Effective utilization of mahua oil blended with optimum amount of Al2O3 and TiO2 nanoparticles for better performance in CI engine

Environmental Science and Pollution Research - The current research work focuses mainly on improving the performance and emission characteristics of nanoparticle-blended mahua oil-fueled diesel...     

The Water Poverty Index: An application in the Indian context

For developing countries, the proportion of households covered by improved water resources is conventionally used to assess the water stress situation. However, in a developing country like India with a high population growth rate, water demand and supply are considerably mismatched. An agro-based economy with large variations in socio-economic conditions and changing rainfall patterns across the states imposes greater challenge on water resources. Therefore, there is a need to assess the water situation across the country in a holistic manner. This paper proposes application of the Water Poverty Index as a comprehensive policy tool to assess actual water-stress situation across 20 major states in India. This index covers important socio-economic parameters such as access, capacity, use and environment in addition to water resources of each state. The results and findings are expected to be of use to policymakers and implementing agencies. In view of policy formulation, a state performing well on a Water Poverty Index component can act as a benchmark for another state.     

Spatial and temporal variability of metals in inter-tidal beach sediment of Mumbai, India

Nine metals were monitored in the beach sediment in Mumbai from May 2011 to March 2012 to evaluate the spatial and temporal distributions. The average heavy metal concentrations exhibited the following order: Fe > Mn > Cr > Co > Ni > Pb > Zn > Cu > Cd for the four sampling sites. The mean concentrations (± SD) of Fe, Mn, Cr, Co, Ni, Pb, Zn, Cu and Cd were estimated to be 31.15?±?10.02 g kg^?1, 535.04?±?76.42, 151.98?±?97.90, 92.76?±?14.18, 67.52?±?11.32, 59.57?±?15.19, 54.65?±?15.01, 32.24?±?8.07 and 18.75?±?1.76 mg kg^?1, respectively. The results indicated that the sediments were polluted with Cd, Cr, Co and Pb due to high anthropogenic influences. Spatial variation of metals revealed that most of the metals were high in Dadar beach and low in Aksa beach. Cd was the highest contaminant metal studied with a mean contamination factor of 93.75. The pollution load indices of the studied beaches ranged from 1.63 (Aksa) to 1.91 (Dadar) and indicated that the beach sediments were polluted with heavy metals. The heavy metal contents increased in relation to monsoon, and most of the heavy metals showed significantly high concentrations in November during the post-monsoon. The statistical analysis revealed significant effect of study site on all the metals studied. Further, there was a significant difference on metal accumulation on bimonthly basis in relation to weather pattern in Mumbai beaches.     

Trace metals biogeochemistry of Kumaun Himalayan Lakes,Uttarakhand, India

The increasing urbanization, along with tourism, has posed a major threat to the Kumaun Himalayan Lakes, Uttarakhand, India. The total metal concentration in the water, interstitial water, and sediments along with the metal fractionation studies were carried out to understand the remobilization of the trace metals from the sediments of the lakes. The high concentration of the metals in the water column of the lakes generally decreases with depth and the metals release from the sediment is mainly due to the prevalence of anoxic condition at the sediment–water interface and sediment column. The sediment shows that metals Fe and Cr are derived from detrital source, whereas Co, Ni, and Zn are derived mainly from the organic matter dissolution. The sparse correlation of the trace metals with Ti shows most of the metals have chiefly re-precipitated from the water column. The metals speciation studies also supports that metals experience a high rate of anoxic dissolution and their precipitation onto the sediments are determined by the sediment composition and organic matter content. The high concentration of manganese in the interstitial water in the lakes indicates dissolution of organic matter. The released manganese is adsorbed/precipitated as carbonate phase (Nainital Lake) and oxide pahse (in other lakes). The study shows that the trace metals are regenerated from the sediments due to oxyhydroxide dissolution and organic matter decomposition.     

