Alternative amendment for soluble phosphorus removal from poultry litter

Background, aim, and scope  

Alum (aluminum sulfate) is the currently preferred chemical amendment for phosphorus (P) treatment in poultry litter (PL). Aluminum-based drinking-water treatment residuals (Al-WTRs) are the waste by-product of the drinking-water treatment process and have been effectively used to remove P from aqueous solutions, but their effectiveness in PL water extracts has not been studied in detail. Elevated cost associated with alum could be minimized by using the equally effective WTRs to remove soluble P from PL, and they can be obtained at a minimal cost from drinking-water treatment plants.     

The impact of agroforestry combined with water harvesting on soil carbon and nitrogen stocks in central Chile evaluated using the ICBM/N model

Soil organic carbon (SOC) and total nitrogen (N) stocks in an agroforestry system with water harvesting were analysed in a field experiment and the results compared with those of other crop management systems in the Mediterranean zone of central Chile. Agroforestry with water harvesting showed higher positive effects on N stocks, mainly in the upper soil layer, than the other crop management systems. However, soil analysis revealed a lack of differences between treatments, a fact that might be related mainly to the short study time (12 years) and the high spatial variability in these soil properties at the experimental site. In addition, the Introductory Carbon Balance Model that simulates N processes (ICBM/N) was evaluated for simulating trends in SOC and N stocks in the field experiment. Soil data collected between 1996 and 2008 in the field experiment and primarily literature data sets were used to test ICBM/N and its performance was evaluated by considering uncertainty in model inputs using Generalised Likelihood Uncertainty Estimation (GLUE) methodology. The GLUE estimates (5% and 95%) and measured SOC and N stocks were in satisfactory agreement. The observed SOC and N stocks were bracketed by the uncertainty bands in 70% and 80% of the simulations, respectively. Sensitivity analysis showed the model to be most sensitive to C parameters, such as the humification coefficient (h). The results of this study show that ICBM/N can be an effective tool for estimating SOC and N stocks from agroforestry combined with water harvesting systems in the Mediterranean zone of central Chile over the medium term. However, they also indicate that additional data sets are needed to redefine the parameter distributions in the model and thus to predict trends in SOC and N stocks in the future.     

Identification of microcystins from three collection strains of Microcystis aeruginosa

Microcystins (MCs) are toxic cyclic heptapeptides produced by various cyanobacteria genera, especially Microcystis. We identified 10 out of 12 MCs produced by three Microcystis aeruginosa strains from cyanobacteria collections, UTEX 2666, UTEX 2670 and UAM 1303, by using two analytical methods: Matrix-assisted Laser Desorption Ionization Time of Flight Mass Spectrometry (MALDI-TOF/MS) and HPLC Photodiode Array Detector coupled to a hybrid Quadrupole Time of Flight Mass Spectrometry (HPLC-PDA-QTOF/MS). MALDI-TOF/MS failed to detect non-polar MCs, such as MC-LY and MC-LW. HPLC-QTOF/MS permitted the accurate identification of most MCs present in methanolic extracts. Besides, three new MCs, namely: [D-Glu(OCH₃)⁶, D-Asp³] MC-LAba, MC-YL and MC-YM were detected by HPLC-QTOF/MS.     

Minimizing disruptions caused by damming and ensuring the health of downstream ecosystems

In view of the Brazilian Ten‐Year Energy Expansion Plan 2021, this article presents a discussion on environmental flow (e‐flow). The authors analyze the literature to show the evolution of publications concerning e‐flow releases from the perspective of ecosystems services preservation considering results from different case studies from throughout the world. Finally, two main recommendations are drawn regarding e‐flow are: (1) performing a holistic approach to e‐flow planning, including hydrological, hydraulic, water quality, habitat, and riparian zone considerations; and (2) installing in new structures adequate bottom outlets to allow a range of adjustable e‐flow from reservoir dams to reproduce natural flow variations.     

