Trace element concentrations in soils along urbanization gradients in the city of Wien, Austria

Urban soil is an important component of urban ecosystems. This study focuses on heavy metal contamination in soils of Wien (Austria) and results are compared to those for a few large European cities. We analysed the elemental contents of 96 samples of topsoil from urban, suburban and rural areas in Wien along a dynamic (floodplain forest) and a stable (oak–hornbeam forest) urbanization gradient. The following elements were quantified using ICP-OES technique: Al, As, Ba, Ca, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Pb, P, S and Zn. For heavy metals PI (pollution index) values were used to assess the level of pollution. The PI values indicated high level of pollution by Pb in the suburban and rural area of stable gradient and in the urban area of dynamic gradient; moderate level of pollution was indicated for Cd in the urban area of stable gradient. The level of pollution was moderate for Co in the suburban and rural area of the stable gradient, and for Cu in suburban area of stable gradient, and urban area of dynamic gradient. The pollution level of Zn was moderate in all areas. Urban soils, especially in urban parks and green areas may have a direct influence on human health. Thus, the elemental analysis of soil samples is one of the best ways to study the effects of urbanization. Our results indicated that the heavy metal contamination was higher in Wien than in a few large European cities.     

Application of activated sludge model no. 3 for the modeling of organic matter biodegradation at thermophilic temperatures.

The primary aim of our research was to investigate the applicability of activated sludge models (ASM) for aerobic thermophilic processes, especially autothermal thermophilic aerobic digestion (ATAD). The ASM3 model (Gujer et al., 1999) theoretically seems to be the most suitable, because storage plays an important role in a batch-feed cycle system like ATAD. The ASM3 model was extended with an activation step of the thermophilic organisms. This model was calibrated and verified by independent test results, demonstrating its ability to describe the process. The growth (microH = 26.04 day(-1)), storage (k(STO) = 20.39 day(-1)), hydrolysis (kH = 11.15 day(-1)) and decay rates (b 9H,O2) = 1.28 day(-1), b(STO,O2 = 1.10 day-1)) obtained from calibration are significantly higher at 55 degrees C than at mesophilic temperatures, justifying the faster metabolism at higher temperatures. An inert fraction of the biomass (characterized by the model parameter f(i) = 0.4) was found to be significantly greater than in the mesophilic case. This can be attributed to the lower diversity of the thermophilic species and thus to their narrower substrate spectra.     

Improving pedestrian safety using combined HOG and Haar partial detection in mobile systems

Objective: The objective of this study is to develop a novel algorithm on a mobile system that can warn drivers about the possibility of a collision with a pedestrian. The constraints of the algorithm are near-real-time detection speed and a good detection rate.

Method: Histogram of gradients (HOG)-based detection is widely used in pedestrian safety applications; however, it has low detection speed for real-time systems. Hence, it has no direct usage for mobile systems. In order to achieve near-real-time detection speed, partial Haar transform predetections are applied to an image before HOG detection. The partial and HOG detections are merged and a score-based confidence level is defined for the final detection phase. In this way, the outcome is prioritized and different warning levels can be issued to warn the driver before a possible pedestrian collision.

Results: The proposed algorithm provides an increase in detection speed (from 46 to 76 fps) and detection rate (from 80 to 91%) with respect to HOG-based pedestrian detection. It also improves confidence of the results by multidetection merging and score assignment to detections.

Conclusions: Performance improvement of the algorithm is compared with respect to state-of-the-art detectors/algorithms. Based on the detection rate and detection speed performance, it can be concluded that the proposed algorithm is suitable to be used for mobile systems to warn drivers about the possibility of collision with a pedestrian.     

Matrix effect in case of purification of oily waters by membrane separation combined with pre-ozonation