Changes in amino acid profile and metal content in seeds of Cicer arietinum L. (chickpea) grown under various fly-ash amendments

Seeds of Cicer arietinum L. plants are edible and a valuable source of protein. Accumulation of toxic metals in the edible part of the plant, grown in fields close to fly-ash (FA) landfills, may pose a threat to human health. In the present study, the effects of FA and its amendments with different ameliorants viz., garden soil (GS), press mud (PM) and saw dust (SD), on total soluble protein contents, amino acid composition and metal accumulation in seeds were investigated in var. CSG-8962 and var. C-235 of C. arietinum. Plants accumulated adequate amounts of essential metals viz. Fe, Cu, Zn in seeds, while the toxic metals such as Cd and Cr were taken up in smaller quantities. The accumulation of Cr and Cd was less in var. C-235 than var. CSG-8962. Amendment of FA with PM enhanced the amount of soluble protein and amino acids in both varieties and was found to be superior among all tested ameliorants. Both quantitative and qualitative analysis of amino acids showed better response in var. C-235 as compared to var. CSG-8962. Thus var. C-235 seems to be suitable for cultivation in FA contaminated areas due to more accumulation of essential metals and less accumulation of toxic metals in seeds. Application of PM may further improve the growth of plants and nutritional quality of seeds.     

THOR dummy chest deflection response in oblique and lateral far-side sled tests

Abstract

Objective: The focus of this study is side impact. Though occupant injury assessment and protection in nearside impacts has received considerable attention and safety standards have been promulgated, field studies show that a majority of far-side occupant injuries are focused on the head and thorax. The 50th percentile male Test Device for Human Occupant Restraint (THOR) has been used in oblique and lateral far-side impact sled tests, and regional body accelerations and forces and moments recorded by load cells have been previously reported. The aim of this study is to evaluate the chestband-based deflection responses from these tests.

Methods: The 3-point belt–restrained 50th percentile male THOR dummy was seated upright in a buck consisting of a rigid flat seat, simulated center console, dashboard, far-side side door structure, and armrest. It was designed to conduct pure lateral and oblique impacts. The center console, dashboard, simulated door structure, and armrest were covered with energy-absorbing materials. A center-mounted airbag was mounted to the right side of the seat. Two 59-gage chestbands were routed on the circumference of the thorax, with the upper and lower chestbands at the level of the third and sixth ribs, respectively, following the rib geometry. Oblique and pure lateral far-side impact tests with and without airbags were conducted at 8.3 m/s. Maximum chest deflections were computed by processing temporal contours using custom software and 3 methods: Procedures paralleling human cadaver studies, using the actual anchor point location and actual alignment of the InfraRed Telescoping Rods for the Assessment of Chest Compression (IR-TRACC) in the dummy on each aspect—that is, right or left,—and using the same anchor location of the internal sensor but determining the location of the peak chest deflection on the contour confined to the aspect of the sensor; these were termed the SD, ID, and TD metrics, respectively.

Results: All deformation contours at the upper and lower thorax levels and associated peak deflections are given for all tests. Briefly, the ID metrics were the lowest in magnitude for both pure lateral and oblique modes, regardless of the presence or absence of an airbag. This was followed by the TD metric, and the SD metric produced the greatest deflections.

Conclusion: The chestbands provide a unique opportunity to compute peak deflections that parallel current IR-TRACC-type deflections and allow computation of peak deflections independent of the initial point of attachment to the rib. The differing locations of the peak deflection vectors along the rib contours for different test conditions suggest that a priori attachment is less effective. Further, varying magnitudes of the differences between ID and TD metrics underscore the difficulty in extrapolating ID outputs under different conditions: Pure lateral versus oblique, airbag presence, and thoracic levels. Deflection measurements should, therefore, not be limited to an instrument that can only track from a fixed point. For improved predictions, these results suggest the need to investigate alternative techniques, such as optical methods to improve chest deflection measurements for far-side occupant injury assessment and mitigation.     

A simplified method for sampling and analysis of high volume surface water for organic contaminants using XAD-2

A simple compressed-gas driven system for field processing and extracting water for subsequent analyses of hydrophobic organic compounds is presented. The pumping device is a pneumatically driven pump and filtration system that can easily clarify at 4 L/min. The extraction device uses compressed gas to drive filtered water through two parallel XAD-2 resin columns, at about 200 mL/min. No batteries or inverters are required for water collection or processing. Solvent extractions were performed directly in the XAD-2 glass columns. Final extracts are cleaned-up on Florisil cartridges without fractionation and contaminants analyzed by GC-MS. Method detection limits (MDLs) and recoveries for dissolved organic contaminants, polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls (PCBs) and pesticides are reported along with results of surface water analysis for the San Francisco Bay, CA.     