Biological nitrogen and carbon removal in a gravity flow biomass concentrator reactor for municipal sewage treatment

A novel membrane system, the Biomass Concentrator Reactor (BCR), was evaluated as an alternative technology for the treatment of municipal wastewater. Because the BCR is equipped with a membrane whose average poresize is 20 μm (18–28 μm), the reactor requires low-pressure differential to operate (gravity). The effectiveness of this system was evaluated for the removal of carbon and nitrogen using two identical BCRs, identified as conventional and hybrid, that were operated in parallel. The conventional reactor was operated under full aerobic conditions (i.e., organic carbon and ammonia oxidation), while the hybrid reactor incorporated an anoxic zone for nitrate reduction as well as an aerobic zone for organic carbon and ammonia oxidation. Both reactors were fed synthetic wastewater at a flow rate of 71 L d^?1, which resulted in a hydraulic retention time of 9 h. In the case of the hybrid reactor, the recycle flow from the aerobic zone to the anoxic zone was twice the feed flow rate. Reactor performance was evaluated under two solids retention times (6 and 15 d). Under these conditions, the BCRs achieved nearly 100% mixed liquor solids separation with a hydraulic head differential of less than 2.5 cm. The COD removal efficiency was over 90%. Essentially complete nitrification was achieved in both systems, and nitrogen removal in the hybrid reactor was close to the expected value (67%).     

Photocatalytic degradation of contaminants of concern with composite NF-TiO2 films under visible and solar light

This study reports the synthesis and characterization of composite nitrogen and fluorine co-doped titanium dioxide (NF-TiO₂) for the removal of contaminants of concern in wastewater under visible and solar light. Monodisperse anatase TiO₂ nanoparticles of different sizes and Evonik P25 were assembled to immobilized NF-TiO₂ by direct incorporation into the sol–gel or by the layer-by-layer technique. The composite films were characterized with X-ray diffraction, high-resolution transmission electron microscopy, environmental scanning electron microscopy, and porosimetry analysis. The photocatalytic degradation of atrazine, carbamazepine, and caffeine was evaluated in a synthetic water solution and in an effluent from a hybrid biological concentrator reactor (BCR). Minor aggregation and improved distribution of monodisperse titania particles was obtained with NF-TiO₂-monodisperse (10 and 50 nm) from the layer-by-layer technique than with NF-TiO₂?+?monodisperse TiO₂ (300 nm) directly incorporated into the sol. The photocatalysts synthesized with the layer-by-layer method achieved significantly higher degradation rates in contrast with NF-TiO₂-monodisperse titania (300 nm) and slightly faster values when compared with NF-TiO₂-P25. Using NF-TiO₂ layer-by-layer with monodisperse TiO₂ (50 nm) under solar light irradiation, the respective degradation rates in synthetic water and BCR effluent were 14.6 and 9.5?×?10^?3?min^?1 for caffeine, 12.5 and 9.0?×?10^?3?min^?1 for carbamazepine, and 10.9 and 5.8?×?10^?3?min^?1 for atrazine. These results suggest that the layer-by-layer technique is a promising method for the synthesis of composite TiO₂-based films compared to the direct addition of nanoparticles into the sol.     

The photocatalytic disinfection of urban waste waters

In this paper we present the results of the photocatalytic disinfection of urban waste water. Two microbial groups, total coliforms and Streptococcus faecalis, have been used as indexes to test disinfection efficiencies. Different experimental parameters have been checked, such as the effect of TiO2, solar or UV-lamp light and pH. Disinfection of water samples has been achieved employing both UV-lamp and solar light in agreement with data shown by other authors. The higher disinfection rates obtained employing an UV-lamp may be explained by the stronger incident light intensity. Nevertheless no consistent differences have been found between TiO2-photocatalysis and direct solar or UV-lamp light irradiation at natural sample pH (7.8). At pH 5 the presence of TiO2 increases the relative inactivation rate compared with the absence of the catalyst. After the photocatalytic bacterial inactivation, the later bacterial reappearance was checked for total coliforms at natural pH and pH 5, with and without TiO2. Two h after the photocatalytic treatment, CFU increment was almost nill. But 24 and 48 h later an important bacterial CFU increment was observed. This CFU increment is slower after irradiation with TiO2 at pH 5 in non-air-purged samples.     

