Detection of petroleum hydrocarbons at low ppb levels using quartz resonator sensors and instrumentation of a smart environmental monitoring system

Petroleum hydrocarbon vapors at low ppb levels can be detected using a thickness shear mode resonator (TSMR) coated with a chemical-sensing overlayer, prepared by radiofrequency sputtering of porous sintered-polyethylene (PS-PE). The sensing capabilities of PS-PE sensors were profoundly affected by the sputtering methods; they were enhanced by the photo-excitation effect, and were reduced by carbonization and water treatment. The photo-assisted PS-PE sensor was extremely sensitive and could detect linear hydrocarbon (> C12) vapors below the ppb level. The time constant of the sorption curve, however, was large, indicating a slow sensing speed. Toward creating instrumentation for a smart environmental monitoring system, the TSMR sensors were arrayed on a circuit board equipped with a serial interface and signal processing chips of the oscillation drive and frequency counter. Co-sorption with water vapor at a relative humidity of about 10% has almost no effect on the sensing ability of PS-PE sensors for 1,2,4-trimethylbenzene. Conversely, it enhances the sensitivity of the TSMR sensor coated with a D-phenylalanine film. Upward shifts in the baseline are evident with elapsed time. However, a rigorous ten-cycle iteration test for 100 ppm toluene vapor demonstrated good reproducibility of the sensor's signals.     

Formation of submicron sulfate and organic aerosols in the outflow from the urban region of the Pearl River Delta in China

Size-resolved chemical compositions of non-refractory submicron aerosols were measured using a quadrupole Aerodyne aerosol mass spectrometer at a rural site near Guangzhou in the Pearl River Delta (PRD) of China in the summer of 2006. Two cases characterized as the outflows from the PRD urban region with plumes of high SO₂ concentration were investigated. The evolution of sulfate size distributions was observed on a timescale of several hours. Namely mass concentrations of sulfate in the condensation mode (with vacuum aerodynamic diameters (D_va) < 300 nm) increased at a rate of about 0.17–0.37 ppbv h^?1 during the daytime. This finding was consistent with the sulfuric acid production rates of about 0.17–0.3 ppbv h^?1, as calculated from the observed gas-phase concentrations of OH (～3.3 × 10⁶–1.7 × 10⁷ cm^?3) and SO₂ (～3–21.2 ppbv). This implies that the growth of sulfate in the condensation mode was mainly due to gas-phase oxidation of SO₂. The observed rapid increase was caused mainly by the concurrent high concentrations of OH and SO₂ in the air mass. The evolution of the mass size distributions of m/z 44, a tracer for oxygenated organic aerosol (OOA), was very similar to that of sulfate. The mass loadings of m/z 44 were strongly correlated with those of sulfate (r² = 0.99) in the condensation mode, indicating that OOA might also be formed by the gas-phase oxidation of volatile organic compound (VOC) precursors. It is likely that sulfate and OOA were internally mixed throughout the whole size range in the air mass.     

A simple method to harness DC (direct current) electrical energy generated by bacterial activity

We developed a new system for collecting electrons generated by bacterial activity to supply DC (direct current) electrical energy. This system used eight titanium sub-electrodes (surface area of each sub-electrode: 189 cm²) connected to one central main titanium electrode (surface area of electrode: 1571 cm²). The distance between each sub-electrode and the main electrode was 30 cm. In an initial experiment, we collected electrons during composting cattle excreta, which was mixed with a commercially available microbial compost activator/starter. We analysed the relationships between the composting temperature and electrical current and voltage. Electrons were effectively collected and used successfully to obtain DC electrical energy. Generation of a stable voltage of approximately 0.5 V was clearly observed. This voltage was not related to compost temperature; however, the generated electrical current increased and decreased with compost temperature. The method was then used in a second experiment to collect electrons generated by bacterial activity in an agricultural field (area: 48 m²). Electrons in the field were effectively collected, and we measured a stable voltage of approximately 1.1 V and a stable current of approximately 0.7 mA. The system has the advantages of being simple, easily maintained, inexpensive, and applicable to large-scale agricultural fields.     

Epidemiology of tornado destruction in rural northern Bangladesh: risk factors for death and injury

The epidemiology of tornado-related disasters in the developing world is poorly understood. An August 2005 post-tornado cohort study in rural Bangladesh identified elevated levels of death and injury among the elderly (≥ 60 years of age) (adjusted odds ratio (AOR) = 8.9 (95 per cent confidence interval (CI): 3.9-20.2) and AOR = 1.6 (95 per cent CI: 1.4-1.8), respectively), as compared to 15-24 year-olds, and among those outdoors versus indoors during the tornado (AOR = 10.4 (95 per cent CI: 5.5-19.9) and AOR = 6.6 (95 per cent CI: 5.8-7.5), respectively). Females were 1.24 times (95 per cent CI: 1.15-1.33) more likely to be injured than males. Elevated risk of injury was significantly associated with structural damage to the house and tin construction materials. Seeking treatment was protective against death among the injured, odds ratio = 0.08 (95 per cent CI: 0.03-0.21). Further research is needed to develop injury prevention strategies and to address disparities in risk between age groups and between men and women.     