In the present study, oil in water emulsions (c_oil?=?100 ppm; d_{oil droplets}?<?2 μm) was purified with ozonation followed by microfiltration using polyethersulfone (PES) membrane (d_pore?=?0.2 μm). The effects of pre-ozonation on membrane microfiltration were investigated in detail both in case of ultrapure and model groundwater matrices, applying different durations (0, 5, 10, and 20 min) of pre-ozonation. Simultaneously, the effects of added inorganic water components on the combined method were investigated. Size distribution of oil droplets, zeta potentials, fluxes, and purification efficiencies were measured and fouling mechanisms were described in all cases. It was found that the matrix significantly affected the size distribution and adherence ability of oil droplets onto the membrane surface, therefore fouling mechanisms also were strongly dependent on the matrix. In case of low salt concentration, the total resistance was caused mainly by reversible resistance, which could be significantly reduced (eliminated) by pre-ozonation. In case of model groundwater matrix, nearly twice higher total resistance was measured, and irreversible resistance was dominant, because of the higher adhesion ability of the oil droplets onto the membrane surface. In this case, pre-ozonation resulted in much lower irreversible, but higher reversible resistance. Increased duration of pre-ozonation raised the total resistance and reduced the elimination efficiency (due to fragmented oil droplets and water soluble oxidation by-products) in both cases, therefore short pre-ozonation can be recommended both from economic and performance aspects.     

Assessment of the effects of urbanization on trace elements of toe bones

Amphibians, particularly frogs and toads, are increasingly used as bioindicators of contaminant accumulation in pollution studies. We developed an analytical technique to analyse their elemental contents based on a small amount of toe bone samples. This method is environment-friendly as, unlike traditional methods, it is not necessary to kill animals during sampling. Using this technique, we explored the effects of urbanization on the elemental contents of toe bones. Bufo bufo specimens were collected from an urban and two rural ponds. The ratios of Ca and P at the ponds were: 20.5% Ca and 14.6% P at the urban pond and 30.4% and 29.6% Ca, 22.4% and 21.7% P at the rural ponds, respectively. For the other elements, the following percentage ratios were found: 0.7% B, 0.3% Mg and 0.06% Zn at the urban pond and 1.1% and 0.4% B, 0.4% Mg and 0.05% Zn at the rural ponds, respectively. Canonical discriminant analysis indicated the separation of the urban and the rural ponds based on the elemental concentrations of toe bones. Significant differences were found between the concentrations of Ca, P, Mg, B and Zn at the urban and the rural ponds (p?相似文献   

Air pollution assessment based on elemental concentration of leaves tissue and foliage dust along an urbanization gradient in Vienna

Foliage dust contains heavy metal that may have harmful effects on human health. The elemental contents of tree leaves and foliage dust are especially useful to assess air environmental pollution. We studied the elemental concentrations in foliage dust and leaves of Acer pseudoplatanus along an urbanization gradient in Vienna, Austria. Samples were collected from urban, suburban and rural areas. We analysed 19 elements in both kind of samples: aluminium, barium, calcium, copper, iron, potassium, magnesium, sodium, phosphor, sulphur, strontium and zinc. We found that the elemental concentrations of foliage dust were significantly higher in the urban area than in the rural area for aluminium, barium, iron, lead, phosphor and selenium. Elemental concentrations of leaves were significantly higher in urban than in rural area for manganese and strontium. Urbanization changed significantly the elemental concentrations of foliage dust and leaves and the applied method can be useful for monitoring the environmental load.     

Transgenic Spartina alterniflora for phytoremediation

Perennial monoculture forming grasses are very important natural remediators of pollutants. Their genetic improvement is an important task because introduction of key transgenes can dramatically improve their remediation potential. Transfer of key genes for mercury phytoremediation into the salt marsh cordgrass (Spartina alterniflora) is reported here. S. alterniflora plays an important role in the salt marsh by cycling of␣elements, both nutrients and pollutants, protects the coastline from erosion, is a keystone species in the␣salt marsh supporting a large food web, which in turn supports a significant segment of economy, including tourism, has an impact on cloud formation and consequently on global weather, and is thus an ecologically important species relevant for our life-support systems. Embryogenic callus of S. alterniflora was co-inoculated with a pair of Agrobacterium strains LBA4404 carrying the organomercurial lyase (merB) and mercuric reductase (merA) genes, respectively, in order to co-introduce both the merA and the merB genes. Seven stable geneticin resistant lines were recovered. The presence of merA and merB genes was verified by PCR and Southern blotting. All but one transgenic lines contained both the merA and the merB sequences proving that co-introduction into Spartina of two genes from separate Agrobacterium strains is feasible and frequent, although the overall frequency of transformation is low. Northern blotting showed differences in relative expression of the two transgenes among individual transformants. The steady-state RNA levels appeared to correlate with the phenotype. Line #7 showed the highest resistance to HgCl₂ (up to 500 μM), whereas line #3 was the most resistant to phenylmercuric acetate (PMA). Wild-type (WT) callus is sensitive to PMA at 50 μM and to HgCl₂ at 225 μM.