菌丝已长满,表达减弱,在出菇及菇体的分化及增大期,eg1的表达量逐渐增强,在成熟期达到最高水平;表明在草菇菇体发育中需要更多碳源及能源的补充,eg1在这方面起着非常重要的作用.图4参14     

Assessment of regional metal levels in ambient air by statistical regression models

The assessment of the particulate matter (PM) levels and its constituents presented in the atmosphere is an important requirement of the air quality management and air pollution abatement. The heavy metal levels in PM10 are commonly evaluated by experimental measurements; nevertheless, the EC Directives also allow the Regional Governments to estimate the regulated metal levels (Pb in Directive 2008/50/EC and As, Ni and Cd in Directive 2004/107/EC) by objective estimation and modelling techniques. These techniques are proper alternatives to the experimental determination because the required analysis and/or the number of required sampling sites are reduced. The present work aims to estimate the annual levels of regulated heavy metals by means of multivariate linear regression (MLR) and principal component regression (PCR) at four sites in the Cantabria region (Northern Spain). Since the objective estimation techniques may only be applied when the regulated metal concentrations are below to the lower assessment threshold, a previous evaluation of the determined annual levels of heavy metals is conducted to test the fulfilment of the EC Directives requirements. At the four studied sites, the results show that the objective estimations are allowed alternatives to the experimental determination. The annual average metal concentrations are well estimated by the MLR technique in all the studied sites; furthermore, the EC quality requirements for the objective estimations are fulfilled by the developed statistical MLR models. Hence these estimations may be used by Regional Governments as a proper alternative to the experimental measurements for the regulated metal levels assessment.     

Waste minimisation in a hard chromiun plating Small Medium Enterprise (SME)

The high potential of waste stream minimisation in the metal finishing sector justifies specific studies of Small and Medium Enterprises (SME). In this work, the minimisation options of the wastes generated in a hard chromium plating activity have been analysed. The study has been performed in a small job shop company, which works in batch mode with big pieces. A process flowsheet after connecting the unit operations and determining the process inputs (raw and secondary materials) and outputs (waste streams) has been carried out. The main properties, quantity and current management of the waste streams have been shown. The obvious lack of information has been identified and finally the waste minimisation options that could be adopted by the company have been recorded.     

Physico-chemical and toxicological characterization of the historic estuarine sediments: a multidisciplinary approach

The accumulation rates, the geochronology of metals and PAH contamination, and the Microtox toxicity are studied in five sediment cores (50 cm length) covering different areas of the Santander Bay, Northern Spain. Chronology given by (210)Pb and (137)Cs reveals significant differences in accumulation rates between sites (0.2-1.1 cm/year), as well as a variable degree of anthropogenic enrichment factors for Fe, Mn, Cu, Pb, Zn, Ni (from 1 to 15) and concentrations of summation Sigma 16PAHs (from 0.01 to 23.84 mg/kg dw) in sediments over the last 90 years. The results indicate the increasing contamination pressure from industrial and urban activities along the Bay. No toxic results from the Microtox test are obtained either with pore water or with normalised sediment aqueous extracts (European Norm EN 12457), suggesting low water solubility and low availability of contaminants in the studied sediments. However, the EC50 values from the Microtox Basic Solid Phase Test (BSPT) ranged from 0.03% to 2.35%, showing vertical toxicity profiles in accordance with metal and PAHs behaviour. The correlation degrees of Microtox BSPT toxicity to chemical concentration in sediment profiles are widely variable showing a high site-dependent toxicity. The oligochaete Limnodrilus hoffmeisteri has been used as a chronic bioassay over surface sediments of two of the studied sites, showing results coherent with the Microtox BSPT acute test results. Global results of the present work provide regional geochemical baselines for metals and PAHs and toxicological data now make it possible to obtain a preliminary quality assessment of the Santander Bay sediment profiles.     

Evaluation of the urban/rural particle-bound PAH and PCB levels in the northern Spain (Cantabria region)