Absence of metallothionein 3 expression in breast cancer is a rare but favorable marker that is under epigenetic control

Cadmium (Cd²⁺), a known carcinogen, mimics the effects of estrogen in the uterus and mammary gland suggesting its possible involvement in the development and progression of breast cancer. This lab showed through analysis of a small set of archival human diagnostic specimens that the third isoform of the classic Cd²⁺ binding protein metallothionein (MT-3) is not expressed in normal breast tissue, but is expressed in some breast cancers and that expression tends to correlate with a poor disease outcome. The goals of this study were to verify that overexpression of MT-3 in a large set of archival human diagnostic specimens tends to correlate with poor disease outcome and define the mechanism of MT-3 gene regulation in the normal breast epithelial cell. The results showed that MT-3 was expressed in approximately 90% of all breast cancers and was absent in normal breast epithelium. The lack of MT-3 staining in some cancers correlated with a favorable patient outcome. High frequency of MT-3 staining was also found for in situ breast cancer suggesting that MT-3 might be an early biomarker for breast cancer. The study also demonstrated that the MCF-10A cell line, an immortalized, non-tumorigenic model of human breast epithelial cells, displayed no basal expression of MT-3, nor was it induced by Cd²⁺. Treatment of the MCF-10A cells with the demethylation agent, 5-aza-2′-deoxycytidine, or the histone deacetylase inhibitor, MS-275, restored MT-3 mRNA expression. It was also shown that the MT-3 metal regulatory elements are potentially active binders of protein factors following treatment with these inhibitors suggesting that MT-3 expression may be subject to epigenetic regulation.     

Irrigation with domestic wastewater: responses on growth and yield of ladyfinger Abelmoschus esculentus and on soil nutrients

Domestic wastewater is generated continuously and in large quantities. It can serve as an alternative water nutrient source for irrigation. In the present study Abelmoschus esculentus L. (Ladyfinger) was irrigated using untreated wastewater (T1), treated wastewater (T2) and rainwater (T3) in pot experiments. The effect was seen on nutrient fortication, growth and yield of the plant and the nutrient status of the soil. Additionally the build up of Cr, Cu and Zn from the irrigation water were anlayzed in different parts of the plant biomass and in the soil. The sapling survival rate was found to be 87% in T1 followed by T2 and T3. Root shoot ratio under different treatments was found in the order T3 (0.46) >T2 (0.35) >T1 (0.31). The chlorophyll a, b and carotene content in the leaves (mg g(-1)) was found to be 6.3, 0.5, 0.9 under T1, 4.8, 0.4, 0.8 under T2 and 3.2, 0.3, 0.5 under T3 respectively and all the three varied in the order T1>T2>T3. The same trend was found in case of total dry matter (g) T1 (6.3) >T2 (3.7) >T3 (2.3) at p < or = 0.05. There was a considerable increase in nutrients in the soil under T1 and T2 as compared to T3 after final harvest. The organic matter (%), NO3-N and PO4(3-) (mg kg(-1)) content post harvest soil was found to be 3.4, 71, 90 under T1 and 2.9, 52, 63 under T2 respectively. Also, there was an increase in cations Na, K, Ca and Mg in the soil irrigated with T1 and T2 after the final harvest. Thus irrigation with wastewater generally increased soil fertility. Only a small percentage of the heavy metal was bioaccumulated by the plant parts from the irrigation water. There was hardly any metal accumulation in fruits. Bulk of the metal ions remained in the soil.     

Role of bioinoculants and organic fertilizers in fodder production and quality of leguminous tree species

The comparative effect of dual inoculation of native N fixer (Rhizobium) and AM fungi consortia with different organic fertilizers (vermicompost and farm yard manure) on fodder production and quality of two leguminous tree species (Leucaena leucocephala (Lam) de. Wit. and Sesbania sesban (L.) Merr.) in silvopastoral system and their impact on the fodder production of un-inoculated Panicum maximum Jacq. under cut and carry system. After three years of plantation maximum tree survival was in L. leucocephala in all the treatments in comparison to S. sesban while fodder production was more in S. sesban for initial two years and in third year it accelerated in L. leucocephala. Dual inoculation with vermicompost significantly improved fodder production, fodder quality and rhizosphere microflora in L. leucocephala but in S. sesban dual inoculation was at par with single inoculation of N fixer, AM fungi and control (without inoculation). The grass production was higher with L. leucocephala for two years while in third year it was more with S. sesban. The association of Rhizobium with AM fungi in L. leucocephala was better than in S. sesban.