Prospects for carbon-neutral housing: the influence of greater wood use on the carbon footprint of a single-family residence

This paper examines the energy and carbon balance of two residential house alternatives; a typical wood frame home using more conventional materials (brick cladding, vinyl windows, asphalt shingles, and fibreglass insulation) and a similar wood frame house that also maximizes wood use throughout (cedar shingles and siding, wood windows, and cellulose insulation) in place of the more typical materials used – a wood-intensive house. Carbon emission and fossil fuel consumption balances were established for the two homes based on the cumulative total of three subsystems: (1) forest harvesting and regeneration; (2) cradle-to-gate product manufacturing, construction, and replacement effects over a 100-year service life; and (3) end-of-life effects – landfilling with methane capture and combustion or recovery of biomass for energy production.The net carbon balance of the wood-intensive house showed a complete offset of the manufacturing emissions by the credit given to the system for forest re-growth. Including landfill methane emissions, the wood-intensive life cycle yielded 20 tons of CO₂e emissions compared to 72 tons for the typical house. The wood-intensive home's life cycle also consumed only 45% of the fossil fuels used in the typical house.Diverting wood materials from the landfill at the end of life improved the life cycle balances of both the typical and wood-intensive houses. The carbon balance of the wood-intensive house was 5.2 tons of CO₂e permanently removed from the atmosphere (a net carbon sink) as compared to 63.4 of total CO₂e emissions for the typical house. Substitution of wood fuel for natural gas and coal in electricity production led to a net energy balance of the wood-intensive house that was nearly neutral, 87.1 GJ energy use, 88% lower than the scenario in which the materials were landfilled.Allocating biomass generation and carbon sequestration in the forest on an economic basis as opposed to a mass basis significantly improves the life cycle balances of both houses. Employing an economic allocation method to the forest leads to 3–5 times greater carbon sequestration and fossil fuel substitution attributable to the house, which is doubled in forestry regimes that remove stumps and slash as fuel. Thus, wood use has the potential to create a significantly negative carbon footprint for a house up to the point of occupancy and even offset a portion of heating and cooling energy use and carbon emissions; the wood-intensive house is energy and carbon neutral for 34–68 years in Ottawa and has the potential to be a net carbon sink and energy producer in a more temperate climate like San Francisco.     

Monitoring potential semiochemicals in individual mouse urine samples

Summary. This work validates a method for detecting potential semiochemicals in mouse urine samples with a volume as small as 10 μL. Using solid-phase microextraction, gas chromatography and mass spectrometry, we screened 2,3,5-trithiahexane, 2-sec-butyl-4,5-dihydrothiazole, geraniol, indole, trans-β-farnesene and farnesol in individual urine samples taken daily from mice housed under various social conditions. Excretion of 2-sec-butyl-4,5-dihydrothiazole by males did not occur when they were housed in rooms containing no females, but increased when raising the males to rooms containing females. Between-male differences in β-farnesene excretion were observed even in the absence of females. These results highlight the usefulness of the proposed analytical method for research in this area.     

Restoration planning to guide Aichi targets in a megadiverse country

Ecological restoration has become an important strategy to conserve biodiversity and ecosystems services. To restore 15% of degraded ecosystems as stipulated by the Convention on Biological Diversity Aichi target 15, we developed a prioritization framework to identify potential priority sites for restoration in Mexico, a megadiverse country. We used the most current biological and environmental data on Mexico to assess areas of biological importance and restoration feasibility at national scale and engaged stakeholders and experts throughout the process. We integrated 8 criteria into 2 components (i.e., biological importance and restoration feasibility) in a spatial multicriteria analysis and generated 11 scenarios to test the effect of assigning different component weights. The priority restoration sites were distributed across all terrestrial ecosystems of Mexico; 64.1% were in degraded natural vegetation and 6% were in protected areas. Our results provide a spatial guide to where restoration could enhance the persistence of species of conservation concern and vulnerable ecosystems while maximizing the likelihood of restoration success. Such spatial prioritization is a first step in informing policy makers and restoration planners where to focus local and large‐scale restoration efforts, which should additionally incorporate social and monetary cost–benefit considerations.