The aim of the present study was to evaluate the polycyclic aromatic hydrocarbon (PAH) and polychlorinated biphenyl (PCB) levels in PM(10) and PM(2.5), at one rural and three urban sites in the Cantabria region (northern Spain). From all of these pollutants, benzo(a)pyrene is regulated by the EU air quality directives; its target value (1?ng/m(3)) was not exceeded. The concentration values of the studied organic pollutants at the studied sites are in the range of those obtained at other European sites. A comparison between the rural-urban stations was developed: (a) PAH concentration values were lower in the rural site (except for fluorene). Therefore, the contribution of local sources to the urban levels of PAHs seems relevant. Results from the coefficient of divergence show that the urban PAH levels are influenced by different local emission sources. (b) PCB rural concentration values were higher than those found at urban sites. Because no local sources of PCBs were identified in the rural site, the contribution of more distant emission sources (about 40?km) to the PCB levels is considered to be the most important; the long-range transport of PCBs does not seem to be significant. Additionally, local PAH tracers were identified by a triangular diagram: higher molecular weight PAHs in Reinosa, naphthalene in Santander and anthracene/pyrene in Castro Urdiales. A preliminary PAH source apportionment study in the urban sites was conducted by means of diagnostic ratios. The ratios are similar to those reported in areas affected by traffic emissions; they also suggest an industrial emission source at Reinosa.     

Inertization of toxic wastes

Toxic wastes, usually found as byproducts of industrial processes originate a constant degradation of the Environment and a complex scientific and technical problem. A Solidification/Inertization technique has been applied to the control of the landfill disposal of steel foundry dust. Based on lixiviation test results are given on possibilities to reduce lead, chromium and cadmium emission to the Environment.     

Organochlorine pesticide residues in sediments from coastal environment of Cantabria (northern Spain) and evaluation of the Atlantic Ocean

This paper documents levels of organochlorine pesticides (OCs) in coastal surface sediments from selected reference sites on the northern Atlantic Spanish coast. One hundred eight samples covering three estuaries in the Cantabrian Coast were sampled in 2006 and analyzed in the finer fraction (<63 ??m) for 19 OCs by gas chromatography with electron capture detector after confirmation by mass spectrometry. Detected organochlorine pesticides were endosulfan ??, endosulfan ??, endosulfan sulfate, hexachlorobenzene (HCB), aldrin, dieldrin, methoxychlor, 1,1-dichloro-2,2-bis(4-chlorophenyl)ethylene (4,4??-DDE) and 1,1-dichloro-2,2-bis(4-chlorophenyl)ethane (4,4??-DDD). Total OCs concentrations ranged from 1.8 ng g^???1 dry weight (dw) to 3.9 ng g^???1 dw, showing a uniform distribution along the studied area, and being consistent with recorded levels in the literature for coastal sediments in other reference sites with low levels of pollution by OCs along the Atlantic Ocean. Endosulfan, 4,4??-DDD, HCB, aldrin, and dieldrin seemed to be ubiquitous as the legacy of past uses and deposition. OCs concentrations were significantly correlated to organic matter content and particle size distribution. No adverse biological effects derived from these pollutants are expected to take place as it can be concluded from the comparison with the existent marine sediment quality guidelines.     

Impact of the global economic crisis on metal levels in particulate matter (PM) at an urban area in the Cantabria Region (Northern Spain)

Air pollution by particulate matter is well linked with anthropogenic activities; the global economic crisis that broke out in the last year may be a proper indicator of this close relationship. Some economic indicators show the regional effects of the crisis on the Cantabria Region. The present work aims to evaluate the impact of the economic crisis on PM10 levels and composition at the major city of the region, Santander. Some metals linked to anthropogenic activities were measured at Santander and studied by Positive Matrix Factorization; this statistical analysis allowed to identify three main factors: urban background, industrial and molybdenum-related factor. The main results show that the temporal trend of the levels of the industrial tracers found in the present study are well agree with the evolution of the studied economic indicators; nevertheless, the urban background tracers and PM10 concentration levels are not well correlated with the studied economic indicators.     

Contribution to closing the loop on waste materials: valorization of bottom ash from waste-to-energy plants under a life cycle approach

Incineration has undergone several technology improvements, reducing air emissions and increasing the efficiency of energy and material recovery; however, there is still a long way to go. To analyze the environmental impacts of waste incineration, this study assessed 15 waste fractions that compose municipal waste in Spain, which are grouped as non-inert materials (plastics, paper, cardboard and organic matter), unburned materials (glass and Al) and ferrous materials. Additionally, this paper evaluates the valorization of bottom ash (BA) to produce steel, aluminum and cement in these recycled/recoverable waste fractions. The results depend on the input waste composition and the heating value (HHV) and showed that ferrous and unburned materials had the worst environmental performance due to the null HHV. The valorization of BA in steel, Al and cement production significantly reduced the environmental impact and the consumption of resources. BA recycling for secondary steel and Al production would improve the environmental performance of the combustion of unburned materials and ferrous materials, whereas the use of BA in cement production diminished the consumption of NR for non-inert materials. This is of great interest for organic matter and PC, waste with a low energy production and high heavy metal and sulfur content.