Disposition of bisphenol A in pregnant mice and fetuses after a single and repeated oral administration

The risk assessment of bisphenol A (BPA) on the development of offspring of humans is an important issue. There have been some reports on the fate of BPA in rodents, but information on the BPA level in fetal organs essential for the extrapolation to humans is inadequate. In the present study, we investigated the distribution pattern of ¹⁴C-BPA-derived radioactivity in fetal tissues following administration of 10?mg/kg ¹⁴C-BPA to the pregnant mice. The radioactivity was rapidly transferred through placenta and distributed to all fetal organs including reproductive organs and brains in a similar level. The concentration declined slowly compared with dams. Analysis of metabolites in fetuses showed that a fraction of BPA was unexpectedly large compared to the maternal blood. There was no clear effect of the fetal position in a uterus to influence the radioactivity concentration in whole fetuses. The dose dependence of pharmacokinetics should be recognized to extrapolate the pharmacokinetic result from animal experiments at high doses to humans at low doses. Similar experiments were conducted with an addition of two doses, 1 and 100?mg/kg, respectively. The pharmacokinetics seemed to be linear between 1 and 10?mg/kg, although at 100?mg/kg BPA was absorbed slowly and the radioactivity concentrations in fetuses were much higher than expected based on the linear dose dependence. Repeated doses were administered to pregnant mice since humans are exposed to BPA chronically. Radioactivity level in most of the fetal tissues on repeated administration was higher than single administration.     

Consideration on safety for emerging technology – Case studies of seven service robots

Despite the fact that several manufacturers of service robots launched their innovations into the market, worldwide guidelines or regulations concerning the safety aspects of service robots are not yet available. However the general principles and methodologies of safety of machinery (e.g., ISO/IEC Guide 51, partly ISO14121, ISO12100) could be implemented to a certain degree. The safety of seven service robots as an emerging technology was verified by safety professionals of “NPO – the Safety Engineering Laboratory” a Non Profit Organization. NPO verified the “Critical Hazards” for each service robot mentioned by the respective manufacturers. For those cases, both the “As Low As Reasonably Practicable” principle and the “Reasonable Alternative Design” standard were applied for judging if the risk associated with the Critical Hazards were tolerable or not and if state of the art measures for reducing the risk were applied adequately. These experiences will help to establish guidelines for the safety of service robots as an emerging technology in the future.     

Transportation of organic matter to the sea floor by carrion falls of the giant jellyfish <Emphasis Type="Italic">Nemopilema nomurai</Emphasis> in the Sea of Japan

The fate of the giant jellyfish Nemopilema nomurai after death was examined in the southwest Sea of Japan. The density of dead jellyfish was greater than that of live animals. The dead animals are heavier than the Japan Sea Proper Water which occurs deeper than 200 m, suggesting that dead jellyfish sink to the sea floor. The sea floor survey, conducted with a towed video tape recorder (VTR) monitoring system between mid September and mid October, observed a total of 138 jellyfish during 28 of 29 operations. The density of carrion ranged between 0.2 and 5.1 individuals/1,000 m² (mean ± SE = 1.1 ± 0.2). Ophiuroids occurred abundantly at 23 jellyfish carcasses and a sea anemone was observed attached to five carcasses. The VTR surveys confirmed that carrion sinks to the sea floor not only during the winter, the normal end of life for medusae, but also during the fall. A trap survey baited with medusae was also employed, and four different species were sampled with the traps: the snow crab (Chionoecetes opilio), a shrimp (Pandalopsis japonica), the ivory shell (Buccinum striatissimum) and an ophiuroid (Ophiura sarsii). Much of the trap bait remained (49–68% weight-mean = 60.3%) during the 23 h soak-time, and the reduction in weight was greater than that observed by bacterial decomposition, suggesting benthic animals consume dead organisms. The present study indicates that dead N. nomurai sink to the sea floor continuously and were subsequently consumed by benthic scavengers.     

Perchlorate contamination of groundwater from fireworks manufacturing area in South India

Perchlorate contamination was investigated in groundwater and surface water from Sivakasi and Madurai in the Tamil Nadu State of South India. Sensitive determination of perchlorate (LOQ?=?0.005 μg/L) was achieved by large-volume (500 μL) injection ion chromatography coupled with tandem mass spectrometry. Concentrations of perchlorate were <0.005–7,690 μg/L in groundwater (n?=?60), <0.005–30.2 μg/L in surface water (n?=?11), and 0.063–0.393 μg/L in tap water (n?=?3). Levels in groundwater were significantly higher in the fireworks factory area than in the other locations, indicating that the fireworks and safety match industries are principal sources of perchlorate pollution. This is the first study that reports the contamination status of perchlorate in this area and reveals firework manufacture to be the pollution source. Since perchlorate levels in 17 out of 57 groundwater samples from Sivakasi, and none from Madurai, exceeded the drinking water guideline level proposed by USEPA (15 μg/L), further investigation on human health is warranted.